Dry tropics water smart : a community based approach to residential outdoor water consumption

This paper discusses the Townsville City Council Dry Tropics Water Smart (DTWS) initiative, developed by TCC Integrated Sustainability Services (ISS) and Townsville Water, and informed by The University of Adelaide. The program draws on many years of experience by the TCC team to blend key community-based research approaches in order to develop this residential outdoor water conservation program. Several community pilots have been conducted to test different behaviour change strategies and messages. This paper outlines recent steps taken to develop the community trials, as guided by a combination of behaviour change theories including community-based social marketing and thematic communications methods. Some preliminary results are outlined focused on community uptake of different strategies, community perceptions of communication materials, and some insights into the effectiveness of outdoor water hardware.

Experimental and numerical analysis of the relationship between indoor and outdoor airborne particles in an operating room

This work investigated the impact of the HVAC filtration system and indoor particle sources on the relationship between indoor and outdoor airborne particle size and concentrations in an operating room. Filters with efficiency between 65% and 99.97% were used in the investigation and indoor and outdoor particle size and concentrations were measured. A balance mass model was used for the simulation of the impact of the surgical team, deposition rate, HVAC exhaust and air change rates on indoor particle concentration. The experimental results showed that high efficiency filters would not be expected to decrease the risk associated with indoor particles larger than approximately 1 µm in size because normal filters are relatively efficient for these large particles. A good fraction of outdoor particles were removed by deposition on the HVAC system surfaces and this deposition increased with particle size. For particles of 0.3-0.5 µm in diameter, particle reduction was about 23%, while for particles >10 µm the loss was about 78%. The modelling results showed that depending on the type of filter used, the surgical team generated between 93-99% of total particles, while the outdoor air contributed only 1-6%.

Exposure to ambient heat and urolithiasis among outdoor workers in Guangzhou, China

Objectives: To assess the impact of exposure to ambient heat on urolithiasis among outdoor workers in a subtropical city of China. Methods: The 2003–2010 health check data of a shipbuilding company in Guangzhou, China were acquired. 190 cases and 760 matched controls were involved in this study. We assessed the relationship between exposure to ambient heat and urolithiasis for different occupations using conditional logistic regression. Results: Spray painters were most likely to develop urolithiasis (OR = 4.4; 95% CI: 1.7, 11.4), followed by smelter workers (OR = 4.0; 95% CI: 1.8, 9.2), welders (OR = 3.7; 95% CI: 1.9, 7.2), production security and quality inspectors (OR = 2.7; 95% CI: 1.4, 3.0), and assemblers (OR = 2.2; 95% CI: 1.1, 4.3). Overall, outdoor workers were more likely to present with urolithiasis compared with indoor employees (p b 0.05). In addition, workers with longer cumulative exposure time (OR = 1.5; 95% CI: 1.2, 1.8) and abnormal blood pressure (OR = 1.6; 95% CI: 1.0, 2.5) had higher risk for urolithiasis. Conclusions: Our findings demonstrate a significant association between exposure to ambient heat and urolithiasis among outdoor working populations. Public health intervention strategies should be developed to specifically target outdoor occupations.

Vision-based simultaneous localization and mapping in changing outdoor environments

For robots operating in outdoor environments, a number of factors, including weather, time of day, rough terrain, high speeds, and hardware limitations, make performing vision-based simultaneous localization and mapping with current techniques infeasible due to factors such as image blur and/or underexposure, especially on smaller platforms and low-cost hardware. In this paper, we present novel visual place-recognition and odometry techniques that address the challenges posed by low lighting, perceptual change, and low-cost cameras. Our primary contribution is a novel two-step algorithm that combines fast low-resolution whole image matching with a higher-resolution patch-verification step, as well as image saliency methods that simultaneously improve performance and decrease computing time. The algorithms are demonstrated using consumer cameras mounted on a small vehicle in a mixed urban and vegetated environment and a car traversing highway and suburban streets, at different times of day and night and in various weather conditions. The algorithms achieve reliable mapping over the course of a day, both when incrementally incorporating new visual scenes from different times of day into an existing map, and when using a static map comprising visual scenes captured at only one point in time. Using the two-step place-recognition process, we demonstrate for the first time single-image, error-free place recognition at recall rates above 50% across a day-night dataset without prior training or utilization of image sequences. This place-recognition performance enables topologically correct mapping across day-night cycles.

Qaphqa : fresh cut 2013 Part 1

'Qaphqa' was an outdoor artwork exhibited in the forecourt of Brisbane’s Institute of Modern Art as part of Fresh Cut exhibition series. The work took the form of a three-storey-high series of stacked 'outhouses', the seat of each opening onto the cubicle below to form what the artist referred to as a 'long drop'. Assembled in untreated pine and plywood and festooned with mock-medieval ensigns and flags, the work included a flyer containing a poem by Jorge Luis Borges and was accompanied by a published catalogue.

Changes in outdoor workers' sun-related attitudes, beliefs, and behaviors : a pre-post workplace intervention

OBJECTIVE To evaluate changes in outdoor workers' sun-related attitudes, beliefs, and behaviors in response to a health promotion intervention using a participatory action research process. METHODS Fourteen workplaces across four outdoor industry types worked collaboratively with the project team to develop tailored sun protection action plans. Workers were assessed before and after the 18-month intervention. RESULTS Outdoor workers reported increases in workplace support for sun protection (P < 0.01) and personal use of sun protection (P < 0.01). More workers reported seeking natural shade (+20%) and wearing more personal protective equipment, including broad-brimmed hats (+25%), long-sleeved collared shirts (+19%), and long trousers (+16%). The proportion of workers reporting sunburn over the past 12 months was lower at postintervention (-14%) (P = 0.03); however, the intensity of reported sunburn increased. CONCLUSIONS This intervention was successful in increasing workers' sun protective attitudes, beliefs, and behaviors.

Estimating the burden of disease attributable to urban outdoor air pollution in South Africa in 2000

Objectives To quantify the mortality burden attributed to urban outdoor air pollution in South Africa in 2000. Design The study followed comparative risk assessment (CRA) methodology developed by the World Heath Organization (WHO). In most urban areas, annual mean concentrations of particulate matter (PM) with diameters less than 10 μum (PM10) from monitoring network data and PM with diameters less than 2.5 μm (PM2.5) derived using a ratio method were weighted according to population size. PM10 and PM2.5 data from air-quality assessment studies in areas not covered by the network were also included. Population-attributable fractions calculated using risk coefficients presented in the WHO study were weighted by the proportion of the total population (33%) in urban environments, and applied to revised estimates of deaths and years of life lost (YLLs) for South Africa in 2000. Setting South Africa. Subjects Children under 5 years and adults 30 years and older. Outcome measures Mortality and YLLs from lung cancer and cardiopulmonary disease in adults (30 years and older), and from acute respiratory infections (ARIs) in children aged 0 - 4 years. Results Outdoor air pollution in urban areas in South Africa was estimated to cause 3.7% of the national mortality from cardiopulmonary disease and 5.1% of mortality attributable to cancers of the trachea, bronchus and lung in adults aged 30 years and older, and 1.1% of mortality from ARIs in children under 5 years of age. This amounts to 4 637 or 0.9% (95% uncertainty interval 0.3 - 1.5%) of all deaths and about 42 000 YLLs, or 0.4% (95% uncertainty interval 0.1 - 0.7%) of all YLLs in persons in South Africa in 2000. Conclusion Urban air pollution has under-recognised public health impacts in South Africa. Fossil fuel combustion emissions and traffic-related air pollution remain key targets for public health in South Africa.

From ideation to sculpture : digital sculpting as the primary 'ideation' tool for creature design

This research project examined the potential for circumventing drawing in the ideation process by adopting digital sculpture as the primary conceptual development and design tool for the digital sculpting of creature designs. Through a series of experimental research cycles, multiple frameworks were explored with the aim of identifying a methodology for creating '3D sculpted sketches' for the initial phases of the ideation process. This research project acknowledges that drawing still remains the predominant method of visualising design ideas for characters and creatures for many artists. However, alongside other ideation techniques digital sculpting can function as a rapid and responsive tool to visualize and explore forms in a digital sculpting environment for the conceptualisation of multiple creature design variations. The results of this study are significant for emerging digital sculptors who may not necessarily have a well-defined creative brief or initial concept.

The role of human factors in led outdoor activity accidents: literature review and exploratory analysis

While the exact rate of incidence is unknown (due to the paucity of exposure data), it is acknowledged that safety compromising accidents and incidents occur in the led outdoor activity domain, and that they represent an important issue. Despite this, compared to other safety critical domains, very little is currently known about the key causal factors involved in such accidents and incidents. This report presents the findings derived from a review of the literature, the aim of which was to identify the Human Factors-related issues involved in accidents and incidents occurring in this area. In addition, to demonstrate the utility of systems-based, theoretically underpinned accident analysis methodologies for identifying the systemic and human contribution to accidents and incidents occurring in the led outdoor activity domain, three case-study accidents were analysed using two such approaches. In conclusion, the review identified a range of causal factors cited in the literature; however, it was noted that the majority of the research undertaken to date lacks theoretical underpinning and focuses mainly on instructor or activity leader causal factors, as opposed to the wider system failures involved. The accident analysis presented highlighted the utility of systems-based, theoretically underpinned accident analysis methodologies for analysing and learning from accidents and incidents in the led outdoor activity sector. In closing, the need for further research in the area is articulated, in particular focussing on the development of standardised and universally accepted accident and incident reporting systems and databases, the development of data driven, theoretically underpinned causal factor taxonomies, and the development and application of systems-based accident analysis methodologies.

Redundant sensing for localisation in outdoor industrial environments

We describe our experiences with automating a large fork-lift type vehicle that operates outdoors and in all weather. In particular, we focus on the use of independent and robust localisation systems for reliable navigation around the worksite. Two localisation systems are briefly described. The first is based on laser range finders and retro-reflective beacons, and the second uses a two camera vision system to estimate the vehicle’s pose relative to a known model of the surrounding buildings. We show the results from an experiment where the 20 tonne experimental vehicle, an autonomous Hot Metal Carrier, was conducting autonomous operations and one of the localisation systems was deliberately made to fail.

Is the sun too bright in Queensland? An approach to robust outdoor colour beacon detection

Using cameras onboard a robot for detecting a coloured stationary target outdoors is a difficult task. Apart from the complexity of separating the target from the background scenery over different ranges, there are also the inconsistencies with direct and reflected illumination from the sun,clouds, moving and stationary objects. They can vary both the illumination on the target and its colour as perceived by the camera. In this paper, we analyse the effect of environment conditions, range to target, camera settings and image processing on the reported colours of various targets. The analysis indicates the colour space and camera configuration that provide the most consistent colour values over varying environment conditions and ranges. This information is used to develop a detection system that provides range and bearing to detected targets. The system is evaluated over various lighting conditions from bright sunlight, shadows and overcast days and demonstrates robust performance. The accuracy of the system is compared against a laser beacon detector with preliminary results indicating it to be a valuable asset for long-range coloured target detection.