979 resultados para anti-war demonstrations
Resumo:
Anti-corrosive and anti-bacterial properties of electrodeposited nanocrystalline Ni-Ag coatings are illustrated. Pure Ni, Ni-7 at.% Ag, & Ni-14 at.% Ag coatings were electrodeposited on Cu substrate. Coating consisted of Ni-rich and Ag-rich solid solution phases. With increase in the Ag content, the corrosion resistance of the Ni-Ag coating initially increased and then decreased. The initial increase was due to the Ni-Ag solid solution. The subsequent decrease was due to the increased galvanic coupling between the Ag-rich and Ni-rich phases. For all Ag contents, the corrosion resistance of the Ni-Ag coating was higher than the pure Ni coating. Exposure to Sulphate Reducing Bacteria (SRB) revealed that the extent of bio-fouling decreased with increase in the Ag content. After 2 month exposure to SRB, the Ni-Ag coatings demonstrated less loss in corrosion resistance (58% for Ni-7 at.% Ag and 20% for Ni-14 at.% Ag) when compared pure Ni coating (115%). (C) 2016 Elsevier B.V. All rights reserved.
Resumo:
Stiction in microelectromechanical systems (MEMS) has been a major failure mode ever since the advent of surface micromachining in the 80s of the last century due to large surface-area-to-volume ratio. Even now when solutions to this problem are emerging, such as self-assembled monolayer (SAM) and other measures, stiction remains one of the most catastrophic failure modes in MEMS. A review is presented in this paper on stiction and anti-stiction in MEMS and nanoelectromechanical systems (NEMS). First, some new experimental observations of stiction in radio frequency (RF) MEMS switch and micromachined accelerometers are presented. Second, some criteria for stiction of microstructures in MEMS and NEMS due to surface forces (such as capillary, electrostatic, van der Waals, Casimir forces, etc.) are reviewed. The influence of surface roughness and environmental conditions (relative humidity and temperature) on stiction are also discussed. As hydrophobic films, the self-assembled monolayers (SAMs) turn out able to prevent release-related stiction effectively. The anti-stiction of SAMs in MEMS is reviewed in the last part.
Resumo:
This paper presents a method for the fast and direct extraction of model parameters for capacitive MEMS resonators from their measured transmission response such as quality factor, resonant frequency, and motional resistance. We show that these parameters may be extracted without having to first de-embed the resonator motional current from the feedthrough. The series and parallel resonances from the measured electrical transmission are used to determine the MEMS resonator circuit parameters. The theoretical basis for the method is elucidated by using both the Nyquist and susceptance frequency response plots, and applicable in the limit where CF > CmQ; commonly the case when characterizing MEMS resonators at RF. The method is then applied to the measured electrical transmission for capacitively transduced MEMS resonators, and compared against parameters obtained using a Lorentzian fit to the measured response. Close agreement between the two methods is reported herein. © 2010 IEEE.
Resumo:
For an anti-plane problem, the differential operator is self-adjoint and the corresponding eigenfunctions belong to the Hilbert space. The orthogonal property between eigenfunctions (or between the derivatives of eigenfunctions) of anti-plane problem is exploited. We developed for the first time two sets of radius-independent orthogonal integrals for extraction of stress intensity factors (SIFs), so any order SIF can be extracted based on a certain known solution of displacement (an analytic result or a numerical result). Many numerical examples based on the finite element method of lines (FEMOL) show that the present method is very powerful and efficient.
Resumo:
Consultoria Legislativa - Área XIV - Comunicação Social, Informática, Telecomunicações, Sistema Postal, Ciência e Tecnologia.
Resumo:
The local characteristics of the anti-plane shear stress and strain field are determined for a material where the stress increases linearly with strain up to a limit and then softens nonlinearly. Two unloading models are considered such that the unloading path always returns to the origin while the other assumes the unloading modulus to be that of the initial shear modulus. As the applied shear increases, an unloading zone is found to prevail between a zone in which the material softens and another zone in which the material is linear-elastic even though the crack does not propagate. The divisions of these zones are displayed graphically.
The Comovement between Monetary and Fiscal Policy Instruments during the Post-War Period in the U.S.
Resumo:
This paper empirically studies the dynamic relationship between monetary and fiscal policies by analyzing the comovements between the Fed funds rate and the primary deficit/output ratio. Simple economic thinking establishes that a negative correlation between Fed rate and deficit arises whenever the two policy authorities share a common stabilization objective. However, when budget balancing concerns lead to a drastic deficit reduction the Fed may reduce the Fed rate in order to smooth the impact of fiscal policy, which results in a positive correlation between these two policy instruments. The empirical results show (i) a significant negative comovement between Fed rate and deficit and (ii) that deficit and output gap Granger-cause the Fed funds rate during the post-Volcker era, but the opposite is not true.
Resumo:
This paper considers the basic present value model of interest rates under rational expectations with two additional features. First, following McCallum (1994), the model assumes a policy reaction function where changes in the short-term interest rate are determined by the long-short spread. Second, the short-term interest rate and the risk premium processes are characterized by a Markov regime-switching model. Using US post-war interest rate data, this paper finds evidence that a two-regime switching model fits the data better than the basic model. The estimation results also show the presence of two alternative states displaying quite different features.
Resumo:
Using U.S. interest rate data covering the period 1950:1-1992:7, this paper tests the rational expectations model of the term structure of interest rates. We show evidence that the rational expectations model of the term structure is supported by the data during the seventies and a period lasting from the mid-eighties to the end of the sample. However, during the …fties, sixties and a period that covers most of the Volcker’s office term (from September 1979 to April 1986) the term structure model is rejected by the data. Moreover, wefind evidence of regime changes in the short-term rate process and the term structure of interest rates. These regime switches roughly coincide with changes in the Federal Reserve chairman. The switches in monetary policy taking place when the chairmanship of the Federal Reserve changes therefore seem to play an important role in characterizing the term structure of interest rates.
Resumo:
Published as an article in: Studies in Nonlinear Dynamics & Econometrics, 2004, vol. 8, issue 1, pages 5.
Resumo:
13 p.
Resumo:
This study was designed to observe the effect of tumor conditioned medium (TCM) on the proliferation and apoptosis of human umbilical vein endothelial cells (HUVECs). HUVECs were exposed to TCM from breast carcinoma cell line MDA-MB-231, then we measured their proliferation, apoptosis and cell cycle distribution by MTT and flow cytometery (FCM). Following the stimulation of TCM, HUVECs showed higher pro-mitogenic and anti-apoptotic ability than did the negative control group (ECGF-free medium with 20% FBS), but a similar ability to the positive control group (medium with ECGF and 20% FBS). From these results, we can conclude that breast carcinoma cell line MDA-MB-231 could secret soluble pro-angiogenic factors that induce HUVEC angiogenic switching, including cell cycle progression, proliferation and growth. The role and character of these factors remain to be further studied.
Resumo:
Ponencia leída en el Foro de Comunicaciones IkasArt II (BEC Barakaldo, 2010.06.17)