对称加密方案的密文验证安全性

文中研究由密文的完整性检查而导致的数据保密性问题,提出一个新的安全概念——加密方案在密文验证攻击下的不可区分性(IND-CVA:indistinguishability ofencryption scheme under ciphertext verification attacks)来刻画加密方案在这种情况下的保密安全性。IND-CVA允许敌手访问加密oracle和密文验证oracle。与IND-CPA和IND-CCA相比,IND-CVA比IND-CPA稍微强些,但要比IND-CCA弱得多。IND-CVA能使多数常用的加密方案(如:OTP,CBC,及CTR)得以满足。并且,这个IND-CVA可以恰当地刻画安全信道的保密安全性。将认证方案和加密方案结合起来是保证通信安全的一种常用方法。然而,在IND-CVA模型下,当利用认证方案来加强保密安全性的时候,却有可能反而破坏了原有的保密安全性。IND-CVA揭示了完整性对保密性的影响,准确刻画了安全信道的保密性要求,为协议设计提供了有益的参考。

黄土高原典型土壤剖面土壤颗粒组成分形特征

采集从北向南依次分布的干润砂质新成土(神木)、黄土正常新成土(延安)和土垫旱耕人为土(杨陵)等典型土壤剖面0～200cm土层土样,通过测定土样颗粒体积分形维数及基本性质,以期阐明黄土高原典型土壤颗粒体积分形特征及其与土壤基本性质间的相关性。结果表明,从南到北,土壤颗粒体积分形维数呈下降趋势,而不同土层土壤颗粒体积分形维数差异不显著。土垫旱耕人为土、黄土正常新成土和干润砂质新成土表层(0～10cm)颗粒体积分形维数分别为2.723±0.024、2.609±0.077和2.589±0.025,表层以下(10～200cm)颗粒平均体积分形维数分别为2.729±0.034、2.584±0.054和2.558±0.034;颗粒体积分形维数与<0.01mm的物理性黏粒及<0.002mm的黏粒体积百分含量呈极显著正相关关系,与0.002～0.05mm的粉粒和>0.05mm的砂粒体积百分含量呈极显著负相关关系,与粉粒的显著性较小,而土壤中物理性黏粒体积百分含量与土壤全氮、有机碳及矿物固定态铵均达到极显著正相关关系,而砂粒体积百分含量与上述土壤基本性质均呈极显著负相关关系。

我国节水型农业技术体系的发展方向

本文阐述了国内外节水农业的发展概况 ,总结了节水农业技术体系特别是高新技术的发展和应用现状 ,辩证地分析了我国节水农业出现的问题及发展前景

热解吸-气相色谱法测定植物源挥发性有机物

以Tenax-TA、Carboxen 1000和Carbosieve SⅢ为采样管填充料,将植物源挥发性有机物吸附于采样管内,样品通过二次热解吸仪解吸后,随载气进入气相色谱仪,采用氢火焰离子化检测器(FID)测定,建立了利用二次热解吸仪与气相色谱联用技术测定植物挥发性有机物的分析方法。载气N2流速为30 mL/min,60℃下吹扫吸附管2 min,然后在250℃下解吸吸附管5 min,冷却1 min后,在275℃下解吸聚焦管3 min,样品经传输线进入气相色谱。气相色谱载气N2压力为190 kPa,FID检测器温度280℃;进样口温度225℃;初始柱温40℃,停留5 min,以2℃/min升温至120℃,保留1 min,然后以20℃/min升温至200℃,保留10 min。方法重现性好,精密度高,线性相关系数大于0.99;检出限均低于9×10-9g/L;解吸效率大于96%,适用于植物源挥发性有机物的测定。

沙地云杉生态型同工酶研究

沙地云杉是内蒙古地区特有树种,只分布于浑善达克沙地东部边缘;由于长期适应干旱生态条件,分化出3种土壤生态型,即紫果型、红果型和绿果型沙地云杉,并在很多生态、生理特征上表现出明显的差异.本文采用聚丙烯酰胺凝胶电泳技术,分析了3种生态型沙地云杉的过氧化物同工酶和酯酶同工酶的酶谱特征.结果表明:不管是过氧化物同工酶还是酯酶同工酶,紫果型沙地云杉的酶带条数最多,红果型其次,绿果型酶带条数最少.在酶带强度方面也有类似的结果,紫果型沙地云杉具有较多的强、次强、中带,红果型其次,绿果型最少.这在一定程度上表明,在干旱条件下产生的3种不同生态型沙地云杉,以紫果型对干旱抗性最强,绿果型最弱,红果型居于二者之间,这一结论将为沙地云杉的经营管理及品种选择提供科学依据. 图2参21

树冠结构参数及附近风场特征的风洞模拟研究

根据风洞模型实验 ,分析了树冠结构参数 (疏透度 β、透风系数α)和附近的风速场特征 .结果表明 ,透风系数与疏透度之间符合幂函数关系α =β0 .6,树冠附近的风速减弱区为椭球形立体空间 ,减弱区随树高、冠幅的增大而增大 ,随透风系数 (或疏透度 )的增大而减小 ,在水平和垂直剖面上 ,等风速线分别为椭圆形和椭圆线段

维生素C二步发酵中L-山梨糖脱氢酶的性质及作用

从氧化葡萄糖酸杆菌细胞质中分离纯化出L 山梨糖脱氢酶 (SDH) ,其分子量为 46× 10 3 ,表观分子量为 190× 10 3 ;在测试范围内 ,最适pH是 7.4,温度为 5 5℃ ,最稳定的 pH是 7.0 ,温度为 30℃以下 ;FeCl3 促进酶活 ,CoCl2 抑制酶活 .该酶活力与发酵产物 2 酮基 L 古龙酸的合成呈正相关 ;伴生菌促进产酸菌生长和代谢 ,并使该酶比活力增加 ,从而提高发酵系统中该酶的总活力 .图 11表 5参 9

Self-assembly of lambda-DNA networks/Ag nanoparticles: Hybrid architecture and active-SERS substrate

In this article, highly rough and stable surface enhanced Raman scattering (SERS)-active substrates had been fabricated by a facile layer by-layer technique. Unique lambda-DNA networks and CTAB capped silver nanoparticles (AgNP) were alternatively self-assembled on the charged mica surface until a desirable number of bilayers were reached. The as-prepared hybrid architectures were characterized by UV-vis spectroscopy, tapping mode atomic force microscopy (AFM) and confocal Raman microscopy, respectively.

Preparation and Physical Properties of LLDPE Grafted with Novel Nonionic Surfactants

Copolymers of linear low-density polyethylene (LLDPE) grafted with two novel nonionic surfactants, acrylic glycerol monostearate ester (AGMS) and acrylic polyoxyethylenesorbitan monooleate ester (ATW-EEN80), containing hydrophilic and hydrophobic groups and 1-olefin double bond were prepared by using a plasticorder at 190 degrees C. To evaluate the grafting degree, two different approaches based on H-1-NMR data were proposed, and FTIR calibration was showed to validate these methods. The rheological response of the molten polymers, determined under dynamic shear flow at small-amplitude oscillations, indicated that crosslinking formation of the chains could be decreased with increasing the monomer concentration. Their thermal behavior was studied by DSC and polarization microscope (PLM): The crystallization temperature (T-C) of grafted LLDPE shifted to higher temperature compared with neat LLDPE because the grafted chains acted as nucleating agents. Water and glycerol were used to calculate the surface free energy of grafted LLDPE films.

Synthesis and self-assembly of a novel Y-shaped copolymer with a helical polypeptide arm

novel biodegradable Y-shaped copolymer, poly(L-lactide)(2)-b-poly(gamma-benzyl-L-glutamic acid) (PLLA(2)-b-PBLG), was synthesized by the ring-opening polymerization (ROP) of N-carboxyanhydride of gamma-benzyl-L-glutamate (BLG-NCA) with centrally amino-functionalized poly(L-lactide), PLLA(2)-NH2, as a macroinitiator in a convenient way. The Y-shaped copolymer and its precursors were characterized by H-1 NMR, FT-IR, GPC, WAXD and DSC measurements. The self-assembly of the PLLA(2)-b-PBLG copolymer in toluene and benzyl alcohol was examined. It was found that the self-assembly of the copolymer was dependent on solvent and on relative length of the PBLG block. For a copolymer with PLLA blocks of 26 in total degree of polymerization (DP), if the PBLG block was long enough (e.g., DP = 54 or more), the copolymer/toluene solution became a transparent gel at room temperature. In benzyl alcohol Solution, only PLLA(2)-b-PBLG containing ca. 190 BLG residues could form a gel: those with shorter PBLG blocks (e.g., DP = 54) became nano-scale fibrous aggregates and these aggregates were dispersed in benzyl alcohol homogeneously.