156 resultados para zeolite X
Resumo:
Variations of peak position of the rocking curve in the Bragg case are measured from a Ge thin crystal near the K-absorption edge. The variations are caused by a phase change of the real part of the atomic scattering factor. Based on the measurement, the values of the real part are determined with an accuracy of better than 1%. The values are the most reliable ones among those reported values so far as they are directly determined from the normal atomic scattering factors.
Resumo:
The basic elements of Bragg-Fresnel multilayer optics are multilayer gratings. In this paper, the fabrication process for the simplest Bragg-Fresnel multilayer optics is given; the diffraction measurements at 8-keV x rays of multilayer gratings are presented; and the measurement results in the diffraction spectrum are analyzed and discussed in detail. (C) 1996 Society of Photo-Optical Instrumentation Engineers.
Resumo:
由于界面互扩散的存在,实际的超薄多层膜很难具有清晰的界面结构,假设超薄多层膜为具有周期性梯度折射率的多层膜结构,用直线模型和余弦模型模拟了周期性梯度折射率多层膜的软X射线反射率,结果证明,折射率余弦渐变的多层膜虽然不具有清晰的界面,但它同样具有很高的反射率。
Resumo:
用磁控溅射法制备了顶层分别是Mo膜层和Si膜层的两个系列的Mo/Si多层膜,它们的周期厚度相同但是膜层数各不相同。Mo/Si多层膜的周期厚度和界面粗糙度由小角X射线衍射(SAXRD)曲线拟和得到。用原子力显微镜测量了Mo/Si多层膜的表面粗糙度。在国家同步辐射实验室测量了Mo/Si多层膜的软X射线反射率。通过理论和试验研究,发现Mo/Si多层膜的软X射线反射率主要由周期数和界面粗糙度决定,表面粗糙度对Mo/Si多层膜的软X射线反射率影响较小。
Resumo:
在特定波长下,用四层结构模型模拟了Mo/Si多层膜的软X射线反射率.研究了扩散屏障层dMo-on-Si和dSi-on-Mo对Mo/Si多层膜软X射线反射率的影响.研究发现,扩散屏障层并不总是损害Mo/Si多层膜的光学性能,通过合理设计dMo-on-Si和dSi-on-Mo厚度,增加dMo-on-Si与dSi-on-Mo的比值,也能提高多层膜的软X射线反射率.
Resumo:
用磁控溅射法分别制备了以Mo膜层和Si膜层为顶层的Mo/Si多层膜系列,利用小角X射线衍射确定了各多层膜的周期厚度。以不同周期数的Mo/Si多层膜的新鲜表面近似等同于同一多层膜的内界面,通过原子力显微镜研究了多层膜界面粗糙度随膜层数的变化规律。并在国家同步辐射实验室测量了各多层膜的软X射线反射率。研究表明:随着膜层数的增加,Mo膜层和Si膜层的界面粗糙度先减小后增加然后再减小,多层膜的峰值反射率先增加后减小。
Resumo:
A study on the layer structure of W/C multilayers deposited by magnetron sputtering is reported. In the study, soft x-ray resonant reflectivity and hard x-ray grazing incidence reflectivity of the W/C multilayers were measured. The imperfections at the interface such as interdiffusion and formation of compounds were dealt with by two methods. On analyzing the experimental results, we found that the incorporation of an interlayer was a more suitable method than the traditional statistical method to describe the layer structure of a W/C system we fabricated. The optical constants of each layer at a wavelength of 4.48 nm were also obtained from the analysis. Copyright (C) 2008 John Wiley & Sons, Ltd.