Investigation of High-Speed Combustible Gas Ignited by a Hot Gas Jet Produced in the Shock Tube

The high-speed combustible gas ignited by a hot gas jet, which is induced by shock focusing, was experimentally investigated. By use of the separation mode of shock tube, the test section of a single shock tube is split into two parts, which provide the high-speed flow of combustible gas and pilot flame of hot gas jet, respectively. In the interface of two parts of test sections the flame of jet was formed and spread to the high-speed combustible gas. Two kinds of the ignitions, 3-D “line-flame ignition” and 2-D “plane-flame ignition”, were investigated. In the condition of 3-D “lineflame ignition” of combustion, thicker hot gas jet than pure air jet, was observed in schlieren photos. In the condition of 2-D “plane-flame ignition” of combustion, the delay time of ignition and the angle of flame front in schlieren photos were measured, from which the velocity of flame propagation in the high-speed combustible gas is estimated in the range of 30–90 m/s and the delay time of ignition is estimated in the range of 0.12–0.29 ms.

Shock tube study of JP-10 ignition delay time

JP-10 (exo-tetrahydrodicyclopentadiene, C10H16) ignition delay times were measured in a preheated shock tube. The vapor pressures of the JP-10 were measured directly by using a high-precision vacuum gauge, to remedy the difficulty in determining the gaseous concentrations of heavy hydrocarbon fuel arising from the adsorption on the wall in shock tube experiments. The whole variation of pressure and emission of the OH or CH radicals were observed in the ignition process by a pressure transducer and a photomultiplier with a monochromator. The emission of the OH or CH radicals was used to identify the time to ignition. Experiments were performed over the pressure range of 151-556 kPa, temperature range of 1000-2100 K, fuel concentrations of 0.1%-0.55% mole fraction, and stoichiometric ratios of 0.25, 0.5, 1.0 and 2.0. The experimental results show that for the lower and higher temperature ranges, there are different dependency relationships of the ignition time on the temperature and the concentrations of JP-10 and oxygen.

A delay model for noise-induced bi-directional switching

Many biological systems can switch between two distinct states. Once switched, the system remains stable for a period of time and may switch back to its original state. A gene network with bistability is usually required for the switching and stochastic effect in the gene expression may induce such switching. A typical bistable system allows one-directional switching, in which the switch from the low state to the high state or from the high state to the low state occurs under different conditions. It is usually difficult to enable bi-directional switching such that the two switches can occur under the same condition. Here, we present a model consisting of standard positive feedback loops and an extra negative feedback loop with a time delay to study its capability to produce bi-directional switching induced by noise. We find that the time delay in the negative feedback is critical for robust bi-directional switching and the length of delay affects its switching frequency.

The effect of the group delay ripple of chirped fiber grating on composite second-order in optical fiber CATV system

The effect of group delay ripple of chirped fiber gratings on composite second-order (CSO) performance in optical fiber CATV system is investigated. We analyze the system CSO performances for different ripple amplitudes, periods and residual dispersion amounts in detail. It is found that the large ripple amplitude and small ripple period will deteriorate the system CSO performance seriously. Additionally, the residual dispersion amount has considerable effect on CSO performance in the case of small ripple amplitude and large ripple period. (c) 2004 Elsevier B.V. All rights reserved.

Group delay dispersion measurement of Yb : Gd2SiO5, Yb : GdYSiO5 and Yb : LuYSiO5 crystal with white-light interferometry

We report the measured group delay dispersion (GDD) of new crystals Yb:Gd2SiO5 (Yb:GSO), Yb:GdYSiO5 (Yb:GYSO) and Yb:LuYSiO5 (Yb:LYSO) over wavelengths from 1000nm to 1200nm, with a white-light interferometer. Those GDD data should be useful for the dispersion compensation for femtosecond pulse generation in the lasers with these new crystals as the gain media. (C) 2007 Optical Society of America

湖北栀子花挥发油的GC/MS分析

利用水蒸气蒸馏法从湖北栀子花鲜花中提取栀子花挥发油。通过 DB 5弹性石英毛细管柱 GC MS分析所得栀子花挥发油 ,共鉴定了 4 0个化合物并测定了其相对含量。湖北栀子花挥发油的主要成分为芳樟醇 ( 1 7 92 %)、茉莉内酯 ( 9 1 1 %)和惕各酸顺 3 己烯酯( 6 5 4 %)

除臭大蒜口服液的GC/MS分析

应用GC/MS联用技术,对除臭大蒜口服液进行了检测,定性鉴定了25种含硫有机化合物。二烯丙基硫醚、甲基烯丙基三硫醚、3-乙烯基-1,2-二硫杂-5-环己烯、2-乙烯基-1,3-二硫杂-5-环己烯和二烯丙基三硫醚是主要组分;二烯丙基四硫醚、烯丙基四硫化氢、2-和3-(2’,3’-二硫杂-5’-己烯基)-3,4-二氢-2H-噻喃、2-(2’-[3’,4’-二氢-2H噻喃基])-1,3-二硫杂-5-环己烯和3-(2’-[3’,4’-二氢-2H-噻喃基])-1,2-二硫杂-5-环己烯是次要组分。最后4种次要组分在

湖泊沉积物中邻苯二甲酸酯类的GC／MS分析

东湖沉积物阴干后用二氯甲烷溶剂萃取，用ＤＢ－５弹性石英毛细管柱ＧＣ／ＭＳ分离鉴定，并结合ｍ／ｚ１４９质量色谱图，确证东湖沉积物中含有９种邻苯二甲酸酯类化合物，它们是邻苯二甲酸二乙酯、二异丁酯、二正丁酯、二己酯、己基辛基酯、二－（２－乙基己基）酯、二辛酯、己基癸基酯和辛基癸基酯，其特征离子及峰度见表１。

自来水中非挥发性氯化产物的GC／MS分析

本文采用ＸＡＤ－２和ＸＡＤ－８（１：１）混合树脂现场富集采样，循环提取器提取，毛细管ＧＣ／ＭＳ定性的方法，通过对冬夏两季的采样分析，初步分析了某地自来（饮用）水中非挥发性有机氯化产物。从夏天自来水中检测出了２８种有机氯化合物。从冬天自来水中只检出了１种有机氯化合物。

湖北大蒜油的GC/MS研究

<正> 1 简介与实验大蒜(Allium sativun L.)系石蒜科葱属植物,世界各地均有栽培,大蒜作为民间药物广泛应用于世界各地。我国用大蒜作为药物有悠久的历史,大蒜在临床上的重要作用引起了广大化学家的重视,对大蒜的分析国内外均有报道。Stoll 等人认为大蒜的主要成分是大蒜辣素(Allicm),其结构式为 CH_2=

珍稀水生动物白暨豚油中脂肪酸的GC/MS分析

白暨豚是一种珍稀水生动物.本文报道了运用 Dexsil-300GC 毛细管柱色质联用仪,对白(?)豚油中脂肪酸进行了分析鉴定,并检测到了22种脂肪酸,其中主要脂肪酸是十四碳烯酸、十六碳烯酸和十八碳烯酸.