Integration and optimization of pressure retarded osmosis with reverse osmosis for power generation and high efficiency desalination

Salinity gradient power is proposed as a source of renewable energy when two solutions of different salinity are mixed. In particular, Pressure Retarded Osmosis (PRO) coupled with a Reverse Osmosis process (RO) has been previously suggested for power generation, using RO brine as the draw solution. However, integration of PRO with RO may have further value for increasing the extent of water recovery in a desalination process. Consequently, this study was designed to model the impact of various system parameters to better understand how to design and operate practical PRO-RO units. The impact of feed salinity and recovery rate for the RO process on the concentration of draw solution, feed pressure, and membrane area of the PRO process was evaluated. The PRO system was designed to operate at maximum power density of . Model results showed that the PRO power density generated intensified with increasing seawater salinity and RO recovery rate. For an RO process operating at 52% recovery rate and 35 g/L feed salinity, a maximum power density of 24 W/m2 was achieved using 4.5 M NaCl draw solution. When seawater salinity increased to 45 g/L and the RO recovery rate was 46%, the PRO power density increased to 28 W/m2 using 5 M NaCl draw solution. The PRO system was able to increase the recovery rate of the RO by up to 18% depending on seawater salinity and RO recovery rate. This result suggested a potential advantage of coupling PRO process with RO system to increase the recovery rate of the desalination process and reduce brine discharge.

Solution chemistry impacts on the seawater neutralisation process: Benefits of nanofiltered seawater and reverse osmosis brine

It is well known that the neutralisation of Bayer liquor with seawater causes the precipitation of stable alkaline products and a reduction in pH and dissolved metal concentrations in the effluent. However, there is limited information available on solution chemistry effects on the stability and reaction kinetics of these precipitates. This investigation shows the influence of reactive species (magnesium and calcium) in seawater on precipitate stabilities and volumetric efficiencies during the neutralisation of bauxite refinery residues. Correlations between synthetic seawater solutions and real samples of seawater (filtered seawater, nanofiltered seawater and reverse osmosis brine) have been made. These investigations have been used to confirm that alternative seawater sources can be used to increase the productivity potential of the neutralisation process with minimal implications on the composition and stability of precipitates formed. The volume efficiency of the neutralisation process using synthetic analogues has been shown to be almost directly proportional with the concentration of magnesium. This was further confirmed in the nanofiltered seawater and reverse osmosis brine that showed increases in the efficiency of neutralisation by factors of 3 and 2 compared to seawater, which corresponds with relatively the same increase in the concentration of magnesium in these alternative seawater sources. An assessment of the chemical stability of the precipitates, volumetric efficiency, and discharge water quality have been determined using numerous techniques that include pH, conductivity, inductively coupled plasma optical emission spectroscopy, infrared spectroscopy, thermogravimetric analysis coupled to mass spectrometry and X-ray diffraction. Correlations between synthetic solution compositions and alternative seawater sources have been used to determine if alternative seawater sources are potential substitutes for seawater based on improvements in productivity, implementation costs, savings to operations and environmental benefits.

Downstream processing of reverse osmosis brine: Characterisation of potential scaling compounds

Reverse osmosis (RO) brine produced at a full-scale coal seam gas (CSG) water treatment facility was characterized with spectroscopic and other analytical techniques. A number of potential scalants including silica, calcium, magnesium, sulphates and carbonates, all of which were present in dissolved and non-dissolved forms, were characterized. The presence of spherical particles with a size range of 10–1000 nm and aggregates of 1–10 microns was confirmed by transmission electron microscopy (TEM). Those particulates contained the following metals in decreasing order: K, Si, Sr, Ca, B, Ba, Mg, P, and S. Characterization showed that nearly one-third of the total silicon in the brine was present in the particulates. Further, analysis of the RO brine suggested supersaturation and precipitation of metal carbonates and sulphates during the RO process should take place and could be responsible for subsequently capturing silica in the solid phase. However, the precipitation of crystalline carbonates and sulphates are complex. X-ray diffraction analysis did not confirm the presence of common calcium carbonates or sulphates but instead showed the presence of a suite of complex minerals, to which amorphous silica and/or silica rich compounds could have adhered. A filtration study showed that majority of the siliceous particles were less than 220 nm in size, but could still be potentially captured using a low molecular weight ultrafiltration membrane.

The brine and gas content of sea ice with attention to low salinities and high temperatures

Based on the well known sea ice phase diagram, equations are derived for determining the brine and gas content of sea Ice for high temperatures (range 0 to -2 °C) and low salinities. The presently widely used equations of Cox and Weeks (1982) are valid only for temperatures below -2°C. Fresh-water ice is used as a boundary condition for the equations. The relative salt concentrations in brine are_assumed to be the same as in normal (or standard) seawater. Two sets of equations are presented: 1) accurate formulae based on UNESCO standard sea water equations, and 2) approximate formulae based on general properties of weak solutions. The approximate formulae are not essentially different from the classical system which basically assumes the freezing point to be a linear function of fractional salt content. The agreement between the two approaches is excellent and the approximate system is good enough for most applications.

Toxicity of heavy metals to brine shrimp Artemia

Bioassay were carried out on 48h cultured nauplii of brine shrimp Artemia by exposing them to seven trace elements viz. copper (Cu), zinc (Zn), cadmium (Cd), nickel (Ni), lead (Pb), iron (Fe) and manganese (Mn). Synergistic effects of all these elements and additive effects of Cu and Zn, Cd and Pb, and Ni and Fe were also investigated. Comparatively, the degree of toxicity for compound bioassays was higher than individual simple tests. The values were averaged and the expected median lethal concentration [LC sub(50)] of tested heavy metals was obtained by probit analysis on the basis of cumulative numbers of dead organisms after 24 and 48h. The order of toxicity of the metals to Artemia was Pb>Cd>Cu>Ni>Zn>Fe>Mn. Potency ratios of the seven metals were also calculated. The 24 and 48h variations obtained in LC sub(50) values were significantly different and relative implications of these are discussed.

Effect of different feeds and water salinities on the cyst production of brine shrimp, Artemia sp.

Effect of different feeds and salinities on cyst production in Artemia sp. was studied. Among the 12 different feeds used, ragi powder suspension showed the best growth and cyst production. A wide range of salinity from 90 to 210‰ was used to study its effect on cyst production. Among all these treatments, 130‰ salinity was found suitable for induction of oviparity and cyst production in the San Francisco Bay strain of Artemia sp.

On the measurement of concentration of blanching brine by electrical conductivity method

Blanching is an important operation in the shrimp canning process, in order to bring down the moisture content of the product to the required level, to allow the proteins to coagulate and to give proper texture, shape and characteristic pink colour to the meat. It has been observed that among other factors responsible for fluctuations in the drained weight in the canned prawns, concentration of brine used for blanching and the duration of blanching are important (Varma, Chaudhury and Pillai 1961). The papers gives details of experiments

Utilization of the fish waste self-brine of fish curing industry as farm fertilizer

Large quantities of self-brine accumulating in curing tanks during the process of commercial fish salting is mostly wasted at present. This liquor exuded from the fish during the process of salting contains considerable amounts of soluble proteins and minerals. Due to the presence of organic matter the self-brine quickly putrefies causing nauseating smell. This renders the whole surroundings insanitary and often leads to health hazards to neighboring localities. Any economic method of utilising this waste brine and converting it into some useful product will be a tangible help to the fish curing industry. Hence, a method is given for converting this waste self-brine into a cheap and efficient fertilizer.

Quality deterioration in tilapia during storage in refrigerated brine

During storage of Tilapia nilotica in refrigerated brine at 4°C, the whole (ungutted) fish had higher levels of free fatty acid and spoiled faster than the gutted fish. The shelf life of whole fish was 16 days and that of gutted 28 days; these values are, at least, as good as those reported for ice storage. Flavour of the cooked fish appeared to be the quahty-hm1tmg factor reducing the shelf-life of gutted tilapia to 28 days even though the raw gutted fish was judged acceptable, after 31 days retaining 65-70% freshness.

The use of decapsulated brine shrimp eggs as food for shrimp larvae

Decapsulated cysts of Artemia salina were experimentally fed to the larvae of Penaeus monodon, Metapenaeus ensis, M. endeavouri and Macrobrachium rosenbergii and were found to be comparable to freshly hatched brine shrimp nauplii.

Some observations on the growth and cyst production characteristics of the brine shrimp Artemia sp. (Gujarat strain) in pond culture and its potential for import substitution

Experimental culture of the brine shrimp Artemia sp. (Gujarat strain) and production of cyst is discussed. The qualitative and quantitative aspects of the cyst and its economic potential for import substitution are highlighted.

Survey of food supplementary (Pseudomonas fluorescence) and live food (Algae and brine shrimp) on Penaeus indicus larval stages

In this study ,the effects of Pseudomonas fluorescence obtained from generator pond water of Kolahi as supplementary and four algae consisting of : Chaetoceros sp, Chlorella and Skeletonema sp and Tetraselmis sp, three types of artemia as live food larval states from zoa to postlarvae (PL4 ) Penaeus indicus were investigated. The results indicate that Pseudomonas fluorescence has positive effect on Penaeus indicits larvae growth and their living food. Effective ranges at minimum and maximum were estimated. In most cases optimum dosage was approximately determined. Optimum dosage is between 50 -150 milligrams per liter for living food and Penaeus larval More than 200 milligram per liter resulted in a negative effect on the growth and survival. Also the results indicate Uromiana artemia. Requires a higher concentration of the bacteria the imported artemia. As a conclusion it is recommended to introduce Pseudonionas fluorescence as a new medium for the growth of some mentioned algae .

Experimental Investigation into the Production Behavior of Methane Hydrate in Porous Sediment with Hot Brine Stimulation

The gas production behavior from methane hydrate in porous sediment by injecting the brine with the salinity of 0−24 wt % and the temperature of −1 to 130 °C was investigated in a one-dimensional experimental apparatus. The results show that the gas production process consists of three periods: the free gas production, the hydrate dissociation, and the general gas reservoir production. The hydrate dissociation accompanies the temperature decrease with the injection of the brine (NaCl solution), and the dissociation duration is shortened with the increase of the salinity. With the injection of hot brine, instantaneous hydrate dissociation rate also increases with the increase of the salinity. However, while the NaCl concentration is beyond a certain value, the rate has no longer continued increasing. Thermal efficiency and energy ratio for the hydrate production can be enhanced by injecting hot brine, and the enhanced effectiveness is quite good with the injection of high salinity at lower temperature.

Identification of a novel DNA methyltransferase 2 from the brine shrimp, Artemia franciscana

DNA methyltransferase 2 (Dnmt2) is a dual-specificity DNA methyltransferase, which contains a weak DNA methyltransferase and novel tRNA methyltransferase activity. However, its biological function is still enigmatic. To elucidate the expression profiles of Dnmt2 in Artemia franciscana, we isolated the gene encoding a Dnmt2 from A. franciscana and named it as AfDnmt2. The cDNA of AfDnmt2 contained a 1140-bp open reading frame that encoded a putative Dnmt2 protein of 379 amino acids exhibiting 32%similar to 39% identities with other known Dnmt2 homologs. This is the first report of a DNA methyltransferase gene in Crustacean. By using semi-quantitative RT-PCR, A)Dnmt2 was found to be expressed through all developmental stages and its expression increased during resumption of diapause cysts development. Southern blot analysis indicated the presence of multiple copies of AfDnmt2 genes in A. franciscana. (C) 2007 Published by Elsevier Inc.