Diesel bus emissions of submicrometer particles measured in a tunnel study

The emission factors of a bus fleet consisting of approximately three hundreds diesel powered buses were measured in a tunnel study under well controlled conditions during a two-day monitoring campaign in Brisbane. The number concentration of particles in the size range 0.017-0.7 m was monitored simultaneously by two Scanning Mobility Particle Sizers located at the tunnel’s entrance and exit. The mean value of the number emission factors was found to be (2.44±1.41)×1014 particles km-1. The results are in good agreement with the emission factors determined from steady-state dynamometer testing of 12 buses from the same Brisbane City bus fleet, thus indicating that when carefully designed, both approaches, the dynamometer and on-road studies, can provide comparable results, applicable for the assessment of the effect of traffic emissions on airborne particle pollution.

Quantification of motor vehicle emission factors from on road measurements

Assessment and prediction of the impact of vehicular traffic emissions on air quality and exposure levels requires knowledge of vehicle emission factors. The aim of this study was quantification of emission factors from an on road, over twelve months measurement program conducted at two sites in Brisbane: 1) freeway type (free flowing traffic at about 100 km/h, fleet dominated by small passenger cars - Tora St); and 2) urban busy road with stop/start traffic mode, fleet comprising a significant fraction of heavy duty vehicles - Ipswich Rd. A physical model linking concentrations measured at the road for specific meteorological conditions with motor vehicle emission factors was applied for data analyses. The focus of the study was on submicrometer particles; however the measurements also included supermicrometer particles, PM2.5, carbon monoxide, sulfur dioxide, oxides of nitrogen. The results of the study are summarised in this paper. In particular, the emission factors for submicrometer particles were 6.08 x 1013 and 5.15 x 1013 particles per vehicle-1 km-1 for Tora St and Ipswich Rd respectively and for supermicrometer particles for Tora St, 1.48 x 109 particles per vehicle-1 km-1. Emission factors of diesel vehicles at both sites were about an order of magnitude higher than emissions from gasoline powered vehicles. For submicrometer particles and gasoline vehicles the emission factors were 6.08 x 1013 and 4.34 x 1013 particles per vehicle-1 km-1 for Tora St and Ipswich Rd, respectively, and for diesel vehicles were 5.35 x 1014 and 2.03 x 1014 particles per vehicle-1 km-1 for Tora St and Ipswich Rd, respectively. For supermicrometer particles at Tora St the emission factors were 2.59 x 109 and 1.53 x 1012 particles per vehicle-1 km-1, for gasoline and diesel vehicles, respectively.

The S.T.A.B. Trial - Standardised Testing of Artificial Blood. A comparative study of various products that may be used as artificial blood for high fidelity simulation training in the critical care setting

Aim: In the current climate of medical education, there is an ever-increasing demand for and emphasis on simulation as both a teaching and training tool. The objective of our study was to compare the realism and practicality of a number of artificial blood products that could be used for high-fidelity simulation. Method: A literature and internet search was performed and 15 artificial blood products were identified from a variety of sources. One product was excluded due to its potential toxicity risks. Five observers, blinded to the products, performed two assessments on each product using an evaluation tool with 14 predefined criteria including color, consistency, clotting, and staining potential to manikin skin and clothing. Each criterion was rated using a five-point Likert scale. The products were left for 24 hours, both refrigerated and at room temperature, and then reassessed. Statistical analysis was performed to identify the most suitable products, and both inter- and intra-rater variability were examined. Results: Three products scored consistently well with all five assessors, with one product in particular scoring well in almost every criterion. This highest-rated product had a mean rating of 3.6 of 5.0 (95% posterior Interval 3.4-3.7). Inter-rater variability was minor with average ratings varying from 3.0 to 3.4 between the highest and lowest scorer. Intrarater variability was negligible with good agreement between first and second rating as per weighted kappa scores (K = 0.67). Conclusion: The most realistic and practical form of artificial blood identified was a commercial product called KD151 Flowing Blood Syrup. It was found to be not only realistic in appearance but practical in terms of storage and stain removal.

HVAC system size – getting it right

There is evidence that many heating, ventilating & air conditioning (HVAC) systems, installed in larger buildings, have more capacity than is ever required to keep the occupants comfortable. This paper explores the reasons why this can occur, by examining a typical brief/design/documentation process. Over-sized HVAC systems cost more to install and operate and may not be able to control thermal comfort as well as a “right-sized” system. These impacts are evaluated, where data exists. Finally, some suggestions are developed to minimise both the extent of, and the negative impacts of, HVAC system over-sizing, for example: • Challenge “rules of thumb��� and/or brief requirements which may be out of date. • Conduct an accurate load estimate, using AIRAH design data, specific to project location, and then resist the temptation to apply “safety factors • Use a load estimation program that accounts for thermal storage and diversification of peak loads for each zone and air handling system. • Select chiller sizes and staged or variable speed pumps and fans to ensure good part load performance. • Allow for unknown future tenancies by designing flexibility into the system, not by over-sizing. For example, generous sizing of distribution pipework and ductwork will allow available capacity to be redistributed. • Provide an auxiliary tenant condenser water loop to handle high load areas. • Consider using an Integrated Design Process, build an integrated load and energy use simulation model and test different operational scenarios • Use comprehensive Life Cycle Cost analysis for selection of the most optimal design solutions. This paper is an interim report on the findings of CRC-CI project 2002-051-B, Right-Sizing HVAC Systems, which is due for completion in January 2006.

Preventing physical activity induced heat illness in school settings

The climatic conditions of tropical and subtropical regions within Australia present, at times, extreme risk of physical activity induced heat illness. Many administrators and teachers in school settings are aware of the general risks of heat related illness. In the absence of reliable information applied at the local level, there is a risk that inappropriate decisions may be made concerning school events that incorporate opportunities to be physically active. Such events may be prematurely cancelled resulting in the loss of necessary time for physical activity. Under high or extremely high risk conditions however, the absence of appropriate modifications or continuation could place the health of students, staff and other parties at risk. School staff and other key stakeholders should understand the mechanisms of escalating risk and be supported to undertake action to reduce the level of risk through appropriate policies, procedures, resources and action plans.

Can B.I.M be civil?

After many years of development BIM (Building Information Modelling) is starting to achieve significant penetration into the building sector of the construction industry. This paper describes the current status of BIM and the drivers that are motivating the change from 2D CAD to BIM within the building sector. The paper then discusses what the implications of the technology underlying BIM may be for the civil construction sector of the construction industry. A project carried out by the Cooperative Research Centre for Construction Innovation is used as an example of this technology as well as several international examples.

Random Indexing K-tree

Random Indexing K-tree is the combination of two algorithms suited for large scale document clustering.

The role of extreme sports in lifestyle enhancement and wellness

Alternative sports are fast becoming the physical activity of choice. Participation rates are even outstripping more traditional activities such as golf. At their most extreme there is no second chance, the most likely outcome of a mismanaged error or accident is death. At this level participants enjoy activities such as B.A.S.E. (Buildings, Antennae, Space, Earth) jumping, big wave surfing, waterfall kayaking, extreme skiing, rope-free climbing and extreme mountaineering. Probably the most common explanation for participation in extreme sports is the notion that participation is just a matter of some people‟s need to take unnecessary risks. This study reports on findings that indicate a more positive experience. A phenomenological method was used via unstructured interviews with 15 extreme sports participants (ages 30 – 72 years) and other firsthand accounts. Extreme sport participants directly related their experience to personal transformations that spill over to life in general. Athletes report feelings of deep psychological wellbeing and meaningfulness. The extreme sport experience enables a participant to break through personal barriers and develop an understanding of their own resourcefulness and emotional, cognitive, physical and spiritual capabilities. Furthermore such a breakthrough also seems to trigger a change in personal philosophy or view on life. The extreme sport experience transforms a participant though not in terms of working towards an external (social or cultural) perception of identity or towards some constructed perception of an ideal self, but by touching something within.

Wellness as higher education curriculum: A comprehensive framework for health education and promotion

A number of studies in relation to the place, impact and purpose of Wellness curricula provide insight into the perceived benefits of Wellness education in university environments. Of particular note is the recommendation by many authors that curriculum design fosters personal experiences, reflective practice and active self-managed learning approaches in order to legitimise (give permission for) the adoption of wellness as a personal lifestyle approach in the frenetic pace of student life. From a broader educational perspective, Wellness education provides opportunities for students to engage in learning self regulation skills both within and beyond the context of the Wellness construct.To realise the suggested potential of Wellness education in higher learning, it is necessary that curricula overlay the principles from the domains of both self-regulation and Wellness, to highlight authentic learning as a means to lifelong approaches. Currently, however, systematic development and empirical examination of the Wellness construct have received limited academic investigation. Despite having a multitude of intended purposes from the educative to the therapy oriented goals of the original authors, most wellness models appear to be limited to the “what” of Wellness. Investigations of the “how” and “why” aspects of Wellness may serve to enhance currently existing models by incorporating behaviour modification and learning approaches in order to create more comprehensive frameworks for health education and promotion.It is also important to note that none of the current Wellness models actually address the educative framework necessary for an individual to learn and thus become aware or understand and make choices about their own Wellness.The literature reviewed within this paper would suggest that learner success is optimised by giving learners authentic opportunities to develop and practice self regulation strategies. Such opportunities include learning experiences that: provide options for self determined outcomes; require skills development; recognise principles of successful learning as outlined by the APA; and are scaffolded according to learner needs rather than in generic ways. Thus, configuring a learner centred curriculum in Wellness Education would potentially benefit from overlaying principles from the domains of both SRL and Wellness to highlight authentic learning as a means to lifelong approaches, triggered by undergraduate experiences.Student perceptions are a rich and significant data base for the measurement of their experiences, activities, practices and behaviours. Wellness undergraduate education, such as the “Fitness, Health and Wellness” unit offered by Queensland University of Technology, offers a context in which to confirm possibilities suggested by the literature reviewed in this paper in a practical, Australian context.