La Internalización de los Costes Medioambientales en el transporte de mercancías por carretera

[ES] La literatura existente señala el potencial de una gestión medioambiental proactiva en la generación de capacidades organizativas relativas a la minimización de costes. Además, durante los últimos años, la internalización de los costes medioambientales de la industria transportista ha sido un importante objetivo en el desarrollo de políticas públicas.

A Fruticultura Irrigada de pequenos produtores no Baixo-Açu: Uma análise da eficiência de custo

This work has as an objective analyze the efficiency of producers costs of the irrigation Project Baixo-Açu , and identify the determining factors of this efficiency. To achieve these targets it was estimated, in a first stage, a frontier of costs by the method, non parametric of Data Envelopment Analysis-DEA, and measured the stakes of efficiency producers. On the second stage, it was utilized the Tobit regression pattern, estimating an inefficiency function of costs, and were indentified the associated factors of resources waste. Among the results found it was noticed the existence of a high waste of resources, that represent more than 54% of effective cost. Among the factors with the highest wastes are: energy, herbicides, defensives and chemical fertilizers. In a general way, the producers presented low efficiency level and, only, two, of seventy-five researched, achieved the frontier of costs minimization. These results reveal, in a certain way, that the producers in irrigated fruit growing in the project Baixo-Açu don t seek to minimize the production costs. It was still noticed, that the reduction of resources waste, and this way the inefficiency of costs, is associated with the agriculturalist education, his experience in agriculture, his access to the technical assistance and credit

Capacity of Active Power Reserve for Frequency Control Enhanced by Distributed Generators

Usually, ancillary services are provided by large conventional generators; however, with the growing interest in distributed generation to satisfy energy and environmental requirements, it seems reasonable to assume that these services could also be provided by distributed generators in an economical and efficient way. In this paper, a proposal for enhancement of the capacity of active power reserve for frequency control using distributed generators is presented. The goal is to minimize the payments done by the transmission system operator to conventional and distributed generators for this ancillary service and for the energy needed to satisfy loads and system losses, subject to a set of constraints. In order to perform analysis, the proposal was implemented using data of the IEEE 30-bus transmission test system. Comparisons were performed considering conventional generators without and with distributed generators installed in the system.

Minimization of bauxite residue neutralization products using nanofiltered seawater

Currently, open circuit Bayer refineries pump seawater directly into their operations to neutralize the caustic fraction of the Bayer residue. The resulting supernatant has a reduced pH and is pumped back to the marine environment. This investigation has assessed modified seawater sources generated from nanofiltration processes to compare their relative capacities to neutralize bauxite residues. An assessment of the chemical stability of the neutralization products, neutralization efficiency, discharge water quality, bauxite residue composition, and associated economic benefits have been considered to determine the most preferable seawater filtration process based on implementation costs, savings to operations and environmental benefits. The mechanism of neutralization for each technology was determined to be predominately due to the formation of Bayer hydrotalcite and calcium carbonate, however variations in neutralization capacity and efficiencies have been observed. The neutralization efficiency of each feed source has been found to be dependent on the concentration of magnesium, aluminium, calcium and carbonate. Nanofiltered seawater with approximately double the amount of magnesium and calcium required half the volume of seawater to achieve the same degree of neutralization. These studies have revealed that multiple neutralization steps occur throughout the process using characterization techniques such as X-ray diffraction (XRD), infrared (IR) spectroscopy and inductively coupled plasma optical emission spectroscopy (ICP-OES).

Interactions of cetaceans with Spanish and Portuguese fisheries in Atlantic waters : costs, benefits and implications for management

With the aim to provide new insights into operational cetacean-fishery interactions in Atlantic waters, this thesis assesses interactions of cetaceans with Spanish and Portuguese fishing vessels operating in Iberian and South West Atlantic waters. Different opportunistic research methodologies were applied, including an interview survey with fishers (mainly skippers) and onboard observations by fisheries observers and skippers, to describe different types of interactions and to identify potential hotspots for cetacean-fishery interactions and the cetacean species most involved, and to quantify the extent and the consequences of these interactions in terms of benefits and costs for cetaceans and fisheries. In addition, the suitability of different mitigation strategies was evaluated and discussed. The results of this work indicate that cetaceans interact frequently with Spanish and Portuguese fishing vessels, sometimes in a beneficial way (e.g. cetaceans indicate fish schools in purse seine fisheries), but mostly with negative consequences (depredation on catch, gear damage and cetacean bycatch). Significant economic loss and high bycatch rates are, however, only reported for certain fisheries and associated with particular cetacean species. In Galician fisheries, substantial economic loss was reported as a result of bottlenose dolphins damaging artisanal coastal gillnets, while high catch loss may arise from common dolphins scattering fish in purse seine fisheries. High cetacean bycatch mortality arises in trawl fisheries, mainly of common dolphin and particularly during trawling in water depths below 350 m, and in coastal set gillnet fisheries (mainly common and bottlenose dolphins). In large-scale bottom-set longline fisheries in South West Atlantic waters, sperm whales may significantly reduce catch rates through depredation on catch. The high diversity of cetacean-fishery interactions observed in the study area indicates that case-specific management strategies are needed to reduce negative impacts on fisheries and cetaceans. Acoustic deterrent devices (pingers) may be used to prevent small cetaceans from approaching and getting entangled in purse seines and set gillnets, although possible problems include cetacean habituation to the pinger sounds, as well as negative side effects on non-target cetaceans (habitat exclusion) and fisheries target species (reduced catch rates). For sardine and horse mackerel, target species of Iberian Atlantic fisheries, no aversive reaction to pinger sounds was detected during tank experiments conducted in the scope of this thesis. Bycatch in trawls may be reduced by the implementation of time/area restrictions of fishing activity. In addition, the avoidance of fishing areas with high cetacean abundance combined with the minimization of fishery-specific sound cues that possibly attract cetaceans, may also help to decrease interactions. In large-scale bottom-set longline fisheries, cetacean depredation on catch may be reduced by covering hooked fish with net sleeves ("umbrellas") provided that catch rates are not negatively affected by this gear modification. Trap fishing, as an alternative fishing method to bottom-set gillnetting and longlining, also has the potential to reduce cetacean bycatch and depredation, given that fish catch rates are similar to the rates obtained by bottom-set gillnets and longlines, whereas cetacean by-catch is unlikely. Economic incentives, such as the eco-certification of dolphin-safe fishing methods, should be promoted in order to create an additional source of income for fishers negatively affected by interactions with cetaceans, which, in turn, may also increase fishers’ willingness to accept and adopt mitigation measures. Although the opportunistic sampling methods applied in this work have certain restrictions concerning their reliability and precision, the results are consistent with previous studies in the same area. Moreover, they allow for the active participation of fishers that can provide important complementary ecological and technical knowledge required for cetacean management and conservation.

Minimization of reversible adder circuits

Losing information causes losing power. Information is lost when the input vector cannot be uniquely recovered from the output vector of a combinational circuit. The input vector of reversible circuit can be uniquely recovered from the output vector. In this study we have emphasized on the design of reversible adder circuits that is efficient in terms of gate count, garbage outputs and quantum cost and that can be technologically mapped. It has been analyzed and demonstrated that the results of our proposed adder circuits shows better performance compared to similar type of existing designs. Technology independent equations required to evaluate these circuits have also been given.

Productivity and costs of Beller-Buncher and forest processor in stands of eucalypts in first cut

The rationalization of forest harvesting and minimization costs is a constant search by the managers involved in this process, making them decide practices which are economically viable to optimize that operation. This study aimed to evaluate technically and economically the performance of feller-buncher and the forest processor in stands of eucalypts in first cut. The technique analysis included time and movements, productivity, efficiency operational and mechanical availability. The economic analysis included the parameters operational cost, harvesting cost and energy consumption. Aiming the optimization the cost of forest harvesting, the system composed by feller-buncher and processor forest presented itself as a technically and economically viable alternative to harvesting eucalypt in first cut or stands that do not have bifurcated trees.

Strategic Behavior in Day-Ahead and Real-Time Markets for Electricity: Offer Cost or Payment Cost Minimization?

This study compares the procurement cost-minimizing and productive efficiency performance of the auction mechanism used by independent system operators (ISOs) in wholesale electricity auction markets in the U.S. with that of a proposed alternative. The current practice allocates energy contracts as if the auction featured a discriminatory final payment method when, in fact, the markets are uniform price auctions. The proposed alternative explicitly accounts for the market clearing price during the allocation phase. We find that the proposed alternative largely outperforms the current practice on the basis of procurement costs in the context of simple auction markets featuring both day-ahead and real-time auctions and that the procurement cost advantage of the alternative is complete when we simulate the effects of increased competition. We also find that a trade-off between the objectives of procurement cost minimization and productive efficiency emerges in our simple auction markets and persists in the face of increased competition.

An Experimental Study of Complex-Offer Auctions: Payment Cost Minimization vs. Offer Cost Minimization

A Payment Cost Minimization (PCM) auction has been proposed as an alternative to the Offer Cost Minimization (OCM) auction to be used in wholesale electric power markets with the intention to lower the procurement cost of electricity. Efficiency concerns about this proposal have relied on the assumption of true production cost revelation. Using an experimental approach, I compare the two auctions, strictly controlling for the level of unilateral market power. A specific feature of these complex-offer auctions is that the sellers submit not only the quantities and the minimum prices at which they are willing to sell, but also the start-up fees that are designed to reimburse the fixed start-up costs of the generation plants. I find that both auctions result in start-up fees that are significantly higher than the start-up costs. Overall, the two auctions perform similarly in terms of procurement cost and efficiency. Surprisingly, I do not find a substantial difference between less market power and more market power designs. Both designs result in similar inefficiencies and equally higher procurement costs over the competitive prediction. The PCM auction tends to have lower price volatility than the OCM auction when the market power is minimal but this property vanishes in the designs with market power. These findings lead me to conclude that both the PCM and the OCM auctions do not belong to the class of truth revealing mechanisms and do not easily elicit competitive behavior.

Efficiency in Deregulated Electricity Markets: Offer Cost Minimization vs. Payment Cost Minimization Auction

This study of the wholesale electricity market compares the efficiency performance of the auction mechanism currently in place in U.S. markets with the performance of a proposed mechanism. The analysis highlights the importance of considering strategic behavior when comparing different institutional systems. We find that in concentrated markets, neither auction mechanism can guarantee an efficient allocation. The advantage of the current mechanism increases with increased price competition if market demand is perfectly inelastic. However, if market demand has some responsiveness to price, the superiority of the current auction with respect to efficiency is not that obvious. We present a case where the proposed auction outperforms the current mechanism on efficiency even if all offers reflect true production costs. We also find that a market designer might face a choice problem with a tradeoff between lower electricity cost and production efficiency. Some implications for social welfare are discussed as well.

Exposure to pesticides, ill health and averting behaviour : costs and determining the relationship

Farmers' exposure to pesticides is high in developing countries. As a result many farmers suffer from ill-health, both short and long term. Deaths are not uncommon. This paper addresses this issue. Field survey data from Sri Lanka are used to estimate farmers' expenditure on defensive behavior (DE) and to determine factors that influence DE. The avertive behavior approach is used to estimate costs. Tobit regression analysis is used to determine factors that influence DE. Field survey data show that farmers' expenditures on DE are low. This is inversely related to high incidence of ill health among farmers using pesticides.