983 resultados para ATOMIC RADII


Relevância:

20.00% 20.00%

Publicador:

Resumo:

A simple procedure for the sequential determination of Cd, Cu and Pb in tea leaves by slurry introduction to thermospray flame furnace atomic absorption spectrometry was developed. Detection limits were 0.05 mg kg-1 for Cd, 2.1 mg kg-1 for Cu and 0.68 mg kg-1 for Pb using 0.67 % (m/v) slurries (100 mg/15 mL). © 2013 Springer Science+Business Media New York.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The performance of the optimal linear feedback control and of the state-dependent Riccati equation control techniques applied to control and to suppress the chaotic motion in the atomic force microscope are analyzed. In addition, the sensitivity of each control technique regarding to parametric uncertainties are considered. Simulation results show the advantages and disadvantages of each technique. © 2013 Brazilian Society for Automatics - SBA.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The wavelength-integrated absorbance (WIA) and summation of absorbance (∑ lines) of different lines were evaluated to enhance sensitivity and determine B, P and S in medicinal plants by HR-CS FAAS. The lowest LOD for B (0.5mgL-1) and P (13.7mgL-1) was obtained by integration of lines 249.773nm (3pixels) and 247.620nm (5pixels), respectively. The ∑ lines for CS at 257.595nm and 257.958nm furnished LOD=30.5mgL-1, ca. 10% lower than the LOD obtained for the WIA using 257.595nm and 5pixels. Data showed the advantage of WIA over ∑ lines to improve sensitivity for all analytes. Under optimized conditions, calibration curves in the 1.0-100mgL-1 B and 50.0-2000mgL-1 P, S ranges were consistently obtained. Results obtained with the HR-CS FAAS method were in agreement at 98% and 95% confidence level with certified values for B and P, respectively. And results for S were in accordance to non-certified values. Concentrations of B, P, and S in 12 medicinal plants analyzed by the proposed method varied within the 19.4-34.5mgkg-1 B, 719-3910mgkg-1 P and 1469-7653mgkg-1 S ranges. © 2012 Elsevier B.V.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The tapping mode is one of the mostly employed techniques in atomic force microscopy due to its accurate imaging quality for a wide variety of surfaces. However, chaotic microcantilever motion impairs the obtention of accurate images from the sample surfaces. In order to investigate the problem the tapping mode atomic force microscope is modeled and chaotic motion is identified for a wide range of the parameter's values. Additionally, attempting to prevent the chaotic motion, two control techniques are implemented: the optimal linear feedback control and the time-delayed feedback control. The simulation results show the feasibility of the techniques for chaos control in the atomic force microscopy. © 2012 IMechE.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Includes bibliography

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Multivariate image analysis applied to the quantitative structure-activity relationships (MIA-QSAR) is a 2D QSAR technique that has been presenting promising outcomes for the development of new drug candidates, due to its simplicity, rapidity and low cost. In this way, the present study aims at introducing, consolidating and improving the new dimensions named aug-MIA-QSAR and aug-MIA-QSARcolor, as well as applying them to the study of neglected diseases, in order to obtain new drug targets using chemico-biological interpretation of the MIA molecular descriptors. Four compound data sets with experimental bioactivities against Chagas disease, malaria, dengue and schistosomiasis were evaluated using three approaches: MIA-QSARt, aug-MIA-QSAR and aug-MIA-QSARcolor. In general, representations of atoms as spheres with different colors and sizes proportional to the corresponding van der Waals radii (aug-MIA approaches) improved the predictive ability and interpretability in all data sets. The use of colors proportional to the Pauling´s electronegativity showed that MIA descriptors are capable of identifying periodic properties relevant for the studied activity. Finally, solid colors instead of spotlighted atoms allowed a correct identification of atoms by means of pixel values in the studies for malaria, dengue and schistosomiasis, which were, subsequently, useful for the chemical interpretation related to the bioactivity. It can be inferred that semicarbazones and thiosemicarbazones derivative with a tri-substituted ring in R1 group and a trifluoro methyl group in the R 3 position instead of a chlorine antitripanossoma resulted in higher activity. The antimalarial activity of quinolon-4(1H)imines can be improved if: 1) R1 and R2 are electron donor groups, 2) R3 has long aminoalkyl chains, and 3) R4 possesses substituents with big atomic volume. In the study for dengue, it was found that tetrapeptides with unbranched small size amino acids in the A1 and A4 positions can increase the substrate affinity (Km) to the NS3 protein, and when in A1 and A2 positions, the substrate cleavage rate (kcat). On the other hand, acidic amino acids in the A2 and A4 positions were found to be related with low substrate affinity to the NS3 protein and when present in A1, with low substrate cleavage rate. Finally, the presence of metoxy substituents in R1 (or R2) and R5 in the neolignan backbone can favor their antischistosomal activity.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)