Biomechanical stability of a posterior-alone fixation technique after craniovertebral junction realignment.

OBJECTIVE: The aim of the current study was to investigate the biomechanical stability and fixation strength provided by a posterior approach reconstruction technique to realign the craniovertebral junction.¦METHODS: We tested seven human cadaver occipito-cervical spines (occiput-C4) by applying pure moments of ±1.5 Nm on a spine tester. Each specimen was tested in the following modes: 1) intact; 2) injured; 3) spacers alone at C1-C2 articulation (S); 4) spacers plus C1-C2 Posterior Instrumentation (S+PI); and 5) spacers plus C1-C2 posterior instrumentation plus midline wiring (S+PI+MLW). C1-C2 range of motion for each construct was obtained in flexion-extension, lateral bending, and axial rotation.¦RESULTS: In all the loading modes, S, S+PI, and S+PI+MLW constructs significantly reduced range of motion compared with the intact and injured condition (P < 0.05). There was no statistical difference between any of the three instrumentation constructs (P > 0.05).¦CONCLUSIONS: This study investigated the biomechanics of the posterior approach technique for realignment of the craniovertebral junction and also made comparisons with additional posterior fixations. The stand-alone spacers were stable in all three loading modes. Posterior instrumentation increased the stability as compared to stand-alone spacers. The third point of fixation, carried out by using midline wiring, increased the stability further. However, there was not much difference in the stability imparted with the midline wiring versus without. The present study highlights the biomechanics of this novel concept and reaffirms the view that distraction of the C1-C2 articular facets and direct articular joint atlantoaxial fixation would be an ideal method of management of basilar invagination.

Capital realignment for moderate and severe SCFE using a modified Dunn procedure

Moderate to severe slipped capital femoral epiphysis leads to premature osteoarthritis resulting from femoroacetabular impingement. We believe surgical correction at the site of deformity through capital reorientation is the best procedure to fully correct the deformity but has traditionally been associated with high rates of osteonecrosis. We describe a modified capital reorientation procedure performed through a surgical dislocation approach. We followed 40 patients for a minimum of 1 year and 3 years from two institutions. No patient developed osteonecrosis or chondrolysis. Slip angle was corrected to 4 degrees to 8 degrees and the mean alpha angle after correction was 40.6 degrees. Articular cartilage damage, full-thickness loss, and delamination were observed at the time of surgery, especially in the stable slips. This technique appears to have an acceptable complication rate and appears reproducible for full correction of moderate to severe slipped capital femoral epiphyses with open physes.

Cavovarus Foot Realignment to Treat Anteromedial Ankle Arthrosis

Background: Adult patients with cavovarus feet were seen with symptomatic anteromedial ankle arthrosis and, frequently, lateral hindfoot instability. Static and dynamic realignment was performed to redistribute joint contact pressures and restore stability. Methods: Thirteen patients with fixed cavovarus feet (6 neurogenic, 7 idiopathic; 6 with hindfoot instability, 7 without) and mild to moderate anteromedial ankle arthrosis were treated by osteotomies and tendon transfers but no lateral ligament reconstruction. Anteromedial cheilectomy of the ankle was added to increase dorsiflexion and alleviate anteromedial impingement. Results: Failure occurred in 2 patients, who required additional procedures. The remaining 11 patients improved from preoperative 45 to 71 points (American Orthopaedic Foot and Ankle Society Ankle-Hindfoot Scale score) at the latest follow-up (average 84 months). Ankle dorsiflexion improved 7 degrees on average. There was no recurrent hindfoot instability and no progression of anteromedial ankle arthrosis over time. Conclusion: Cavovarus foot realignment with anteromedial ankle cheilectomy reliably improved patients’ symptoms related to ankle arthrosis, restored lateral hindfoot stability, and stabilized the extent of anteromedial ankle arthrosis when talar varus tilt was reduced. Level of Evidence: Level IV, retrospective case series.

Portado del algoritmo de Viterbi a una arquitectura multiprocesador

Cada vez es más frecuente que los sistemas de comunicaciones realicen buena parte de sus funciones (modulación y demodulación, codificación y decodificación...) mediante software en lugar de utilizar hardware dedicado. Esta técnica se denomina “Radio software”. El objetivo de este PFC es estudiar un algoritmo implementado en C empleado en sistemas de comunicaciones modernos, en concreto la decodificación de Viterbi, el cual se encarga de corregir los posibles errores producidos a lo largo de la comunicación, para poder trasladarlo a sistemas empotrados multiprocesador. Partiendo de un código en C para el decodificador que realiza todas sus operaciones en serie, en este Proyecto fin de carrera se ha paralelizado dicho código, es decir, que el trabajo que realizaba un solo hilo para el caso del código serie, es procesado por un número de hilos configurables por el usuario, persiguiendo que el tiempo de ejecución se reduzca, es decir, que el programa paralelizado se ejecute de una manera más rápida. El trabajo se ha realizado en un PC con sistema operativo Linux, pero la versión paralelizada del código puede ser empleada en un sistema empotrado multiprocesador en el cual cada procesador ejecuta el código correspondiente a uno de los hilos de la versión de PC. ABSTRACT It is increasingly common for communications systems to perform most of its functions (modulation and demodulation, coding and decoding) by software instead of than using dedicated hardware. This technique is called: “Software Radio”. The aim of the PFC is to study an implemented algorithm in C language used in modern communications systems, particularly Viterbi decoding, which amends any possible error produced during the communication, in order to be able to move multiprocessor embedded systems. Starting from a C code of the decoder that performs every single operation in serial, in this final project, this code has been parallelized, which means that the work used to be done by just a single thread in the case of serial code, is processed by a number of threads configured by the user, in order to decrease the execution time, meaning that the parallelized program is executed faster. The work has been carried out on a PC using Linux operating system, but the parallelized version of the code could also be used in an embedded multiprocessor system in which each processor executes the corresponding code to every single one of the threads of the PC version.

Disapproving the recommendations of the Defense Base Closure and Realignment Commission : adverse report of the Committee on Armed Services, House of Representatives, on H.J. Res. 65, together with additional and dissenting views (including cost estimate of the Congressional Budget Office).

"September 29, 2005."

Study of EEPN mitigation using modified RF pilot and Viterbi-Viterbi based phase noise compensation

We propose - as a modification of the optical (RF) pilot scheme -a balanced phase modulation between two polarizations of the optical signal in order to generate correlated equalization enhanced phase noise (EEPN) contributions in the two polarizations. The method is applicable for n-level PSK system. The EEPN can be compensated, the carrier phase extracted and the nPSK signal regenerated by complex conjugation and multiplication in the receiver. The method is tested by system simulations in a single channel QPSK system at 56 Gb/s system rate. It is found that the conjugation and multiplication scheme in the Rx can mitigate the EEPN to within 1/2 orders of magnitude. Results are compared to using the Viterbi-Viterbi algorithm to mitigate the EEPN. The latter method improves the sensitivity more than two orders of magnitude. Important novel insight into the statistical properties of EEPN is identified and discussed in the paper. © 2013 Optical Society of America.

Phase noise tolerance study in coherent optical circular QAM transmissions with Viterbi- Viterbi carrier phase estimation

We present a performance evaluation of a non-conventional approach to implement phase noise tolerant optical systems with multilevel modulation formats. The performance of normalized Viterbi-Viterbi carrier phase estimation (V-V CPE) is investigated in detail for circular m-level quadrature amplitude modulation (C-mQAM) signals. The intrinsic property of C-mQAM constellation points with a uniform phase separation allows a straightforward employment of V-V CPE without the need to adapt constellation. Compared with conventional feed-forward CPE for square QAM signals, the simulated results show an enhanced tolerance of linewidth symbol duration product (ΔvTs) at a low sensitivity penalty by using feed-forward CPE structure with C-mQAM. This scheme can be easily upgraded to higher order modulations without inducing considerable complexity.

Cleavage Politics in Changing Times. Political Realignment Processes in Western European Countries

The dissertation fits the political realignment literature and aims to pro-vide further insights into cleavage politics by investigating voting behaviour in the Western European countries’ national elections. In particular, the dis-sertation focuses on the class and value voting patterns and on the change of these patterns in different countries and over the course of time. Peculiar pro-cesses affected all Western European party systems: whilst the «traditional» cleavage theory accounts for National and Industrial revolutions, those pro-cesses assumed to constitute the «societal modernization» determined chang-es in electoral competitions that questioned the relevance of individuals’ so-cial positions to study electoral preferences. Since the associations between social positions and voting behaviour underpin the so-called political cleav-age, the dealignment perspective assumes them to have been eroding since the second half of the XX century. On the other hand, the realignment perspective argues that the cleavage theory still accounts for individuals’ vote choices: of the four «traditional» cleavages, this perspective hypothesizes new class vot-ing patterns and alignments between electoral preferences and a new line of conflict, that is based on values. The dissertation provides a theoretical ac-count of the realignment of the class cleavage and a new conceptualization of value voting. Then, class and value voting patterns are explored. The analyses employ European Social Survey data and detect general and country-specific patterns. The dissertation adopts a mediation perspective and aims to observe how class voting patterns change when controlling for value orientations. The results are provided with a sensitivity analysis, indeed two versions of the measures computed for value orientations are compared. The findings show that social class continues to affect voting behaviour and that value orienta-tions both mediate this effect and affect electoral preferences.

O direito das minorias e as nações indígenas no Brasil

O presente artigo trata de questões da história, do direito, da economia, da antropologia, da sociologia, da política, no que tange a minorias, salientando alguns marcos significativos da política indigenista brasileira na década de 1980. No que tange aos direitos humanos aplicados às minorias, se anteriormente o fulcro era a proteção desses direitos, hoje se demanda a sua regulação e a garantia jurídica, fomentando uma reordenação dessas relações. Essa foi uma grande contribuição da Constituição de 1988 no que diz respeito às comunidades indígenas que habitam o território nacional.

West (side) and north (rear) elevations, public housing, Cotton Tree Housing Estate, Maroochydore

This pilot project at Cotton Tree, Maroochydore, on two adjacent, linear parcels of land has one of the properties privately owned while the other is owned by the public housing authority. Both owners commissioned Lindsay and Kerry Clare to design housing for their separate needs which enabled the two projects to be governed by a single planning and design strategy. This entailed the realignment of the dividing boundary to form two approximately square blocks which made possible the retention of an important stand of mature paperbark trees and gave each block a more useful street frontage. The scheme provides seven two-bedroom units and one single-bedroom unit as the private component, with six single-bedroom units, three two-bedroom units and two three-bedroom units forming the public housing. The dwellings are deployed as an interlaced mat of freestanding blocks, car courts, courtyard gardens, patios and decks. The key distinction between the public and private parts of the scheme is the pooling of the car parking spaces in the public housing to create a shared courtyard. The housing climbs to three storeys on its southern edge and falls to a single storey on the north-western corner. This enables all units and the principal private outdoor spaces to have a northern orientation. The interiors of both the public and private units are skilfully arranged to take full advantage of views, light and breeze.

View northeast over single story apartment, Cotton Tree Housing Estate, Maroochydore

This pilot project at Cotton Tree, Maroochydore, on two adjacent, linear parcels of land has one of the properties privately owned while the other is owned by the public housing authority. Both owners commissioned Lindsay and Kerry Clare to design housing for their separate needs which enabled the two projects to be governed by a single planning and design strategy. This entailed the realignment of the dividing boundary to form two approximately square blocks which made possible the retention of an important stand of mature paperbark trees and gave each block a more useful street frontage. The scheme provides seven two-bedroom units and one single-bedroom unit as the private component, with six single-bedroom units, three two-bedroom units and two three-bedroom units forming the public housing. The dwellings are deployed as an interlaced mat of freestanding blocks, car courts, courtyard gardens, patios and decks. The key distinction between the public and private parts of the scheme is the pooling of the car parking spaces in the public housing to create a shared courtyard. The housing climbs to three storeys on its southern edge and falls to a single storey on the north-western corner. This enables all units and the principal private outdoor spaces to have a northern orientation. The interiors of both the public and private units are skilfully arranged to take full advantage of views, light and breeze.