无压灌溉日光温室番茄作物-皿系数研究

以-25 kPa作为土壤水势临界值,将作物—皿系数(Kcp)设为0.2,0.4,0.6,0.8,1.0,1.2六个处理,研究了不同灌溉水量时的番茄产量、品质和灌溉水利用效率。通过经济效益评价,研究了杨凌地区无压灌溉温室番茄获得最高经济效益时的作物—皿系数。通过张力计读数变化规律,研究了利用张力计测量无压灌溉湿润体内土壤水势的特点。研究结果表明,Kcp为0.2~0.8时,灌溉水量的增加对番茄产量影响不大;Kcp为1.0~1.2时,灌溉水量的增加能显著提高番茄产量和果实大小;Kcp为0.2时的灌溉水量能极显著提高番茄的灌溉水利用效率。在综合考虑了杨凌地区水价、番茄使用目的和市场价格波动规律后,Kcp取值1.2能获得最高的经济效益。作物—皿系数法计算灌溉水量时的滞后性特点和张力计埋设位置,是判断利用张力计监测土壤水势临界值方法有效性的两个重要因素。

Utilização do tanque Classe A para a estimativa da evapotranspiração de referência dentro de casa de vegetação

O trabalho teve como objetivos estimar a evapotranspiração de referência (ETo) dentro e fora de casa de vegetação, pelo método do tanque Classe A, utilizando-se de dois valores de Kp e estabelecer correlações entre a ETo, dentro e fora da casa de vegetação, buscando evitar a instalação do tanque Classe A dentro da mesma. O experimento foi conduzido na Faculdade de Ciências Agrárias e Veterinárias, Câmpus de Jaboticabal - SP. Instalaram-se dois tanques Classe A, um dentro e outro fora da casa de vegetação. Para o tanque instalado dentro da casa de vegetação, utilizaram-se dois coeficientes de tanque: Kp = 0,7 e Kp = 1,0. Para o tanque instalado fora da casa de vegetação utilizou-se Kp = 0,85. Constatou-se que a ETo dentro da casa de vegetação foi menor que a estimada fora da mesma. Recomenda-se a instalação do tanque Classe A dentro da casa de vegetação para a estimativa da ETo, utilizando-se de Kp = 1,0.

Coeficiente do tanque Classe A obtido por diferentes métodos em ambiente protegido e no campo

There are several methods for determining the Class-A pan coefficient (Kp) to estimate the reference evapotranspiration (ETo), which is of great importance to water management in agriculture. Most of these methods take into account the wind speed, relative humidity and the fetch area. This study was done in region of Botucatu, SP, in greenhouse and field in the months of July-August (dry) and September-October (rainy), used the methods of Doorenbos e Pruitt (1977), Cuenca (1989), Snyder (1992), Pereira et al. (1995), Allen et al. (1998) and correlation between ETo determined by Penman-Monteith (EToPM) and evaporation of the Class-A pan (ECA). The EToPM was used as standard for the correlations between the ETo determined by the Class-A pan (EToTCA) obtained by different methods of Kp. The Kp in greenhouse ranged between 0.51 and 0.85, and in the field from 0.33 to 0.85. The methods of Allen et al. (1998) and Snyder (1992) are the most recommended for dry months in greenhouse and rainy months the correlation between the ECA and EToPM e Cuenca (1989). In the field condition, the methods of Allen et al. (1998) and of correlation between the ECA and EToPM for dry months, and for rainy months of Allen et al. (1998) and Cuenca (1989). The method of Allen et al. (1998) was the most efficient, regardless of the environment and of months analyzed. The fixed value of Kp should only be used when it is not possible to determine from its more sophisticated methods.

Investigations of evaporation from a screened pan and development of a coefficient for the conversion of pan evaporation to lake evaporation /

Mode of access: Internet.

Simple reflection technique for measuring the linear electro-optic coefficient of the polymer thin films

The simple reflection technique is usually used to measure the linear electro-optic (EO) coefficient (Pockels coefficient) in the development of EO polymer thin films. But there are some problems in some articles in the determination of the phase shift between the s and p light modes of a laser beam waveguided into the polymer film while a modulating voltage is applied across the electrodes, and different expressions for the linear EO coefficient measured have been given in these articles. In our research, more accurate expression of the linear EO coefficient was deduced by suitable considering the phase shift between the s and p light modes. The linear EO coefficients of several polymer thin films were measured by reflection technique, and the results of the Linear EO coefficient calculated by different expressions were compared. The limit of the simple reflection technique for measuring the linear EO coefficient of the polymer thin films was discussed.

Estimation thermal expansion coefficient from lattice energy for inorganic crystals

By using the study of the lattice energy and the structural parameters of binary inorganic crystals, a new parameter reflecting the thermal expansion property has been found, the relation between the linear expansion coefficient and new parameter has been established. A semiempirical method for evaluation of linear expansion coefficient from the lattice energy is presented, and developed to the complex crystals. The estimated values of the linear expansion coefficients of both simple and complex crystals are in good agreement with the experimental values.

Stretching-induced orientation to improve mechanical properties of electrospun pan nanocomposites

Partially aligned and oriented polyacrylonitrile(PAN)-based nanofibers were electrospun from PAN and SWNTs/PAN in the solution of dimethylformamide(DMF) to make the carbon nanofibers. The as-spun nanofibers were hot-stretched in an oven to enhance its orientation and crystallinity. Then it were stabilized at 250 square under a stretched stress, and carbonized at 1000 square in N-2 atmosphere by fixing the length of the stabilized nanofiber to convert them into carbon nanofibers. With this hot-stretched process and with the introduction of SWNTs, the mechanical properties will be enhanced correspondingly. The crystallinity of the stretched fibers confirmed by X-ray diffraction has also increased. For PAN nanofibers, the improved fiber alignment and crystallinity resulted in the increased mechanical properties, such as the modulus and tensile strength of the nanofibers. It was concluded that the hot-stretched nanofiber and the SWNTs/PAN nanofibers can be used as a potential precursor to produce high-performance carbon composites.

Drag coefficient in a crystal suspension

A single air bubble rising in xanthan gum crystal suspension has been studied experimentally. The suspension was made by different concentrations of xanthan gum solutions with 0.23 mm polystyrene crystal particles. Drag co-efficient data and a new correlation of drag coefficient is presented for spherical and nonspherical bubbles in non-Newtonian crystal suspension. The correlation is developed in terms of the Reynolds number, Re and the bubble shape factor, � (the ratio between the surface equivalent sphere diameter to the volume equivalent sphere diameter). The experimental drag coefficient was found to be consistent with this new predicted correlation and published data over the ranges, 0.1