Does the Triple P-Positive Parenting Program provide value for money?

Objective: The aim of the present study was to investigate the economic case for the implementation of the Triple P- Positive Parenting Program on a population basis in Queensland, Australia, in order to reduce the prevalence of conduct disorder in children. Method: Threshold analysis was undertaken together with a limited cost-effectiveness analysis. Results: The Triple P-Positive Parenting Program is a dominant intervention; that is, it costs less than the amount it saves, until the reduction in prevalence falls below 7% where net costs become positive. Conclusions: Triple P is likely to be a worthwhile use of limited health funds. The economic case is promising, but further research is required to confirm the study results.

Implementation of Triple P-Positive Parenting Program in Hong Kong: Predictors of programme completion and clinical outcomes

This study examined the effectiveness of the Triple P-Positive Parenting Program in a government child health service delivery context with Chinese parents in Hong Kong. Specifically, the study sought to identify pre-intervention variables that might predict programme outcomes such as, level of clinical improvement and programme completion. Participants were 661 parents of pre-school and primary aged children participating in a group version of the Triple P-Positive Parenting Program. There were significant decreases in disruptive child behaviours, levels of parenting stress, general stress and anxiety and an increase in parenting sense of competence. Greater change in reports of child behaviour problems was related to lower levels of family income, new immigrant family status, and higher pre-intervention levels of parenting stress. The present study provides a profile of parents who are most likely to benefit from parent training programmes.

Towards a public health approach to parenting

There are various parenting, school and personal factors at play in determining a child’s risk of developing serious conduct problems. The temptation is therefore to conclude that “more is better than less”, but we think that has not been convincingly demonstrated. Some large-scale multi-risk-factor reduction approaches that include parenting, school and child-specific interventions with older school-aged children have shown promise but are complex to administer, costly to implement and have yet to show strong long-term outcomes. But in young children (toddler and preschool-aged children) there is strong evidence that social-learning-based parenting programmes are effective with a wide range of families from quite diverse socio-economic and ethnic backgrounds. We choose to focus on such programmes.

The explicit hazard model – part 1: theoretical development

Modern Engineering Asset Management (EAM) requires the accurate assessment of current and the prediction of future asset health condition. Appropriate mathematical models that are capable of estimating times to failures and the probability of failures in the future are essential in EAM. In most real-life situations, the lifetime of an engineering asset is influenced and/or indicated by different factors that are termed as covariates. Hazard prediction with covariates is an elemental notion in the reliability theory to estimate the tendency of an engineering asset failing instantaneously beyond the current time assumed that it has already survived up to the current time. A number of statistical covariate-based hazard models have been developed. However, none of them has explicitly incorporated both external and internal covariates into one model. This paper introduces a novel covariate-based hazard model to address this concern. This model is named as Explicit Hazard Model (EHM). Both the semi-parametric and non-parametric forms of this model are presented in the paper. The major purpose of this paper is to illustrate the theoretical development of EHM. Due to page limitation, a case study with the reliability field data is presented in the applications part of this study.

Agaricus blazei (Himematsutake) does not alter the development of rat diethylnitrosamine-initiated hepatic preneoplastic foci

The modifying potential of crude extracts of the mushroom Agaricus blazei Murrill (Himematsutake) on the development and growth of glutathione S-transferase placental form (GST-P)-positive liver foci (liver preneoplastic lesion) was investigated in adult male Wistar rats. Six groups of animals were used. Groups 2 to 5 were given a single i.p. injection of 200 mg/kg b.w. of diethylnitrosamine (DEN) and groups 1 and 6 were treated with saline at the beginning of the experiment. After 2 weeks, animals of groups 3 to 6 were orally treated with three dose levels of aqueous extracts of the mushroom A. blazei (1.2, 5.6, 11.5, and 11.5 mg/ml of dry weight of solids) for 6 weeks. All animals were subjected to two-thirds partial hepatectomy at week 3 and sacrificed at week 8. Two hours before sacrifice, ten animals of each group were administered a single i.p injection of 100 mg/kg of bromodeoxyuridine (BrdU). Apoptotic bodies and BrdU-positive hepatocyte nuclei were quantified in liver sections stained for hematoxylin and eosin (H&E) (eosinophilic foci) and simultaneously stained for GST-P expression (GST-P-positive foci), respectively. The 6-week treatment with A. blazei did not alter the development (number and size) of GST-P-positive foci and did not affect the growth kinetics of liver normal parenchyma or foci in DEN-initiated animals. Our results indicate that the treatment with aqueous extracts of the mushroom A. blazei during the post-initiation stage of rat liver carcinogenesis does not exert any protective effect against the development of GST-P-positive foci induced by DEN. (Cancer Sci 2003; 94: 188-192).

Anti-mosquito midgut antibodies block development of Plasmodium falciparum and Plasmodium vivax in multiple species of Anopheles mosquitoes and reduce vector fecundity and survivorship

The mosquito midgut plays a central role in the sporogonic development of malaria parasites. We have found that polyclonal sera, produced against mosquito midguts, blocked the passage of Plasmodium falciparum ookinetes across the midgut, leading to a significant reduction of infections in mosquitoes. Anti-midgut mAbs were produced that display broad-spectrum activity, blocking parasite development of both P. falciparum and Plasmodium vivax parasites in five different species of mosquitoes. In addition to their parasite transmission-blocking activity, these mAbs also reduced mosquito survivorship and fecundity. These results reveal that mosquito midgut-based antibodies have the potential to reduce malaria transmission in a synergistic manner by lowering both vector competence, through transmission-blocking effects on parasite development, and vector abundance, by decreasing mosquito survivorship and egg laying capacity. Because the intervention can block transmission of different malaria parasite species in various species of mosquitoes, vaccines against such midgut receptors may block malaria transmission worldwide.

Development of a triple stage heat transformer for the recycling of low temperature heat energy

Absorption heat transformers are thermodynamic systems which are capable of recycling industrial waste heat energy by increasing its temperature. Triple stage heat transformers (TAHTs) can increase the temperature of this waste heat by up to approximately 145˚C. The principle factors influencing the thermodynamic performance of a TAHT and general points of operating optima were identified using a multivariate statistical analysis, prior to using heat exchange network modelling techniques to dissect the design of the TAHT and systematically reassemble it in order to minimise internal exergy destruction within the unit. This enabled first and second law efficiency improvements of up to 18.8% and 31.5% respectively to be achieved compared to conventional TAHT designs. The economic feasibility of such a thermodynamically optimised cycle was investigated by applying it to an oil refinery in Ireland, demonstrating that in general the capital cost of a TAHT makes it difficult to achieve acceptable rates of return. Decreasing the TAHT's capital cost may be achieved by redesigning its individual pieces of equipment and reducing their size. The potential benefits of using a bubble column absorber were therefore investigated in this thesis. An experimental bubble column was constructed and used to track the collapse of steam bubbles being absorbed into a hotter lithium bromide salt solution. Extremely high mass transfer coefficients of approximately 0.0012m/s were observed, showing significant improvements over previously investigated absorbers. Two separate models were developed, namely a combined heat and mass transfer model describing the rate of collapse of the bubbles, and a stochastic model describing the hydrodynamic motion of the collapsing vapour bubbles taking into consideration random fluctuations observed in the experimental data. Both models showed good agreement with the collected data, and demonstrated that the difference between the solution's temperature and its boiling temperature is the primary factor influencing the absorber's performance.

Development of a GEM Electronic Board (GEB) for triple-GEM detectors

Developed for use with triple GEM detectors, the GEM Electronic Board (GEB) forms a crucial part of the electronics readout system being developed as part of the CMS muon upgrade program. The objective of the GEB is threefold; to provide stable powering and ground for the VFAT3 front ends, to enable high-speed communication between 24 VFAT3 front ends and an optohybrid, and to shield the GEM detector from electromagnetic interference. The paper describes the concept and design of a large-size GEB in detail, highlighting the challenges in terms of design and feasibility of this deceptively difficult system component.

Development of novel brush-type chiral stationary phases based on terpenoid selectors: HPLC evaluation and theoretical investigation of enantioselective binding interactions

The terpenoid chiral selectors dehydroabietic acid, 12,14-dinitrodehydroabietic acid and friedelin have been covalently linked to silica gel yielding three chiral stationary phases CSP 1, CSP 2 and CSP 3, respectively. The enantiodiscriminating capability of each one of these phases was evaluated by HPLC with four families of chiral aromatic compounds composed of alcohols, amines, phenylalanine and tryptophan amino acid derivatives and beta-lactams. The CSP 3 phase, containing a selector with a large friedelane backbone is particularly suitable for resolving free alcohols and their derivatives bearing fluorine substituents, while CSP 2 with a dehydroabietic architecture is the only phase that efficiently discriminates 1, 1'-binaphthol atropisomers. CSP 3 also gives efficient resolution of the free amines. All three phases resolve well the racemates of N-trifluoracetyl and N-3,5-dinitrobenzoyl phenylalanine amino acid ester derivatives. Good enantioseparation of beta-lactams and N-benzoyl tryptophan amino acid derivatives was achieved on CSP 1. In order to understand the structural factors that govern the chiral molecular recognition ability of these phases, molecular dynamics simulations were carried out in the gas phase with binary diastereomeric complexes formed by the selectors of CSP 1 and CSP 2 and several amino acid derivatives. Decomposition of molecular mechanics energies shows that van der Waals interactions dominate the formation of the diastereomeric transient complexes while the electrostatic binding interactions are primarily responsible for the enantioselective binding of the (R)- and (S)-analytes. Analysis of the hydrogen bonds shows that electrostatic interactions are mainly associated with the formation of N-(HO)-O-...=C enantio selective hydrogen bonds between the amide binding sites from the selectors and the carbonyl groups of the analytes. The role of mobile phase polarity, a mixture of n-hexane and propan-2-ol in different ratios, was also evaluated through molecular dynamics simulations in explicit solvent. (c) 2006 Elsevier Ltd. All rights reserved.

A procedure to estimate parameters of a line segment taking into account its representation through pi circuits: Theoretical development

The objective of this paper is to show an alternative methodology to estimate per unit length parameters of a line segment of a transmission line. With this methodology the line segment parameters can be obtained starting from the phase currents and -voltages in receiving and sending end of the line segment. If the line segment is represented as being one or more pi circuits whose frequency dependent parameters are considered lumped, its impedance and admittance can be easily expressed as functions of the currents and voltages at the sending and receiving end. Because we are supposing that voltages and currents at the sending and receiving end of the tine segment (in frequency domain) are known, it is possible to obtains its impedance and admittance and consequently its per unit length longitudinal and transversal parameters. The procedure will be applied to estimate the longitudinal and transversal parameters of a small segment of a single-phase line that is already built.