9 resultados para 1-HEXYL-4-ETHYLOCTYL ISOPROPYLPHOSPHONIC ACID

em Doria (National Library of Finland DSpace Services) - National Library of Finland, Finland


Relevância:

100.00% 100.00%

Publicador:

Resumo:

Artikkeli sisältää Sosiologipäivien 22 työryhmäraporttia sosiologian eri aloilta

Relevância:

100.00% 100.00%

Publicador:

Resumo:

kuv., 10 x 20 cm

Relevância:

100.00% 100.00%

Publicador:

Resumo:

B12-vitamiinin puute iäkkäillä: laboratoriodiagnostiikka, yleisyys ja yhteys sairastavuuteen Tausta: B12-vitamiinin puute on yleistä iäkkäillä ja se tulisi todeta riittävän varhaisessa vaiheessa palautumattomien vaurioiden estämiseksi. On epäselvää pitäisikö diagnostiikka kohdistaa tiettyihin riskiryhmiin vai mahdollisesti seuloa valikoimatonta vanhusväestöä. Myöskään yksimielisyyttä laboratoriotutkimusten valinnasta ei ole. Tavoitteet: Tutkimuksen tarkoituksena oli evaluoida uutta HoloTC RIA menetelmää ja tuottaa viitearvot sille, selvittää B12-vitamiinin puutteen yleisyys, yhteys sairastavuuteen ja mahdolliset riskitekijät suomalaisessa vanhusväestössä, arvioida munuaisfunktion vaikusta B12-vitamiinin puutteen laboratoriotutkimuksiin ja näiden perusteella ehdottaa suomalaiseen terveydenhuoltoon sopivaa laboratoriotutkimusstrategiaa. Aineisto ja menetelmät: Liedon iäkkäät -tutkimuksen vanhusaineisto on edustava otos yhden kunnan yli 65-vuotiaasta väestöstä, yhteensä 1260 henkilöä. Tutkittavat kävivät lääkärintarkastuksessa, ja heistä on käytettävissä runsaasti laboratoriotutkimuksia sekä tiedot sairauksista, ruokavaliosta, lääkkeiden ja vitamiinivalmisteiden käytöstä, dementiaseula ja depressiokysely. Viitearvoaineistoa varten kerättiin näytteet 84 vapaaehtoisesta terveestä aikuisesta ja menetelmäevaluaatiota varten 107 sairaalapotilaasta. Tulokset: HoloTC RIA menetelmän toistettavuus oli hyvä manuaalimenetelmäksi. 95%:n viiteväli holotranskobalamiinille oli 37-171 pmol/l. Kaikilla tutkittavilla, joilla oli muilla laboratoriotutkimuksilla osoitettu todennäköinen B12-vitamiinin puute, myös holotranskobalamiini oli viitealueen alarajaa pienempi. Suurentuneella kystatiini C-pitoisuudella osoitettu munuaisten vajaatoiminta korreloi voimakkaasti homokysteiinin (rs=0.53, p<0.001) ja metyylimalonihapon (rs=0.27, p<0.001) pitoisuuksiin, mutta ei kokonais-B12-vitamiinin (rs=- 0.04, p=0.227) tai holotranskobamiinin (rs=-0.01, p=0.817) pitoisuuksiin. Suomalaisessa vanhusväestössä B12-vitamiinin puutteen prevalenssi oli 12%. Kokonais- B12-vitamiinin pitoisuus oli matala (<150 pmol/l) 6%:lla. Miessukupuoli (OR 1.9, 95% CI 1.2-2.9), ikä ≥75 (OR 2.2, 95% CI 1.4-3.4) ja maitotuotteiden välttäminen (OR 2.3, 95% CI 1.2-4.4) lisäsivät B12-vitamiinin puutteen riskiä, mutta anemia (OR 1.3, 95% CI 0.7-2.3) tai makrosytoosi (OR 1.2, 95% CI 0.6-2.7) eivät. Päätelmät: Diagnosoimaton B12-vitamiinin puute on yleistä iäkkäillä, mutta kliinisesti merkityksellistä spesifistä riskiryhmää ei löydy. Koska anemian ja makrosytoosin puuttuminen ei poissulje B12-vitamiinin puutetta ja munuaisten vajaatoiminta heikentää metabolisten merkkiaineiden käyttökelpoisuutta, kokonais-B12-vitamiinia suositellaan ensisijaiseksi laboratoriotutkimukseksi epäiltäessä B12-vitamiinin puutetta ja tarvittaessa varmentavina tutkimuksina käytetään homokysteiiniä ja holotranskobalamiinia.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Työn tarkoituksena oli löytää kapillaarielektroforeesimenetelmä (CE), joka soveltuisi metallien neste-nesteuutossa käytettävien orgaanisten uuttofaasien koostumuksen analysointiin. Kapillaarielektroforeesissa käytetyn elektrolyyttiliuoksen analyytti-kohtaista optimointia ei tässä työssä tehty, vaan liikkeelle lähdettiin fenoleille tarkoitetulla menetelmällä. Tarkasteltavia uuttoreagenssiryhmiä olivat hydroksi-oksiimit sekä fosfiinihappo- ja fosforihappopohjaiset reagenssit. Tutkittavia kaupallisia laimentimia olivat Orfom SX 11 ja Shellsol D70. Lisäksi tutkittiin kahta modifiointiainetta, TOPOa (tri-n-oktyylifosfiinioksidi) ja TXIB:tä (2,2,4-trimetyyli-1,3-pentaanidiolidi-isobutyraatti). Työssä tavoiteltiin kapillaarielektroforeesin hyötyjä erityisesti hydrometallurgisessa teollisuudessa. Suurimpana hyötynä ennakoitiin mahdollisuus analysoida suuria molekyylejä, kuten uuttoreagenssi-metallikomplekseja, joita ei pystytä analysoimaan kaasukromatografilla (GC). Näytteet voidaan myös analysoida ilman hidasta ja usein ei-kvantitatiivista derivatisointia. Kirjallisuudesta ei löytynyt aiempia artikkeleita CE:n soveltamisesta kyseisille aiheille. Kapillaarielektroforeesianalyyseissa pystyttiin esimerkiksi havaitsemaan hydroksi-oksiimin kuparikompleksi orgaanisessa faasissa. Seulonta-ajoissa yleisenä ongelmana oli kuitenkin tulosten heikko toistettavuus. Kapillaari-elektro-foreesi-menetelmä tarjoaa selvästi mahdollisuuksia tulevaisuudessa, mutta vielä sillä ei päästy luotettavaan toistoon sähkökentän häiriöiden ja elektrolyyttiliuoksen riittämättömän optimoinnin vuoksi. Lisäksi teollisissa olosuhteissa käytetyille autenttisille hydroksioksiimi- ja fosfiinihapponäytteille tehtiin perinteisiä kaasukromatografia-analyysejä, joiden perusteella voitiin nähdä uuttofaasin koostumuksen muuttuneen prosessissa. Hapettuminen sekä eri hydrolyysireaktiot ovat tärkeimmät syyt reagenssien ja laimentimien muuttumiselle. Näitä hajoamistuotteita ei tässä työssä onnistuttu analysoimaan kapillaarielektroforeesilla.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

The consumption of manganese is increasing, but huge amounts of manganese still end up in waste in hydrometallurgical processes. The recovery of manganese from multi-metal solutions at low concentrations may not be economical. In addition, poor iron control typically prevents the production of high purity manganese. Separation of iron from manganese can be done with chemical precipitation or solvent extraction methods. Combined carbonate precipitation with air oxidation is a feasible method to separate iron and manganese due to the fast kinetics, good controllability and economical reagents. In addition the leaching of manganese carbonate is easier and less acid consuming than that of hydroxide or sulfide precipitates. Selective iron removal with great efficiency from MnSO4 solution is achieved by combined oxygen or air oxidation and CaCO3 precipitation at pH > 5.8 and at a redox potential of > 200 mV. In order to avoid gypsum formation, soda ash should be used instead of limestone. In such case, however, extra attention needs to be paid on the reagents mole ratios in order to avoid manganese coprecipitation. After iron removal, pure MnSO4 solution was obtained by solvent extraction using organophosphorus reagents, di-(2-ethylhexyl)phosphoric acid (D2EHPA) and bis(2,4,4- trimethylpentyl)phosphinic acid (CYANEX 272). The Mn/Ca and Mn/Mg selectivities can be increased by decreasing the temperature from the commonly used temperatures (40 –60oC) to 5oC. The extraction order of D2EHPA (Ca before Mn) at low temperature remains unchanged but the lowering of temperature causes an increase in viscosity and slower phase separation. Of these regents, CYANEX 272 is selective for Mn over Ca and, therefore, it would be the better choice if there is Ca present in solution. A three-stage Mn extraction followed by a two-stage scrubbing and two-stage sulfuric acid stripping is an effective method of producing a very pure MnSO4 intermediate solution for further processing. From the intermediate MnSO4 some special Mn- products for ion exchange applications were synthesized and studied. Three types of octahedrally coordinated manganese oxide materials as an alternative final product for manganese were chosen for synthesis: layer structured Nabirnessite, tunnel structured Mg-todorokite and K-kryptomelane. As an alternative source of pure MnSO4 intermediate, kryptomelane was synthesized by using a synthetic hydrometallurgical tailings. The results show that the studied OMS materials adsorb selectively Cu, Ni, Cd and K in the presence of Ca and Mg. It was also found that the exchange rates were reasonably high due to the small particle dimensions. Materials are stable in the studied conditions and their maximum Cu uptake capacity was 1.3 mmol/g. Competitive uptake of metals and acid was studied using equilibrium, batch kinetic and fixed-bed measurements. The experimental data was correlated with a dynamic model, which also accounts for the dissolution of the framework manganese. Manganese oxide micro-crystals were also bound onto silica to prepare a composite material having a particle size large enough to be used in column separation experiments. The MnOx/SiO2 ratio was found to affect significantly the properties of the composite. The higher the ratio, the lower is the specific surface area, the pore volume and the pore size. On the other hand, higher amount of silica binder gives composites better mechanical properties. Birnesite and todorokite can be aggregated successfully with colloidal silica at pH 4 and with MnO2/SiO2 weight ratio of 0.7. The best gelation and drying temperature was 110oC and sufficiently strong composites were obtained by additional heat-treatment at 250oC for 2 h. The results show that silica–supported MnO2 materials can be utilized to separate copper from nickel and cadmium. The behavior of the composites can be explained reasonably well with the presented model and the parameters estimated from the data of the unsupported oxides. The metal uptake capacities of the prepared materials were quite small. For example, the final copper loading was 0.14 mmol/gMnO2. According to the results the special MnO2 materials are potential for a specific environmental application to uptake harmful metal ions.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Invokaatio: D.A.G.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Invokaatio: D.D.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

In the last decades, the chemical synthesis of short oligonucleotides has become an important aspect of study due to the discovery of new functions for nucleic acids such as antisense oligonucleotides (ASOs), aptamers, DNAzymes, microRNA (miRNA) and small interfering RNA (siRNA). The applications in modern therapies and fundamental medicine on the treatment of different cancer diseases, viral infections and genetic disorders has established the necessity to develop scalable methods for their cheaper and easier industrial manufacture. While small scale solid-phase oligonucleotide synthesis is the method of choice in the field, various challenges still remain associated with the production of short DNA and RNA-oligomers in very large quantities. On the other hand, solution phase synthesis of oligonucleotides offers a more predictable scaling-up of the synthesis and is amenable to standard industrial manufacture techniques. In the present thesis, various protocols for the synthesis of short DNA and RNA oligomers have been studied on a peracetylated and methylated β-cyclodextrin, and also on a pentaerythritol-derived support. On using the peracetylated and methylated β-cyclodextrin soluble supports, the coupling cycle was simplified by replacement of the typical 5′-O-(4,4′-dimethoxytrityl) protecting group with an acid-labile acetal-protected 5′-O-(1-methoxy-1-methylethyl) group, which upon acid-catalyzed methanolysis released easily removable volatile products. For this reason monomeric building blocks 5′-O-(1-methoxy-1-methylethyl) 3′-(2-cyano-ethyl-N,N-diisopropylphosphoramidite) were synthesized. Alternatively, on using the precipitative pentaerythritol support, novel 2´-O-(2-cyanoethyl)-5´-O-(1-methoxy-1-methylethyl) protected phosphoramidite building blocks for RNA synthesis have been prepared and their applicability by the synthesis of a pentamer was demonstrated. Similarly, a method for the preparation of short RNAs from commercially available 5´-O-(4,4´-dimethoxytrityl)-2´-O-(tert-butyldimethyl-silyl)ribonucleoside 3´-(2-cyanoethyl-N,N-diisopropylphosphoramidite) building blocks has been developed