Development of a modified flyash as a permeable reactive barrier media for a former manufactured gas plant site Northern Ireland

A sequential biological permeable reactive barrier (PRB) was determined to be the best option for remediating groundwater that has become contaminated with a wide range of organic contaminants (i.e., benzene, toluene, ethylbenzene, xylene and polyaromatic hydrocarbons), heavy metals (i.e., lead and arsenic), and cyanide at a former manufactured gas plant after 150 years of operation in Portadown, Northern Ireland. The objective of this study was to develop a modified flyash that could be used in the initial cell within a sequential biological PRB to filter complex contaminated groundwater containing ammonium. Flyash modified with lime (CaOH) and alum was subjected to a series of batch tests which investigated the modified cation exchange capacity (CEC) and rate of removal of anions and cations from the solution. These tests showed that a high flyash composition medium (80%) could remove 8.65 mol of ammonium contaminant for every kilogram of medium. The modified CEC procedure ruled out the possibility of cation exchange as the major removal mechanism. The medium could also adsorb anions as well as cations (i.e., Pb and Cr), but not with the same capacity. The initial mechanism for Pb and Cr removal is probably precipitation. This is followed by sorption, which is possibly the only mechanism for the removal of dichromate anions. Scanning electron microscopic analysis revealed very small (

An approach to determine the local boundary of small disturbance voltage stability region in a cut-set power space:基于微扰的割集电压稳定域局部边界求解方法

A new approach to determine the local boundary of voltage stability region in a cut-set power space (CVSR) is presented. Power flow tracing is first used to determine the generator-load pair most sensitive to each branch in the interface. The generator-load pairs are then used to realize accurate small disturbances by controlling the branch power flow in increasing and decreasing directions to obtain new equilibrium points around the initial equilibrium point. And, continuous power flow is used starting from such new points to get the corresponding critical points around the initial critical point on the CVSR boundary. Then a hyperplane cross the initial critical point can be calculated by solving a set of linear algebraic equations. Finally, the presented method is validated by some systems, including New England 39-bus system, IEEE 118-bus system, and EPRI-1000 bus system. It can be revealed that the method is computationally more efficient and has less approximation error. It provides a useful approach for power system online voltage stability monitoring and assessment. This work is supported by National Natural Science Foundation of China (No. 50707019), Special Fund of the National Basic Research Program of China (No. 2009CB219701), Foundation for the Author of National Excellent Doctoral Dissertation of PR China (No. 200439), Tianjin Municipal Science and Technology Development Program (No. 09JCZDJC25000), National Major Project of Scientific and Technical Supporting Programs of China During the 11th Five-year Plan Period (No. 2006BAJ03A06). ©2009 State Grid Electric Power Research Institute Press.

The development of University Technology Transfer stakeholder relationships at a regional level: Lessons for the future

The increasing importance placed upon regional development and the knowledge-based economy as economic growth stimuli has led to a changing role for Universities and their interaction with the business community through (though not limited to) the transfer of technology from academia to industry. With the emergence of Local Enterprise Partnerships (LEPs) replacing the Regional Development Agencies (RDAs), there is a need for policy and practice going forward to be clearly informed by a critique of TTO (Technology Transfer Office)–RDA stakeholder relationship in a lessons learned approach so that LEPs can benefit from a faster learning curve. Thus, the aim of this paper is to examine the stakeholder relationship between three regional universities in the context of its TTO and the RDA with a view to determining lessons learned for the emerging LEP approach. Although the issues raised are contextual, the abstracted stakeholder conceptualisation of the TTO–RDA relationship should enable wider generalisation of the issues raised beyond the UK. Stakeholder theory relationship and stage development models are used to guide a repeat interview study of the TTO and RDA stakeholder groupings. The findings, interpreted using combined category and stage based stakeholder models, show how the longitudinal development of the TTO–RDA stakeholder relationship for each case has progressed through different stakeholder pathways, and stages where specific targeting of funding was dependant on the stakeholder stage. Greater targeted policy and funding, based on the stakeholder relationship approach, led to the development of joint mechanisms and a closer alignment of performance measures between the TTO and the RDA. However, over-reliance on the unitary nature of the TTO–RDA relationship may lead to a lack of cultivation and dependency for funding from other stakeholders.

An exploration of business model development in the commercialization of technology innovations

Research on business model development has focused on the relationships between elements of value conceptualization and organization having a linear sequence in which business models are first designed and then implemented. Another stream of research points to business model development with these elements interacting in a cyclical manner. There is a need to improve our understanding of the connective mechanisms and dynamics involved in business model development, particularly from the challenging perspective of commercializing innovations. The aim of this paper was to explore business model development during the commercialization of innovations through a case-based qualitative study. This study found from four case studies that specific elements of business model development, representative of the conceptualization of value and organizing for value creation, integrate in a dynamic and cyclical process in the commercialization of technology innovations. The study provides empirical evidence that adds new insights to literature on sequential and more interactive processes of business model development. It also contributes to literature on business model development and particularly how it relates to the commercialization of innovations.

Development and evaluation of a novel integrated anti-icing/de-icing technology for carbon fibre composite aerostructures using an electro-conductive textile

The preliminary evaluation is described of a new electro-thermal anti-icing/de-icing device for carbon fibre composite aerostructures. The heating element is an electro-conductive carbon-based textile (ECT) by Gorix. Electrical shorting between the structural carbon fibres and the ECT was mitigated by incorporating an insulating layer formed of glass fibre plies or a polymer film. A laboratory-based anti-icing and de-icing test program demonstrated that the film-insulated devices yielded better performance than the glssass fibre insulated ones. The heating capability after impact damage was maintained as long as the ECT fabric was not breached to the extent of causing electrical shorting. A modified structural scarf repair was shown to restore the heating capacity of a damaged specimen.