Fuzzy-logic based frequency controller for wind farms augmented with energy storage systems

Displacement of conventional synchronous generators by non-inertial units such as wind or solar generators will result in reduced-system inertia affecting under-frequency response. Frequency control is important to avoid equipment damage, load shedding, and possible blackouts. Wind generators along with energy storage systems can be used to improve the frequency response of low-inertia power system. This paper proposes a fuzzy-logic based frequency controller (FFC) for wind farms augmented with energy storage systems (wind-storage system) to improve the primary frequency response in future low-inertia hybrid power system. The proposed controller provides bidirectional real power injection using system frequency deviations and rate of change of frequency (RoCoF). Moreover, FFC ensures optimal use of energy from wind farms and storage units by eliminating the inflexible de-loading of wind energy and minimizing the required storage capacity. The efficacy of the proposed FFC is verified on the low-inertia hybrid power system.

Design and flight testing of an integrated solar powered UAV and WSN for greenhouse gas monitoring emissions in agricultural farms

There is an increased interest in measuring the amount of greenhouse gases produced by farming practices . This paper describes an integrated solar powered Unmanned Air Vehicles (UAV) and Wireless Sensor Network (WSN) gas sensing system for greenhouse gas emissions in agricultural lands. The system uses a generic gas sensing system for CH4 and CO2 concentrations using metal oxide (MoX) and non-dispersive infrared sensors, and a new solar cell encapsulation method to power the unmanned aerial system (UAS)as well as a data management platform to store, analyze and share the information with operators and external users. The system was successfully field tested at ground and low altitudes, collecting, storing and transmitting data in real time to a central node for analysis and 3D mapping. The system can be used in a wide range of outdoor applications at a relatively low operational cost. In particular, agricultural environments are increasingly subject to emissions mitigation policies. Accurate measurements of CH4 and CO2 with its temporal and spatial variability can provide farm managers key information to plan agricultural practices. A video of the bench and flight test performed can be seen in the following link: https://www.youtube.com/watch?v=Bwas7stYIxQ

Shared leadership in Queensland schools : a collective case study

Shared leadership has been identified as a key governance base for the future of government and Catholic schools in Queensland, the state’s two largest providers of school education. Shared leadership values the contributions that many individuals can make through collaboration and teamwork. It claims to improve organisational performance and reduce the increasing pressures faced by principals. However despite these positive features, shared leadership is generally not well understood, not well accepted and not valued by those who practice or study leadership. A collective case study method was chosen, incorporating a series of semi-structured interviews with principals and the use of official school documents. The study has explored the current understanding and practice of shared leadership in four Queensland schools and investigated its potential for use.

On collective unintelligence

The idea of collective unintelligence is examined in this paper to highlight some of the conceptual and practical problems faced in modeling groups. Examples drawn from international crises and economics provide illustrative problems of collective failures to act in intelligent ways, despite the inputs and efforts of many skilled and intelligent parties. Choices made of “appropriate” perceptions, analysis and evaluations are examined along with how these might be combined. A simple vector representation illustrates some of the issues and creative possibilities in multi-party actions. Revealed as manifest (un-)intelligence are the resolutions of various problems and potentials that arise in dealing with the “each and all” of a group (wherein items are necessarily non-parallel and of unequal valency). Such issues challenge those seeking to model collective intelligence, but much may be learned.

Models of collective cell spreading with variable cell aspect ratio : a motivation for degenerate diffusion models

Continuum diffusion models are often used to represent the collective motion of cell populations. Most previous studies have simply used linear diffusion to represent collective cell spreading, while others found that degenerate nonlinear diffusion provides a better match to experimental cell density profiles. In the cell modeling literature there is no guidance available with regard to which approach is more appropriate for representing the spreading of cell populations. Furthermore, there is no knowledge of particular experimental measurements that can be made to distinguish between situations where these two models are appropriate. Here we provide a link between individual-based and continuum models using a multi-scale approach in which we analyze the collective motion of a population of interacting agents in a generalized lattice-based exclusion process. For round agents that occupy a single lattice site, we find that the relevant continuum description of the system is a linear diffusion equation, whereas for elongated rod-shaped agents that occupy L adjacent lattice sites we find that the relevant continuum description is connected to the porous media equation (pme). The exponent in the nonlinear diffusivity function is related to the aspect ratio of the agents. Our work provides a physical connection between modeling collective cell spreading and the use of either the linear diffusion equation or the pme to represent cell density profiles. Results suggest that when using continuum models to represent cell population spreading, we should take care to account for variations in the cell aspect ratio because different aspect ratios lead to different continuum models.

Manipulating task constraints to improve tactical knowledge and collective decision-making in rugby union

In team sports such as rugby union, a myriad of decisions and actions occur within the boundaries that compose the performance perceptual- motor workspace. The way that these performance boundaries constrain decision making and action has recently interested researchers and has involved developing an understanding of the concept of constraints. Considering team sports as complex dynamical systems, signifies that they are composed of multiple, independent agents (i.e. individual players) whose interactions are highly integrated. This level of complexity is characterized by the multiple ways that players in a rugby field can interact. It affords the emergence of rich patterns of behaviour, such as rucks, mauls, and collective tactical actions that emerge due to players’ adjustments to dynamically varying competition environments. During performance, the decisions and actions of each player are constrained by multiple causes (e.g. technical and tactical skills, emotional states, plans, thoughts, etc.) that generate multiple effects (e.g. to run or pass, to move forward to tackle or maintain position and drive the opponent to the line), a prime feature in a complex systems approach to team games performance (Bar- Yam, 2004). To establish a bridge between the complexity sciences and learning design in team sports like rugby union, the aim of practice sessions is to prepare players to pick up and explore the information available in the multiple constraints (i.e. the causes) that influence performance. Therefore, learning design in training sessions should be soundly based on the interactions amongst players (i.e.teammates and opponents) that will occur in rugby matches. To improve individual and collective decision making in rugby union, Passos and colleagues proposed in previous work a performer- environment interaction- based approach rather than a traditional performer- based approach (Passos, Araújo, Davids & Shuttleworth, 2008).

Adventure as the metaphoric basis for constructing a narrative to defuse a collective critical incident

This article describes an exercise in collective narrative practice, built around the metaphor of adventure. This metaphor helped to scaffold the development of stories of personal agency for a group of Australian primary school children whose teachers were afraid they might be traumatised by events which occurred during a school excursion. During the excursion, the group of 110 Year 5 and 6 school children had their accommodation broken into on two separate occasions and various belongings stolen. The very brief period made available for ‘debriefing’ was used to introduce the metaphor of adventure, and open up space for the children to begin constructing a story in which they were ‘powerful’, as an alternative to the story of powerlessness and victimhood in which they were initially caught up.

Information literacy research : dimensions of the emerging collective consciousness

Information literacy researchers are beginning to develop a collective consciousness, a consciousness that represents the newly appearing territory of information literacy research. This paper analyses the information literacy research territory as it is represented by the emerging collective consciousness of information literacy researchers. Five dimensions of the collective consciousness are proposed: 1) the sectoral location of the research, 2) ways of seeing information literacy, 3) ‘what’ is being investigated; that is the research object, 4) ‘how’ the object is being investigated; that is the research approaches and paradigms, and 5) disciplinary influences. These dimensions are used to: 1) reveal the character of the information literacy research territory which is in early stages of construction; 2) show how different kinds of research approaches can shed different kinds of light on the object of research; and 3) demonstrate how the five dimensions work together in the development of new studies.

Tensions in developing a secure collective information practice : the case of Agile Ridesharing

Many current HCI, social networking, ubiquitous computing, and context aware designs, in order for the design to function, have access to, or collect, significant personal information about the user. This raises concerns about privacy and security, in both the research community and main-stream media. From a practical perspective, in the social world, secrecy and security form an ongoing accomplishment rather than something that is set up and left alone. We explore how design can support privacy as practical action, and investigate the notion of collective information-practice of privacy and security concerns of participants of a mobile, social software for ride sharing. This paper contributes an understanding of HCI security and privacy tensions, discovered while “designing in use” using a Reflective, Agile, Iterative Design (RAID) method.

Models of collective cell motion for cell populations with different aspect ratio : diffusion, proliferation and travelling waves

Continuum, partial differential equation models are often used to describe the collective motion of cell populations, with various types of motility represented by the choice of diffusion coefficient, and cell proliferation captured by the source terms. Previously, the choice of diffusion coefficient has been largely arbitrary, with the decision to choose a particular linear or nonlinear form generally based on calibration arguments rather than making any physical connection with the underlying individual-level properties of the cell motility mechanism. In this work we provide a new link between individual-level models, which account for important cell properties such as varying cell shape and volume exclusion, and population-level partial differential equation models. We work in an exclusion process framework, considering aligned, elongated cells that may occupy more than one lattice site, in order to represent populations of agents with different sizes. Three different idealizations of the individual-level mechanism are proposed, and these are connected to three different partial differential equations, each with a different diffusion coefficient; one linear, one nonlinear and degenerate and one nonlinear and nondegenerate. We test the ability of these three models to predict the population level response of a cell spreading problem for both proliferative and nonproliferative cases. We also explore the potential of our models to predict long time travelling wave invasion rates and extend our results to two dimensional spreading and invasion. Our results show that each model can accurately predict density data for nonproliferative systems, but that only one does so for proliferative systems. Hence great care must be taken to predict density data for with varying cell shape.

Is social entrepreneurship the way forward? The case of the livingin collective

Social entrepreneurship can be conceived generally as a creative force born to address emergent or longstanding unfulfilled community needs occurring within or across the non-profit, business or government sectors. In this paper, we consider the current case study of a collective comprising a non-profit community organisation, pro-bono design group and university researchers and its attempts to negotiate the tension between social innovation and social entrepreneurship in order to address the lack of suitable options for independent living for individuals with disabilities and their families. With much of the developed world coming to terms with a rapidly aging population, and increased survival rates for individuals with disabilities, there has never been a more opportune time to consider work such as this which attempts to address social and market gaps in a socially innovative and inclusive way.