Estudo da Determinação dos Grupos Silanóis ( º Si-OH) em Sílica: Aplicação à Materiais de Recheio Utilizados em Cromatografia Gasosa

A simple chemical method has been developed to quantify the silanol groups (º Si-OH) in silica as well as in coated chromatographic supports for use in packed - column Gas Chromatography. After adsorption of 10 mg/mL methylene blue, centrifuging action and filtration, the absorbance of the solution was inversely proportional to the silanol quantity. The difference between the absorbance of the pure solution and that of the solid - free filtrate was related to the silica weight, yielding a quantitative analysis of these groups.

Studies of Eu- and Yb-induced Reconstructions on the Si(100) Surface

This thesis presents experimental studies of rare earth (RE) metal induced structures on Si(100) surfaces. Two divalent RE metal adsorbates, Eu and Yb, are investigated on nominally flat Si(100) and on vicinal, stepped Si(100) substrates. Several experimental methods have been applied, including scanning tunneling microscopy/spectroscopy (STM/STS), low energy electron diffraction (LEED), synchrotron radiation photoelectron spectroscopy (SR-PES), Auger electron spectroscopy (AES), thermal desorption spectroscopy (TDS), and work function change measurements (Δφ). Two stages can be distinguished in the initial growth of the RE/Si interface: the formation of a two-dimensional (2D) adsorbed layer at submonolayer coverage and the growth of a three-dimensional (3D) silicide phase at higher coverage. The 2D phase is studied for both adsorbates in order to discover whether they produce common reconstructions or reconstructions common to the other RE metals. For studies of the 3D phase Yb is chosen due to its ability to crystallize in a hexagonal AlB2 type lattice, which is the structure of RE silicide nanowires, therefore allowing for the possibility of the growth of one-dimensional (1D) wires. It is found that despite their similar electronic configuration, Eu and Yb do not form similar 2D reconstructions on Si(100). Instead, a wealth of 2D structures is observed and atomic models are proposed for the 2×3-type reconstructions. In addition, adsorbate induced modifications on surface morphology and orientational symmetry are observed. The formation of the Yb silicide phase follows the Stranski-Krastanov growth mode. Nanowires with the hexagonal lattice are observed on the flat Si(100) substrate, and moreover, an unexpectedly large variety of growth directions are revealed. On the vicinal substrate the growth of the silicide phase as 3D islands and wires depends drastically on the growth conditions. The conditions under which wires with high aspect ratio and single orientation parallel to the step edges can be formed are demonstrated.

Correlação entre a estrutura atômica superficial e o processo de adsorção-dessorção reversível de hidrogênio em eletrodos monocristalinos Pt(111), Pt(100) e Pt(110)

Platinum is widely used as electrode in electrocatalytic processes, however the use of polycrystalline electrodes introduces a series of variables in the electrochemical system due to the aleatory contribution of all the crystallographic orientations with different surface packing of atoms. Single crystal platinum electrodes of low Miller index present surface structure of high regularity and serve as model to establish a correlation among the macroscopic and microscopic properties of the electrochemical interface. Therefore, the main aim of this work is the study of the voltammetric profiles of the reversible adsorption-desorption of hydrogen on Pt(100), Pt(110) and Pt(111), in order to correlate the electrochemical properties of each different orientation with the surface atomic structure.

Surface passivation and optical characterization of Al2O3/a-SiCx stacks on c-Si substrates

Postprint (published version)

Síntesis de capas de SiC en substrato de Si mediante implantación iónica

En este trabajo se investiga la síntesis de estructuras SiC/Si mediante implantación iónica de carbono en Si. Las implantaciones se han realizado a energías entre 25 y 300 keV y las dosis en el rango lO^^ylO^^ cm , manteniendo el substrato a temperatura ambiente o 500°C. Algunas estructuras han sido recocidas a 1150°C. Los resultados indican que implantando a temperatura ambiente se forma una capa de SiC amorfa y de composición gradual, que recristaliza formando precipitados de ß-SiC con orientaciones aleatorias después del recocido. Además se forma un capa superficial rica en carbono, debida a la difusión del carbono hacia la superficie durante la implantación, y que desaparece con el recocido. Implantando a 500°C se forma directamente una capa con una muy alta densidad de precipitados de ß-SiC orientados preferencialmente con la matriz de silicio. Dada la estabilidad térmica y química de dicha capa se han realizado membranas de SiC mediante técnicas fotolitográficas y ataque químico selectivo, cuya rugosidad superficial es inferior a 6 nm. Estas membranas muestran unos gradientes de tensiones residuales, que prácticamente desaparecen después del recocido. Los resultados confirman la potencialidad de la implantación iónica para la formación de estructuras microme-cánicas de SiC sobre Si.

Caracterización estructural de capas epitaxiadas de InGaAs/InAlAs crecidas sobre substratos (111) de InP

Se ha analizado por microscopía electrónica en transmisión (TEM) la estructura de transistores HEMT basados en un pozo cuántico tensionado de InGaAs/InAlAs crecido sobre un sustrato {111} de InP. Se han observado dislocaciones filiformes y defectos planares que cruzan la capa superior hacia la superficie, así como maclas paralelas a la interficie y grandes complejos defectivos en forma de V que se nuclean unos pocos nanometres por encima de la interficie entre el pozo cuántico y la capa superior que lo confina. La estructura de los defectos es muy diferente de la observada en heteroestructuras similares crecidas sobre sustratos {100}, hecho que sugiere que hay que tener en cuenta consideraciones sobre el proceso mismo de nucleación de los defectos junto con las convencionales relacionadas con el desajuste de redes.

Obtención de láminas delgadas de Y-Ba-Cu-O sobre Si (100)

Se ha utilizado la evaporación secuencial de Cu, Y2O3 y BaF2 para la obtención de láminas delgadas superconductoras de YBa-CuO sobre substratos de Si monocristalino con orientación [100], recubiertos con una lámina barrera de Zr02. Se han estudiado los efectos de la variación de los espesores relativos de las láminas constituyentes y del espesor total de la lámina resultante. Las láminas se han caracterizado mediante medidas de la variación de la resistencia con la temperatura, microscopía electrónoca de barrido, difractometría de rayos X, microson-da electrónica y espectometría de masas de iones secundarios. Las láminas presentan un ligero carácter semiconductor en el estado normal, con temperaturas de inicio de la transición su-perconductora alrededor de 90 K, y resistencia nula, en el mejor de los casos, a 45 K.

För si sådan är kärlekens begäran

Soitinnus: mieskuoro (TTBB).

För si sådan är kärlekens begäran

Soitinnus: mieskuoro

Calorimetry of hydrogen desorption from ɑ-Si nanoparticles

The process of hydrogen desorption from amorphous silicon (ɑ-Si) nanoparticles grown by plasmaenhanced chemical vapor deposition (PECVD) has been analyzed by differential scanning calorimetry (DSC), mass spectrometry, and infrared spectroscopy, with the aim of quantifying the energy exchanged. Two exothermic peaks centered at 330 and 410 °C have been detected with energies per H atom of about 50 meV. This value has been compared with the results of theoretical calculations and is found to agree with the dissociation energy of Si-H groups of about 3.25 eV per H atom, provided that the formation energy per dangling bond in ɑ-Si is about 1.15 eV. It is shown that this result is valid for ɑ-Si:H films, too

Como si fuera posible recoger sentimientos = As if it were possible to collect suffering

Se trata de una propuesta como resultado del trabajo conjunto entre la escuela de Arte Pigment y el ESPAI ZERO1 del Museu Comarcal de la Garrotxa, destinado exclusivamente a exposiciones temporales de creación contemporánea y como continuidad de propuestas anteriores de colaboración: REPLICA23 y SONESNAT JUNIOR. Com si fos possible recollir el sofriment es un proyecto de la artista Anna Manel.la, y se consideró una propuesta interesante y un reto para conversar, intercambiar y crear con los alumnos sobre el tema de la exposición: la muerte y el sufrimiento. Asimismo porque es una artista conocida por los alumnos de la escuela Pigment, ya que anteriormente habían realizado un proyecto de apadrinamiento de esculturas y habitualmente ella participa en programas divulgativos en la escuela. El trabajo desarrollado centra el aprendizaje en la creación y en la investigación artística como ejes de los procesos de conceptualización con el objetivo de atender las dinámicas y los estímulos característicos de los niños. Facilitando procesos de búsqueda, exploración y manipulación sin condicionantes y promoviendo procesos autónomos en los que los mismos niños se planteen dudas e interrogantes y se enfrenten a situaciones cada vez mas complejas

Bowing the violin : a case study for auditory-motor pattern modelling in the context of music performance

This project addresses methodological and technological challenges in the development of multi-modal data acquisition and analysis methods for the representation of instrumental playing technique in music performance through auditory-motor patterning models. The case study is violin playing: a multi-modal database of violin performances has been constructed by recording different musicians while playing short exercises on different violins. The exercise set and recording protocol have been designed to sample the space defined by dynamics (from piano to forte) and tone (from sul tasto to sul ponticello), for each bow stroke type being played on each of the four strings (three different pitches per string) at two different tempi. The data, containing audio, video, and motion capture streams, has been processed and segmented to facilitate upcoming analyses. From the acquired motion data, the positions of the instrument string ends and the bow hair ribbon ends are tracked and processed to obtain a number of bowing descriptors suited for a detailed description and analysis of the bow motion patterns taking place during performance. Likewise, a number of sound perceptual attributes are computed from the audio streams. Besides the methodology and the implementation of a number of data acquisition tools, this project introduces preliminary results from analyzing bowing technique on a multi-modal violin performance database that is unique in its class. A further contribution of this project is the data itself, which will be made available to the scientific community through the repovizz platform.

Historisk och oeconomisk beskrifning öfwer siö-staden Nystad

Painovuosi nimekkeestä.

Resistência quantitativa à ferrugem da folha em genótipos de aveia branca: III - Correlação de componentes de resistência entre si e com a intensidade de doença no campo

A seleção de genótipos com resistência quantitativa à ferrugem da folha da aveia (Avena sativa), baseada nos componentes que a condicionam, necessita do conhecimento da associação destes componentes entre si e deles com a quantidade de doença no campo, representada pela área abaixo da curva de progresso da doença (AACPD). Este trabalho objetivou determinar estas correlações, a partir de resultados de ensaios realizados previamente, em que 31 genótipos de aveia branca tiveram sua reação à ferrugem determinada no campo e seus componentes de resistência quantificados. As correlações encontradas foram geralmente baixas, tanto dos componentes entre si, como deles com a intensidade da doença no campo. As correlações mais altas, e consistentes entre os anos, com a AACPD foram da eficiência de infecção em plântulas, do período de latência e do comprimento de pústulas em plantas adultas. Estes dados sugerem que os componentes citados podem ter uma influência um pouco maior que os demais sobre a expressão da resistência parcial a campo. Entretanto, a baixa correlação entre os componentes medidos, indica que a seleção de genótipos, nesta interação patógeno-hospedeiro, não deve ser realizada com base em apenas um componente de resistência. Os resultados sugerem que a expressão da resistência parcial à ferrugem da folha da aveia não é condicionada apenas por um componente de resistência, mas sim pelo efeito conjunto de todos eles. Além disto, é possível que mecanismos diferenciados estejam atuando em cada genótipo, de forma que os componentes de resistência mais importantes para um não sejam os mesmos para outro.

Characteristics of pyridine adsorption on Au(111) and Au(210) by EIS parameters fitting procedure

Some aspects of the application of electrochemical impedance spectroscopy to studies of solid electrode / solution interface, in the absence of faradaic processes, are analysed. In order to perform this analysis, gold electrodes with (111) and (210) crystallographic orientations in an aqueous solution containing 10 mmol dm-3 KF, as supporting electrolyte, and a pyridine concentration varying from 0.01 to 4.6 mmol dm-3, were used. The experimental data was analysed by using EQUIVCRT software, which utilises non-linear least squares routines, attributing to the solid electrode / solution interface behaviour described by an equivalent circuit with a resistance in series with a constant phase element. The results of this fitting procedure were analysed by the dependence on the electrode potential on two parameters: the pre-exponential factor, Y0, and the exponent n f, related with the phase angle shift. By this analysis it was possible to observe that the pyridine adsorption is strongly affected by the crystallographic orientation of the electrode surface and that the extent of deviation from ideal capacitive behaviour is mainly of interfacial origin.