Forebody Compressibility Research of Hypersonic Vehicle

Three kinds of forebody model of hypersonic vehicles were studied with numerical simulation method. It shows that the two- order compressive ramp model is the best selection among the three for its good evaluative parameters value at the cowl of the inlet . This model can provide higher value of flux coefficient and total pressure recovery coefficient and lower average Mach number compared with those of the other two models . Simultaneously different compressive angles may have different effects . The configuration which the firstorder of compressive angle is 4°and the second 5°is the optimum combination. Furthermore factors such as attack angle were concerned. Better result may be obtained with a range of attack angles . Based on the work above the integrated design for forebodyPinlet of a hypersonic vehicle was performed. The numerical result shows that this integrated model provides good flow field quality for inlet and engine work.

The electron trajectory in a relativistic femtosecond laser pulse

In this report, we start from Lagrange equation and analyze theoretically the electron dynamics in electromagnetic field. By solving the relativistic government equations of electron, the trajectories of an electron in plane laser pulse, focused laser pulse have been given for different initial conditions. The electron trajectory is determined by its initial momentum, the amplitude, spot size and polarization of the laser pulse. The optimum initial momentum of the electron for LSS (laser synchrotron source) is obtained. Linear polarized laser is more advantaged than circular polarized laser for generating harmonic radiation.

Quantum trajectory analysis for electrical detection of single-electron spin resonance

A Monte Carlo simulation on the basis of quantum trajectory approach is carried out for the measurement dynamics of a single-electron spin resonance. The measured electron, which is confined in either a quantum dot or a defect trap, is tunnel coupled to a side reservoir and continuously monitored by a mesoscopic detector. The simulation not only recovers the observed telegraphic signal of detector current, but also predicts unique features in the output power spectrum which are associated with electron dynamics in different regimes.

Counterions in polyelectrolyte multilayers: A vehicle for introducing functionalities

Counterions present at the surface of polyelectrolyte multilayers were utilized for the introduction of charged species into the multilayer via ion exchange. A typical polyelectrolyte multilayer film with Na+ counterions in the outermost layer was immersed in an AgNO3 aqueous solution and the rapid ion-exchange process was complete within 1 min. The silver ions thus introduced were then reduced in situ and silver nanoparticles were produced at the surface of the multilayer assembly. This example demonstrates that the counterions naturally occurring in every polyelectrolyte multilayer film can be a convenient vehicle for the introduction of various functionalities to the film.

无人三体船试验平台的设计与实现

三体船特殊的构型使其非常适合用作水面无人平台(USV)的实验载体,本文介绍了一种自制的三体船型水面无人实验平台的系统设计、控制系统硬件以及实验结果,为以后开展三体船水动力建模、鲁棒控制方法的研究以及水面无人平台的开发提供依据。同时采用基于backstepping的控制方法对三体船进行了实验验证,实验结果表明控制方法的有效性以及平台的可靠性。

Theoretical and experimental research on time-optimal trajectory planning and control of industrial robots

提出了一种用于工业机器人时间最优轨迹规划及轨迹控制的新方法，它可以确保在关节位移、速度、加速度以及二阶加速度边界值的约束下，机器人手部沿笛卡尔空间中规定路径运动的时间阳短。在这种方法中，所规划的关节轨迹都采用二次多项式加余弦函数的形式，不仅可以保证各关节运动的位移、速度 、加速度连续而且还可以保证各关节运动的二阶加速度连续。采用这种方法，既可以提高机器人的工作效率又可以延长机器人的工作寿命以PUMA560机器人为对象进行了计算机仿真和机器人实验，结果表明这种方法是正确的有效的。它为工业机器人在非线性运动学约束条件下的时间最优轨迹规划及控制问题提供了一种较好的解决方案。

基于车体加速度反馈的轮式移动机器人轨迹跟踪控制研究

本文分析了轮式移动机器人在运行过程中由于动力学不确定性引起的力矩扰动 ,并提出了一种基于传感器的移动机器人控制方法 .在利用线加速度传感器实时测量机器人车体加速度信号的基础上 ,实现了车体加速度反馈控制 ,实验证明了该方法的有效性 .

水下机器人的神经网络自适应控制

研究了水下机器人神经网络直接自适应控制方法,采用Lyapunov稳定性理论,证明了存在有界外界干扰和有界神经网络逼近误差条件下,水下机器人控制系统的跟踪误差一致稳定有界.为了进一步验证该水控制方法的正确性和稳定性,利用水下机器人实验平台进行了动力定位实验、单自由度跟踪实验和水平面跟踪实验等验证实验.

Multi-sensors data acquisition and information fusion for manned submersible vehicle

本文介绍了一种用于载人潜水器的导航传感器的数据采集及信息融合技术。航行控制计算机通过基于工业以太网的数据通信系统对各传感器进行数据采集,采用卡尔曼滤波器完成对各传感器数据信息的融合,以便提高数据的精度和控制系统的性能,并将结果送给监控计算机,用于载人潜水器的姿态显示。