Undercooling and Rapid Solidification of Nb-Si Eutectic Alloys Studied by Long Drop Tube

Niobium-silicide alloys have great potential for high temperature turbine applications. The two-phase Nb/Nb5Si3 in situ composites exhibit a good balance in mechanical properties. Using the 52 in drop tube, the effect of undercooling and rapid solidification on the solidification process and micro-structural characterization of Nb-Si eutectic alloy was studied. The microstructures of the Nb-Si composites were investigated by optics microscope (OM), X-ray diffraction (XRD) and scanning electron microscope (SEM) equipped with X-ray energy dispersive spectrometry (EDS). Up to 480 K, deep undercooling of the Nb-Si eutectic samples was successfully obtained, which corresponds to 25% of the liquidus temperature. Contrasting to the conventional microstructure usually found in the Nb-Si eutectic alloy, the microstructure of the undercooled sample is divided into the fine and coarse regions. The most commonly observed microstructure is Nb+Nb5Si3, and the Nb3Si phase is not be found. The change of coarseness of microstructure is due to different cooling rates during and after recalescence. The large undercooling is sufficient to completely bypass the high temperature phase field.

Les attributs et contextes d'utilisation du travail collaboratif

Résumé: Le travail collaboratif s’invite à présent partout, et est identifié dans des domaines aussi multiples que variés. Dans le monde de l’entreprise, de la prise en charge médico-sociale, de l’éducation / formation, de la recherche, de l’économie, de la politique, de la gestion de carrière… etc. Ce travail vise dans un premier temps à décliner ce qu’est la collaboration, ses caractéristiques, ses contextes d’utilisation, et la façon dont elle se différencie des autres formes d’organisation (coopération et compétition notamment). Dans un deuxième temps, il réexamine la question de la nouveauté du travail collaboratif à la lumière des résultats obtenus. S’il est assez évident que les « ingrédients », les attributs du travail collaboratif ne sont pas nouveaux (le développement informatique mis à part), il semble en revanche que les combinaisons rencontrées et les domaines d’application génèrent de nouvelles questions. Pour finir, en s’inspirant des termes associés à collaboration, il considère quelques-uns des nouveaux enjeux dans la sphère professionnelle.

Laboratory-scale fluidized bed rig for high-temperature tube wastage studies

As part of a study of the wear of candidate heat exchanger tube materials for use in fluidized bed combustors, two similar laboratory-scale rigs have been built and characterized. Specimens of selected alloys are carried on counter-rotating rotors immersed in a fluidized bed, and are exposed to particle impact velocities of up to approximately 3 ms-1 at temperatures up to 1000°C. The performance of this design of apparatus has been investigated in detail. The effects of several experimental variables have been studied, including angle of particle impact, specimen speed, position of the rotor within the fluidized bed, duration of exposure, bed material particle size, degradation of the bed material, degree of fluidization of the bed, and size of specimen. In many cases the results obtained with steel specimens at elevated temperatures are similar to those observed with polymeric specimens at low temperatures.

The Interaction Between Shock Waves and Solid Spheres Arrays in a Shock Tube

When a shock wave interacts with a group of solid spheres, non-linear aerodynamic behaviors come into effect. The complicated wave reflections such as the Mach reflection occur in. the wave propagation process. The wave interactions with vortices behind each sphere's wake cause fluctuation in the pressure profiles of shock waves. This paper reports an experimental study for the aerodynamic processes involved in the interaction between shock waves and solid spheres. A schlieren photography was applied to visualize the various shock waves passing through solid spheres. Pressure measurements were performed along different downstream positions. The experiments were conducted in both rectangular and circular shock tubes. The data with respect to the effect of the sphere array, size, interval distance, incident Mach number, etc., on the shock wave attenuation were obtained.

Entre Syrie et Mésopotamie : vases zoomorphes du Règne de Mittani

Abstract: The Mittanian zoomorphic vessels from Nuzi, Tell Brak, Tell al-Rimah and other sites allow the creation of a significant database for analysis based on typological criteria as well as spatial distribution. This class of materials is attested in several areas of the ancient Near East from the Late Calcholitic and still produced until the Mittanian age and thereafter. Most of the finds come from temples or domestic contexts and they can be now securely dated, while their spatial distribution can be properly investigated. Lion representations seem to predominate, but pigs and other animals appear as well. The exact function and meaning of these vessels are difficult to ascertain, nevertheless, in most cases, they are probably related to cultic practices performed throughout the Mittanian Empire.

Free-Space Interconnect for Optical Switch and Analogue Neural Network

In this paper, the architecture of a vector-matrix multiplier (MVM) is simulated. The optical design can be made compact by the use of GRIN lenses for the optical fan-in. The intended application area was in storage area networks (SANs) but the concept can be applied to a neural network. © 2011 Allerton Press, Inc.

La precarite de l’emploi et ses multiples impacts a la lumière du genre

Résumé: A l’heure où l’on évoque une “génération précaire” il est intéressant de s’interroger sur l’accroissement de la précarité de l’emploi en France et d’étudier ses éventuels effets sur les salariés. L’objectif de la présente recherche était d’observer les impacts causés par la précarité de l’emploi sur une population de référence et voir si ces effets différaient selon le sexe du salarié soumis à la précarité. Pour ce faire, nous avons soumis un questionnaire à deux groupes de travailleurs. Ce dernier portait sur la précarité de l’emploi et ses impacts en termes de stress, consommation de substances et impacts sur la sphère privée. Les résultats font apparaître des effets significatifs et des tendances qui existent sur certaines des dimensions interrogées (stress et consommation) entre le groupe de travailleurs précaires et non précaires. De plus, des effets entre hommes et femmes ont également été relevés. Par contre, nous n’avons pas d’effets observés sur la sphère privée de l’individu. Suite à l’absence d’effet constaté nous interrogeons la spécificité de la population. Aussi, nous envisageons de prolonger cette étude sur la recherche d’indicateurs concernant la précarité enseignante. Mots clés: précarité professionnelle, précarité du travail, précarité de l’emploi, travailleurs précaires, inégalités hommes femmes, stress, substances addictives, impact vie hors travail

Preliminary Investigation of Fluid Flow in Meso-Scale Rectangular Tube

The fluid flow associated with micro and meso scale devices is currently of interest. Experiments were performed to study the fluid flow in meso-scale channels. A straight flow tube was fabricated with 1.0x4.0mm^2 in rectangular cross section and 200mm in length, which was made of quartz for flow visualization and PIV measurements. Reynolds numbers were ranged from 311 to over 3105. The corresponding pressure drop was from 0.65KPa to over 16.58KPa between the inlet and outlet of the tube. The micro PIV was developed to measure the velocity distribution in the tube. A set of microscope object lens was mounted ahead of CCD camera to obtain optimized optical magnification on the CCD chip. The velocity distributions near the outlet of the tube were measured to obtain full-developed flow. A CW laser beam was focused directly on the test section by a cylinder lens to form a small light sheet. Thus, high power density of light was formed on the view region. It is very important to the experiment while the velocity of the flow reaches to a few meters per second within millimeter scale. In this case, it is necessary to reduce exposure time to microseconds for PIV measurements. In the present paper, the experimental results are compared with the classical theories.

An investigation of electromagnetic wave propagation in plasma by shock tube

This paper presents the electromagnetic wave propagation characteristics in plasma and the attenuation coefficients of the microwave in terms of the parameters n(e), v, w, L, w(b). The phi800 mm high temperature shock tube has been used to produce a uniform plasma. In order to get the attenuation of the electromagnetic wave through the plasma behind a shock wave, the microwave transmission has been used to measure the relative change of the wave power. The working frequency is f = (2 similar to 35) GHz (w = 2pif, wave length lambda = 15 cm similar to 8 mm). The electron density in the plasma is n(e) = (3 x 10(10) similar to 1 x 10(14)) cm(-3). The collision frequency v = (1 x 10(8) similar to 6 x 10(10)) Hz. The thickness of the plasma layer L = (2 similar to 80) cm. The electron circular frequency w(b) = eB(0)/m(e), magnetic flux density B-0 = (0 similar to 0.84) T. The experimental results show that when the plasma layer is thick (such as L/lambda greater than or equal to 10), the correlation between the attenuation coefficients of the electromagnetic waves and the parameters n(e), v, w, L determined from the measurements are in good agreement with the theoretical predictions of electromagnetic wave propagations in the uniform infinite plasma. When the plasma layer is thin (such as when both L and lambda are of the same order), the theoretical results are only in a qualitative agreement with the experimental observations in the present parameter range, but the formula of the electromagnetic wave propagation theory in an uniform infinite plasma can not be used for quantitative computations of the correlation between the attenuation coefficients and the parameters n(e), v, w, L. In fact, if w < w(p), v(2) much less than w(2), the power attenuations K of the electromagnetic waves obtained from the measurements in the thin-layer plasma are much smaller than those of the theoretical predictions. On the other hand, if w > w(p), v(2) much less than w(2) (just v approximate to f), the measurements are much larger than the theoretical results. Also, we have measured the electromagnetic wave power attenuation value under the magnetic field and without a magnetic field. The result indicates that the value measured under the magnetic field shows a distinct improvement.

La souffrance émotionnelle des personnels d’intervention : résultats préliminaires de l’étude sur la santé et la qualité de vie au travail dans les métiers du secteur de l’aide et du soin à domicile

Resumen: La prolongación de la edad y el aumento de la expectativa de vida han hecho surgir nuevas necesidades de atención para las personas ancianas y ello ha inducido a la ampliación de las prestaciones de servicios a domicilio. En este sentido, el trabajo de estos profesionales de intervención a domicilio, así como sus misiones, están en plena mutación. Es un sector con dificultades, debido a la dificultad de reclutar un personal especializado y al absentismo inquietante. Después de un análisis sobre el estado de este sector de la profesión en el que se establece la diferencia entre el enfoque físico y el psicológico sobre la salud, nuestra reflexión se centra en los riesgos psicosociales de esta población de profesionales. Se presentan los resultados preliminares de la investigación realizada con una muestra de 38 personas que ejercían laboralmente en este sector. Emerge la expresión de un sufrimiento emocional, en la que el aislamiento de los participantes es uno de los factores que caracterizan los oficios identificados con una fuerte dimensión relacional con personas vulnerables. La dimensión asistencial del trabajo se presenta como fuente de satisfacción del oficio pero, a su vez, puede conducir a una dificultad de gestionar acontecimientos no previstos

Shock tube study of JP-10 ignition delay time

JP-10 (exo-tetrahydrodicyclopentadiene, C10H16) ignition delay times were measured in a preheated shock tube. The vapor pressures of the JP-10 were measured directly by using a high-precision vacuum gauge, to remedy the difficulty in determining the gaseous concentrations of heavy hydrocarbon fuel arising from the adsorption on the wall in shock tube experiments. The whole variation of pressure and emission of the OH or CH radicals were observed in the ignition process by a pressure transducer and a photomultiplier with a monochromator. The emission of the OH or CH radicals was used to identify the time to ignition. Experiments were performed over the pressure range of 151-556 kPa, temperature range of 1000-2100 K, fuel concentrations of 0.1%-0.55% mole fraction, and stoichiometric ratios of 0.25, 0.5, 1.0 and 2.0. The experimental results show that for the lower and higher temperature ranges, there are different dependency relationships of the ignition time on the temperature and the concentrations of JP-10 and oxygen.

Combustion tube studies of dust flame acceleration

A new pneumatic dispersion system for obtaining a good quality uniform dust suspension in a horizontal dust combustion tube was developed. The effect of three different dispersion techniques on self-sustained dust flame acceleration in such a combustion tube was examined. The importance of the dispersion quality in the test tube for maintaining a self-sustained dust flame acceleration was demonstrated. A combustion tube for studies of flame acceleration in fine aluminum dust-air mixture and its transition to detonation under industrial ignition conditions was constructed in the course of the present study. It consists mainly of an initiation section and a test section. The initiation section must be equipped in a well-developed dispersion system for creating a good dispersion condition in the test tube. The length of this section is 3 meters. The test tube requires only to distribute uniformly the dust over the bottom of the tube prior to the experiment. The aluminum dust spherical in shape with 6 mu m in diameter was used for tests. Experimental results demonstrated that the increase in flame velocity is roughly linear through the entire length of the test tube. The highest flame propagation velocity in fine aluminum dust-air mixture approaches some 1200m/s at a distance of 4.8m from the ignition plate.

Magnetostatic configuration of a confined magnetic-flux tube

In this paper an isolated magnetic flux tube confined in stratified atmosphere is studied for slender and axisymmetric model. The functions of the pressure, density, and temperature are expanded as a Taylor series of magnetic surface function psi. Several models of an isolated magnetic flux tube confined in a stratified atmosphere are constructed, and the external pressure of the stratified atmosphere decreases reasonably with increasing height. The distribution of thermal dynamic quantities and the magnetic pressure in the flux tube are also obtained.