Motorcycle handling. Volume II: technical report. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Maintenance comparison on FMVSS no. 121 configured vehicles versus non 121 configured vehicles. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Effect of rate of change of slip on the peak braking coefficient of passenger car tires. Technical report.

Mode of access: Internet.

Correlation between ultrasonic nondestructive inspection and wheel test of 34 retreaded tires. Interim report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington, D.C.

Development of car/trailer handling and braking standards. Volume II: technical report for Phase I - rear wheel drive tow cars. Final report.

National Highway Traffic Safety Administration, Office of Passenger Vehicle Research, Washington, D.C.

Steering wheel oscillations and vertical movement in 30 mph barrier impacts. Technical report.

Mode of access: Internet.

Slip casting of nuclear fuel elements.

"Contract no. AT(30-1)-2258"

That wild wheel, a novel,

Mode of access: Internet.

Occupant response and vehicle acceleration in a 30 mph frontal impact test - 1981 Subaru DL - 4 wheel drive - 4 door wagon - NHTSA 811301. Final report.

National Highway Traffic Safety Administration, Office of Passenger Vehicle Research, Washington, D.C.

Relationship of locked wheel friction to that of other test modes. Final report.

Pennsylvania Department of Transportation, Bureau of Materials, Testing and Research, Harrisburg

An infared experiment on a road wheel during an FMVSS 109 type compliance test.

Mode of access: Internet.

Interior with Woman at the Spinning Wheel

Esias Boursse; 1 ft. 11 5/8 in.x 1 ft. 7 19/64 in.; oil on canvas

An investigation of the slip-casting mechanism as applied to stainless steel powder /

The slip-casting technique, which is successfully employed in the ceramic industry, was utilized to produce sintered stainless steel components experimentally. The procedure used is described, along with an evaluation of the physical and mechanical properties of the samples produced. Specimens were made with properties comparable to those of wrought stainless steel and of cold pressed and sintered steel powder.