Cup Anemometer's loss of performance due to ageing process, and its effect on Annual energy Production (AEP) estimates

The deviation of calibration coefficients from five cup anemometer models over time was analyzed. The analysis was based on a series of laboratory calibrations between January 2001 and August 2010. The analysis was performed on two different groups of anemometers: (1) anemometers not used for any industrial purpose (that is, just stored); and (2) anemometers used in different industrial applications (mainly in the field—or outside—applications like wind farms). Results indicate a loss of performance of the studied anemometers over time. In the case of the unused anemometers the degradation shows a clear pattern. In the case of the anemometers used in the field, the data analyzed also suggest a loss of performance, yet the degradation does not show a clear trend. A recalibration schedule is proposed based on the observed performances variations

Analysis of calibration results from cup and propeller anemometers. Influence on wind turbine Annual Energy Production (AEP) calculations

The calibration coefficients of several models of cup and propeller anemometers were analysed. The analysis was based on a series of laboratory calibrations between January 2003 and August 2007. Mean and standard deviation values of calibration coefficients from the anemometers studied were included. Two calibration procedures were used and compared. In the first, recommended by the Measuring network of Wind Energy Institutes (MEASNET), 13 measurement points were taken over a wind speed range of 4 to 16  m  s−1. In the second procedure, 9 measurement points were taken over a wider speed range of 4 to 23  m  s−1. Results indicated no significant differences between the two calibration procedures applied to the same anemometer in terms of measured wind speed and wind turbines' Annual Energy Production (AEP). The influence of the cup anemometers' design on the calibration coefficients was also analysed. The results revealed that the slope of the calibration curve, if based on the rotation frequency and not the anemometer's output frequency, seemed to depend on the cup center rotation radius.

Modelling a cable structure for a new wind energy production device

Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para obtenção do grau de Mestre em Engenharia Mecânica Especialização em Concepção e Produção

Energy production from lipids by novel anaerobes

[Excerpt] Anaerobic microbial diversity encloses a very high potential that can be used for biotechnological applications. This potential is still largely unexplored, since the majority of the microorganisms in Nature are unknown or poorly characterized. This work is focused on the study of novel anaerobic microorganisms that participate in the metabolism of lipids, long chain fatty acids (LCFA) and glycerol, with the main goal of producing valuable energy-rich organic compounds. For that, conventional anaerobic culturing procedures were combined with continuous bioreactors operation and allied to microbial ecology approaches. Two main examples of the work performed will be presented. (...)

The Rebound Effect with Energy Production: A Partial Equilibrium Analysis

Rebound is the extent to which improvements in energy efficiency fail to translate fully into reductions in energy use because of the implicit fall in the price of energy, when measured in efficiency units. This paper discusses aspects of the rebound effect that are introduced once energy is considered as a domestically produced commodity. A partial equilibrium approach is adopted in order to incorporate both energy use and production in a conceptually tractable way. The paper explores analytically two interesting results revealed in previous numerical simulations. The first is the possibility that energy use could fall by more than the implied improvement in efficiency. This corresponds to negative rebound. The second is the finding that the short-run rebound value can be greater than the corresponding long-run value.

Distributed Energy Production in the North-West Region of Russia

The energy system of Russia is the world's fourth largest measured by installed power. The largest are that of the the United States of America, China and Japan. After 1990, the electricity consumption decreased as a result of the Russian industry crisis. The vivid economic growth during the latest few years explains the new increase in the demand for energy resources within the State. In 2005 the consumption of electricity achieved the maximum level of 1990 and continues to growth. In the 1980's, the renewal of power facilities was already very slow and practically stopped in the 1990's. At present, the energy system can be very much characterized as outdated, inefficient and uneconomic because of the old equipment, non-effective structure and large losses in the transmission lines. The aim of Russia's energy reform, which was started in 2001, is to achieve a market based energy policy by 2011. This would thus remove the significantly state-controlled monopoly in Russia's energy policy. The reform will stimulateto decrease losses, improve the energy system and employ energy-saving technologies. The Russian energy system today is still based on the use of fossil fuels, and it almost totally ignores the efficient use of renewable sources such as wind, solar, small hydro and biomass, despite of their significant resources in Russia. The main target of this project is to consider opportunities to apply renewable energy production in the North-West Federal Region of Russia to partly solve the above mentioned problems in the energy system.

Risk Management Services in Energy Production

Työ käsittelee energian tuotannossa esiintyviä tärkeimpiä taloudellisia ja teknisiä riskejä sekä niiden hallitsemista energian tuottajan näkökulmasta. Ensiksi käsitellään yleisesti riskienhallintaa, eri riskityyppejä ja esitetään periaatteellinen riskienhallintaprosessi. Sen jälkeen tarkastellaan energiamarkkinoiden nykytilannetta lähinnä Pohjoismaiden tasolla ja verrataan sitä aikaisempaan tilanteeseen energian tuottajan kannalta. Tämä siksi, että energiamarkkinoiden vapautuminen on muuttanut merkittävästi energian tuotantoon liittyviä taloudellisia riskejä, käytännössä lisännyt niitä. Pääpaino on energian tuotannossa esiintyvien olennaisten riskien tarkastelussa ja niiden hallitsemisessa. Ensin esitellään työn kannalta olennaiset riskit ja tekijät joista ne aiheutuvat. Jokainen riski ja sen aiheuttamat haitat liiketoiminnalle kuvataan lyhyesti. Sen jälkeen kiinnitetään huomiota asioihin, jotka ovat tyypillisiä energian tuotannolle ja aiheuttavat samalla erikoisvaatimuksia riskienhallinnalle. Sitten käydään läpi sopivat riskienhallinnan menetelmät, jotka ovat yleisesti käytössä energian tuotannossa, aiemmin esitetyille olennaisille riskeille. Esitetyistä riskienhallinta menetelmistä useimpia ei ole kohdistettu millekään yksittäiselle riskille, vaan monia niistä voidaan käyttää useammankin riskin hallintaan.

Utilisation of biomass for energy production in the North-West Russian forest industry

Traditionally, fossil fuels have always been the major sources of the modern energy production. However prices on these energy sources have been constantly increasing. The utilization of local biomass resources for energy production can substitute significant part of the required energy demand in different energy sectors. The introduction of the biomass usage can easily be started in the forest industry first as it possesses biomass in a large volume. The forest industry energy sector has the highest potential for the fast bioenergy development in the North-West Russia. Therefore, the question concerning rational and effective forest resources use is important today as well as the utilization of the forestry by-products. This work describes and analyzes the opportunities of utilising biomass, mainly, in the form of the wood by-products, for energy production processes in general, as well as for the northwest Russian forest industry conditions. The study also covers basic forest industry processes and technologies, so, the reader can get familiar with the information about the specific character of the biomass utilization. The work gives a comprehensive view on the northwest forest industry situation from the biomass utilisation point of view. By presenting existing large-scale sawmills and pulp and paper mills the work provides information for the evaluation of the future development of CHP investments in the northwest Russian forest industry.

Small scale energy production in Helsinki Metropolitan area in emission trading point of view

Emission trading with greenhouse gases and green certificates are part if the climate policy the main target of which is reduce greenhouse gas emissions. The carbon dioxide and fine particle emissions of energy production in Helsinki Metropolitan area are calculated in this study. The analysis is made mainly by district heating point of view and the changes of the district heating network are assessed. Carbon dioxide emissions would be a bit higher, if the district heating network is expanded, but then the fine particle emissions would be much lower. Carbon dioxide emissions are roughly 10 % higher, if the district heating network is expanded at same rate as it has in past five years in the year 2030. The expansion of district heating network would decrease the fine particle emissions about 40 %. The cost of the expansion is allocated to be reduction cost of the fine particle emissions, which is considerably higher than the traditional reduction methods costs. The possible new nuclear plant would reduce the emissions considerably and the costs of the nuclear plant would be relatively low comparing the other energy production methods.

Sustainable Waste-to-Energy Production: Performance Evaluation of Distributed Generation fuelled by Landfill Gas

The environmental impact of landfill is a growing concern in waste management practices. Thus, assessing the effectiveness of the solutions implemented to alter the issue is of importance. The objectives of the study were to provide an insight of landfill advantages, and to consolidate landfill gas importance among others alternative fuels. Finally, a case study examining the performances of energy production from a land disposal at Ylivieska was carried out to ascertain the viability of waste to energy project. Both qualitative and quantitative methods were applied. The study was conducted in two parts; the first was the review of literatures focused on landfill gas developments. Specific considerations were the conception of mechanism governing the variability of gas production and the investigation of mathematical models often used in landfill gas modeling. Furthermore, the analysis of two main distributed generation technologies used to generate energy from landfill was carried out. The review of literature revealed a high influence of waste segregation and high level of moisture content for waste stabilization process. It was found that the enhancement in accuracy for forecasting gas rate generation can be done with both mathematical modeling and field test measurements. The result of the case study mainly indicated the close dependence of the power output with the landfill gas quality and the fuel inlet pressure.

Utilization of Meat and bone meal for energy production

At the end of the 1990s the stock breeding in the Europe was suffering from the animal disease epidemics such as Bovine spongiform encephalopathy (BSE) and foot –and mouth disease. The European Union (EU) tackled to this problem by tightening the legislation of animal by-products. At this point, rendering and fat producing industries faces new challenges, which they have to cope with in a way of trying to find alternatives to their products (animal fats and meat and bone meal). One of the most promising alternatives to utilize these products was to use them in energy production purposes. The purpose of the Thesis was to examine the utilization possibilities of Meat and bone meal (MBM) for energy production. The first part of the Thesis consists of theory part. The theory part includes evaluation of basic properties of MBM as a fertilizer and as a fuel, legislative evaluation and evaluation of different burning techniques. The second part of the Thesis consists of burning tests in Energy laboratory of LUT with different mixtures of peat and MBM. The purpose of the burning tests was to identify co-firing possibilities of peat and MBM and emission- and ash properties for peat and MBM.

An Economic Analysis of Wind Energy Production in the Remote Areas of Quebec.

Rapport de recherche

Évaluation de la modélisation et des prévisions de la vitesse du vent menant à l'estimation de la production d'énergie annuelle d'une turbine éolienne

Suite à un stage avec la compagnie Hatch, nous possédons des jeux de données composés de séries chronologiques de vitesses de vent mesurées à divers sites dans le monde, sur plusieurs années. Les ingénieurs éoliens de la compagnie Hatch utilisent ces jeux de données conjointement aux banques de données d’Environnement Canada pour évaluer le potentiel éolien afin de savoir s’il vaut la peine d’installer des éoliennes à ces endroits. Depuis quelques années, des compagnies offrent des simulations méso-échelle de vitesses de vent, basées sur divers indices environnementaux de l’endroit à évaluer. Les ingénieurs éoliens veulent savoir s’il vaut la peine de payer pour ces données simulées, donc si celles-ci peuvent être utiles lors de l’estimation de la production d’énergie éolienne et si elles pourraient être utilisées lors de la prévision de la vitesse du vent long terme. De plus, comme l’on possède des données mesurées de vitesses de vent, l’on en profitera pour tester à partir de diverses méthodes statistiques différentes étapes de l’estimation de la production d’énergie. L’on verra les méthodes d’extrapolation de la vitesse du vent à la hauteur d’une turbine éolienne et l’on évaluera ces méthodes à l’aide de l’erreur quadratique moyenne. Aussi, on étudiera la modélisation de la vitesse du vent par la distributionWeibull et la variation de la distribution de la vitesse dans le temps. Finalement, l’on verra à partir de la validation croisée et du bootstrap si l’utilisation de données méso-échelle est préférable à celle de données des stations de référence, en plus de tester un modèle où les deux types de données sont utilisées pour prédire la vitesse du vent. Nous testerons la méthodologie globale présentement utilisée par les ingénieurs éoliens pour l’estimation de la production d’énergie d’un point de vue statistique, puis tenterons de proposer des changements à cette méthodologie, qui pourraient améliorer l’estimation de la production d’énergie annuelle.