International tourists and road safety in Australia: developing a national research and management programme

Motor vehicle crashes are the leading cause of injury death for international tourists. This makes road safety an important issue for tourism authorities. Unfortunately, as it is in other areas of tourist health, the common response from the travel and tourism industry is to remain silent about this problem and to leave any mishaps in the hands of insurers. At the same time, but for different reasons, international tourists are not usually targeted for road safety initiatives by transport authorities. Given that there are considerable 'hidden' costs associated with international tourists and motor vehicle crashes, the topic should be of concern to both tourism and transport groups. This paper examines issues concerned with driving in unfamiliar surroundings for international visitors in Australia, and proposes a national research and management programme to guide policy and planning in the area. (C) 1999 Elsevier Science Ltd. All rights reserved.

Curving simulation and stability of a creep-controlled wheelset for high speed rail-vehicles

Higher travel speeds of rail vehicles will be possible by developing sophisticated top performance bogies having creep-controlled wheelsets. In this case the torque transmission between the right and the left wheel is realized by an actively controlled creep coupling. To investigate hunting stability and curving capability the linear equations of motion are written in state space notation. Simulation results are obtained with realistic system parameters from industry and various controller gains. The advantage of the „creep-controlled wheelset" is discussed by comparison the simulation results with the dynamic behaviour of the special cases „solid-axle wheelset" and „loose wheelset" (independent rotation of the wheels). The stability is also investigated with a root-locus analysis.

Time and distance in acceleration of road commercial vehicles

The time and the distance traveled during the acceleration and the velocity retaking are parameters used for the comparison and the project of vehicles. In this paper equations for the calculation of those parameters are presented. Several criteria are presented for the shift gears. It is also verified the occurrence or not of total slip during the acceleration of the vehicle. The theoretical models were implemented in a developed computational system. Such system was applied in a Mercedes-Benz do Brazil sample vehicle, in order to facilitate comparisons between the simulate values and the experimental road tests. Copyright © 1997 Society of Automotive Engineers, Inc.

Fuel consumption of road commercial vehicles in the driving schedule

The fuel consumption is an important factor in the vehicle development due the fact that it has a direct effect on its trade aims. Besides that, it is known that the petrol is a scarce fuel. In this paper it is presented a procedure of fuel consumption calculation for a vehicle traveling in driving schedule. In such calculation it has been taken into account the operational conditions (load, pavement, climbing road, among others) and the building characteristics (map engine, transmission, frontal area, tire, among others) of road vehicles. There has also been an application of the theoretical model developed in a sample Mercedes-Benz do Brasil vehicle which has been compared with the values of experimental tests. Copyright © 1997 Society of Automotive Engineers, Inc.

The Topographical, statistical, and historical gazetteer of Scotland : with a complete county-atlas from recent surveys, exhibiting all the lines of road, rail, and canal communication and an appendix, containing the results in detail of the census of 1851.

Includes bibliographical references and indexes.

The economic costs of road traffic crashes: Australia, states and territories

In this paper, we obtain detailed data on road traffic crash (RTC) casualties, by severity, for each of the eight state and territory jurisdictions for Australia and use these to estimate and compare the economic impact of RTCs across these regions. We show that the annual cost of RTCs in Australia, in 2003, was approximately $17b, which is approximately 2.3% of the Gross Domestic Product (GDP). Importantly, though, there is remarkable intra-national variation in the incident rates of RTCs in Australia and costs range from approximately 0.62 to 3.63% of Gross State Product (GSP). The paper makes two fundamental contributions: (i) it provides a detailed breakdown of estimated RTC casualties, by state and territory regions in Australia, and (ii) it presents the first sub-national breakdown of RTC costs for Australia. We trust that these contributions will assist policy-makers to understand sub-national variations in the road toll better and will encourage further research on the causes of the marked differences between RTC outcomes across the states and territories of Australia. (c) 2006 Elsevier Ltd. All rights reserved.

Public and Private Sector Decision Makers Within the Rail Baltica Growth Corridor

Transport volumes have increased and will continue to increase in European Union. Even though the growth has not been equal between different transport modes. Most of the growth has been faced on road transport. European Union aims to balance the unbalanced market shares between the modes by gaining and supporting the competitiveness of railway and waterway transport. In EU railway transportation is seen as solution to increase safety in traffic and decrease the environmental impacts of transportation. The aim of this research is to figure out how it is possible to decrease the environmental impacts by the technology already in use. Main focus of this research is in intermodality and combining the road and railway transportation. This study aims also to figure out demands and expectations towards new Rail Baltica railway route connecting Tallinn and Berlin. The research is conducted by performing a literature review about decreasing environmental impacts and combining road and rail transport. Another viewpoint is taken from the possible effects of tourism to the passenger transport on rails. Knowledge gained by literature review is deepened by additional internet questionnaire study and expert interview study. In decreasing the environmental impacts of transportation electric trains are definitely the best option providing that the electricity is generated from renewable or carbon dioxide free sources. Decrease of environmental impacts has been reached also with acceptance of larger road transport vehicles. According to interviewed passenger transport experts, the whole route from Tallinn to Berlin may not be convenient to be used in passenger transport, just because the route is too long.. In EU freight is transported mainly with semi-trailer combinations, and that is why it could be logical if huckepack trains would be used on Rail Baltica. Huckepack train allows semi-trailers to be transported on rails with time efficient loading-unloading process. Overall, Rail Baltica project is experienced as a future-oriented one and new railway alignment is seen as great alternative option for transport modes using fossil fuels.