917 resultados para simultaneous shape and topology optimisation
Resumo:
In most commercially available predictive control packages, there is a separation between economic optimisation and predictive control, although both algorithms may be part of the same software system. This method is compared in this article with two alternative approaches where the economic objectives are directly included in the predictive control algorithm. Simulations are carried out using the Tennessee Eastman process model.
Resumo:
There are approximately 7000 languages spoken in the world today. This diversity reflects the legacy of thousands of years of cultural evolution. How far back we can trace this history depends largely on the rate at which the different components of language evolve. Rates of lexical evolution are widely thought to impose an upper limit of 6000-10,000 years on reliably identifying language relationships. In contrast, it has been argued that certain structural elements of language are much more stable. Just as biologists use highly conserved genes to uncover the deepest branches in the tree of life, highly stable linguistic features hold the promise of identifying deep relationships between the world's languages. Here, we present the first global network of languages based on this typological information. We evaluate the relative evolutionary rates of both typological and lexical features in the Austronesian and Indo-European language families. The first indications are that typological features evolve at similar rates to basic vocabulary but their evolution is substantially less tree-like. Our results suggest that, while rates of vocabulary change are correlated between the two language families, the rates of evolution of typological features and structural subtypes show no consistent relationship across families.
Resumo:
In mid-March 2005, a rare lower stratospheric polar vortex filamentation event was observed simultaneously by the JPL lidar at Mauna Loa Observatory, Hawaii, and by the EOS MLS instrument onboard the Aura satellite. The event coincided with the beginning of the spring 2005 final warming. On 16 March, the filament was observed by lidar around 0600 UT between 415 K and 455 K, and by MLS six hours earlier. It was seen on both the lidar and MLS profiles as a layer of enhanced ozone, peaking at 1.7 ppmv in a region where the climatological values are usually around or below 1 ppmv. Ozone profiles measured by lidar and MLS were compared to profiles from the Chemical Transport Model MIMOSA-CHIM. The agreement between lidar, MLS, and the model is excellent considering the difference in the sampling techniques. MLS was also able to identify the filament at another location north of Hawaii.
Resumo:
Results are presented of a study of a performance of various track-side railway noise barriers, determined by using a two- dimensional numerical boundary element model. The basic model uses monopole sources and has been adapted to allow the sources to exhibit dipole-type radiation characteristics. A comparison of boundary element predictions of the performance of simple barriers and vehicle shapes is made with results obtained by using the standard U.K. prediction method. The results obtained from the numerical model indicate that modifying the source to exhibit dipole characteristics becomes more significant as the height of the barrier increases, and suggest that for any particular shape, absorbent barriers provide much better screening efficiency than the rigid equivalent. The cross-section of the rolling stock significantly affects the performance of rigid barriers. If the position of the upper edge is fixed, the results suggest that simple absorptive barriers provide more effective screening than tilted barriers. The addition of multiple edges to a barrier provides additional insertion loss without any increase in barrier height.
Resumo:
The 3D shape of an object and its 3D location have traditionally thought of as very separate entities, although both can be described within a single 3D coordinate frame. Here, 3D shape and location are considered as two aspects of a view-based approach to representing depth, avoiding the use of 3D coordinate frames.
Resumo:
Dayside poleward moving auroral forms (PMAFs) were detected between 06:30 and 07:00 UT on December 16, 1998, by the meridian scanning photometer and the all-sky camera at Ny Alesund, Svalbard. Simultaneous SuperDARN HF radar measurements permitted the study of the associated ionospheric velocity pattern. A good general agreement is observed between the location and movement of velocity enhancements (flow channels) and the PMAFs. Clear signatures of equatorward flow were detected in the vicinity of PMAFs. This flow is believed to be the signature of a return flow outside the reconnected Aux tube, as predicted by the Southwood model. The simulated signatures of this model reproduce globally the measured signatures, and differences with the experimental data can be explained by the simplifications of the model. Proposed schemes of the flow modification due to the presence of several flow channels and the modification of cusp and region 1 field-aligned currents at the time of sporadic reconnection events are shown to fit well with the observations.
Resumo:
Aiming to determine the relationship between the frequency of testicular shape and the andrological aspects in young Nellore bulls, 18,676 animals were assessed. All andrological examinations were performed between the years 2000 and 2008. Animals were classified as able for breeding, able for breeding in natural mating system, unable for breeding and discarded. The testicular shape was classified as long, fairly long, oval-long, spherical-oval, and spherical. The analysis of Pearson correlations was performed for testicular shape with scrotal circumference, testicular volume, progressive motility, sperm vigor, major defects, minor defects and total defects. Testicles with oval shape prevailed (99.61%). It was obseved that 76.34; 66.34; 64.34; 58.33 and 50.00% of the animals were classified as sound for breeding for shapes long, fairly long, oval-long, spherical-oval, and spherical, respectively. Correlations between testicular shape with scrotal circumference, testicular volume, progressive motility, sperm vigor, major, minor and total defects were 0.26; 0.08; 0.00; 0.11; -0.02; 0.02 and -0.01, respectively. Testicular shape had no influence upon the andrological examination results. Testicles of long shape were prevalent within the population.
Resumo:
The effect of changes in left ventricular (LV) shape and dimensions due to acute arterial hypertension induced by mechanical obstruction of the aorta for 10 min on LV mass values estimated by M-mode echocardiogram was studied in 14 anesthetized dogs. Although the systolic pressure increased from 117.5 +/- 19.9 to 175.4 +/- 22.9 mmHg altered ventricular diameter from 2.77 +/- 0.49 cm to 3.17 +/- 0.67 cm (P<0.05) and wall thickness from 0.83 +/- 0.09 to 0.75 +/- 0.09 cm (P<0.05), LV mass estimated before (73.5 +/- 19.1 g) and after (78.3 +/- 26.4 g) hypertension was not significantly different. We demonstrate here for the first time that changes in LV dimensions induced by acute arterial hypertension do not modify LV mass values estimated by the M-mode electrocardiogram method.
Resumo:
The Berry phase for an electron in a one-dimensional box rotated around a magnetic flux line has contributions from the geometry and the magnetic flux, which gives an Aharonov-Bohm effect. For a circular box enclosing the magnetic flux, the Berry phase depends on the boundary conditions.
Resumo:
The simultaneous formation of nanometer sized zinc oxide (ZnO), and acetate zinc hydroxide double salt (Zn-HDS) is described. These phases, obtained using the sol-gel synthesis route based on zinc acetate salt in alcoholic media, were identified by direct characterization of the reaction products in solution using complementary techniques: nephelometry, in situ Small-Angle X-ray Scattering (SAXS), UV-Vis spectroscopy and Extended X-ray Absorption Fine Structures (EXAFS). In particular, the hydrolytic pathway of ethanolic zinc acetate precursor solutions promoted by addition of water with the molar ratio N = [H2O]/[Zn2+] = 0.05 was investigated in this paper. The aim was to understand the formation mechanism of ZnO colloidal suspension and to reveal the factors responsible for the formation of Zn-HDS in the final precipitates. The growth mechanism of ZnO nanoparticles is based on primary particle (radius approximate to 1.5 nm) rotation inside the primary aggregate (radius < 3.5 nm) giving rise to an epitaxial attachment of particles and then subsequent coalescence. The growth of second ZnO aggregates is not associated with the Otswald ripening, and could be associated with changes in equilibrium between solute species induced by the superficial etching of Zn-HDS particles at the advanced stage of kinetic.
Resumo:
The electronic states of quantum rings with centerlines of arbitrary shape and non-uniform width in a threading magnetic field are calculated. The solutions of the Schrodinger equation with Dirichlet boundary conditions are obtained by a variational separation of variables in curvilinear coordinates. We obtain a width profile that compensates for the main effects of the curvature variations in the centerline. Numerical results are shown for circular, elliptical, and limacon-shaped quantum rings. We also show that smooth and tiny variations in the width may strongly affect the Aharonov-Bohm oscillations.
Resumo:
Tensile strength (TS) of soil aggregates is an important indicator of soil quality. However, TS varies with aggregate shape. Thus, the objective of this study was to quantify the influence of aggregate shape on TS and propose a shape standardization protocol to increase accuracy in the measurement of TS. The latter was determined on 7,560 aggregates divided into three shapes, (i) irregular shape (IS), (ii) spherical shape (SS), and (iii) flat surface (FS), while preserving the inherent structure of the aggregate. The aggregates with IS had a larger range in the TS (306 kPa) because of the shape variability when compared with SS (238 kPa) and FS (129 kPa). The TS determined in aggregates with FS had smaller coefficient of variation (46%) in comparison with those of IS (70%) and SS (66%), indicating that the aggregate uniformity reduced the influence of shape on the TS. A smaller force (42.12 kPa) was needed to rupture aggregates with FS than IS (58.43 kPa) and SS (56.89 kPa) because of better force distribution in causing the tensile stress. The use of aggregates with the FS enables an accurate assessment of TS in relation to a wide range of management treatments. Copyright © 2013 by Lippincott Williams & Wilkins.
Resumo:
Pós-graduação em Ciências Biológicas (Zoologia) - IBRC
Resumo:
Review of The Bible at Qumran: Text, Shape, and Interpretation, edited by Peter W. Flint. Studies in the Dead Sea Scrolls and Related Literature. Grand Rapids, MI: Eerdmans, 2001. Pp. xv + 266. Price: $22.00. ISBN 0-8028-4630-0. This volume is another contribution to the Eerdmans series Studies in the Dead Sea Scrolls and Related Literature. The essays are loosely gathered around the topic "The Bible at Qumran," and the editor has divided the articles into two groups. Part 1, "The Scriptures, the Canon, and the Scrolls," includes articles by J.A. Sanders, B.W. Waltke, E. Ulrich, C.A. Evans, and the editor, P.W. Flint. The contributors to Part 2, "Biblical Interpretation and the Dead Sea Scrolls," are J.C. VanderKam, C.A. Evans, J.E. Bowley, J.M. Scott, M.G. Abegg, and R.W. Wall. Unlike other volumes of collected essays in this series, which have highlighted the work of a single author or published the proceedings of a particular conference, this collection has a more disparate origin. Some contributions were given as papers at the Dead Sea Scrolls Institute of Trinity Western University (Bowley, Ulrich, VanderKam and Wall), one (Waltke) is reprinted from The New International Dictionary of Old Testament Theology and Exegesis (Grand Rapids: Zondervan, 1997), and the rest (Abegg, Evans, Flint, Sanders and Scott) were invited for the volume.
Resumo:
Pieri N.C.G., Alicia M. Flamini A.M., Barbeito C.G., Casals J.B., Roque K.B., Favaron P.O., Miglino M.A. & Martins D.S. 2012. [Shape and function of the perineal muscles of viscacha (Lagostomus maximus).] Forma e funcao dos musculos perineais da viscacha (Lagostomus maximus). Pesquisa Veterinaria Brasileira 32(2):183-187. Departamento de Zootecnia, Faculdade de Zootecnia e Engenharia de Alimentos, Universidade de Sao Paulo, Av. Duque de Caxias Norte 225, Pirassununga, SP 13635-900, Brazil. E-mail: daniele@usp.br. Among the rodent species studied we can highlight the wide variation in the morphology of the male reproductive system. Thus, considering the ecological importance of rodents, and the large number and geographical representation of this animal, as well as shortages regarding the reproductive anatomy, we developed this study with viscacha, a South American histricomorph rodent. As this species has some very peculiar reproductive features, we described the gross anatomy of the perineal muscles and the role of copulatory behavior. The perineal region of viscacha is composed of five muscles, three of which are arranged in the superficial genitourinary diaphragm, as Musculus ischiocavernosus, M. bulbocavernosus and M. bulbospongiosus, and the muscles that lie at the pelvic diaphragm, M. levator ani and M. retractor penis. Therefore, we emphasize that the study of the pelvic floor in wild animals is of great value, then contribute to a better understanding of the mechanisms related to erection and ejaculation or collaborate with studies on the reproduction of animals.