More is not necessarily better. A biomechanical study on distal screw numbers in volar locking distal radius plates

INTRODUCTION: Currently available volar locking plates for the treatment of distal radius fractures incorporate at least two distal screw rows for fixation of the metaphyseal fragment and have a variable-angle locking mechanism which allows placement of the screws in various directions There is, however no evidence that these plates translate into better outcomes or have superior biomechanical properties to first generation plates, which had a single distal screw row and fixed-angle locking. The aim of our biomechanical study was to compare fixed-angle single-row plates with variable-angle multi-row plates to clarify the optimal number of locking screws. MATERIALS AND METHODS: Five different plate-screw combinations of three different manufacturers were tested, each group consisting of five synthetic fourth generation distal radius bones. An AO type C2 fracture was created and the fractures were plated according to each manufacturer's recommendations. The specimens then underwent cyclic and load-to-failure testing. An optical motion analysis system was used to detect displacement of fragments. RESULTS: No significant differences were detected after cyclic loading as well as after load-to-failure testing, neither in regard to axial deformation, implant rigidity or maximum displacement. The fixed-angle single-row plate showed the highest pre-test rigidity, least increase in post-testing rigidity and highest load-to-failure rigidity and least radial shortening. The radial shortening of plates with two distal screw rows was 3.1 and 4.3 times higher, respectively, than that of the fixed-angle single-row plate. CONCLUSION: The results of our study indicate that two distal screw rows do not add to construct rigidity and resistance against loss of reduction. Well conducted clinical studies based on the findings of biomechanical studies are necessary to determine the optimal number of screws necessary to achieve reproducibly good results in the treatment of distal radius fractures.

Using neo-Piagetian theory, formative in-Class tests and think alouds to better understand student thinking : a preliminary report on computer programming

It is acknowledged around the world that many university students struggle with learning to program (McCracken et al., 2001; McGettrick et al., 2005). In this paper, we describe how we have developed a research programme to systematically study and incrementally improve our teaching. We have adopted a research programme with three elements: (1) a theory that provides an organising framework for defining the type of phenomena and data of interest, (2) data on how the class as a whole performs on formative assessment tasks that are framed from within the organising framework, and (3) data from one-on-one think aloud sessions, to establish why students struggle with some of those in-class formative assessment tasks. We teach introductory computer programming, but this three-element structure of our research is applicable to many areas of engineering education research.

The magic of numbers and the amazing disappearing act : the politics of counting youth homelessness

No-one wants to see young people who are no longer able to stay at home with their parents living in situations that are neither stable nor safe. Most Australians also appreciate that youth homelessness is typically a result of factors beyond the control of young people like poverty, lack of affordable housing, parental divorce or separation, family conflict and violence, sexual abuse, or mental health problems.1 Since the Burdekin Report of 1989 first put the issue on the national agenda, youth homelessness has been a point of some political sensitivity as the numbers of young homeless stayed stubbornly high through the 1990s and into the 2000s.

Mobility of the creative class and city attractiveness : a case study of Chinese animation workers

Abstract: The paper investigates the geographical mobility of creative workers in China,focusing on the authors’ survey of workers in the animation industry. More specifically,the authors use the Reilly-Converse model and GIS tools to probe the locational choices of Chinese animation workers in Beijing and Shanghai by analyzing such factors of spatial attractiveness as home town, place of residence, and university from which the worker graduated. The paper compares the creative milieus in Beijing and Shanghai, and demonstrates that the “personal trajectory” of human capital is a key determinant of occupational location. The results of the authors’ survey highlight the limitations of Richard Florida’s 3T theory in the Chinese context.

The interface of the national Australian curriculum and the pre-Year 1 class in school : exploring tensions

The Australian state -based educational system of a national school curriculum that includes a pre-Year 1 Foundation Year has raised questions about the purpose of this year of early education. A document analysis was undertaken across three Australian states, examining three constructions of the pre-Year 1 class and tensions arising from varied perspectives. Tensions have emerged over state-based adaptations of the national curriculum, scripted pedagogies for change management, differing ideological perspectives and positioning of stakeholders. The results indicate that since 2012 there has been a shift in constructions of the pre-Year 1 class towards school-based ideologies, especially in Queensland. Accordingly, positioning of children, parents and teachers has also changed. These results resonate with previous international indications of ‘schooling’ early education. The experiences of Australian early adopters of the curriculum offer insights for other jurisdictions in Australia and internationally, and raise questions about future development in early years education.

Effect of Reynolds numbers on flow past four square cylinders in an in-line square configuration for different gap spacings

In this paper two-dimensional (2-D) numerical investigation of flow past four square cylinders in an in-line square configuration are performed using the lattice Boltzmann method. The gap spacing g=s/d is set at 1, 3 and 6 and Reynolds number ranging from Re=60 to 175. We observed four distinct wake patterns: (i) a steady wake pattern (Re=60 and g=1) (ii) a stable shielding wake pattern (80≤Re≤175 and g=1) (iii) a wiggling shielding wake pattern (60≤Re≤175 and g=3) (iv) a vortex shedding wake pattern (60≤Re≤175 and g=6) At g=1, the Reynolds number is observed to have a strong effect on the wake patterns. It is also found that at g=1, the secondary cylinder interaction frequency significantly contributes for drag and lift coefficients signal. It is found that the primary vortex shedding frequency dominates the flow and the role of secondary cylinder interaction frequency almost vanish at g=6. It is observed that the jet between the gaps strongly influenced the wake interaction for different gap spacing and Reynolds number combination. To fully understand the wake transformations the details vorticity contour visualization, power spectra of lift coefficient signal and time signal analysis of drag and lift coefficients also presented in this paper.

A class B switch-mode assisted linear amplifier

A switch-mode assisted linear amplifier (SMALA) combining a linear (Class B) and a switch-mode (Class D) amplifier is presented. The usual single hysteretic controlled half-bridge current dumping stage is replaced by two parallel buck converter stages, in a parallel voltage controlled topology. These operate independently: one buck converter sources current to assist the upper Class B output device, and a complementary converter sinks current to assist the lower device. This topology lends itself to a novel control approach of a dead-band at low power levels where neither class D amplifier assists, allowing the class B amplifier to supply the load without interference, ensuring high fidelity. A 20 W implementation demonstrates 85% efficiency, with distortion below 0.08% measured across the full audio bandwidth at 15 W. The class D amplifier begins assisting at 2 W, and below this value, the distortion was below 0.03%. Complete circuitry is given, showing the simplicity of the additional class D amplifier and its corresponding control circuitry.

A class E resonant inverter for use as electronic fluorescent lamp ballast

Class E Resonant Inverters are theoretically capable of delivering any power to a load and achieve 100% efficiency at any frequency of operation. In practice efficiency in the “high 90's” can be achieved into megahertz frequencies regardless of inverter output powers. The topology also allows the manipulation of output power through sub-optimal operation, with a negligible efficiency penalty. The 24W inverter discussed in this paper was specifically designed to harness the benefits, and discuss the shortcomings, of the Class E topology for use in the growing market for portable, battery powered lighting. It exhibits a peak recorded power efficiently of over 98%, and a conservatively measured efficiency of 95% across a range of dimming settings.

Exploiting Web 2.0 technologies to forge live connectedness in class

The economics of supporting learning has seen institutional encouragement of a wide range of blended learning initiatives in face to face and online teaching and learning. This has become one of the key drivers for the adoption of technology in teaching, in a manner occassionally guilty of putting the cart before the horse. Learning spaces are increasingly equipped with a dizzying array of technological options testifying to institutional and governmental investment and commitment in supporting face to face blended learning (QUT, 2011, C/4.2). Yet innovation within traditional learning and teaching models faces a number of challenges both at an institutional level and at the teaching coal face. Web 2.0 technologies present a vast array of opportunities to harness and capture the attention of students in engaging learning opportunitites. This presentation will explore technologies supportive of active learning pedagogies.

The use of Facebook in tertiary education : case study of a unit-related Facebook page in a university justice class

Purpose – This study aims to evaluate the usefulness of a university unit Facebook page, which was established to support a first-year university justice unit. The study pays particular regard to the Facebook page's impact on students learning outcomes and communications amongst students and between students and teaching staff. Design/methodology/approach – All students enrolled in the unit were asked to complete an online survey, which sought to determine whether they used the unit Facebook page and if so, the nature and extent of their use. Findings – The study found that the unit Facebook page was useful in achieving most learning objectives for the unit. This included enhancing students' knowledge and understanding of unit content, as well as their ability to critically analyse unit materials. Students also indicated that they found the Facebook page better than the university's central learning management system across a range of areas. It was particularly useful for facilitating unit-related discussions. Research limitations/implications – The survey results reported in this paper are based on a relatively small sample of students (n=67) from a first-year university justice unit. Future studies should seek to garner evidence from broader and larger samples that transcend specific unit populations. However, the findings of this study do indicate further support for the use of Facebook as a supplementary tool in university education. Originality/value – This study focuses on two aspects of social networking technologies that have not been previously researched and thus contributes to the growing literature on the uses and benefits of Facebook in tertiary education.

A CLASS act : the teaching team approach to subject coordination

Advancing the development of good practice around the teaching team has been the focus of a recently completed, nationally funded Australian grant entitled Coordinators Leading Advancement of Sessional Staff (CLASS). The project focused on developing leadership capacity of subject coordinators to provide supportive contexts for sessional staff to enhance their knowledge of teaching practice and contribute to subject improvement through a team approach. An action learning approach and notions of distributed leadership underpinned the activities of the teaching teams in the program. This paper provides an overview of a practical approach, led by the subject coordinator, to engaging sessional staff through the facilitation of a supportive network within the teaching team. It addresses some of the gaps identified in the recent literature which includes lack of role clarity for all members of the team and provides some examples of initiatives that teams engaged with to address some of the challenges identified. Resources to support this approach were developed and are shared through the project website. Recommendations for future direction include improved policy and practice at the institutional level, better recognition and reward for subject coordinators and resourcing to support the participation and professional development needs of sessional staff.

'In the Room' and 'School Chemistry Class'

Two poems in journal Axon. 2013 Issue 4.

Theoretical and practical issues in team teaching a large undergraduate class

Attempts by universities to provide an improved learning environment to students have led to an increase in team-teaching approaches in higher education. While the definitions of team-teaching differ slightly, the benefits of team-teaching have been cited widely in the higher education literature. By tapping the specialist knowledge of a variety of staff members, students are exposed to current and emerging knowledge in different fields and topic areas; students are also able to understand concepts from a variety of viewpoints. However, while there is some evidence of the usefulness of team-teaching, there is patchy empirical support to underpin how well students appreciate and adapt to team-teaching approaches. This paper reports on the team-teaching approaches adopted in the delivery of an introductory journalism and communication course at the University of Queensland. The success of the approaches is examined against the background of quantitative and qualitative data. The study found that team-teaching is generally very well received by undergraduate students because they value the diverse expertise and teaching styles they are exposed to. Despite the positive feedback, students also complained about problems of continuity and cohesiveness.