1.3μm InGaAsP/InP应变多量子阱部分增益耦合DFB激光器

在国内首次报道了采用直接刻蚀有源区技术在应变多量子阱有源区结构基础上制作了1.3μm InGaAsP/InP部分增益耦合DFB激光器，器件采用全MOVPE生长，阈值电流10mA,边模抑制比(SMSR)大于35dB,在端面未镀膜情况下器件单纵模成品率较高。

LP-MOVPE生长的低阈值1.3μm InGaAsP/InP 压、张应变交替 MQW 激光器特性

国内首次报道了LP-MOVPE法生长高质量的高、张应变交替InGaAsP多量子阱结构的研制过程及其材料的高精度X-ray双晶摇摆衍射曲线和荧光光谱特性表征。经过双腔面镀增透射膜后，其TE模与TM模自发发射谱光强差为3dBm，呈现偏振补偿特性。

LP-MOVPE生长的1.3μmInGaAsP/InP张压应变交替MQW特性

于2010-11-23批量导入

新型结构的1.3μm GexSi（1-x）/Si MQW 波导探测器的优化设计

首次提出了一种新型的环形1.3μm Ge_xSi_(1-x)/Si波导探测器结构.器件的主体由3μm宽环形波导构成.器件的输入端是8μm宽的波导.这两部分通过劈形波导过渡连接.各部分经过优化设计,可以同时实现高的耦合效率和高内量子效率.对于器件的材料结构、电学和光学特性进行了仔细的分析与设计.结果表明,优化设计的器件其外量子效率可达28%,比已经报道的直波导探测器的外量子效率提高2～3倍.而上升下降时间仍然保持在110ps左右.

三端1.3μm InGaAsP/Inp双区共腔激光器

于2010-11-23批量导入

Fabrication of 1.3 mu m Si-based MEMS tunable optical filter

In this paper we report the fabrication of 1.3 mum Si-based MEMS tunable optical filter, by surface micromaching. Through wet etching of polyimide sacrificial layer, a tunable Fabry-Perot filter was successfully fabricated. We make the capacitance measurement of the prototype device, compare the experimental curve with the theoretical one, and explain the difference between them.

1.3 mu m GaInNAs/GaAs quantum well lasers and photodetectors

The growth of GalnNAs/GaAs quantum well (QW) has been investigated by solid-source molecular beam epitaxy (MBE). N was introduced by a dc-active plasma source. Highest N concentration of 2.6% in GaInNAs/GaAs QW was obtained, corresponding to the photoluminescence peak wavelength of 1.57 mum at 10K. The nitrogen incorporation behavior in MBE growth and the quality improvement of the QW have been studied in detail. 1.3 mum GaInNAs/GaAs SQW laser and MQW resonant-cavity enhanced photodetector have been achieved.

1.3 mu m GaInNAs/GaAs multiple-quantum-wells resonant-cavity-enhanced photodetectors

A GaInNAs/GaAs multiple quantum well (MQW) resonant-cavity enhanced (RCE) photodetector operating at 1.3 mum with the full-width at half-maximum of 5.5 nm was demonstrated. The GaInNAs RCE photodetector was grown by molecular-beam epitaxy using an ion-removed dc-plasma cell as nitrogen source. GaInNAs/GaAs MQW shows a strong exciton peak at room temperature that is very beneficial for applications in long-wavelength absorption devices. For a 100-mum diameter RCE photodetector, the dark current is 20 and 32 pA at biases of 0 and 6 V, respectively, and the breakdown voltage is -18 V. The measured 3-dB bandwidth is 308 MHz. The reasons resulting in the poor high speed property were analyzed. The tunable wavelength of 18 nm with the angle of incident light was observed.

Photoluminescence characterization of 1.3 mu m In(Ga)As/GaAs islands grown by molecular beam epitaxy

1.3 mum wavelength In(Ga)As/GaAs nanometer scale islands grown by molecular beam epitaxy (MBE) were characterized by photoluminescence (PL) and atomic force microscopy (AFM) measurements. It is shown that inhomogeneous broadening of optical emission due to fluctuation of the In0.5Ga0.5As islands both in size and in compositions can be effectively suppressed by introducing a AlAs layer and a strain reduction In0.2Ga0.8As layer overgrown on top of the islands, 1.3mum emission wavelength with narrower line-width less than 20meV at room temperature was obtained.

Normal-incident SiGe/Si MQWs photodetectors operating at 1.3 mu m

A normal-incident SiGe/Si multiple quantum wells (MQWs) photodetector was reported. The structure and fabrication process of the photodetector were introduced. The photocurrent spectra measurement showed that the response spectra was expanded to 1.3 mu m wavelength. The quantum efficiency of the photodetector was 0.1% at 1.3 mu m and 20% at 0.95 mu m.

1.3 mu m InGaAsP/InP strained layer multi-quantum-well complex-coupled distributed feedback laser

1.3 mu m strained-layer multi-quantum wells complex-coupled distributed feedback lasers with a wide temperature range of 20 to 100 degrees C are reported. The low threshold current of 10mA and high single-facet slope efficiency of 0.3mW/mA were obtained for an as cleaved device. The single mode yield was as high as 80%.

Surface morphology and optical property of 1.3 mu m In0.5Ga0.5As/GaAs self-organized quantum dots grown by MBE

Surface morphology and optical properties of 1.3 mum self-organized InGaAs/GaAs quantum dots structure grown by molecular beam epitaxy have been investigated by atomic force microscopy and photoluminescence measurements. It has been shown that the surface morphology evolution and emission wavelengths of InGaAs/GaAs QDs can be controlled effectively via cycled monolayer deposition methods due to the reduction of the surface strain. Our results provide important information for optimizing the epitaxial parameters for obtaining 1.3 mum long wavelength emission quantum dots structures. (C) 2002 Elsevier Science B.V. All rights reserved.

Microphotoluminescence investigation of InAs quantum dot active region in 1.3 mu m vertical cavity surface emitting laser structure

Microphotoluminescence (mu-PL) investigation has been performed at room temperature on InAs quantum dot (QD) vertical cavity surface emitting laser (VCSEL) structure in order to characterize the QD epitaxial structure which was designed for 1.3 mu m wave band emission. Actual and precise QD emission spectra including distinct ground state (GS) and excited state (ES) transition peaks are obtained by an edge-excitation and edge-emission (EEEE) mu-PL configuration. Conventional photoluminescence methods for QD-VCSELs structure analysis are compared and discussed, which indicate the EEEE mu-PL is a useful tool to determine the optical features of the QD active region in an as-grown VCSEL structure. Some experimental results have been compared with simulation results obtained with the aid of the plane-wave admittance method. After adjustment of epitaxial growth according to EEEE mu-PL measurement results, QD-VCSEL structure wafer with QD GS transition wavelength of 1300 nm and lasing wavelength of 1301 nm was obtained.

用1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮萃取~(46)Sc的研究

用1-苯基-3-甲基-4-苯甲酰基-5-吡唑啉酮(PMBP)做萃取剂,氯仿和环己烷为稀释剂,观察了在HCl溶液46Sc的溶剂萃取行为。实验结果表明,从10-3~10-2mol/L的HCl溶液中用PMBP-氯仿(或环己烷)能有效地萃取46Sc,萃取率可达95%以上。另外,对PMBP从HCl溶液中萃取46Sc和234Th的结果也做了比较,结果表明,通过控制水溶液中HCl的浓度,能实现234Th与46Sc的分离。