Use of 3D printed materials as tissue-equivalent phantoms

This study used the specific example of 3D printing with acrylonitrile butadiene styrene (ABS) as a means to investigate the potential usefulness of benchtop rapid prototyping as a technique for producing patient specific phantoms for radiotherapy dosimetry. Three small cylinders and one model of a human lung were produced via in-house 3D printing with ABS, using 90%, 50%, 30% and 10% ABS infill densities. These phantom samples were evaluated in terms of their geometric accuracy, tissue equivalence and radiation hardness, when irradiated using a range of clinical radiotherapy beams. The measured dimensions of the small cylindrical phantoms all matched their planned dimensions, within 1mm. The lung phantom was less accurately matched to the lung geometry on which it was based, due to simplifications introduced during the phantom design process. The mass densities, electron densities and linear attenuation coefficients identified using CT data, as well as the results of film measurements made using megavoltage photon and electron beams, indicated that phantoms printed with ABS, using infill densities of 30% or more, are potentially useful as lung- and tissue-equivalent phantoms for patient-specific radiotherapy dosimetry. All cylindrical 3D printed phantom samples were found to be unaffected by prolonged radiation and to accurately match their design specifications. However, care should be taken to avoid oversimplifying anatomical structures when printing more complex phantoms.

Environmental efficiency of energy, materials, and emissions

This study estimates the environmental efficiency of international listed firms in 10 worldwide sectors from 2007 to 2013 by applying an order-m method, a non-parametric approach based on free disposal hull with subsampling bootstrapping. Using a conventional output of gross profit and two conventional inputs of labor and capital, this study examines the order-m environmental efficiency accounting for the presence of each of 10 undesirable inputs/outputs and measures the shadow prices of each undesirable input and output. The results show that there is greater potential for the reduction of undesirable inputs rather than bad outputs. On average, total energy, electricity, or water usage has the potential to be reduced by 50%. The median shadow prices of undesirable inputs, however, are much higher than the surveyed representative market prices. Approximately 10% of the firms in the sample appear to be potential sellers or production reducers in terms of undesirable inputs/outputs, which implies that the price of each item at the current level has little impact on most of the firms. Moreover, this study shows that the environmental, social, and governance activities of a firm do not considerably affect environmental efficiency.

Mentors’ personal attributes for enhancing their mentees’ primary science teaching

Problems can occur in mentoring relationships if there is a “lack of mentoring skills on the part of the mentor” (Soutter, Kerr - Roubicek & Smith, 2000, p. 6), which includes the effectiveness of mentor’s personal attributes. There is little Australian research that analyses primary teachers’ personal attributes for mentoring; hence this study aims to examine preservice teachers’ perceptions of their mentors’ personal attributes. Specifically, this study focuses on mentors’ personal attributes in relation to their mentoring of primary science teaching....

Mentors and modelling primary science teaching practices

Introduction There are concerns about the science performance of Australian primary school students (Good rum, Hackling & Rennie, 2001), which requires a “major set of initiatives that focus on teacher beliefs and practices in the teaching and learning of science” (Sharpley, Tytler & Conley, 2000, p. 1). The science education community is calling for a “new approach” to science education in American schools, with an approach where a “mentor models, then coaches, then scaffolds, and then gradually fades scaffolding” (Barab & Hay, 2001, pp. 74, 90). The mentor, as modeller of practice, appears to be a key factor for enhancing science teaching, which may assist towards implementing science education reform

A review of benchmarking in carbon labelling schemes for building materials

As one of the largest sources of greenhouse gas (GHG) emissions, the building and construction sector is facing increasing pressure to reduce its life cycle GHG emissions. One central issue in striving towards reduced carbon emissions in the building and construction sector is to develop a practical and meaningful yardstick to assess and communicate GHG results through carbon labelling. The idea of carbon labelling schemes for building materials is to trigger a transition to a low carbon future by switching consumer-purchasing habits to low-carbon alternatives. As such, failing to change purchasing pattern and behaviour can be disastrous to carbon labelling schemes. One useful tool to assist customers to change their purchasing behaviour is benchmarking, which has been very commonly used in ecolabelling schemes. This paper analyses the definition and scope of benchmarking in the carbon labelling schemes for building materials. The benchmarking process has been examined within the context of carbon labelling. Four practical issues for the successful implementation of benchmarking, including the availability of benchmarks and databases, the usefulness of different types of benchmarks and the selection of labelling practices have also been clarified.

Teaching independent learning skills in the first year: A positive psychology strategy for promoting law student well-being

Empirical evidence in Australia and overseas has established that in many university disciplines, students begin to experience elevated levels of psychological distress in their first year of study. There is now a considerable body of empirical data that establishes that this is a significant problem for law students. Psychological distress may hamper a law student’s capacity to learn successfully, and certainly hinders their ability to thrive in the tertiary environment. We know from Self-Determination Theory (SDT), a conceptual branch of positive psychology, that supporting students’ autonomy in turn supports their well-being. This article seeks to connect the literature on law student well-being and independent learning using Self-Determination Theory (SDT) as the theoretical bridge. We argue that deliberate instruction in the development of independent learning skills in the first year curriculum is autonomy supportive. It can therefore lay the foundation for academic and personal success at university, and may be a protective factor against decline in law student psychological well-being.

Investigating sea level rise due to global warming in the teaching laboratory using Archimedes’ principle

A teaching laboratory experiment is described that uses Archimedes’ principle to precisely investigate the effect of global warming on the oceans. A large component of sea level rise is due to the increase in the volume of water due to the decrease in water density with increasing temperature. Water close to 0 °C is placed in a beaker and a glass marble hung from an electronic balance immersed in the water. As the water warms, the weight of the marble increases as the water is less buoyant due to the decrease in density. In the experiment performed in this paper a balance with a precision of 0.1 mg was used with a marble 40.0 cm3 and mass of 99.3 g, yielding water density measurements with an average error of -0.008 ± 0.011%.

Mathematics knowledge for teaching and the classroom environment

This study investigated the classroom environment in an underperforming mathematics classroom. The objectives were: (1) to investigate the classroom environment and identify influences upon it, and (2) to further explore those influences (i.e., teacher knowledge). This was completed using a diachronic case study approach in which data were gathered during lesson observations and coaching sessions. These data were analysed to describe and exemplify the classroom environment, then further described against forms of teacher knowledge. Conjectures regarding the importance of teacher knowledge of content were made which formed a base for developing a model of teacher planning and pedagogy.

A mathematical model for intermittent microwave convective (IMCD) drying of food materials

Intermittent microwave convective drying (IMCD) is an advanced technology that improves both energy efficiency and food quality in drying. Modelling of IMCD is essential to understand the physics of this advanced drying process and to optimize the microwave power level and intermittency during drying. However, there is still a lack of modelling studies dedicated to IMCD. In this study, a mathematical model for IMCD was developed and validated with experimental data. The model showed that the interior temperature of the material was higher than the surface in IMCD, and that the temperatures fluctuated and redistributed due to the intermittency of the microwave power. This redistribution of temperature could significantly contribute to the improvement of product quality during IMCD. Limitations when using Lambert's Law for microwave heat generation were identified and discussed.

Teaching children who have a diagnosis of Autism Spectrum Disorder

Best practice dictates that the Autism Spectrum Disorder (ASD) diagnostic process is informed by experienced professionals from at least two disciplines, for example psychology or speech pathology, with the diagnosis ultimately provided by a specialist medical practitioner e.g. child psychiatrist, neurologist or paediatrician. Irrespective of a child’s age, diagnosis relies upon information about their early development. Current information and observations on a child’s behaviour, communication and socialisation are considered by the specialist medical practitioner against the signs and symptoms detailed in one of several diagnostic systems. Two recently used classification systems in Australia have been the fourth edition of the Diagnostic Statistical Manual of Mental Disorders (DSM-IV) published by the American Psychiatric Association (1994) and the tenth edition of the International Classification of Disease (ICD-10), published by the World Health Organisation (2003).

BPMVM Evaluation Experiment Materials

All the materials used for our two experimental studies for evaluating the BPMVM modeller.

Australian Consumer Law Commentary and Materials [5th Ed.]

"The Australian Consumer Law came into operation on 1 January 2011 as a single national law. It replaced 17 different pieces of Commonwealth, State and Territory legislation relating to consumer protection. Its introduction meant that for the first time, consumers throughout Australia had the same rights and remedies and correspondingly, businesses had the same obligations and responsibilities towards consumers without the barrier of confusing and expensive local variations in the law. Australian Consumer Law: Commentary and Materials contains up-to-date material on the Australian Consumer Law, and in particular the fifth edition incorporates: a revised treatment of unconscionability, taking account of the changes to Part 2-2 of the ACL that became effective in 2012; other State and Federal provisions relating to unfair terms and cases such as Kakavas v Crown Melbourne, ACCC v Lux Distributors, Director of Consumer Affairs v Scully and PT Ltd v Spuds Surf; a comprehensive treatment of the impact of Google v ACCC, Forrest v ASIC and ACCC v TPG – the trilogy of decisions that provide the most recent insights into the High Court’s thinking on aspects of the prohibitions of misleading conduct in the ACL and the Corporations Act 2001; numerous decisions of note; and the possible impact of the Harper Review."--publisher website

International representations of inclusive education: How is inclusive practice reflected in the professional teaching standards of China and Australia?

Inclusive education focuses on addressing marginalisation, segregation and exclusion within policy and practice. The purpose of this article is to use critical discourse analysis to examine how inclusion is represented in the education policy and professional documents of two countries, Australia and China. In particular, teacher professional standards from each country are examined to determine how an expectation of inclusive educational practice is promoted to teachers. The strengthening of international partnerships to further support the implementation of inclusive practices within both countries is also justified.