884 resultados para Low-power applications


Relevância:

80.00% 80.00%

Publicador:

Resumo:

We demonstrate 10 Gb/s directly-modulated 1.3 mu m InAs quantum-dot (QD) lasers grown on GaAs substrates by molecular beam epitaxy. The active region of the QD lasers consists of five-stacked InAs QD layers. Ridge-waveguide lasers with a ridge width of 4 mu m and a cavity length of 600 mu m are fabricated with standard lithography and wet etching techniques. It is found that the lasers emit at 1293 nm with a very low threshold current of 5 mA at room temperature. Furthermore, clear eye-opening patterns under 10 Gb/s modulation rate at temperatures of up to 50 degrees C are achieved by the QD lasers. The results presented here have important implications for realizing low-cost, low-power-consumption, and high-speed light sources for next-generation communication systems.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

This paper proposes a novel noise optimization technique. The technique gives analytical formulae for the noise performance of inductively degenerated CMOS low noise amplifier (LNA) circuits with an ideal gate inductor for a fixed bias voltage and nonideal gate inductor for a fixed power dissipation, respectively, by mathematical analysis and reasonable approximation methods. LNA circuits with required noise figure can be designed effectively and rapidly just by using hand calculations of the proposed formulae. We design a 1.8 GHz LNA in a TSMC 0.25 pan CMOS process. The measured results show a noise figure of 1.6 dB with a forward gain of 14.4 dB at a power consumption of 5 mW, demonstrating that the designed LNA circuits can achieve low noise figure levels at low power dissipation.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

A low-power, highly linear, multi-standard, active-RC filter with an accurate and novel tuning architec-ture is presented. It exhibits 1EEE 802. 11a/b/g (9.5 MHz) and DVB-H (3 MHz, 4 MHz) application. The filter exploits digitally-controlled polysilicon resistor banks and a phase lock loop type automatic tuning system. The novel and complex automatic frequency calibration scheme provides better than 4 comer frequency accuracy, and it can be powered down after calibration to save power and avoid digital signal interference. The filter achieves OIP3 of 26 dBm and the measured group delay variation of the receiver filter is 50 ns (WLAN mode). Its dissipation is 3.4 mA in RX mode and 2.3 mA (only for one path) in TX mode from a 2.85 V supply. The dissipation of calibration consumes 2 mA. The circuit has been fabricated in a 0.35μm 47 GHz SiGe BiCMOS technology; the receiver and transmitter filter occupy 0.21 mm~2 and 0.11 mm~2 (calibration circuit excluded), respectively.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

A compact direct digital frequency synthesizer (DDFS) for system-on-chip implementation of the high precision rubidium atomic frequency standard is developed. For small chip size and low power consumption, the phase to sine mapping data is compressed using sine symmetry technique, sine-phase difference technique, quad line approximation technique,and quantization and error read only memory (QE-ROM) technique. The ROM size is reduced by 98% using these techniques. A compact DDFS chip with 32bit phase storage depth and a 10bit on-chip digital to analog converter has been successfully implemented using a standard 0.35μm CMOS process. The core area of the DDFS is 1.6mm^2. It consumes 167mW at 3.3V,and its spurious free dynamic range is 61dB.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

采用可求解可压缩流动与传热的全速度SIMPLE算法, 对低功率氩电弧加热发动机内部的传热与流动进行了数值模拟, 获得了电弧加热发动机内的温度、速度、马赫数及流线分布. 计算结果表明: 电弧加热发动机内最高温度出现在阴极下游附近中心轴线处, 这是因为电弧在阴极表面收缩形成阴极弧点, 从而焦耳热成为该高温区的主要加热机制; 沿着发动机中心轴线, 气体温度和速度开始时随着距阴极距离的增加而迅速增加, 然后在等离子体流向喷管出口的过程中, 气体温度和速度逐渐下降. 此外还详细考察了弧电流变化对电弧加热发动机内部传热与流动特性的影响, 计算获得的发动机流量和比冲与实验结果基本一致.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

This paper present that the system can acquire the remote temperature measurement data of 40 monitoring points,through the RS-232 serial port and the Intranet.System s hardware is consist of TI s MSP430F149 mixed-signal processor and UA7000A network module.Using digital temperature sensor DS18B20,the structure is simple and easy to expand,the sensors directly send out the temperature data.MSP430F149 has the advantage of ultra-low-power and high degree of integration.Using msp430F149,the multi-branch multi-p...中文文摘:文章论述了通过RS-232串口和Intranet网络,来实现对远端的40个温度测量点的监控。系统硬件由TI公司的MSP430F149混合信号处理器和UA7000A网络模块构成。传感器采用数字式温度传感器DS18B20,它将直接得到温度的数字量,结构简单,易于扩展。MSP430F149处理器具有超低功耗和高度集成等优点,利用它构建的多分支多通道温度测量系统功能强大,结构简单,可靠性高,抗干扰能力强。系统客户端软件采用Microsoft Visual C++6.0设计。本监控系统能够很好地完成对4个分支共40个温度测量点的远程实时监控。

Relevância:

80.00% 80.00%

Publicador:

Resumo:

This paper discuss a Ion-pump Power Supply control system making use of RS232 series bus and Intranet.The system s hardware VAC800 is composed of MSP430F149 mixed-signal processors produced by TI and UA7000A network model.MSP430F149 has advantages of ultra-low-power and high-integration.The Ion-pump Power Supply control system has the characteristics of strong function,simple structure,high reliability,strong resistance of noise,no peripheral chip,etc.Visual studio 2005 is used to design the system s softwa...中文文摘:论述了通过RS-232总线和Intranet网络,来实现对远端的离子泵电源的监测与控制。系统硬件VAC800由TI公司的MSP430F149混合信号处理器和UA7000A网络模块构成。MSP430F149具有超低功耗和高集成度等优点,利用它构建的离子泵电源监控系统功能强大,结构简单,可靠性高,抗干扰能力强。系统软件采用visual studio 2005设计。本监控系统能够很好地完成对加速器离子泵电源监视与控制。

Relevância:

80.00% 80.00%

Publicador:

Resumo:

椭圆曲线密码算法作为高安全性的公钥密码;ECC算法的优化和软硬件实现是当前的研究热点;采用硬件实现椭圆曲线密码算法具有速度快、安全性高的特点,随着功耗分析、旁路攻击等新型分析方法的发展,密码算法硬件实现中的低功耗设计越来越重要;针对椭圆曲线密码算法的特点,主要对该算法芯片设计中的低功耗设计方法进行探讨。

Relevância:

80.00% 80.00%

Publicador:

Resumo:

The authors observed a negative differential resistance (NDR) in organic devices consisting of 9,10-bis-(9,9-diphenyl-9H-fluoren-2-yl)-anthracene (DPFA) sandwiched between Ag and indium tin oxide electrodes. The large NDR shown in current-voltage characteristics is reproducible, resulting in that the organic devices can be electrically switched between a high conductance state (on state) and a low conductance state (off state). It can be found that the currents at both on to off states are space-charge limited and attributed to the electron traps at the Ag/DPFA interface. The large and reproducible NDR makes the devices of tremendous potential in low power memory and logic circuits.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

工业无线技术是一种本世纪初新兴的、面向设备间信息交互的无线网络技术,适合在恶劣的工业现场环境下使用,具有强抗扰、低功耗、实时通信等技术特征,是对现有无线技术在工业应用方向上的功能扩展和技术创新,并将最终转化为新的无线技术标准。本文介绍我国在工业无线技术方面的研究进展,重点介绍具有自主知识产权的工业无线网络核心技术以及相关国家标准体系的建设情况。

Relevância:

80.00% 80.00%

Publicador:

Resumo:

介绍了一种基于DSP2812的动态传感器网络实验平台的设计与开发.该实验平台的设计由配备各种低成本、低功耗的传感器和无线通信模块的可移动的传感器节点组成.在介绍动态传感器网络实验平台的各个组成部分之后,对系统进行了的基本实验测试,并给出了测试结果.*

Relevância:

80.00% 80.00%

Publicador:

Resumo:

针对远距离声源发射的水声信号微弱、水声接收设备电源能量有限的特点,提出一种功耗小、对无源元件误差灵敏度低、高增益放大的微弱水声信号通用放大电路。系统采用场效应管共源单调谐放大器为前置放大级,由四级级联低功耗运放构成带通滤波放大电路,省去传统的R、C低通网络,实现了对微弱水声信号的高增益放大和海洋背景噪声的归一化处理。通过计算电路网络传递函数极点证明了电路系统的稳定性。海上使用表明系统具有精度高、适应性强、电路稳定性好、功耗小等优点。

Relevância:

80.00% 80.00%

Publicador:

Resumo:

研究一种用于有色噪声背景下接收水声信号的窄带滤波方法。它用白化滤波器实现有色噪声的匹配滤波。该滤波电路具有优良的选频能力,抗干扰性强,功耗极低,较好地解决了水下信息传输中存在的通道之间频率间隔小、信号微弱、易受噪声干扰、用电池供电而要求工作时间长等问题。采用这种窄带滤波方法的水声接收机具有结构简单、性能稳定、对弱信号检测能力强等优点,增大了定位声纳的作用距离。

Relevância:

80.00% 80.00%

Publicador:

Resumo:

This thesis presents the design, construction, control and evaluation of a novel force controlled actuator. Traditional force controlled actuators are designed from the premise that "Stiffer is better''. This approach gives a high bandwidth system, prone to problems of contact instability, noise, and low power density. The actuator presented in this thesis is designed from the premise that "Stiffness isn't everything". The actuator, which incorporates a series elastic element, trades off achievable bandwidth for gains in stable, low noise force control, and protection against shock loads. This thesis reviews related work in robot force control, presents theoretical descriptions of the control and expected performance from a series elastic actuator, and describes the design of a test actuator constructed to gather performance data. Finally the performance of the system is evaluated by comparing the performance data to theoretical predictions.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

Projeto de Pós-Graduação/Dissertação apresentado à Universidade Fernando Pessoa como parte dos requisitos para obtenção do grau de Mestre em Ciências Farmacêuticas