The Effect of Periodic Segmentation Cracks on the Interfacial Debonding: Study on Interfacial Stresses

Hard coatings on relatively soft substrate always face the danger of debonding along the interface. Interfacial stresses are considered to be the initial driving force for the interfacial debonding of the relatively strong bonded coatings. Interfacial stresses due to the mismatch of strain between the coating and substrate are simulated with FEM firstly. The distribution of the interfacial stresses is achieved, which confirms an excessive stresses concentration near the interface end. Subsequently, the redistribution of interfacial stresses is calculated for a coating with periodic segmentation cracks. Results indicate that the distribution of interfacial stresses is altered greatly with the periodic segmentation cracks. To reveal the effect of the spacing of the periodic segmentation cracks on the distribution of interfacial stresses, different crack density is modeled within the coating. It is found that that the peak values of the interfacial stresses decrease with the increase of crack density, i.e. with reduction of spacing of segmentation cracks.

流体力学在健康工程工业中大有作为

通过简介作者的一些研究和国内同行的一些典型工作，说明健康工程中有许多急待解决的课题需要扶植.将其转化为相应的健康工程工业，潜力是巨大的，而在其中，流体力学是大有作为的.

六阶精度的群速度直接控制紧致格式及其应用

差分数值解产生非特殊振荡的直接原因是在于非均一的波群的群速度，因此本文利用直接群速度控制的方法重新构造具有六阶精度的紧致型差分格式，以达到改善激波数值解的目的。对所构造的格式的精度及数值解随控制参数变化的行为进行了分析。最后文中给出了一些典型算例，证明了文中所构造的格式具有方法简便，物理含义清楚，精度高，网格基架点小，和捕捉激波能力较强的优点。

Static shape control of repetitive structures integrated with piezoelectric actuators

In this paper, several simplification methods are presented for shape control of repetitive structures such as symmetrical, rotational periodic, linear periodic, chain and axisymmetrical structures. Some special features in the differential equations governing these repetitive structures are examined by considering the whole structures. Based on the special properties of the governing equations, several methods are presented for simplifying their solution process. Finally, the static shape control of a cantilever symmetrical plate with piezoelectric actuator patches is demonstrated using the present simplification method. The result shows that present methods can effectively be used to find the optimal control voltage for shape control.

Comparison of Various Adhesion Contact Theories and the Influence of Dimensionless Load Parameter

Three models, JKR (Johnson, Kendall and Roberts), DMT (Derjaguin, Muller, and Toporov) andMD (Maugis-Dugdale),are compared with the Hertz model in dealing with nano-contact problems. It has been shown that both the dimensionless load parameter, P D P=.1/4

从能斯特定理导不出绝对零度下热容量的零极限

证明一些文献从能斯特定理终结式导出等容热容量和等压热容量在绝对零度下的零极限limT→0CV=0和limT→0Cp=0的有关推导不成立,并证明不可能从能斯特定理或其终结式导出这些结论.但如果把普朗克的绝对熵原理作为热力学第三定律的基本表述形式,则由此可以导出等容热容量和等压热容量的零极限.

Experimental study on pore pressure in rock-soil slope during reservoir water level fluctuation

A test system was developed for measuring the pore pressure in porous media, and a new model was devised for the pore pressure testing in both saturated and unsaturated rock-soil. Laboratory experiments were carried out to determine the pore pressure during water level fluctuation. The variations of transient pore pressure vs. time at different locations of the simulated rock-soil system were acquired and processed, and meanwhile the deformation and failure of the model are observed. The experiment results show that whether the porous media are saturated or not, the transient pore pressure is mainly dependent on the water level fluctuation, and coupled with the variation of the stress field.

Experimental investigation on the chaotic phenomena in the wake of a natural thermal convection flow

Chaotic phenomena in the wake of thermal convection flow fields above a heating flat plate were investigated experimentally. A newly developed electron beam fluorescence technique (EBF) was used to simultaneously measure density fluctuation at 7 points in a cross section above the plate. Correlation dimensions, intermittence coefficients, Fourier spectrum have been obtained for different Grashof numbers. Spatial distribution of correlation dimensions are presented. The experimental result shows that there is a certain relationship between the density fluctuation and the Gr number. And time-spacial characteristic of chaos evolution is also given.

偶应力问题的非协调元分析

从偶应力弹性体势能泛函的驻值条件出发,得到了偶应力理论中非协调元体系的能量相容原理.基于其常应力(常偶应力)分片检验条件的强形式,对平面四结点单元的非协调试探内函数进行了优化,提出了一种稳定有效的非协调元方法.有限元列式中,微转动和宏观转动相等的约束条件通过罚因子的形式引入.分析了含中心圆孔的无限平板,在单轴拉伸以及纯剪状态时,偶应力的存在对孔周应力集中的影响.算例表明,该单元计算效率高,精度好,即使在材料本征长度很小时,仍然能够得到相当理想的结果.

Gal(1-x)Mn(1-x)Sb Grown on GaSb with Mass-Analyzed Low-Energy Dual Ion Beam Deposition

The Ga1-xMnxSb samples were fabricated by the implantation of Mn ions into GaSb (1 0 0) substrate with mass-analyzed low-energy dual ion beam deposition system, and post-annealing. Auger electron spectroscopy depth profile of the Ga1-xMnxSb samples showed

材料磨损与MEMS中的磨损现象

　磨损是材料和机械失效的主要原因之一。本文介绍了近年来材料磨损性能研究的进展,磨损的几种破坏机 制以及相应的磨损理论模型,并介绍了MEMS 中磨损研究的现状。

Deformation twinning and its effect on crack extension

Deformation twinning near a crack tip is observed in b.c.c. metal Mo based on molecular dynamics simulation at temperature T = 50 K and loading rate (K) over dot(II) = 0.0706 MPa m(1/2)/ps. The defor mation twinning is closely controlled by both the crystal geometry orientation and the stress distribution. The width of the deformation twin band is affected by the distance between the upper and lower crack surfaces. The twin plane and twin direction are (<1(1)over bar>2) and [(1) over bar 11], respectively. The initial crack extension occurs in the deformation twin region near the crack tip. The simulation shows that the extension direction of the crack is changed as the crack propagates over the twinning boundary.

关联参照模型和位错发射过程的分子动力学模拟

提出关联参照模型和随位错位置变化的柔性位移边界条件，提供了一个在固定位移边界条件下位错穿越边界的方法。应用三维分子动力学方法研究了体心立方(BCC)金属晶体钼理解尖发射位错的力学行为。

Elastic fields of interacting elliptic inhomogeneities

This paper presents a method for the calculation of two-dimensional elastic fields in a solid containing any number of inhomogeneities under arbitrary far field loadings. The method called 'pseudo-dislocations method', is illustrated for the solution of interacting elliptic inhomogeneities. It reduces the interacting inhomogeneities problem to a set of linear algebraic equations. Numerical results are presented for a variety of elliptic inhomogeneity arrangements, including the special cases of elliptic holes, cracks and circular inhomogeneities. All these complicated problems can be solved with high accuracy and efficiency.