VFT performance of a 180/110 mm co-axial gap in SF6 up to 4 bar absolute

Disconnector switch operation in GIS generates VFT voltages in the system. It is important, for insulation co-ordination purposes, to obtain accurate VFT V-t data for typical gap geometries found in GIS. This paper presents experimentally obtained VFT V-t data for a 180/1 lOmm co-axial gap. The VFT has a time to first peak of 35 ns and a oscillation frequency of 13,6 MHz. Due to the location of the voltage divider in a compartment adjacent to the gap, a correction factor of 1.1 is used to relate the measured breakdown voltage to that in the gap. Positive polarity VFT V-t data is presented for 1, 2, 3 and 4 bar absolute and negative polarity VFT data for 3 and 4 bar absolute. Two methods of generating the VFT's are used. The first is to power up the test transformer at power frequency. The second is to generate a switching impulse by discharging a capacitor into the primary of the test transformer.

Don't feed the 'patent trolls': [An overhaul of the patent system is necessary to keep up with advances in technology.]

The government is sitting on its hands when an overhaul of the patent system is necessary to keep up with advances in technology in the 21st century.

Arson-associated homicide in Australia: A five year follow-up

Arson homicides are rare, representing only two percent of all homicides in Australia each year. In this study, data was collected from the AIC’s National Homicide Monitoring Program (NHMP) to build on previous research undertaken into arson-associated homicides (Davies & Mouzos 2007) and to provide more detailed analysis of cases and offenders. Over the period 1989 to 2010, there were 123 incidents of arson-associated homicide, involving 170 unique victims and 131 offenders. The majority of incidents (63%) occurred in the victim’s home and more than half (57%) of all victims were male. It was found that there has been a 44 percent increase in the number of incidents in the past decade. It is evident that a considerable proportion of the identified arson homicides involved a high degree of premeditation and planning. These homicides were commonly committed by an offender who was well known to the victim, with over half of the victims (56%) specifically targeted by the offender. This paper therefore provides a valuable insight into the nature of arson homicides and signposts areas for further investigation.

Directional synthesis of tin oxide@graphene nanocomposites via a one-step up-scalable wet-mechanochemical route for lithium ion batteries

Directional synthesis of SnO2@graphene nanocomposites via a one-step, low-cost, and up-scalable wetmechanochemical method is achieved using graphene oxide and SnCl2 as precursors. The graphene oxides are reduced to graphene while the SnCl2 is oxidized to SnO2 nanoparticles that are in situ anchored onto the graphene sheets evenly and densely, resulting in uniform SnO2@graphene nanocomposites. The prepared nanocomposites possess excellent electrochemical performance and outstanding cycling in Li-ion batteries.

SnO2 decorated graphene nanocomposite anode materials prepared via an up-scalable wet-mechanochemical process for sodium ion batteries

A facile and up-scalable wet-mechanochemical process is designed for fabricating ultra-fine SnO2 nanoparticles anchored on graphene networks for use as anode materials for sodium ion batteries. A hierarchical structure of the SnO2@graphene composite is obtained from the process. The resultant rechargeable SIBs achieved high rate capability and good cycling stability.

Smarten up! Applying market design theory to housing supply

PROBLEM Cost of delivering medium density apartments impedes supply of new and more affordable housing in established suburbs EXISTING FOCUS - Planning controls - Construction costs, esp labour - Regulation eg sustainability

Nutritional rehabilitation in cystic fibrosis: A 5 year follow-up study

Previously, we reported catch-up weight gain, growth, and improved lung function in a group of malnourished cystic fibrosis (CF) children receiving aggressive nutritional supplementation for 1 year compared with a forced expiratory volume in 1 s (FEV1)-, height-, and sex-matched comparison group receiving standard therapy. To evaluate long-term effects, the clinical progress of both groups has been studied over a 5 year period. The supplemented group (n = 10) received supplements for a median of 1.35 years to achieve nutritional rehabilitation. Compared with the nonsupplemented group (n = 14), the previously supplemented group had lower mortality (2 vs. 4, N.S.) and significantly greater weight and height z scores at 4 and 5 years. The progression of pulmonary function abnormalities as measured by FEV, and forced vital capacity (FVC) slopes was greater at 3 years in the nonsupplemented group (FEV1, p < 0.05) but no significant differences in rates of deterioration of pulmonary function were seen after 5 years in the two groups of survivors. We conclude that intensive nutritional support for 1 year has both short-and long-term effects on nutrition and growth, still evident some years after the cessation of this therapeutic modality. Supplementation for periods of longer than 1 year may produce greater gains and possibly prolong the improvement in pulmonary function observed in the earlier study. © 1992 Raven Press, Ltd., New York.

Speeding up AdaBoost Classifier with Random Projection

The development of techniques for scaling up classifiers so that they can be applied to problems with large datasets of training examples is one of the objectives of data mining. Recently, AdaBoost has become popular among machine learning community thanks to its promising results across a variety of applications. However, training AdaBoost on large datasets is a major problem, especially when the dimensionality of the data is very high. This paper discusses the effect of high dimensionality on the training process of AdaBoost. Two preprocessing options to reduce dimensionality, namely the principal component analysis and random projection are briefly examined. Random projection subject to a probabilistic length preserving transformation is explored further as a computationally light preprocessing step. The experimental results obtained demonstrate the effectiveness of the proposed training process for handling high dimensional large datasets.

A follow up MRI-based geometry and computational fluid dynamics study of carotid bifurcation

Cardiovascular disease is the leading causes of death in the developed world. Wall shear stress (WSS) is associated with the initiation and progression of atherogenesis. This study combined the recent advances in MR imaging and computational fluid dynamics (CFD) and evaluated the patient-specific carotid bifurcation. The patient was followed up for 3 years. The geometry changes (tortuosity, curvature, ICA/CCA area ratios, central to the cross-sectional curvature, maximum stenosis) and the CFD factors (Velocity distribute, Wall Shear Stress (WSS) and Oscillatory Shear Index (OSI)) were compared at different time points.The carotid stenosis was a slight increase in the central to the cross-sectional curvature, and it was minor and variable curvature changes for carotid centerline. The OSI distribution presents ahigh-values in the same region where carotid stenosis and normal border, indicating complex flow and recirculation.The significant geometric changes observed during the follow-up may also cause significant changes in bifurcation hemodynamics.

Association between aneurysm shoulder stress and abdominal aortic aneurysm expansion: A longitudinal follow-up study

Background Aneurysm expansion rate is an important indicator of the potential risk of abdominal aortic aneurysm (AAA) rupture. Stress within the AAA wall is also thought to be a trigger for its rupture. However, the association between aneurysm wall stresses and expansion of AAA is unclear. Methods and Results Forty-four patients with AAAs were included in this longitudinal follow-up study. They were assessed by serial abdominal ultrasonography and computed tomography scans if a critical size was reached or a rapid expansion occurred. Patient-specific 3-dimensional AAA geometries were reconstructed from the follow-up computed tomography images. Structural analysis was performed to calculate the wall stresses of the AAA models at both baseline and final visit. A nonlinear large-strain finite element method was used to compute the wall-stress distribution. The relationship between wall stresses and expansion rate was investigated. Slowly and rapidly expanding aneurysms had comparable baseline maximum diameters (median, 4.35 cm [interquartile range, 4.12 to 5.0 cm] versus 4.6 cm [interquartile range, 4.2 to 5.0 cm]; P=0.32). Rapidly expanding AAAs had significantly higher shoulder stresses than slowly expanding AAAs (median, 300 kPa [interquartile range, 280 to 320 kPa] versus 225 kPa [interquartile range, 211 to 249 kPa]; P=0.0001). A good correlation between shoulder stress at baseline and expansion rate was found (r=0.71; P=0.0001). Conclusion A higher shoulder stress was found to have an association with a rapidly expanding AAA. Therefore, it may be useful for estimating the expansion of AAAs and improve risk stratification of patients with AAAs.

Dark Spots, Bubbles, and Shells in the Lobes of Extragalactic Radio Sources

Based on maps of the extragalactic radio sources Cyg A, Her A, Cen A, 3C 277.3 and others, arguments are given that the twin-jets from the respective active galactic nucleus ram their channels repeatedly through thin, massive shells. The jets are thereby temporarily choked and blow radio bubbles. Warm shell matter in the cocoon shows up radio-dark through electron-scattering.

Up close and personal with those experiencing homelessness: Pharmacist involvement in a multidisciplinary healthcare team

Introduction. The Brisbane City Council holds a biannual Homeless Connect event which brings together business and community groups on one day to provide free services to people experiencing or at risk of homelessness. Pharmacists were involved in this initiative and provided health services in a multidisciplinary healthcare environment building on the lessons of previous Homeless Connect events (Chan et al, 2015) Aims. To explore pharmacists reflections on their role in a multidisciplinary healthcare team providing services at a community outreach event for those experiencing homelessness. Methods. The pharmacists (n=2) documented the types of services provided during the Homeless Connect event. A semi-structured interview was conducted post-event to investigate barriers, facilitators and changes that would be recommended for future events. Their perceptions of their role in the multidisciplinary healthcare team were also explored. Results. Primarily, the services provided included delivery of primary healthcare, advice on accessing cost effective pharmacy services and addressing medication enquiries. The pharmacists also provided moisturiser samples and health information leaflets. Interdisciplinary referrals were primarily between the pharmacists and podiatrists; no pharmacist-medical practitioner referrals occurred. The pharmacists did believe they had a positive role in this health initiative but improvements could be implemented to improve the delivery of these services in future events. Discussion. Pharmacists can play an important role in providing services to people experiencing or at risk of homelessness and the overall experience was positive for the pharmacists. They were able to integrate into a multidisciplinary healthcare team in this setting but strategies for further collaboration were identified. The possibility of involving pharmacy students in future events was identified.

Short-term responses of leaf growth rate to water deficit scale up to whole-plant and crop levels: An integrated modelling approach in maize.

Physiological and genetic studies of leaf growth often focus on short-term responses, leaving a gap to whole-plant models that predict biomass accumulation, transpiration and yield at crop scale. To bridge this gap, we developed a model that combines an existing model of leaf 6 expansion in response to short-term environmental variations with a model coordinating the development of all leaves of a plant. The latter was based on: (1) rates of leaf initiation, appearance and end of elongation measured in field experiments; and (2) the hypothesis of an independence of the growth between leaves. The resulting whole-plant leaf model was integrated into the generic crop model APSIM which provided dynamic feedback of environmental conditions to the leaf model and allowed simulation of crop growth at canopy level. The model was tested in 12 field situations with contrasting temperature, evaporative demand and soil water status. In observed and simulated data, high evaporative demand reduced leaf area at the whole-plant level, and short water deficits affected only leaves developing during the stress, either visible or still hidden in the whorl. The model adequately simulated whole-plant profiles of leaf area with a single set of parameters that applied to the same hybrid in all experiments. It was also suitable to predict biomass accumulation and yield of a similar hybrid grown in different conditions. This model extends to field conditions existing knowledge of the environmental controls of leaf elongation, and can be used to simulate how their genetic controls flow through to yield.