片上集成自动可调谐非对称带通滤波器

提出了具有3阶高通、2阶低通的带有自动调谐系统的有源电阻电容非对称带通滤波器结构.带通滤波器的中心频率为4.055 MHz,带宽为2.63 MHz.源阻抗为50Ω时,滤波器带内3阶交凋量为18.489 dB·m.滤波器输人参考噪声为47.91×10~(-6)V_(rms)(均方根电压).滤波器采用基于二进制搜索算法(BSA)的调谐方案,其调谐精度为(-1.65%,2.66%).调谐电路的芯片面积为0.282 mm×0.204 mm,不到主滤波器面积的1/5.调谐系统完成调谐功能后会自动关闭,降低了功耗和对主滤波器的串扰.在1.8 V电源电压下,滤波器消耗电流为1.96 mA.该滤波器已在IBM 0.18 μm标准互补金属氧化物半导体(CMOS)工艺线流片成功.

近空间升华沉积CdTe薄膜的微结构和PL谱

用近空间华法在CdS薄膜上沉积了CdTe薄膜。研究了在两种保护气氛下所沉积的多晶CdTe薄膜在后处理后的微结构、表面形貌及光致发光(PL)谱，并研究了CdTe表面的CdS/CdTe界面的P谱的区别，根据薄膜的微结构对碲化镉在太阳电池中的应用进行了讨论。

快速热退火和氢等离子体处理对富硅氧化硅薄膜微结构与发光的影响

采用micro-Raman散射、傅里叶变换红外吸收谱和光致发光谱研究了快速热退火及氢等离子体处理对等离子体增强化学气相沉积法200 ℃衬底温度下生长的富硅氧化硅（SRSO）薄膜微结构和发光的影响。研究发现在300-600 ℃范围内退火，SRSO薄膜中非晶硅和SiO_x:H两相之间的相分离程度随退火温度升高趋于减小；而在600-900 ℃范围内退火，其相分离程度退火温度升高又趋于增大；同时发现SRSO薄膜发光先是随退火温度的升高显著加强，然后在退火温度达到和超过600 ℃后迅速减弱；发光峰位在300 ℃退火后蓝移，此后随退火温度升高逐渐红移。对不同温度退火后的薄膜进行氢等离子体处理，发光强度不同程度有所增强，发光峰位有所移动，但不同温度退火样品发光增强的幅度和峰位移动的趋势不同。分析认为退火能够引起薄膜中非晶硅颗粒尺度、颗粒表面结构状态以及氢的存在和分布等方面的变化。结果表明不仅颗粒的尺度大小，而且颗粒表面的结构状态都对非晶硅颗粒能带结构和光生载流子复合机理发挥重要影响。

氢化非晶硅氧薄膜微结构

以Raman散射、X射线电子能谱和红外吸了光谱细致研究了PECVD法250℃衬底温度下制备的氢化非晶硅氧（a-SiOx:H)薄膜的微结构及键构型。研究表明，在0．52≤x≤1.58的氧含量范围内，a-SiOx:H薄膜成分和结构不是均一的，依赖于局域键构型氧化程度的不同，大致存在着5种在一定程度上相互分离的结构组分，即Si,Si2O(:H),SiO(:H),Si2O3(:H)和SiO2。其中的Si相以非氢化的非晶硅（a-Si)颗粒形式存在，随氧含量x的增加其尺度持续减小但始终存在。提出一种多壳层模型来描述a-SiOx:H薄膜的结构，认为a-SiOx:H薄膜中a-Si颗粒依次为Si2O(:H),SiO(:H),Si2O3(:H)和SiO2壳层所包围。随薄膜氧含量x的增加，各壳层厚度相应变化但各自的化学构成基本保持不变。

Resonant tunneling of holes in GaMnAs-related double- barrier structures

Using the multiband quantum transmitting boundary method (MQTBM), hole resonant tunneling through AlGaAs/GaMnAs junctions is investigated theoretically. Because of band-edge splitting in the DMS layer, the current for holes with different spins are tuned in resonance at different biases. The bound levels of the "light" hole in the quantum well region turned out to be dominant in the tunneling channel for both "heavy" and "light" holes. The resonant tunneling structure can be used as a spin filter for holes for adjusting the Fermi energy and the thickness of the junctions.

Influences of initial buffer layer deposition on electrical and optical properties in cubic GaN grown on GaAs(100) by metalorganic chemical vapor deposition

We present some results on the effect of initial buffer layer on the crystalline quality of Cubic GaN epitaxial layers grown on GaAs(100) substrates by metalorganic chemical vapor deposition. Photoluminescence and Hall measurements were performed to characterize the electrical and optical properties of cubic GaN. The crystalline quality subsequently grown high-temperature (HT) cubic GaN layers strongly depended on thermal effects during the temperature ramping process after low temperature (LT) growth of the buffer layers. Atomic force microscope (AFM) and reflection high-energy electron diffraction (RHEED) were employed to investigate this temperature ramping process. Furthermore, the role of thermal treatment during the temperature ramping process was identified. Using the optimum buffer layer, the full width at half maxim (FWHM) at room temperature photoluminescence 5.6 nm was achieved. To our knowledge, this is the best FWHM value for cubic GaN to date. The background carrier concentration was as low as 3 x 10(13) cm(-3). (C) 2000 Published by Elsevier Science S.A. All rights reserved.