A 3 Tesla Superconducting Magnet for Hall Sensor Calibration

A 3 T superconducting magnet with a 70 mm diameter warm bore and energy storage of 47 kJ has been successfully fabricated and tested, which can be used to calibrate Hall sensors in high magnetic field as well as conduct superconducting experiments. The magnet consists of three solenoid coils and an iron yoke. The homogeneity of the magnetic field in the region of interest (ROI) is +/- 6.0 x 10(-5). The coils of the magnet were fabricated with NbTi-Cu superconducting wire and the stray magnetic field is shielded by an iron yoke. The coils and yoke are fully immersed in a helium vessel. The optimized structural design, stress and quench simulation, fabrication and test results are presented in this paper.

Magnetic Field Design of the Dipole for Super-FRS at FAIR

The Super-FRS (Super FRagment Separator) is a part of FAIR (Facility for Antiproton and Ion Research), which will be constructed at GSI, Germany by 17 countries. The Super-FRS comprises 24 superferric dipole magnets. The 2D and 3D magnetic field simulations of the prototype magnet are described in this paper. A passive trim slot and four chamfered removable poles are used to satisfy the required field homogeneity which is better than +/-3 x 10(-4) at 1.6 T, 0.8 T and 0.16 T in a wide elliptical useable aperture of 380 mm x 140 mm. Measurement results at various field levels are shown in this paper as well. It can be seen from the comparison of calculation and measurement results that the magnetic designs of the magnet fulfils the requirements.

Structural stability of C-60 films under the bombardment of 1.95 GeV Kr ions

The structural stability of C-60 films under the bombardment of 1.95 GeV Kr ions is investigated. The irradiated C-60 films were analyzed by Fourier Transform Infrared (FTIR) spectroscopy and Raman scattering technique. The analytical results indicate that the irradiation induced a decrease of icosahedral symmetry of C-60 molecule and damage of C-60 films; different vibration modes of C-60 molecule have different irradiation sensitivities; the mean efficient damage radius obtained from experimental data is about 1.47 nm, which is in good agreement with thermal spike model prediction.

Calculation of the thermal expansion coefficient for Bi2Sr2CaCu2O8

An estimation method of thermal expansion coefficient in term of lattice energy which was developed earlier for simple materials is extended to a complex material of Bi2Sr2CaCu2O8 (Bi-2212). The calculation of the chemical bond property and thermal expansion coefficient of Bi-2212 has been carried out and the theoretical values were in good agreement with the corresponding experimental results. The dependence of the thermal expansion coefficient on the different structures and on the flexible oxidation states of Bi and Cu are investigated. The results indicate that the thermal expansion coefficients of Bi-2212 are insensitive to the low lattice distortion of the average structure and the changes of formal valences of Bi and Cu ions.

Chemical bond properties and Mossbauer spectroscopy in REBa2Cu3O7 (RE = Eu, Y)

By using the chemical bond theory of complex crystals, the chemical bond properties of REBa2Cu3O7 (RE = Eu, Y) were calculated. The calculated covalencies for Cu(1)-O and Cu(2)-O bond in REBa2Cu3O7 compounds are 0.41 and 0.28 respectively. Mossbauer isomer shifts of Fe-57 doped, and Sn-119 doped in REBa2Cu3O7-x were calculated by using the chemical environmental factor, h(e), defined by covalency and electronic polarizability. Four valence state tin ion and iron ion sites were identified in Fe-57 and Sn-119 doped REBa2Cu3O7-x superconductors.

Investigation of Pr valence and relationship between bond covalency and T-c in Y1-xPrxBa2Cu3O7 (x = 0-1)

The valence of Pr and relationship between bond covalency and T-c in Y1-xPrxBa2Cu3O7 (x = 0-1) have been studied using complex chemical bond theory. The results indicate that the depression of superconductivity in Y1-xPrxBa2Cu3O7 can be reasonably explained by bond covalency difference for the bonds between CuO2 plane and CuO chain. T-c decreases with the decreasing of bond covalency difference and reaches zero when bond covalency difference is zero (or bond covalency in CuO2 exceeds that in CuO chain) at Pr concentration 0.55 and valence +3.30. These are in good agreement with the experiments and meanwhile suggest that the valence of Pr is + 3.30 in Y1-xPrxBa2Cu3O7. The results also indicate that for Pr valence less than +3.15, superconductivity always exists for whatever Pr concentration, whereas for Pr with a valence of +4.0, superconductivity disappears as soon as Pr concentration exceeds 0.19. This supports with the viewpoint that higher valence Pr will contribute more electrons to CuO2 plane, filling the mobile holes responsible for conduction. For PrBa2Cu3O7 with no Ba-site Pr, our calculation suggests that it will be a superconductor if the average valence of Pr is less than +3.15. (C) 1998 Published by Elsevier Science B.V. All rights reserved.

Valences of Cu in Y1-xCaxBa2Cu3O6+y

The valences of Cu in Y1-xGaxBa2Cu3O6+y have been investigated by using complex chemical bond theory The results for the valences of Cu(1) and Cu(2) in the calculation suggest that the holes introduced by calcium substitution only reside in CuO2 planes, and there is a competition mechanism for the hole density in CuO2 planes between Ca doping and oxygen depletion. These conclusions are satisfactorily in agreement with experiments.

Semiempirical study on the valences of Cu and bond covalency in Y1-xCaxBa2Cu3O6+y

The valences of Cu and bond covalencies in Y1-xCaxBa2Cu3O6+y, have been investigated using complex chemical bond theory, This theory is the generalization of Phillips, Van Vechten, Levine, and Tanaka's scheme. The results indicate that the valences of Cu(1) and Cu(2) in our calculation agree well with those obtained by the bond valence sum method. The valences of Cu(1) and Cu(2) in our calculation also suggest that the holes introduced by Ca substitution only reside in CuO2 planes and there is a competing mechanism for the hole density in CuO2 planes between,Ca doping and oxygen depletion. These conclusions are in satisfactory agreement with experiments. The calculated ordering of covalencies is Cu(1)-O(4)>Cu(1)-O(1)>Cu(2)-O(2,3)>Cu(2)-O(1)>Ca-O>Y-O similar to Ba-O, regardless of the Ca doping level and oxygen content. [S0163-1829(98)03325-6].

Dependence of superconducting temperature on chemical bond parameters in YBa2Cu3O6+delta (delta=0-1)

The chemical bond parameters, that is ionicities and average energy gaps, for all types of chemical bonds in YBa2Cu3O6+delta have been investigated with variation of oxygen content delta (delta = 0.0, 0.35, 0.45, 0.58, 0.64, 0.73, 0.78, 0.81, 0.95, 1.00). The theory used is the complex crystal chemical bond theory, which is the development of P-V-L theory. The two plateaus near 90 K and 60 K in superconducting transition temperatures, and the disappearance of superconductivity with the change of oxygen content, were reasonably explained by chemical bond parameters. The results also showed that the Cu-O chains play a vital role in the transition from non-superconductors to superconductors, and the highest transition temperature occurred when the plane-chain reached a coupling state. (C) 1998 Elsevier Science Ltd. All rights reserved.

The bond ionicity in RBa2Cu3O7 (R=Pr, Sm, Eu, Gd, Dy, Y, Ho, Er, Tm)

RBa2Cu3O7 (R = Pr, Sm, Eu, Gd, Dy, Y, Ho, Er, Tm) has been studied using complex chemical bond theory. The results indicated that with the decreasing of R radius, the ionicities for all considered types of bond decrease. This is in good agreement with the experimental fact that T-c decreases with the decreasing of R radius. PrBa2Cu3O7 with no Ba-site Pr in this calculation is also predicted to be a superconductor. This supports the conclusion obtained by Blackstead et al. The ionicity for each bond obeys the following order: Ba-O > R-O > Cu(2)-O(1) > Cu(2)-O(2,3) > Cu(1)-O(4) similar to Cu(1)-O(1).

Comparative study on the doping effect of 3d elements in Bi(1.5)Pb(0.2)Sr(2)Ca(2)Cu(2.8)M(0.2)O(y) (M=Sc,Ti,V,Cr,Mn,Fe,Co,Ni, or Zn)

With XRD, R-T, and ac chi measurements a comparative study on the doping effects of 3d elements in Bi(1.5)Pb(0.2)Sr(2)Ca(2)Cu(2.8)M(0.2)O(y) (M = Sc, Ti, V, Cr, Mn, Fe, Co, Ni, or Zn) has been carried out. The effects of the former five members are significantly different, both on phase formed and on T-c, from the latter four. It seems that the effect on phase stabilization correlates with the valency of the doped cation. In connection with the instability of the 2223 phase, the correlation has been discussed.

THE EFFECT ON PHYSICAL-PROPERTIES OF THE SUBSTITUTION OF CA OR BA FOR SR IN NDSRNIO4

A new solid solution series, NdSr(1-x)M(x)NiO(4) (M = Ca: 0.0 less than or equal to x less than or equal to 1.0; M = Ba: 0.0 less than or equal to x less than or equal to 0.6), was synthesized by solid state reaction, and the structures, magnetic and electrical properties and optical spectra of this series have been studied. All the samples crystalized in tetragonal systems, with the exception of NdCaNiO4, which crystallized in the orthohombic system. IR spectra of NdSr1-xCaxNiO4 indicated that the lengths of two Ni-O bonds decrease with increasing Ca content. The electrical conduction changed from metallic-type to semiconductive-type when x greater than or equal to 0.4 (M = Ca, Ba), and the room temperature resistivities of NdSr1-xCaxNiO4 increased with the increase of Ca content. Magnetic susceptibility measurements revealed that Ni+3 ions in all the samplies were in low-spin state over the temperature range 77-300 K.

ELECTROCHEMICAL MECHANISM FOR FULLERENE FORMATION IN PLASMA ARCS

During the synthesis of fullerenes by dc plasma arcs, it has been found that the anodic graphite rod consistently burns up, while the cathodic graphite rod grows slag at its end. Further investigations revealed that the anodic and cathodic graphite rods p

PREPARATION AND ELECTRICAL-PROPERTIES OF BISMUTH STRONTIUM DIMANGANESE HEXOXIDE [BISRMN2O6]

BiSrMn2O6 is prepared by solid state reaction at 850 degrees C. It is tetragonal with a= 0.7821nm c= 0.3790 nm. It is a black n-type semiconductor below 820K. Its resistivity is 3 Omega-CM at room temperature. A semiconductor -metal transition is observed around 820K, Bi1+xSr1-xMn2O6-y is a solid solution for -0.2 less than or equal to x less than or equal to 0.2. Its unit cell dimensions increase but resistivity decreases when the Bi contents increase.

EFFECT OF CODOPING SB AND V TO THE BIPBSRCACUO SYSTEM

With XRD, R- T curves, and a.c chi measurements, the doping and codoping effects of Sb and V to a Cu-deficient Pb-doped Bi system have been studied. A sample singly doped with V possesses a T(c) about 2 K lower than that of a sample singly doped with Sb. This is attributed to the different sites of their substitution. It was observed that for promoting 2223 phase formation, Sb and V works cooperatively, and the codoping of Sb may enhance the 2223 phase formed. With a low doping level of Sb, the optimum doping amount of V is 0.3, i.e., with a nominal composition of Bi1.5Pb0.3Sb0.06Sr2Ca2Cu2.4V0.3Oy. A sample in which the 2223 phase is the dominant phase and which has a zero resistance transition temperature of 105 K has been obtained.