Nitrate retention under sugarcane in wet tropical Queensland deep soil profiles

Nitrate leaching below the crop root-zone in variable charge soils may be adsorbed at anion exchange sites, thereby temporarily reducing the risk of contamination of water bodies. The objectives of this study were (i) to investigate whether nitrate adsorption, accumulation, and retention in the Johnstone River Catchment of Far North Queensland wet tropics is widespread; (ii) to assess the capacity of soil in the Johnstone River Catchment to retain nitrate; and (iii) to deduce the consequences of nitrate adsorption/desorption on contamination of water bodies. Soil cores ranging from 8 to 12.5 m depth were taken from 28 sites across the catchment, representing 9 Ferrosol soil types under sugarcane (Saccharum officinarum-S) cultivation for at least 50 years and from rainforest. The cores were segmented at 0.5-m depth increments and subsamples were analysed for nitrate-N, cation and anion exchange capacities, pH, exchangeable cations (Ca, Mg, K, Na), soil organic C, electrical conductivity, sulfate-S, and chloride. Nitrate-N concentration under sugarcane ranged from 0 to 72.5 mg/kg, compared with 0 to 0.31 mg/kg under rainforest, both Pin Gin soils. The average N load in 1-12 m depth across 19 highly oxidic profiles of the Pin Gin soil series was 1550 kg/ha, compared with 185 kg/ha under 8 non-Pin Gin soils and 11 kg/ha in rainforest on a Pin Gin soil. Most of the nitrate retention was observed at depth of 2-12 m, particularly at 4-10 m, indicating that the accumulation was well below the crop root-zone. The average maximum potential nitrate retention capacity was 10.8 t/ha for the Pin Gin and 4.7 t/ha for the non-Pin Gin soil. Compared with the current N load, the soils still possess a large capacity to adsorb and retain nitrate in profiles. Retention of large quantities of the leached nitrate deep in most of the profiles has reduced the risk of contamination of water bodies. However, computations show that substantial quantities of the nitrate leached below the root-zone were not adsorbed and remain unaccounted for. This unaccounted nitrate might have entered both on- and off-site water bodies and/or have been denitrified.

Perfil das condi????es de sa??de das capitais brasileiras na perspectiva dos Objetivos de Desenvolvimento do Mil??nio (ODM)

No contexto atual, o uso de indicadores sociais na avalia????o das pol??ticas p??blicas tem se tornado cada vez maior. Os indicadores sociais tamb??m t??m sido implementados no acompanhamento dos Objetivos de Desenvolvimento do Mil??nio (ODM), projeto da Organiza????o das Na????es Unidas (ONU) em que v??rios pa??ses, inclusive o Brasil, firmaram um pacto para tornar o mundo menos desigual. Sendo assim, para avaliar o cumprimento das metas estabelecidas nos ODM, este artigo pretende delinear perfis das capitais brasileiras quanto ??s condi????es de sa??de, sob a perspectiva dos ODM, a fim de contribuir para a formula????o e avalia????o de pol??ticas p??blicas e indicar um caminho para a escolha de indicadores importantes de serem monitorados. Foram delineados perfis, com a ado????o do m??todo Grade of Membership, quanto ?? sa??de nas capitais brasileiras. Perante os resultados obtidos, pode-se dizer que as condi????es de sa??de nas capitais brasileiras apresentam forte vi??s regional.

A vida longa das linhas retas: cinco mitos sobre as fronteiras na África Negra

Este trabalho estuda as fronteiras políticas na África Negra nas suas dimensões históricas e atuais. Discutindo e criticando as suposições estereotipadas no discurso popular e acadêmico sobre as fronteiras na África, visa explicar porque elas exibiram, apesar de todas as suas imperfeições e defeitos, tanta resistência a mudanças.

Características físico-quimicas, análise sensorial e conservação de frutos de cultivares de bananeira resistentes à sigatoca-negra

O cultivar Prata Anã é o mais plantada no Norte de Minas Gerais, o que demonstra estar a bananicultura regional baseada numa variedade suscetível à sigatoca-negra. Apesar de existirem cultivares resistentes em fase de recomendação para o cultivo na região, ainda são escassos os trabalhos relacionados a metodologias de conservação pós-colheita. Assim, o objetivo deste trabalho foi avaliar o período de armazenamento e as características físico-químicas e sensoriais dos cultivares de bananeira Fhia - 02 e Precioso, ambos resistentes à sigatoca-negra, e o efeito da atmosfera modificada associada à refrigeração. Foram realizados três experimentos, o primeiro em temperatura ambiente, o segundo a 12 ºC e o terceiro a 15 ºC. Esses experimentos foram instalados no delineamento em blocos casualizados em esquema de parcelas subdivididas no tempo, tendo nas parcelas um fatorial 2 (com e sem embalagem) x 2 (Fhia - 02 e Precioso) e nas subparcelas as avaliações em intervalo de seis e dois dias para frutos armazenados nas temperaturas de 12, 15 e 25 ºC, com quatro repetições e três frutos por unidade experimental. Após o tratamento, os frutos foram dispostos em bandejas de poliestireno expandido (sem embalagem) e embalagens de 10 e 16 µm e umidade relativa de 90%. As características avaliadas foram: tamanho, diâmetro, cor, firmeza, perda de matéria fresca, sólidos solúveis totais (SST), acidez total titulável (ATT), SST/ATT, pH e análise sensorial. O uso da embalagem associada à refrigeração permitiu armazenar os frutos por 28 dias, mantendo as características físico-químicas.

ZigBee-based Remote Patient Monitoring

ZigBee-based Remote Patient Monitoring

Qualidade pós-colheita da alface hidropônica em ambiente protegido sob malhas termorefletoras e negra

Considerando que a duração da exposição, a qualidade e intensidade de luz afetam as características de qualidade das hortaliças folhosas, conduziu-se um experimento, em ambiente protegido, com o objetivo de avaliar a qualidade pós-colheita da alface hidropônica, sob os efeitos das malhas de sombreamento, com diferentes percentagens de atenuação da radiação solar. O delineamento experimental foi o de blocos casualizados, no esquema fatorial 2 x 5, com três repetições, sendo os tratamentos constituídos por quatro malhas termorefletoras (40; 50; 60 e 70% de sombreamento) e uma testemunha, com malha negra 50%. Em cada parcela, representada por um sistema hidropônico individual, foi cultivada a alface (cv. Olinda, Crespa), sendo avaliada sua qualidade por ocasião da colheita e após quatro dias de armazenamento refrigerado (7,6 ± 1ºC e 27 ± 5 % UR). Observou-se que o excesso de sombreamento, ocasionado pelas malhas termorefletoras 60 e 70% e malha negra 50%, comprometeram a aparência da alface. As plantas submetidas ao sombreamento com a malha termorefletora 40% apresentaram menor perda de massa, ao final de quatro dias de armazenamento. Os graus de sombreamento ocasionados pelas malhas termorefletoras e pela malha negra não influenciaram nos teores de ácido cítrico, sólidos solúveis, vitamina C e clorofila total da alface.

Remote Patient Monitoring Based on ZigBee: Lessons from a Real-World Deployment

AIM: This work presents detailed experimental performance results from tests executed in the hospital environment for Health Monitoring for All (HM4All), a remote vital signs monitoring system based on a ZigBee® (ZigBee Alliance, San Ramon, CA) body sensor network (BSN). MATERIALS AND METHODS: Tests involved the use of six electrocardiogram (ECG) sensors operating in two different modes: the ECG mode involved the transmission of ECG waveform data and heart rate (HR) values to the ZigBee coordinator, whereas the HR mode included only the transmission of HR values. In the absence of hidden nodes, a non-beacon-enabled star network composed of sensing devices working on ECG mode kept the delivery ratio (DR) at 100%. RESULTS: When the network topology was changed to a 2-hop tree, the performance degraded slightly, resulting in an average DR of 98.56%. Although these performance outcomes may seem satisfactory, further investigation demonstrated that individual sensing devices went through transitory periods with low DR. Other tests have shown that ZigBee BSNs are highly susceptible to collisions owing to hidden nodes. Nevertheless, these tests have also shown that these networks can achieve high reliability if the amount of traffic is kept low. Contrary to what is typically shown in scientific articles and in manufacturers' documentation, the test outcomes presented in this article include temporal graphs of the DR achieved by each wireless sensor device. CONCLUSIONS: The test procedure and the approach used to represent its outcomes, which allow the identification of undesirable transitory periods of low reliability due to contention between devices, constitute the main contribution of this work.

Exposure assessment: the influence of environmental monitoring methodology

Exposure assessment is an important step of risk assessment process and has evolved more quickly than perhaps any aspect of the four-step risk paradigm (hazard identification, exposure assessment, dose-response analysis, and risk characterization). Nevertheless, some epidemiological studies have associated adverse health effects to a chemical exposure with an inadequate or absent exposure quantification. In addition to the metric used, the truly representation of exposure by measurements depends on: the strategy of sampling, random collection of measurements, and similarity between the measured and unmeasured exposure groups. Two environmental monitoring methodologies for formaldehyde occupational exposure were used to assess the influence of metric selection in exposure assessment and, consequently, in risk assessment process.

Monitoring exposure to airborne ultrafine particles in Lisbon, Portugal

The aim of this study is to contribute to the assessment of exposure levels of ultrafine particles (UFP) in the urban environment of Lisbon, Portugal, due to automobile traffic, by monitoring lung-deposited alveolar surface area (resulting from exposure to UFP) in a major avenue leading to the town centre during late Spring, as well as in indoor buildings facing it. This study revealed differentiated patterns for week days and weekends, consistent with PM(2.5) and PM(10) patterns currently monitored by air quality stations in Lisbon. The observed ultrafine particulate levels could be directly related with the fluxes of automobile traffic. During a typical week, UFP alveolar deposited surface area varied between 35.0 and 89.2 µm(2)/cm(3), which is comparable with levels reported for other towns such in Germany and United States. The measured values allowed the determination of the number of UFP per cm(3), which are comparable to levels reported for Madrid and Brisbane. In what concerns outdoor/indoor levels, we observed higher levels (32-63%) outdoor, which is somewhat lower than levels observed in houses in Ontario.

Biological monitoring of aflatoxin (AFB1) in workers of swine and poultry production

Although a great body of literature exists concerning the ingestion of food contaminated with aflatoxin, there are still few studies regarding mycotoxin inhalation in occupational settings. Since mycotoxins are relatively non-volatile, inhalation exposure is cause by inhalation of airborne fungal particulates or fungi-contaminated substrates that contain aflatoxin. We intend to know if there is occupational exposure to aflatoxin in Portuguese poultry and swine production. A total of 19 individuals (11 swine; 8 poultry) agreed and provided blood samples during the course of this investigation. Measurement of AFB1 was performed by ELISA. The samples were treated with pronase (Merck), wash in a Column C18 and purification was made with immunoaffinity columns (R.biopharma), specific for AFB1. It was applied statistical test (Mann-Whitney) to verified statistical difference in AFB1 results between the two settings. Results varied with concentrations from

Determination of electricity consumers’ load profiles via weighted evidence accumulation clustering using subsampling

With the electricity market liberalization, the distribution and retail companies are looking for better market strategies based on adequate information upon the consumption patterns of its electricity consumers. A fair insight on the consumers’ behavior will permit the definition of specific contract aspects based on the different consumption patterns. In order to form the different consumers’ classes, and find a set of representative consumption patterns we use electricity consumption data from a utility client’s database and two approaches: Two-step clustering algorithm and the WEACS approach based on evidence accumulation (EAC) for combining partitions in a clustering ensemble. While EAC uses a voting mechanism to produce a co-association matrix based on the pairwise associations obtained from N partitions and where each partition has equal weight in the combination process, the WEACS approach uses subsampling and weights differently the partitions. As a complementary step to the WEACS approach, we combine the partitions obtained in the WEACS approach with the ALL clustering ensemble construction method and we use the Ward Link algorithm to obtain the final data partition. The characterization of the obtained consumers’ clusters was performed using the C5.0 classification algorithm. Experiment results showed that the WEACS approach leads to better results than many other clustering approaches.

Typical load profiles in the smart grid context – a clustering methods comparison

The present research paper presents five different clustering methods to identify typical load profiles of medium voltage (MV) electricity consumers. These methods are intended to be used in a smart grid environment to extract useful knowledge about customer’s behaviour. The obtained knowledge can be used to support a decision tool, not only for utilities but also for consumers. Load profiles can be used by the utilities to identify the aspects that cause system load peaks and enable the development of specific contracts with their customers. The framework presented throughout the paper consists in several steps, namely the pre-processing data phase, clustering algorithms application and the evaluation of the quality of the partition, which is supported by cluster validity indices. The process ends with the analysis of the discovered knowledge. To validate the proposed framework, a case study with a real database of 208 MV consumers is used.

Controlo estratégico dos custos das atividades e recursos da Direção Comercial da Eletricidade dos Açores, S.A.

Dissertação de Mestrado, Ciências Económicas e Empresariais, 16 de Janeiro 2014, Universidade dos Açores.