Effects of Graphitization on the Synthesis of Ultrafine Diamond by Explosive Detonation

金刚石的石墨化对于炸药爆轰过程中金刚石的产出率有重要的影响。对碳相图进行了讨论,提出采用金刚石2石墨的动力学平衡线来评价炸药爆轰过程中金刚石的石墨化。通过数值模拟,对炸药爆轰过程中金刚石的石墨化进行了分析和讨论。

Zernike多项式展开系数的时间相关性

分析了受大气湍流扰动的光波波前在系统接收孔径上的Zernike多项式展开系数的时间相关性,在此基础上进一步分析了从不同方向到达系统接收孔径的光波波前整体倾斜之间的相关性，并给出了光波在水平均匀大气中传播时的结果。

平面强爆震波对运动薄物体的绕射

本文用奇点分布法研究平面强爆震波对运动三维薄物体的绕射问题,并求得解析解。这个解是以前激波绕射问题Ting和Gunzburger解在强爆震波情况的推广。

圆柱壳体的弯曲蠕变屈曲

本文利用作者提出的比应力-应变方法分析了圆柱壳体的弯曲蠕变屈曲,结果与已有的实验趋向相符.根据蠕变屈曲的特点,作者建议在工程设计中采取按要求的临界时间确定可承受的载荷应力,比之通常用的给定应力预计寿命更为恰当和可取.

Two-dimensional simulation of inductive plasma sources with self-consistent power deposition

A time averaged two-dimensional fluid model including an electromagnetic module with self-consistent power deposition was developed to simulate the transport of a low pressure radio frequency inductively coupled plasma source. Comparsions with experiment and previous simulation results show, that the fluid model is feasible in a certain range of gas pressure. In addition, the effects of gas pressure and power input have been discussed.

Fission of solitary wave in stratified fluid

In this paper, we study the fission of a solitary wave in the stratified fluid with a free surface. It has been discovered that there is no difference between the fissions of the internal solitary waves in odd or even modes, and the effect of the stratification on the fission of a surface solitary wave can almost be neglected

GPS变形监测平差计算及不确定度分析

全球定位系统（GPS）是一种全天候、高精度的连续定位系统，它以速度快、方法灵活多样、操作简便等优势被广泛应用于工程测量和变形监测中。结合水厂铁矿GPS边坡变形监测实例，对GPS监测网的星历预报、基线向量平差计算、网平差计算、结果及残差不确定度进行了细致分析研究，以验证GPS技术在边坡变形监测中的可靠性和精度。

MEMS材料力学性能的测试技术

微电子机械系统（MEMS）技术的迅速崛起，推动了所用材料微尺度力学性能测试技术的发展，首先按作用方式将实验分成压痕／划痕、弯曲、拉伸、扭转四大类，系统介绍检测MEMS材料微尺度力学性能的微型试样、测试方法及其实验结果。测试材料主要有硅、氧化硅、氮化硅和一些金属。实验结果主要包括基本的力学性能参数如弹性模量、残余应力、屈服强度、断裂强度和疲劳强度等。最后，简要分析了未来的发展需求。

低能离子束方法制备Fe组分渐变的Fe-Si薄膜

利用质量分离的低能离子束技术 ,获得了Fe组分渐变的Fe Si薄膜。利用俄歇电子能谱法 (AES)、X射线衍射法 (XRD)以及X射线光电子能谱法 (XPS)测试了薄膜的组分、结构特性。测试结果表明 ,在室温下制备的Fe Si薄膜呈非晶态。非晶薄膜在 40 0℃下退火 2 0min后晶化 ,没有Fe的硅化物相形成。退火后Fe Si薄膜的Fe组分从表面向内部逐渐降低。

同轴送粉激光成形中粉末与激光的相互作用

详细介绍了同轴送粉激光成形过程中,金属粉末与激光束相互作用时间的计算方法。在ANSYS软件平台上,建立了金属粉末穿越激光束过程中粉末温度场的计算模型。系统计算了不同颗粒大小316L不锈钢粉末与不同功率激光束相互作用后的温度。在此基础上,计算了金属粉末与激光束的能量交换及金属粉末落入激光熔池后与激光熔池的能量交换。计算结果表明,在激光束直径为3 mm条件下,316L不锈钢粉末穿过功率大于1000 W的激光束后,所有尺寸金属粉末均被熔化,即金属粉末以液态进入激光熔池。通过金属粉末与激光束及激光熔池的能量交换计算,可知在激光成形中,约有5%的激光能量用于加热和熔化粉末,而大约95%的激光能量用于激光熔池的形成及由于热传导造成的热量损失。

Pulse temporal cleaner based on nonlinear ellipse rotation by using BK7 glass plate

We report a new pulse cleaning technique to enhance the contrast ratio of intense ultra-short laser pulses. A pulse temporal cleaner based on nonlinear ellipse rotation by using BK7 glass plate is developed, and a contrast ratio improvement of two orders of magnitude for the milli-joule level femtosecond input pulses is demonstrated, the total transmission efficiency of the pulse cleaner is 16.7%.

Ultrabroad infrared luminescence from Bi-doped aluminogermanate glasses

We report ultrabroad infrared luminescence from Bi-doped aluminogermanate glasses. The infrared luminescence almost covers the whole low loss wavelength region (1200-1650 nm) of silica glass fiber when excited by a diode laser at 980 nm. The full width at half maximum (FWHM) of the luminescence is 510 nm. The luminescence peak can be divided into three Gaussian peaks, and the fluorescence lifetime of the three emissions are 297 mu s, 470 mu s and 1725 mu s, respectively. These fluorescence properties indicate that the glasses are promising material for broadband optical amplifiers. (C) 2007 Elsevier Ltd. All rights reserved.