Fins and Fin Rays from Whale Shark (Rhiniodon typus Smith)

The whale shark (Rhiniodon typus Smith) is an under exploited species and it is mainly caught for its liver oil . The processing of shark fin for rays is reported here . The fins have a high content of rays . The yield of fin rays from undried fins ranged from 0 .53 to 4 .40 percent with maximum ray content in the lower lobe of caudal fin . The physical and chemical characteristics of the rays are reported . The total nitrogen content is about 15 to 16 percent (dry weight basis)

Optimization of pH and Direct Imaging Conditions of Complexed Methylene Blue Sensitized Poly(vinyl chloride) Films

Significant results of our experimental investigations on the dependence of pH on real time transmission characteristics on recording media fabricated by doping PVC with complexed methylene blue are presented. The optimum pH value for faster bleaching was found to be 4×5. In typical applications, the illumination from one side, normal to the surface of this material, initiates a chemical sequence that records the incident light pattern in the polymer. Thus direct imaging can be successfully done on this sample. The recorded letters were very legible with good contrast and no scattering centres. Diffraction efficiency measurements were also carried out on this material.

Swelling behaviour of isora/natural rubber composites in oils used in automobiles

Natural rubber/isora fibre composites were cured at various temperatures. The solvent swelling characteristics of natural rubber composites containing both untreated and alkali treated fibres were investigated in aromatic and aliphatic solvents like toluene, and n-hexane. The diffusion experiments were conducted by the sorption gravimetric method. The restrictions on elastomer swelling exerted by isora fibre as well as the anisotropy of swelling of the composite have been confirmed by this study. Composite cured at 100°C shows the lowest percentage swelling. The uptake of aromatic solvent is higher than that of aliphatic solvent for the composites cured at all temperatures. The effect of fibre loading on the swelling behaviour of the composite was also investigated in oils like petrol, diesel, lubricating oil etc. The % swelling index and swelling coefficient of the composite were found to decrease with increase in fibre loading. This is due to the increased hindrance exerted by the fibres at higher fibre loadings and also due to the good fibre-rubber interactions. Maximum uptake of solvent was observed with petrol followed by diesel and then lubricating oil. The presence of bonding agent in the composites restrict the swelling considerably due to the strong interfacial adhesion. At a fixed fibre loading, the alkali treated fibre composite showed lower percentage swelling compared to the untreated one.

Optimization of pH and direct imaging conditions of complexed methylene blue sensitized poly(vinyl chloride) films

Significant results of our experimental investigations on the dependence of pH on real time transmission characteristics on recording media fabricated by doping PVC with complexed methylene blue are presented. The optimum pH value for faster bleaching was found to be 4 . 5. In typical applications, the illumination from one side, normal to the surface of this material, initiates a chemical sequence that records the incident light pattern in the polymer. Thus direct imaging can be successfully done on this sample. The recorded letters were very legible with good contrast and no scattering centres. Diffraction efficiency measurements were also carried out on this material.

Anisotropy in elastic properties of lithium sodium sulphate hexahydrate single crystal—An ultrasonic study

The double sulfate family (ABSO4), where A and B are alkali metal cations, is the object of great interest owing to the complexity and richness of its sequence of phase transition induced by temperature variation. A new sulfate salt characterized by the presence of water molecule in the unit cell with the chemical formula, Li2Na3(SO4)2⋅6H2O (LSSW), was obtained. The ultrasonic velocity measurement was done with pulse echo overlap technique [PEO]. All the six second order elastic stiffness constants, C11 = C22, C33, C44 = C55, C12, C14 and C13 = C23 are reported for the first time. The anisotropy in the elastic properties of the crystal are well explained by the pictorial representation of the polar plots of phase velocity, slowness, Young’s modulus and linear compressibility in a–b and a–c planes.

Effects of Thermal Modifications on the Rheological Characteristics and Protein Quality of Three Species of Fish of Varying Collagen Content

School of Industrial Fisheries, Cochin University of Science and Technology

Iron Promoted Sulphated Zirconia Systems as Efficient Catalysts for Phenol Hydroxylation

The present work investigates on the applicability of metal promoted sulphated zirconia catalysts for the hydroxylation of phenol under mild conditions. The percentage conversion and product distribution was highly sensitive towards the reaction parameters like the catalyst composition, reaction temperature, H202/ phenol ratio and the solvent used.

Characteristics of laser-induced plasma from highTc superconductor

The spectroscopic analysis of the emission from the plasma produced by irradiating a highT c superconducting GdBa2Cu3O7 target with a high power Nd:YAG laser beam shows the existence of the bands from different oxides in addition to the lines from neutrals and ions of the constituent elements. The spectral emissions by oxide species in laser-induced plasma show considerable time delays as compared to those from neutral and ionic species. Recombination processes taking place during the cooling of the hot plasma, rather than the plasma expansion velocities, have been found to be responsible for the observed time delays in this case. The decays of emission intensities from various species are found to be non-exponential.

Screen printed nanosized ZnO thick film

Nanosized ZnO was prepared by polyol synthesis. Fluorescence spectrum of the ZnO colloid at varying pump intensities was studied. The powder was extracted and characterized by XRD and BET. The extracted powder was screen printed on glass substrates using ethyl cellulose as binder and turpinol as solvent. Coherent back scattering studies were performed on the screen printed sample which showed evidence of weak localization. The screen printed pattern showed strong UV emission.

Damage threshold determination of bulk polymer samples using pulsed photothermal deflection technique

Photothermal deflection technique was used for determining the laser damage threshold of polymer samples of teflon (PTFE) and nylon. The experiment was conducted using a Q-switched Nd-YAG laser operating at its fundamental wavelength (1-06μm, pulse width 10 nS FWHM) as irradiation source and a He-Ne laser as the probe beam, along with a position sensitive detector. The damage threshold values determined by photothermal deflection method were in good agreement with those determined by other methods.

Ferrofluid thin films as optical gaussmeters proposed for field and magnetic moment sensing

Ferrofluids belonging to the series, Ni x Fe1-x Fe2O4 and Zn x Fe1-x Fe2O4, were synthesized using cold co-precipitation. Liquid films of these ferrofluids were prepared by encapsulating the ferrofluids in between two optically smooth and ultrasonically cleaned glass plates. Magnetic field induced laser transmission through these ferrofluid films has been investigated. Magnetic field values can be calibrated in terms of output laser power in the low field region in which the variation is linear. This set up can be used as a cheap optical gaussmeter in the low field regime. Using the same set-up, the saturation magnetization of the sample used can also be calculated with a sample that is pre-characterized. Hence both magnetization of the sample, as well as applied magnetic field can be sensed and calculated with a precalibrated sample.

Biochemical & Pharmacological evaluation of liver oils of selected deep sea sharks and chimaeras of the Indian EEZ

With a seacoast of 8,1 18 km, an exclusive economic zone (EEZ) of 2 million square km, and with an area of about 30,000 square km under aquaculture, lndia produces close to six million tonnes of fish, over 4 per cent of the world fish production. While the marine waters upto 50m depth have been fully exploited, those beyond, remain unexplored. There is an ever increasing demand for fishery resources as food. The coastal fishery resources of the country are dwindling at a rapid pace and it becomes highly imperative that we search for alternate fishery resources for food. The option we have is to hunt for marine fishery resources. Studies pertaining to proximate composition, amino acid and fatty acid composition are essential to understand the nutraceutical values of these deep sea fishery resources. The present study was aimed to carry out proximate composition of deep sea fishery resources obtained during cruises onboard the FORV Sarise Sampada, to identify fishery resources which have appreciable lipid content and thereby analyse the bioactive potentials of marine lipids, to study the amino acid profile of these fishery resources, to understand the contents of SPA, MUFA and PUFA and to calculate the n3/n6 fatty acid contents. Though the presence of nutraceuticals was identified in the marine fishery resources their use as potential food resources deserve further investigation. So the study were carried out to calculate the hepatosomatic indices of sharks & chimaeras and conduct biochemical characterisation of liver oils of Apristurus indicus, Cenlrophorus scalprams, Centroselachus crepidater, Neoharriotta raleighana, and Harriotta pinnata obtained during cruises onboard the FORV Sugar Sampada.Therapeutic use of shark liver oil is evident from its use for centuries as a remedy to heal wounds and fight flu (Neil er al. 2006). Japanese seamen called it 'samedava' or "cure all". Shark liver oil is being promoted worldwide as a dietary supplement to boost the immune system, fight infections, to treat cancer and to lessen the side effects of conventional cancer treatment. These days more emphasis is laid on the nutritive benefits of shark liver oils especially on the omega 3 polyunsaturated fatty acids ( PUFAs) (Anandan er al. 2007) and alkylglycerols (AKGs) (Pugliese er al. I998) contained in them due to the high rise of inflammatory disorders such as arthritis, asthma and neurodegenerative diseases like Alzheimer’s, Parkinson’s and Schizophrenia. So the present study also evaluate the pharmacological properties with respect to analgesic, anti-inflammatory, anti pyretic and anti-ulcer effects of four different liver oils of sharks belonging to the Indian EEZ and to identify the components of oil responsible for these activities.The analgesic and anti-inflammatory activities of liver oils from Neoharriotra raleighana (NR), Centrosymnus crepidater (CC), Apristurus indicus (AI), and Centrophorus sculpratus (CS) sharks caught from the Arabian Sea and the Indian Ocean were compared. The main objectives also include determination of the cholesterol lowering effects of liver oils of Neoharriotra raleighana (NR) and Centrophorus sculpratus (CS) on the high fat diet induced dyslipidemia and to compare the impact of four isolipidemic diets, on levels of serum diagnostic marker enzymes, on lipid profile of blood and liver and antioxidant status of heart in male Albino rats. And also to study the efficacy of Centrophorus sculpratus (CS) liver oil against Complete Freund’s Adjuvant-induced arthritis and to compare the anti-inflammatory activity of this oil with a traditionally used anti-inflammatory substance gingerol (oleoresin extracted from ginger.). The results of the present study indicated that both (Centrophorus sculpratus liver oils as well as gingerol extracts proved to be effective natural remedies against CFA-induced arthritis in Albino rats.

Studies on the utilization of selected species of Sharks

This thesis Entitled Studies on the Utilization of selected Species of sharks. The present study is the result of work carried out for 5 years, during the period from April, 1983 to March 1988. The materials were collected from the catches of the Government of India vessels, operated along the south west coast of India and landed in the Integrated Fisheries Project, Cochin—16. The sharks were caught by different types of gears such as bottom trawls, pelagic trawls, long line etc. A number of species of sharks were landed during this period and three species were selected for the present study namely Scoliodon palasorra (bleeker 1853, grey Shark), Carcharhinus limbatus (valenciennes 1839,black tip shark ) and centrophorus granulosus (bloch and schneider 1801 ,spiny shark). During this study period the quantity of shark utilized was 12,55,942 kg out of which 9.71% used for the production of Dressed shark; 36.21% for the production of Fillets; 49.09% converted into Dried shark and 4.99% was domesticallyy marketed as whole form. Besides this 526 kg of dried shark fin and 289.25 kg of shark fin rays were produced.The effect of Smoking of shark fillets and minced meat at different temperature were also studied during this period. Canning of cooked shark meat, smoked fillets and fish balls were carried out in media like brine, vegetable oil, tomato sauce etc. The quality of smoked fillets in vegetable oil was found superior to other canned products from shark meat.During this study an attempt was also made to evaluate the commercial processing of shark resources and found feasible.

On the optical and electrical properties of rf and a.c. plasma polymerized aniline thin films

Polyaniline is a widely studied conducting polymer and is a useful material in its bulk and thin film form for many applications, because of its excellent optical and electrical properties. Pristine and iodine doped polyaniline thin films were prepared by a.c. and rf plasma polymerization techniques separately for the comparison of their optical and electrical properties. Doping of iodine was effected in situ. The structural properties of these films were evaluated by FTIR spectroscopy and the optical band gap was estimated from UV-vis-NIR measurements. Comparative studies on the structural, optical and electrical properties of a.c. and rf polymerization are presented here. It has been found that the optical band gap of the polyaniline thin films prepared by rf and a.c. plasma polymerization techniques differ considerably and the band gap is further reduced by in situ doping of iodine. The electrical conductivity measurements on these films show a higher value of electrical conductivity in the case of rf plasma polymerized thin films when compared to the a.c. plasma polymerized films. Also, it is found that the iodine doping enhanced conductivity of the polymer thin films considerably. The results are compared and correlated and have been explained with respect to the different structures adopted under these two preparation techniques

Evaluation of a.c. conductivity of rubber ferrite composites from dielectric measurements

The effect of frequency, composition and temperature on the a.c. electrical conductivity were studied for the ceramic, Ni1–xZnxFe2O4, as well as the filler (Ni1–xZnxFe2O4) incorporated rubber ferrite composites (RFCs). Ni1–xZnxFe2O4 (where x varies from 0 to 1 in steps of 0×2) were prepared by usual ceramic techniques. They were then incorporated into a butyl rubber matrix according to a specific recipe. The a.c. electrical conductivity (sa.c.) calculations were carried out by using the data available from dielectric measurements and by employing a simple relationship. The a.c. conductivity values were found to be of the order of 10–3 S/m. Analysis of the results shows that sa.c. increases with increase of frequency and the change is same for both ceramic Ni1–xZnxFe2O4 and RFCs. sa.c. increases initially with the increase of zinc content and then decreases with increase of zinc. Same behaviour is observed for RFCs too. The dependence of sa.c. on the volume fraction of the magnetic filler was also studied and it was found that the a.c. conductivity of RFCs increases with increase of volume fraction of the magnetic filler. Temperature dependence of conductivity was studied for both ceramic and rubber ferrite composites. Conductivity shows a linear dependence with temperature in the case of ceramic samples