A comparison of thermal condition between pilot- and full-scale furnaces for studying slagging and fouling propensity in PF boilers

The Australian Coal Industry Research Laboratory (ACIRL) furnace is scaled to simulate slagging and fouling in operating boilers. This requires that the gas and target temperatures, the heat flux, and the flow pattern be the same as those in real boilers. The gas and target temperatures are maintained by insulating the wall and cooling the target respectively. The flow pattern of a small burner cannot be the same as a large furnace. However, this flow pattern is partially compensated for by placing the slagging panels in three vertical locations. The paper develops the models of radiant heat transfer from the flame to the deposits both in pilot-scale and full-scale furnaces. They are used to compare the effective radiant heat transfer of the pilot- and full-scale furnaces. The experimental data both from the pilot- and full-scale furnaces are used to verify the incident heat flux and temperature profiles in the pilot- and full-scale furnaces. The results showed that the thermal condition in the pilot-scale furnace meets the requirements for studying the slagging regarding the gas temperature and the incident heat flux, particularly for the panel #1. The gas temperature in the convective section also meets the requirement for studying the fouling.

Spontaneous-combustion propensity of New Zealand coals under adiabatic conditions

Pulverised New Zealand coal samples have been tested from an initial temperature of 40 degreesC and reacted adiabatisally in an oven with oxygen to provide a full temperature history of auto-oxidation up to the self-sustained process of combustion. This procedure produces a self-heating rate index, R-70, calculated as the ratio of the time taken to reach 70 degreesC (degreesC/h). The R-70 index is a measure of the coal's propensity to spontaneous combustion. R-70 values for New Zealand coals are much higher than any previously published results. They show a rank dependence, whereby subbituminous coals have the highest propensity to spontaneous combustion (14.91-17.23 degreesC/h). A lignite sample has an R-70 value of 7.76 degreesC/h, and high-volatile bituminous B coals have R-70 values of 0.31-2.23 degreesC/h. Samples stored for 2 years show the same rank trend. The nature of this trend is most likely a function of the internal surface area of the coal that governs the available sites for oxidation. Calculating the Suggate rank; for any New Zealand coal can be used to rare its propensity to spontaneous combustion. Resin bodies in the subbituminous coal show no propensity to spontaneous combustion. (C) 2001 Elsevier Science B.V. All rights reserved.

Linking entrepreneural orientation to export performance: the role of intangible resources and dynamic capabilities

Understanding the determinants of international performance, and in particular, export performance is key for the success of international companies. Research in this area focuses mainly on how resources and capabilities allow companies to gain competitive advantage and superior performance in external markets. Building on the Resource-Based View (RBV) and the Dynamic Capabilities Approach (DCA), this study aims at analysing the effect of intangible resources and capabilities on export performance. Specifically, this study focuses on the proposition that entrepreneurial orientation potentiates the attraction of intangible resources, namely relational and informational resources. Moreover, we propose that these resources impact export performance both directly and indirectly through dynamic capabilities.

Influence of entrepreneurial orientation in export performance

This study aims at investigating the influence that entrepreneurial orientation has on export performance of Portuguese footwear small and mediumenterprises (SMEs). Therefore, a quantitative methodological approach was used, conducting a descriptive, exploratory and transversal empirical study, having applied a questionnaire to a sample of Portuguese companies exporting footwear. The research results suggest that entrepreneurial orientation enhances export performance in the analysed SMEs, particularly innovation and proactiveness, through the amount of funds invested, human resources dedicated to this activity, number of new products or services introduced in the market and frequent change in product lines or services and materialization of a long-term perspective, which is accompanied by innovative activities or new businesses. Therefore, the findings sustain the necessity to invest in entrepreneurial orientation as a strategic determinant, which contributes to the growth of small firms in foreignmarkets. Finally, the main limitation of this study is related to the sample size, since it was difficult to find companies willing to collaborate with this kind of research.

Continuous Infusion of Piperacillin/Tazobactam in Septic Critically Ill Patients - a Multicenter Propensity Matched Analysis

The clinical efficacy of continuous infusion of piperacillin/tazobactam in critically ill patients with microbiologically documented infections is currently unknown. We conducted a retrospective multicenter cohort study in 7 Portuguese intensive care units (ICU). We included 569 critically ill adult patients with a documented infection and treated with piperacillin/tazobactam admitted to one of the participating ICU between 2006 and 2010. We successfully matched 173 pairs of patients according to whether they received continuous or conventional intermittent dosing of piperacillin/tazobactam, using a propensity score to adjust for confounding variables. The majority of patients received 16g/day of piperacillin plus 2g/day of tazobactam. The 28-day mortality rate was 28.3% in both groups (p = 1.0). The ICU and in-hospital mortality were also similar either in those receiving continuous infusion or intermittent dosing (23.7% vs. 20.2%, p = 0.512 and 41.6% vs. 40.5%, p = 0.913, respectively). In the subgroup of patients with a Simplified Acute Physiology Score (SAPS) II>42, the 28-day mortality rate was lower in the continuous infusion group (31.4% vs. 35.2%) although not reaching significance (p = 0.66). We concluded that the clinical efficacy of piperacillin/tazobactam in this heterogeneous group of critically ill patients infected with susceptible bacteria was independent of its mode of administration, either continuous infusion or intermittent dosing.

Determinants of export diversification and sophistication in sub-saharan Africa

This paper studies the political and economic factors that determine successful export diversification (ED) and export sophistication (ES) strategies in the Sub-Saharan African (SSA) countries and also the way in which successful ED and sophistication strategies contribute to explain the improving in some of the millennium development goals (MDG). We run separate regressions for the determinants of ES and ED, using disaggregated data of the 48 SSA countries, from 1960 to 2005. The results suggest that better governance is an important determinant for the success of diversification and sophistication strategies in SSA. In particular the level of corruption, transparency and accountability are important factors in limiting or promoting the scope of diversification and the level of sophistication of the exports. The results also suggest that increases in human capital in SSA countries promote both ED and ES, showing that the level of education of the workforce is positively related with ES and ED, with higher levels of education (tertiary) playing a more important role in explaining ES, while lower levels of education (primary) being more important as determinants of ED. In the second part we explore the links between ED and ES and growth presenting evidence that ED and ES are linked to growth stability in SSA. This study also suggests that the Sub-Saharan countries that were more successful in achieving ED and ES tend to be more successful in improving the living conditions of their population. Using different variables of Infant Mortality (one of the MDG) and life expectancy as dependent variables, we present evidence that suggests that in SSA higher ED and ES are associated with lower infant mortality and higher life expectancy. We show that this result is robust, presenting positive and significant results even when a large number of different control variables are introduced, or when fixed effects and instrumental variables are considered. The evidence suggests that ED and ES are part of the solution for a successful development of SSA.

Promoting Portuguese exports to Germany: An export promotion plan for the machinery & equipment sector

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Management from the NOVA – School of Business and Economics

Should Unilever JM export Cornettos to emergent countries?

Field Lab in Entrepreneurial Innovative Ventures

Mandinga for export : a globalização da Capoeira

Esta tese de doutoramento resulta de uma investigação antropológica sobre o conceito de mandinga, na prática da capoeira, e a sua importância na globalização desta forma de arte afro-brasileira na Europa. A pesquisa, que foi realizada na Polónia e em Portugal, busca resposta para a seguinte pergunta: Quais os processos geradores da noção atual de mandinga como propriedade imaterial da capoeira, e de que forma a mandinga foi exportada, apropriada e ressignificada nos processos globais da contemporaneidade? A busca por esta resposta compreendeu um trabalho de campo de três anos realizado nos grupos UNICAR (União Internacional de Capoeira Regional) na cidade de Cracóvia, na Polónia, e do Grupo Capoeirarte, na cidade do Porto, em Portugal. Para além de, através do conceito de mandinga, tentar compreender o processo de transnacionalização da capoeira, o trabalho pretende ainda situar a forma como em alguns contextos sociais, culturais e políticos da Europa, os europeus se relacionam com práticas exteriores a sua cultura e, através de processos de ressignificação, se apropriam e nativizam o outro.

Optimization of export support systems: How to promote exports from Portugal to Germany in the area of information technology and electronics

This work project focuses on developing new approaches which enhance Portuguese exports towards a defined German industry sector within the information technology and electronics fields. Firstly and foremost, information was collected and a set of expert and top managers’ interviews were performed in order to acknowledge the demand of the German market while identifying compatible Portuguese supply capabilities. Among the main findings, Industry 4.0 presents itself as a valuable opportunity in the German market for Portuguese medium sized companies in the embedded systems area of expertise for machinery and equipment companies. In order to achieve the purpose of the work project, an embedded systems platform targeting machinery and equipment companies was suggested as well as it was developed several recommendations on how to implement it. An alternative approach for this platform was also considered within the German market namely the eHealth sector having the purpose of enhancing the current healthcare service provision.

Optimization of export support systems

The present paper is a personal reflection on a work project carried out to promote exports from Portugal to Germany in the IT area, under consideration of the deliverables required by the clients CCILA and Anetie. The project outcome approaches the fact that the majority of the Portuguese market players has disadvantages in size and does rarely coordinate activities among each other, which hinders them to export successfully on a broad scale. To bring together Portuguese delivery potential and German market demand, expert interviews were conducted. Based on the findings, a concept was developed to overcome the domestic collaboration issues in order to strengthen the national exports in the identified sector - embedded systems implementation services for machinery and equipment companies.

Flow cytometry analyses of calcification propensity

Dissertação de mestrado integrado em Engenharia Biomédica (área de especialização em Engenharia Clínica)