Síntese, caracterização e análise térmica dos sais de lítio, sódio e potássio do ácido palmítico e do seu éster etílico

Alkaline salts of the palmitic acid were synthesized and characterized from aqueous and ethanolic medium. The salts were characterized by elemental analysis (EA) and infrared spectroscopy (IR). EA and IR, being its synthesis comproved, also characterized the ethyl palmitate. All the salts and the ester were submitted to thermal analysis using thermogravimetry (TG), and differential thermal analysis (DTA) in the temperature ranging from room to 700 ºC under air dynamic atmosphere. Differential scanning calorimetry (DSC) measurements were taken from -90 ºC up to temperatures close to the starting of the decomposition temperature, determined by thermogravimetry, using heating and cooling cycles.

Estudo cinético da decomposição térmica do pentaeretritol-tetranitrado (PETN)

The pentaerythritol-tetranitrate (PETN) is a nitroether used in explosives and propellant formulations. Due to its suitable properties, PETN is used in booster manufacture. Knowing the thermal decomposition behavior of an energetic material is very important for storage and manipulation, and the purpose of this work is to study the kinetic parameters of the decomposition of PETN, compare the results with literature data and to study the decomposition activation energy differences between two crystalline forms of PETN (tetragonal and needle) by means of differential scanning calorimetry (DSC). Fourier transform infrared spectroscopy (FT-IR) is used to study the two crystalline forms.

Uso da cinza da casca do arroz (CCA) obtida da geração de energia térmica como adsorvente de Zn(II) em soluções aquosas

The removal study was conducted using 1.00 g of the rice husk ash (RHA) and 20.0 mL solution with concentrations in the range of 10-1000 mg/L of Zn(II). The influence of contact time, initial metal concentration, agitation and pH of the removal process was investigated. Superior removals to 95% were obtained at the end of 24 h of contact. The agitation increased in 20% the removal of Zn(II), being needed only 5 min to reach the equilibrium. The adsorption process was studied by the models of isotherms of Langmuir, Freundlich and BET, obtaining results of R L and 1/n for a process favorable of adsorption. BET isotherm best represents the equilibrium adsorption. The results showed that the RHA has the largest capacity and affinity for the removal of Zn(II).

Argilas como catalisadores verdes na esterificação do colesterol: caracterização espectroscópica e identificação de polimorfos por métodos de análise térmica. Uma proposta laboratorial interdisciplinar para o 1º ciclo universitário

A laboratory experiment that enables the professor to introduce the problematic of sustainable development in pharmaceutical chemistry to undergraduate students is proposed, using a simple synthetic procedure. Cholesteryl acetate is prepared by the esterification of cholesterol using Montmorillonite K10 as heterogeneous catalyst. Cholesterol and cholesteryl acetate are characterized by spectroscopic (¹H RMN, 13C RMN, FTIR) and thermal analysis techniques. The thermal methods are used to introduce the concepts of polymorphism and the nature of mesophases.

Análise térmica aplicada à caracterização da sinvastatina em formulações farmacêuticas

Thermogravimetry (TG) and differential scanning calorimetry (DSC) are used in pharmaceutical studies for drugs characterization, purity, formulations compatibility, polymorphism identification, stability evaluation, and thermal decomposition of drugs and pharmaceutical formulations. Simvastatin showed fusion at 138.5 ºC and thermal stability up to 248 ºC. Simvastatin was incompatible with preservative excipient butylhydroxyanisole (BHA) performing a process of crystal amorphization. The drug showed morphological polymorphism, where it has the same unit cell but with different crystal habits according to the recrystallization solvent.

Estudo das condições de estocagem do bagaço de cana-de-açúcar por análise térmica

An evaluation was made of the properties of sugarcane bagasse during the storage process for subsequent burning in a boiler. Samples of bagasse were collected over a period of 150 days from the Caeté sugar mill (MG) at various points of the stockpile soon after the sugarcane was pressed to extract its juice, as well as from natural bagasse, dry and damp. Thermal analyses of the samples were carried out and the results indicated that, during the storage of bagasse, dry or damp, the biomass loses up to 32% of its calorific power, due to decomposition of the hemicellulose.

Análise térmica aplicada a fármacos e formulações farmacêuticas na indústria farmacêutica

Several matters of the pharmaceutical demonstrate the great importance of thermal analysis application, especially TG and DSC for the pharmaceutical industry future, namely: characterization of the drugs with the thermal events definition, in studies of drug purity, in the polymorphs identification, in compatibility studies of solid dosage pharmaceutical formulations, in drugs and pharmaceutical formulations thermal stability, and in determination of shelf life for isothermal degradation kinetics by extrapolation using the Arrhenius equation. Thus, the test results obtained from thermal analysis are directly related to the quality of a pharmaceutical product, whether the stability or bioavailability of the pharmaceutical product.

Efeitos da história térmica nas propriedades do polímero pet: um experimento para ensino de análise térmica

Polyethilenetherephtalate (PET) is commonly used in manufacturing of beverage bottles representing a didactic appeal in thermal analysis education due to its presence in the student's day life. Additionally such polymer presents well defined thermal analytical curves and a well known thermal behavior. TGA curve is used to present the thermal stability. The thermal history effects in the thermal properties of a PET sample from a soft drink bottle are used to demonstrate the effect of different heating/cooling conditions on glass transition, melting, crystallization and crystalline degree using DSC curves.

O efeito da desativação térmica nas propriedades oxirredutoras e na atividade catalítica de catalisadores CZ e Pd-CZ

Automotive catalyst, using in Brazil since 1992, is a essential technology for vehicular emissions control. Noble metals are the active phase of these catalysts, and cerium zirconium mixed oxides (CZ), responsibles for the oxygen storage capacity (OSC), one of the most important aspect for the operational performance of the catalyst. In this context, the oxireduction properties analysis of CZ and Pd/CZ (palladium supported in CZ) system are the objective of this study, as well as, the impact of the thermal aging in the OSC. Aging consisted of treatments at 900 or 1200 °C, for 12 or 36 h, in oxidizing condition.

Desenvolvimento e uso do compósito de Nb2O5|Cu como revestimento aplicado por aspersão térmica sobre o aço AISI 1020 para proteção contra a corrosão pelo solo em estruturas enterradas

An Nb2O|Cu corrosion-resistant coating was developed and applied onto AISI 1020 steel substrate by Powder Flame Spray. A galvanostatic electrochemical technique was employed, with and without ohmic drop, in four different soils (two corrosively aggressive and two less aggressive). Behavior of coatings in different soils was compared using a cathodic hydrogen reduction reaction (equilibrium potential, overvoltage and exchange current density) focusing on the effect of ohmic drop. Results allow recommendation of Nb2O5|Cu composite for use in buried structure protection.

Estudo comparativo entre as metodologias eschka, infravermelho, condutividade térmica (TCD) e ultravioleta para a determinação de enxofre total em combustíveis sólidos

The oxidation of sulphur compounds upon burning emits large quantities of SOx into the atmosphere. Therefore, there is growing interest in fast and accurate methods for analyzing sulphur content in fuels. The objective of this work was to compare four different methods of total sulphur determination in solid fuels. The methods used in this work were Eschka, Infrared, Thermal Conductivity Detection (TCD) and Ultraviolet Fluorescence Detection (UV). The preliminary results showed that TCD and UV methods (nonstandard methods for solid fuels) have similar precision to the infrared method (standard method) for high-sulphur coal samples.

Inovação & propriedade industrial & indústria química

ABSTRACT The main aim of this paper was to contribute to reflections in Brazil on the need to transfer knowledge held at universities and R&D institutions over to companies, i.e. to transfer scientific knowledge of chemistry to technology. It discusses how the competitiveness of countries is increasingly dependent on their technological capacity. The chemicals industry is a fundamental driver of social, environmental, economic and industrial indicators of sustainable development. In Brazil, the chemicals industry's deficit has grown over the last three decades. Patents are important sources of information because patent documents contain 75% of all technological information available. The National Institute of Industrial Property in Brazil has created a Technology Observatory with the purpose of identifying and analyzing technological information contained in patent documents within the ambit of partnerships with government entities or business associations, in order to support their technology-related decision-making processes. The paper gives examples of ethanol and biotechnology patent documents, including pharmaceuticals, of which there are very few in Brazil. However, a few of the patent applications identified are filed in Brazil, giving the country the opportunity to transform this scientific knowledge into technology by means of partnership agreements with companies. Finally, the paper presents information on the patent applications filed by the world's leading chemicals companies as measured by their revenues, and the respective numbers of patent applications in the last five years in organic chemistry and polymers, sectors in which Brazil is currently dependent on imports for over 50% of its needs. The patent assignees in these sectors in Brazil are also identified, and the paper concludes that Brazil needs to invest in the development of professionals, providing clearly-defined career paths in technology innovation teams at R&D institutions, and to foster more initiatives such as the creation of a new research and innovation entity, EMBRAPII, since investing in science and technology is a prerequisite for knowledge production, industrial property, economic development and, consequently, the competitiveness of the country.

Panorama de propriedade intelectual, transferência de tecnologia e inovação da química brasileira e a comparação com os países do BRIC

Based on Science, Technology & Innovation (ST&I) indicators, Brazil is a competitive and interesting country from the point of view of technological foreign investment. However, it is still incipient with regard to national investments, production of technological knowledge, inbound mobility of scientists and technology transfer to the productive sector. Among many other factors, global patent production is considered as an important indicator of innovation. Likewise, the balance between revenue and expenses obtained through royalties and licensing fees of technologies is also critical in mapping the diffusion and absorption of knowledge. The understanding of intellectual property and its strategic management brings a significant advantage to the economic and technological development of nations, especially in the field of chemistry, which greatly contributes to biotechnology, new materials and microelectronics - three fundamental areas for innovation in developed countries. Therefore, this article aims to map out competencies in chemistry in Brazil and evaluate science, technology and innovation indicators in the country, comparing this dynamic to the one of other BRIC members (Russia, India and China). Chemistry is the fourth biggest field of interest in Brazil based on the number of researchers registered at the governmental platform for researchers, Plataforma Lattes/CNPq, and is preceded by education, medicine and agronomy. The majority of research groups are registered in the area of materials, followed by macromolecules and polymers, pharmaceutical products and basic materials chemistry. These groups represent approximately 77% of research groups analyzed, therefore, indicating a tendency in the country. The analyses of patents in different sub-areas of chemistry reveal that non-residents file most deposits in the country, a probable reflection of the low internal intellectual property culture. Pharmaceutics and Fine Chemistry are prominent areas in the country, in line with the global trend. Among BRIC countries, China has the highest number of patents and of requests for protection in international offices. On the other hand, Brazil has the lowest number of chemical patents published at USPTO, EPO and JPO. An analysis of the transfer of technology data indicates an increase in this activity in various sub-areas of chemistry in the country. Despite the great efforts made by the country to consolidate its national innovation system, more needs to be done to put Brazil in a competitive position. In a globalized world dominated by large players, Brazil needs a lot of progress on ownership and generation of chemistry technologies to strengthen its national sovereignty. It is essential to strengthen chemical research at all levels, from elementary school to university, as an inexhaustible source of knowledge and technology that, when properly protected, may generate real public achievement and social return.