National Air and Radiation Environmental Laboratory : a leader in environmental radiation measurement.

Mode of access: Internet.

Factors affecting the use of CaF2 : Mn thermoluminescent dosimeters for low-level environmental radiation monitoring /

Mode of access: Internet.

The status and quality of radiation measurements for air /

Issued Oct. 1977.

A summary of accidents and incidents involving radiation in atomic energy activities, June 1945 through December 1955 /

"TID-5360; Subject category: Health and Biology."

Ultrox International ultraviolet radiation/oxidation technology : applications analysis report.

Mode of access: Internet.

Radiation control, for fire and other emergency forces,

Includes bibliography.

The effects of ionizing radiation on the reproductive capacity of adult Penaeus (Marsupenaeus) japonicus (Bate)

The reproductive capacity of adult Penaeus (Marsupenaeus) japonicus (Bate) was assessed after exposure to ionizing gamma radiation from a cobalt-60 source. Males and females were each exposed to 0, 10 and 20 Gray (Gy) of ionizing radiation (IR) and reciprocally crossed to give nine mating combinations. Fecundity and hatch rate of resulting spawnings were used as measures of reproductive capacity. IR significantly (P

Impact of changes in natural ultraviolet radiation on pigment composition, physiological and morphological characteristics of the Antarctic moss, Grimmia antarctici

The impact of ambient ultraviolet (UV)-B radiation on the endemic bryophyte, Grimmia antarctici, was studied over 14 months in East Antarctica. Over recent decades, Antarctic plants have been exposed to the largest relative increase in UV-B exposure as a result of ozone depletion. We investigated the effect of reduced UV and visible radiation on the pigment concentrations, surface reflectance and physiological and morphological parameters of this moss. Plexiglass screens were used to provide both reduced UV levels (77%) and a 50% decrease in total radiation. The screen combinations were used to separate UV photoprotective from visible photoprotective strategies, because these bryophytes are growing in relatively high light environments compared with many mosses. G. antarctici was affected negatively by ambient levels of UV radiation. Chlorophyll content was significantly lower in plants grown under near-ambient UV, while the relative proportions of photoprotective carotenoids, especially beta-carotene and zeaxanthin, increased. However, no evidence for the accumulation of UV-B-absorbing pigments in response to UV radiation was observed. Although photosynthetic rates were not affected, there was evidence of UV effects on morphology. Plants that were shaded showed fewer treatment responses and these were similar to the natural variation observed between moss growing on exposed microtopographical ridges and in more sheltered valleys within the turf. Given that other Antarctic bryophytes possess UV-B-absorbing pigments which should offer better protection under ambient UV-B radiation, these findings suggest that G. antarctici may be disadvantaged in some settings under a climate with continuing high levels of springtime UV-B radiation.

Social and scientific issues in the acceptibility of radiation risks

Ionising radiation hazards are perhaps the most documented and regulated occupational and environmental hazard. In the radiological protection field a single expert advisory organisation has had an unusually large influence on the international standard setting process. This is the International Commission on Radiological Protection (ICRP). Two common, and opposing views, exist over the formulation of protection recommendations by the ICRP. The first, and most widely accepted, is that its recommendations are scientifically determined. The second view, is that its recommendations are politically or socially determined. Neither of these analyses adequately accounts for the complex process in which protection recommendations are formulated. A third view, provided by studies of the origins of scientific controversy, suggests that both science and social factors are important in the assessment and limitation of risk. The aim of this thesis is not simply to examine the origin of controversy. Issues of equal, if not more, importance are the resolution of controversy, the formation of consensus and the maintenance of expert authority and influence. These issues form the central focus of this thesis. The aim is to assess the process through which the ICRP formulates its radiological protection recommendations and comment on the extent that these are influenced by the affiliations of its members. This thesis concludes that the ICRP's recommendations have been shaped by a complex relationship of scientific and social considerations, in which a socio-technical commitment to nuclear energy has played a key role. The Commission has responded to new scientific data by making complex changes to its philosophy and methods of describing risk. Where reductions in numerical limits have been applied they have been accompanied by practical measures designed to limit the impact of the change and provide continuity with the old limits and flexibility in the application of the new recommendations.

Towards standardization of UV eye protection:what can be learned from photodermatology?

While knowledge about standardization of skin protection against ultraviolet radiation (UVR) has progressed over the past few decades, there is no uniform and generally accepted standardized measurement for UV eye protection. The literature provides solid evidence that UV can induce considerable damage to structures of the eye. As well as damaging the eyelids and periorbital skin, chronic UV exposure may also affect the conjunctiva and lens. Clinically, this damage can manifest as skin cancer and premature skin ageing as well as the development of pterygia and premature cortical cataracts. Modern eye protection, used daily, offers the opportunity to prevent these adverse sequelae of lifelong UV exposure. A standardized, reliable and comprehensive label for consumers and professionals is currently lacking. In this review we (i) summarize the existing literature about UV radiation-induced damage to the eye and surrounding skin; (ii) review the recent technological advances in UV protection by means of lenses; (iii) review the definition of the Eye-Sun Protection Factor (E-SPF®), which describes the intrinsic UV protection properties of lenses and lens coating materials based on their capacity to absorb or reflect UV radiation; and (iv) propose a strategy for establishing the biological relevance of the E-SPF. © 2013 John Wiley & Sons A/S.

Ultraviolet damage to the eye revisited:eye-sun protection factor (E-SPF®), a new ultraviolet protection label for eyewear

Ultraviolet (UV) radiation potentially damages the skin, the immune system, and structures of the eye. A useful UV sun protection for the skin has been established. Since a remarkable body of evidence shows an association between UV radiation and damage to structures of the eye, eye protection is important, but a reliable and practical tool to assess and compare the UV-protective properties of lenses has been lacking. Among the general lay public, misconceptions on eye-sun protection have been identified. For example, sun protection is mainly ascribed to sunglasses, but less so to clear lenses. Skin malignancies in the periorbital region are frequent, but usual topical skin protection does not include the lids. Recent research utilized exact dosimetry and demonstrated relevant differences in UV burden to the eye and skin at a given ambient irradiation. Chronic UV effects on the cornea and lens are cumulative, so effective UV protection of the eyes is important for all age groups and should be used systematically. Protection of children's eyes is especially important, because UV transmittance is higher at a very young age, allowing higher levels of UV radiation to reach the crystalline lens and even the retina. Sunglasses as well as clear lenses (plano and prescription) effectively reduce transmittance of UV radiation. However, an important share of the UV burden to the eye is explained by back reflection of radiation from lenses to the eye. UV radiation incident from an angle of 135°-150° behind a lens wearer is reflected from the back side of lenses. The usual antireflective coatings considerably increase reflection of UV radiation. To provide reliable labeling of the protective potential of lenses, an eye-sun protection factor (E-SPF®) has been developed. It integrates UV transmission as well as UV reflectance of lenses. The E-SPF® compares well with established skin-sun protection factors and provides clear messages to eye health care providers and to lay consumers. © 2014 Behar-Cohen et al, This work is published by Dove Medical Press Ltd.

Radiological protection and the exposure of animals as patients in veterinary medicine

It is apparent that most of the techniques that make use of ionising radiation in human medical practices are now being applied in veterinary medicine. Steps are being taken by the IAEA to provide guidance for humans involved in such practices, but there appears to be no international initiative that considers the protection or welfare of the animal as a patient. There is therefore a risk that the deliberate exposure of an animal, particularly in the therapeutic application of radiation, could do more harm than good. In the light of recent developments in dosimetric modelling and the application of known effects of radiation on different types of animals, for the purposes of the protection of biota in an environmental context, it is argued that it would be sensible now to start a serious consideration of this issue. Some suggestions are made with regard to a number of areas that could be considered further, both specifically and with regard to the field of radiological protection as a whole.

Radiological protection and the exposure of animals as patients in veterinary medicine

It is apparent that most of the techniques that make use of ionising radiation in human medical practices are now being applied in veterinary medicine. Steps are being taken by the IAEA to provide guidance for humans involved in such practices, but there appears to be no international initiative that considers the protection or welfare of the animal as a patient. There is therefore a risk that the deliberate exposure of an animal, particularly in the therapeutic application of radiation, could do more harm than good. In the light of recent developments in dosimetric modelling and the application of known effects of radiation on different types of animals, for the purposes of the protection of biota in an environmental context, it is argued that it would be sensible now to start a serious consideration of this issue. Some suggestions are made with regard to a number of areas that could be considered further, both specifically and with regard to the field of radiological protection as a whole.

CHARACTERIZATION OF RADIATION DAMAGE TO A NOVEL PHOTONIC CRYSTAL SENSOR

New methods of nuclear fuel and cladding characterization must be developed and implemented to enhance the safety and reliability of nuclear power plants. One class of such advanced methods is aimed at the characterization of fuel performance by performing minimally intrusive in-core, real time measurements on nuclear fuel on the nanometer scale. Nuclear power plants depend on instrumentation and control systems for monitoring, control and protection. Traditionally, methods for fuel characterization under irradiation are performed using a “cook and look” method. These methods are very expensive and labor-intensive since they require removal, inspection and return of irradiated samples for each measurement. Such fuel cladding inspection methods investigate oxide layer thickness, wear, dimensional changes, ovality, nuclear fuel growth and nuclear fuel defect identification. These methods are also not suitable for all commercial nuclear power applications as they are not always available to the operator when needed. Additionally, such techniques often provide limited data and may exacerbate the phenomena being investigated. This thesis investigates a novel, nanostructured sensor based on a photonic crystal design that is implemented in a nuclear reactor environment. The aim of this work is to produce an in-situ radiation-tolerant sensor capable of measuring the deformation of a nuclear material during nuclear reactor operations. The sensor was fabricated on the surface of nuclear reactor materials (specifically, steel and zirconium based alloys). Charged-particle and mixed-field irradiations were both performed on a newly-developed “pelletron” beamline at Idaho State University's Research and Innovation in Science and Engineering (RISE) complex and at the University of Maryland's 250 kW Training Reactor (MUTR). The sensors were irradiated to 6 different fluences (ranging from 1 to 100 dpa), followed by intensive characterization using focused ion beam (FIB), transmission electron microscopy (TEM) and scanning electron microscopy (SEM) to investigate the physical deformation and microstructural changes between different fluence levels, to provide high-resolution information regarding the material performance. Computer modeling (SRIM/TRIM) was employed to simulate damage to the sensor as well as to provide significant information concerning the penetration depth of the ions into the material.

Corrosion protection of PVD and paint coatings for selective solar absorber surfaces

The selective solar absorber surface is a fundamental part of a solar thermal collector, as it is responsible for the solar radiation absorption and for reduction of radiation heat losses. The surface’s optical properties, the solar absorption (á) and the emittance (å), have great impact on the solar thermal collector efficiency. In this work, two coatings types were studied: coatings obtained by physical vapor deposition (PVDs) and coatings obtained by projection with different paints (PCs) on aluminum substrates. The most common industrial high performing solar selective absorbers are nowadays produced by vacuum deposition methods, showing some disadvantages, such as lower durability, lower resistance to corrosion, adhesion and scratch, higher cost and complex production techniques. Currently, spectrally selective paints are a potential alternative for absorbing surfaces in low temperature applications, with attractive features such as ease of processing, durability and commercial availability with low cost. Solar absorber surfaces were submitted to accelerated ageing tests, specified in ISO 22975-3. This standard is applicable to the evaluation of the long term behavior and service life of selective solar absorbers for solar collectors working under typical domestic hot water system conditions. The studied coatings have, in the case of PVDs solar absorptions between 0.93 and 0.96 and emittance between 0.07 and 0.10, and in the case of PCs, solar absorptions between 0.91 and 0.93 and emittance between 0.40 and 0.60. In addition to evaluating long term behavior based on artificial ageing tests, it is also important to know the degradation mechanism of different coatings that are currently in the market. Electrochemical impedance spectroscopy (EIS) allows for the assessment of mechanistic information concerning the degradation processes, providing quantitative data as output, which can easily relate to the kinetic parameters of the system. EIS measures were carried out on Gamry FAS2 Femostat coupled with a PCL4 Controller. Two electrolytes were used, 0.5 M NaCl and 0.5 M Na2SO4, and the surfaces were tested at different immersion times up to 4 weeks. The following types of specimens have been tested: Aluminium with/without surface treatment, 3 selective paint coatings (one with a poly(urethane) binder and two with silicone binders) and 2 PVD coatings. Based on the behaviour of the specimens throughout the 4 weeks of immersion, it is possible to conclude that the coating showing the best protective properties corresponds to the selective paint coating with a polyurethane resin followed by the other paint coatings, whereas both the PVD coatings do not confer any protection to the substrate, having a deleterious effect as compared to the untreated aluminium reference.