Effects of CO2 laser conditioning of the antireflection Y2O3/SiO2 coatings at 351 nm

Y2O3/SiO2 coatings were deposited on fused silica by electron beam evaporation. A continuous wave CO2 laser was used to condition parts of the prepared samples at different scanning speeds in the air. LAMBDA 900 spectrometer was used to investigate the changes of the transmittance and residual reflection spectrum. A Nomarski microscope under dark field was used to examine the changes of the micro defect density. The changes of the surface roughness and the microstructure of the film before and after conditioning were investigated by AFM and X-ray diffraction, respectively. We found that laser-induced damage threshold (LIDT) of the films conditioning at 30 mm/s scanning speed was increased by more than a factor of 3 over the thresholds of the as-deposited films. The conditioning effect was correlated with an irradiation-induced decrease of the defect density and absorption of the films. (c) 2005 Elsevier B.V. All rights reserved.

Laser conditioning of ZrO2 : Y2O3/SiO2 mirror coatings prepared by E-beam evaporation

Laser conditioning effects of the dielectric mirror coatings with different designs were investigated. Simple quarter-wave ZrO2:Y2O3/SiO2 mirrors and half-wave SiO2 over-coated ZrO2:Y2O3/SiO2 mirror coatings were fabricated by E-beam evaporation (EBE). The absorbance of the samples before and after laser conditioning was measured by surface thermal lensing (STL) technology and the defects density was detected under Nomarski microscope. The enhancement of the laser damage resistance was found after laser conditioning. The dependence of the laser conditioning on the coating design was also observed and the over-coated sample obtained greatest enhancement, whereas the absorbance of the samples did not change obviously. During the sub-threshold fluence raster scanning, the minor damage about defects size was found and the assumption of pre-damage mechanism, based on the functional damage concept, was put forward. The improvement of the laser induced damage threshold (LIDT) was attributed to the benign damage of the defects and the dependence on the coating design owed to the damage growth behavior of different coating designs. (C) 2004 Elsevier B.V. All rights reserved.

Y2O3 stabilized ZrO2 thin films deposited by electron beam evaporation: Structural, morphological characterization and laser induced damage threshold

Four kinds of Y2O3 stabilized ZrO2 (YSZ) thin films with different Y2O3 content have been prepared on BK7 substrates by electron-beam evaporation method. Structural properties and surface morphology of thin films were investigated by X-ray diffraction (XRD) spectra and scanning probe microscope. Laser induced damage threshold (LIDT) was determined. It was found that crystalline phase and microstructure of YSZ thin films was dependent on Y2O3 molar content. YSZ thin films changed from monoclinic phase to high temperature phase (tetragonal and cubic) with the increase of Y2O3 content. The LIDT of stabilized thin film is more than that of unstabilized thin films. The reason is that ZrO2 material undergoes phase transition during the course of e-beam evaporation resulting in more numbers of defects compared to that of YSZ thin films. These defects act as absorptive center and the original breakdown points. (c) 2006 Elsevier B.V. All rights reserved.

一种用于Yb：YAG激光器的波长分离膜的研制

以1030nm高反．940。980nm高透的波长分离膜作为实例，为提高该薄膜元件的波长分离效果，从膜系的优化方面做了一系列的研究。诸如采用带通滤光片的设计思想，在膜堆两侧加入了匹配层，调整膜堆的周期厚度，并用膜系设计软件对通带作进一步的优化。通过这一系列的优化设计后．利用RF双离子柬溅射工艺在BK7玻璃基底上沉积样品薄膜，并在基底背面加镀通带增透膜。结果显示，透射带在940和980nm处的透过率分别为97．73％和93．63％．反射带在1030nm的反射率为99．99％。对所制备的样品薄膜进行了激光损伤阈

Influence of ytterbia content on residual stress and microstructure of Y2O3-ZrO2 thin films prepared by EB-PVD

Y2O3 stabilized ZrO2 (YSZ) thin films with different Y2O3 molar contents (0, 3, 7, and 12 mol%) are deposited on BK7 substrates by electron-beam evaporation technique. The effects of different Y2O3 contents on residual stresses and structures of YSZ thin films are studied. Residual stresses are investigated by means of two different techniques: the curvature measurement and x- ray diffraction method. It is found that the evolution of residual stresses of YSZ thin films by the two different methods is consistent. Residual stresses of films transform from compressive stress into tensile stress and the tensile stress increases monotonically with the increase of Y2O3 content. At the same time, the structures of these films change from the mixture of amorphous and monoclinic phases into high temperature cubic phase. The variations of residual stress correspond to the evolution of structures induced by adding of Y2O3 content.

Effect of a feeding stimulant on feeding adaptation of gibel carp Carassius auratus gibelio (Bloch), fed diets with replacement of fish meal by meat and bone meal

The objectives of the study were to investigate the effect of a feeding stimulant on feeding adaptation of gibel carp (Carassius auratus gibelio Bloch) fed diets with replacement of fish meal by meat and bone meal (MBM), and whether or not the juvenile gibel carp could adapt to higher MBM level in the diet. Juvenile and adult gibel carp were tested. Two and one replacement levels were used for juvenile and adult fish respectively. Each group of diets was set as two types with or without a unique rare earth oxide: Y2O3, Yb2O3, La2O3, Sm2O3, Nd2O3 or Gd2O3 (only the first four rare earth oxides were used in adult diets) for four adaptation periods of 3, 7, 14 and 28 days respectively. After mixing, an equal mixture of all six diets for juvenile or four diets for adult was offered in excess for 2 days. During the last 2 days of each experiment, no feed was offered and faeces from each tank were collected. Feeding preference was expressed as relative feed intake of each diet, which was estimated based on the relative concentration of each marker in the faeces. Given some adaptation period, such as 3-28 days, the effects of MBM and squid extract inclusion on the preference to each diet were reduced. After 28 days adaptation, the preferences between groups were not significantly different.

多孔硅基MnSb铁磁性薄膜和Y2O3:Eu的制备及性质研究

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

掺Yb双包层光纤激光器v形槽侧面粘和泵浦方法

一种掺Yb双包层光纤激光器v形槽侧面粘和泵浦方法，其特征在于，包括如下步骤:步骤1:在双包层光纤的内包层和外包层上用精密光学微加工技术沿双包层光纤的轴向加工一段v形槽，该v形槽的底部高于双包层光纤的纤芯的表面;步骤2:将多模尾纤的一端用化学腐蚀方法去掉涂敷层，得到裸尾纤;步骤3:将多模尾纤一端的裸尾纤放入双包层光纤的v形槽内，该裸尾纤与纤芯相隔一距离;步骤4:使用光学折射率匹配胶填充于v形槽内，使裸尾纤与纤芯平行固定于v形槽内。

Passive Q-switched mode locking of double-clading Yb : fiber laser with ion-implanted GaAs

We report the technique of the ion-implanted semi-insulating GaAs wafer used for passive Q-switched mode locking in double-cladding Yb:fiber laser. The wafer was implanted with 400-keV energy, 10(16)/cm(2) dose As+ ions, and was annealed at 600degreesC for 20 min. At the pump power of 5W, we achieved output power of 200mW. The repetition rate of envelope of Q-switched mode locking is 50-kHz with a FWHM envelope of 4mus. The repetition rate of mode locked pulse train was found to be 15-MHz. This is the first report of such a kind of laser to the best of our knowledge.

Antiphase state in passively Q-switched Yb : YAG microchip multimode lasers with a saturable absorber GaAs

We report on recent experimental results of the spontaneous antiphase dynamics that occurs in a laser-diode-pumped multimode passively Q-switched microchip Yb:YAG (where YAG is yttrium aluminum garnet) lasers with a saturable absorber GaAs. We observe that the pulse sequence of the first mode characterized by one, two, and three pulses as a group and all the modes display an antiphase state as the pumping ratio rises. We modify the multimode rate equations to account for nonlinear absorption due to GaAs in the presence of spatial hole burning. We perform numerical simulations based on the proposed rate equations and reproduce the observed antiphase state of two and three active modes.

Observation of antiphase states in a passively Q-switched multimode microchip Yb : YAG laser with a GaAs saturable absorber

Antiphase dynamics has been observed experimentally for the laser modes operation in a laser-diode-pumped Q-switched microchip Yb:YAG laser with GaAs as a saturable absorber in the presence of spatial hole-burning. The Q-switched pulses sequences of two modes at different pump power have been obtained. The experimental results have shown that the pulses sequences displayed classic antiphase dynamics. (C) 2003 Elsevier B.V. All rights reserved.