Visualization of thermal characteristics around the absorber tube of a standard parabolic trough thermal collector by 3D simulation

Three dimensional conjugate heat transfer simulation of a standard parabolic trough thermal collector receiver is performed numerically in order to visualize and analyze the surface thermal characteristics. The computational model is developed in Ansys Fluent environment based on some simplified assumptions. Three test conditions are selected from the existing literature to verify the numerical model directly, and reasonably good agreement between the model and the test results confirms the reliability of the simulation. Solar radiation flux profile around the tube is also approximated from the literature. An in house macro is written to read the input solar flux as a heat flux wall boundary condition for the tube wall. The numerical results show that there is an abrupt variation in the resultant heat flux along the circumference of the receiver. Consequently, the temperature varies throughout the tube surface. The lower half of the horizontal receiver enjoys the maximum solar flux, and therefore, experiences the maximum temperature rise compared to the upper part with almost leveled temperature. Reasonable attributions and suggestions are made on this particular type of conjugate thermal system. The knowledge that gained so far from this study will be used to further the analysis and to design an efficient concentrator photovoltaic collector in near future.

ACE research vignette 024 : New firm formation and job creation by type of firm an type of region.

This series of research vignettes is aimed at sharing current and interesting research findings from our team of international Entrepreneurship researchers. This vignette, written by Mr. Darren Kavanagh and Professor Per Davidsson, takes a closer look at job creation by new firms.

Does experience with one type of two-wheeler affect behaviours and attitudes to other types?

Failure to give way by motor vehicles is a factor in many collisions with both powered and unpowered two wheelers (TWs). Motor vehicle drivers often report that they did not see the TW, but research has shown that motor vehicle drivers who have experience riding a motorcycle are less likely to fail to detect motorcycles. The research reported here examines whether this phenomenon extends to detection of bicycles and whether car drivers who have experience with one mode of TW show improved detection of the other mode. A driving simulator study was conducted in an Australian urban setting which incorporated some of the most common car-TW crash scenarios. Participants with car-only, car plus motorcycle, car plus bicycle, and car plus bicycle plus motorcycle experience operated a car simulator. Their interactions with both types of TWs were measured in terms of visual detection, lateral distance and speed when approaching and passing. The effects of different levels of colour and lighting of the TWs on driver responses were also examined. The attitudes of participants towards TWs were measured in a questionnaire.

Perceived barriers to healthy lifestyle activities in midlife and older Australian women with type 2 diabetes

Purpose: Type 2 diabetes is a leading cause of morbidity and mortality in midlife and older Australian women with known modifiable risk factors for type 2 diabetes including smoking, nutrition, physical activity and obesity. In Australia little research has been done to investigate the perceived barriers to healthy lifestyle activities in midlife and older women with type 2 diabetes. The primary aim of this study was to explore the level and type of perceived barriers to health promotion activities. The secondary aim was to explore the relationship of perceived barriers to smoking behaviour, fruit and vegetable intake, physical activity, and body mass index. Methods: The study was a cross sectional survey of women, aged over 45 with type 2 diabetes, attending metropolitan community health clinics (N = 41). Data was collected from self-report questionnaire and analysed using descriptive and inferential statistics. Results: Women in the study had average total barriers scores similar to those reported in the literature for women with a range of physical disabilities and illnesses. The leading barriers for this group of women were: lack of interest, concern about safety, too tired, lack of money and feeling what they do does not help. There was no association between total barriers scores and body mass index, physical activity, fruit and vegetable intake or socio-demographic variables. Conclusion: This study contributes to understanding the perceptions of midlife and older women with type 2 diabetes about the level and type of barriers to healthy lifestyle activities that they experience. Evidence from this study can be applied to inform health promotion for lifestyle risk factor reduction in women with type 2 diabetes.

Astrophysics and the solar nebula

The following types of experiments for a proposed Space Station Microgravity Particle Research Facility are described: (1) nucleation of refractory vapors at low pressure/high temperature; (2) coagulation of refractory grains; (3) optical properties of refractory grains; (4) mantle growth on refractory cores; (5) coagulation of core-mantle grains; (6) optical properties of core-mantle grains; (7) lightning strokes in the primitive solar nebula; and (8) separation of dust from a grain/gas mixture that interacts with a meter-sized planetesimal to determine if accretion occurs. The required capabilities and desired hardware for the facility are detailed.

The AusD Study: A population-based study of the determinants of serum 25-hydroxyvitamin D concentration across a broad latitude range

Observational studies suggest that people with a high serum 25-hydroxyvitamin D (25(OH)D) concentration may have reduced risk of chronic diseases such as osteoporosis, multiple sclerosis, type 1 diabetes, cardiovascular disease, and some cancers. The AusD Study (A Quantitative Assessment of Solar UV Exposure for Vitamin D Synthesis in Australian Adults) was conducted to clarify the relationships between ultraviolet (UV) radiation exposure, dietary intake of vitamin D, and serum 25(OH)D concentration among Australian adults residing in Townsville (19.3°S), Brisbane (27.5°S), Canberra (35.3°S), and Hobart (42.8°S). Participants aged 18-75 years were recruited from the Australian Electoral Roll between 2009 and 2010. Measurements were made of height, weight, waist:hip ratio, skin, hair, and eye color, blood pressure, and grip strength. Participants completed a questionnaire on sun exposure and vitamin D intake, together with 10 days of personal UV dosimetry and an associated sun-exposure and physical-activity diary that was temporally linked to a blood test for measurement of 25(OH)D concentration. Ambient solar UV radiation was also monitored at all study sites. We collected comprehensive, high-quality data from 1,002 participants (459 males, 543 females) assessed simultaneously across a range of latitudes and through all seasons. Here we describe the scientific and methodological issues considered in designing the AusD Study.

‘Working with the team’ : an exploratory study of improved type 2 diabetes management in a new model of integrated primary/secondary care

This study aimed to explore how a new model of integrated primary/secondary care for type 2 diabetes management, the Brisbane South Complex Diabetes Service (BSCDS), related to improved diabetes management in a selected group of patients. We used a qualitative research design to obtain detailed accounts from the BSCDS via semi-structured interviews with 10 patients. The interviews were fully transcribed and systematically coded using a form of thematic analysis. Participants’ responses were grouped in relation to: (1) Patient-centred care; (2) Effective multiprofessional teamwork; and (3) Empowering patients. The key features of this integrated primary/secondary care model were accessibility and its delivery within a positive health care environment, clear and supportive interpersonal communication between patients and health care providers, and patients seeing themselves as being part of the team-based care. The BSCDS delivered patient-centred care and achieved patient engagement in ways that may have contributed to improved type 2 diabetes management in these participants.

Desalination by a solar thermally driven distillation process

Desalination processes to remove dissolved salts from seawater or brackish water includes common industrial scale processes such as reverse osmosis, thermal processes (i.e. multi-stage flash, multiple-effect distillation) and mechanical vapour compression. These processes are very energy intensive. The Institute for Future Environments (IFE) has evaluated various alternative processes to accomplish desalination using renewable or sustainable energy sources. A new process - a solar, thermally driven distillation system . based on the principles of a solar still – has been examined. This work presents an initial evaluation of the process.

Desalination by a solar thermal membrane distillation process

A solar thermal membrane distillation pilot plant was operated for over 70 days in field conditions. The pilot plant incorporated a single spiral wound permeate gap membrane distillation style of module. All energy used to operate the unit was supplied by solar hot water collectors and photovoltaic panels. The process was able to produce a distillate stream of product water with a conductivity less than 10 µS/cm. Feed water concentration varied from 2,400 µS/cm to 106,000 µS/cm. The process is expected to find application in the production of drinking water for remote island and arid regions without the consumption of electrical energy.

Blocking layer optimisation of poly(3-hexylthiopene)based solid state dye sensitized solar cells

The optimisation study of the fabrication of a compact TiO2 blocking layer (via Spray Pyrolysis Deposition) for poly (3-hexylthiopene) (P3HT) for Solid State Dye Sensitized Solar Cells (SDSCs) is reported. We used a novel spray TiO2 precursor solution composition obtained by adding acetylacetone to a conventional formulation (Diisopropoxytitanium bis (acetylacetonate) in ethanol). By Scanning Electron Microscopy a TiO2 layer with compact morphology and thickness of around 100 nmis shown. Through a Tafel plot analysis an enhancement of the device diode-like behaviour induced by the acetylacetone blocking layer respect to the conventional one is observed. Significantly, the device fabricatedwith the acetylacetone blocking layer shows an overall increment of the cell performance with respect to the cellwith the conventional one (DJsc/Jsc = +13.8%, DFF/FF = +39.7%, DPCE/PCE = +55.6%). A conversion efficiency optimumis found for 15 successive spray cycles where the diode-like behaviour of the acetylacetone blocking layer is more effective. Over three batches of cells (fabricated with P3HT and dye D35) an average conversion efficiency value of 3.9% (under a class A sun simulator with 1 sun A.M. 1.5 illumination conditions) was measured. From the best cell we fabricated a conversion efficiency value of 4.5% was extracted. This represents a significant increment with respect to previously reported values for P3HT/dye D35 based SDSCs.

Cometary evolution : clues on physical properties from chondritic interplanetary dust particles

The degree of diversity or similarity detected in comets depends primarily on the lifetimes of the individual cometary nuclei at the time of analysis. It is inherent in our understanding of cometary orbital dynamics and the seminal model of comet origins that cometary evolution is the natural order of events in our Solar System. Thus, predictions of cometary behaviour in terms of bulk physical, mineralogical or chemical parameters should contain an appreciation of temporal variation(s). Previously, Rietmeijer and Mackinnon [1987] developed mineralogical bases for the chemical evolution of cometary nuclei primarily with regard to the predominantly silicate fraction of comet nuclei. We suggested that alteration of solids in cometary nuclei should be expected and that indications of likely reactants and products can be derived from judicious comparison with terrestrial diagenetic environments which include hydrocryogenic and low-temperature aqueous alterations. In a further development of this concept, Rietmeijer [1988] provides indirect evidence for the formation of sulfides and oxides in comet nuclei. Furthermore, Rietmeijer [1988] noted that timescales for hydrocryogenic and low-temperature reactions involving liquid water are probably adequate for relatively mature comets, e.g. P/comet Halley. In this paper, we will address the evolution of comet nuclei physical parameters such as solid particle grain size, porosity and density. In natural environments, chemical evolution (e.g. mineral reactions) is often accompanied by changes in physical properties. These concurrent changes are well-documented in the terrestrial geological literature, especially in studies of sediment diagenesis and we suggest that similar basic principles apply within the upper few meters of active comet nuclei. The database for prediction of comet nuclei physical parameters is, in principle, the same as used for the proposition of chemical evolution. We use detailed mineralogical studies of chondritic interplanetary dust particles (IDPS) as a guide to the likely constitution of mature comets traversing the inner Solar System. While there is, as yet, no direct proof that a specific sub-group or type of chondritic IDP is derived from a specific comet, it is clear that these particles are extraterrestrial in origin and that a certain portion of the interplanetary flux received by the Earth is cometary in origin. Two chondritic porous (CP) IDPS, sample numbers W701OA2 and W7029CI, from the Johnson Space Center Cosmic Dust Collection have been selected for this study of putative cometary physical parameters. This particular type of particle is considered a likely candidate for a cometary origin on the basis of mineralogy, bulk composition and morphology. While many IDPs have been subjected to intensive study over the past decade, we can develop a physical parameter model on only these two CP IDPs because few others have been studied in sufficient detail.

An investigation of factors influencing diabetes self-management among adults with type 2 diabetes in Vietnam

Background: In diabetes care, health care professionals need to provide support for their patients. In order to provide good diabetes self-management support for adults with type 2 diabetes in Vietnam, it is important that health care professionals in Vietnam understand the factors influencing diabetes self-management among these people. However, knowledge about factors influencing diabetes self-management among adults with type 2 diabetes in Vietnam is limited. Objectives: This study aimed to investigate factors influencing diabetes self-management among adults with type 2 diabetes in Vietnam. Methodology: A cross-sectional survey with convenience sampling was conducted on 198 adults with type 2 diabetes in VietnamData collection was administeted via interview. Descriptive statistics, simple correlation statistics and structural equation modelling statistics were used for data analysis. Results: Adults with type 2 diabetes in Vietnam had limited diabetes knowledge (Median = 6.0). The majority of the study participants (72.7%) believed that performing diabetes self-management activities was very important or extremely important for controlling their blood glucose levels and for preventing complications from diabetes; about half usually received support from their family and friends’ (48.5%), and around two thirds rarely received support from their health care providers (68.2%). Many of the participants (41.4%) had limited confidence to perform diabetes management activities. The practices of diabetes self-management were limited among the study population (Mean = 96.7, SD = 19.4). Diabetes knowledge (β = 0.17, p < .001), belief in treatment effectiveness (β = 0.13, p < .01), family and friends’ support (β = 0.13, p < .001), health care providers’ support (β = 0.27, p < .001) and diabetes management self-efficacy (β = 0.43, p < .001) directly influenced their diabetes self-management. Diabetes knowledge, and family and friends’ support also indirectly influenced diabetes self-management among these people through their belief in treatment effectiveness and their diabetes management self-efficacy (p < .05). Conclusion: Findings in this study indicated that health care professionals should provide diabetes self-management support for adults with type 2 diabetes in Vietnam in the future. The adapted theory-based model of factors influencing diabetes self-management among adults with type 2 diabetes in Vietnam found in this study could be a useful framework to develop this supporting program.

Write vs. type : tangible and situated media for situated engagement

Digital media is often criticised for being intangible, transient and ephemeral. These characteristics limit the provision of long-lasting social experiences, as it is through the use of all our senses that we attach meaning to space, creating a sense of place. This paper presents a comparative study of the affordances of two design interventions, one tangible paper-based, called Print + Talk = Love (PTL), the other digital screen-based, called Discussions in Space (DIS). The emphasis is on a) how tangible media, such as paper, provides different and meaningful collective experiences, and b) how it can stand on its own as an interactive design intervention and as a comprehensive data-gathering tool in urban public places. By positioning PTL and DIS within the context of urban public places and testing their abilities to engage participants, we examine their particular situated engagement abilities through a mixed method approach. As a result, the digital aspects of DIS, e.g., using Twitter, extend the situated experience beyond the actual location of the intervention. Moreover, informing a hybrid approach, we also found that the physical aspects of PTL and its tangible presence, kept the user experience focused on the actual place and event surrounding the intervention.