Behavior of geopolymer concrete exposed to elevated temperatures

The research in the area of geopolymer is gaining momentum during the past 20 years. Studies confirm that geopolymer concrete has good compressive strength, tensile strength, flexural strength, modulus of elasticity and durability. These properties are comparable with OPC concrete.There are many occasions where concrete is exposed to elevated temperatures like fire exposure from thermal processor, exposure from furnaces, nuclear exposure, etc.. In such cases, understanding of the behaviour of concrete and structural members exposed to elevated temperatures is vital. Even though many research reports are available about the behaviour of OPC concrete at elevated temperatures, there is limited information available about the behaviour of geopolymer concrete after exposure to elevated temperatures. A preliminary study was carried out for the selection of a mix proportion. The important variable considered in the present study include alkali/fly ash ratio, percentage of total aggregate content, fine aggregate to total aggregate ratio, molarity of sodium hydroxide, sodium silicate to sodium hydroxide ratio, curing temperature and curing period. Influence of different variables on engineering properties of geopolymer concrete was investigated. The study on interface shear strength of reinforced and unreinforced geopolymer concrete as well as OPC concrete was also carried out. Engineering properties of fly ash based geopolymer concrete after exposure to elevated temperatures (ambient to 800 °C) were studied and the corresponding results were compared with those of conventional concrete. Scanning Electron Microscope analysis, Fourier Transform Infrared analysis, X-ray powder Diffractometer analysis and Thermogravimetric analysis of geopolymer mortar or paste at ambient temperature and after exposure to elevated temperature were also carried out in the present research work. Experimental study was conducted on geopolymer concrete beams after exposure to elevated temperatures (ambient to 800 °C). Load deflection characteristics, ductility and moment-curvature behaviour of the geopolymer concrete beams after exposure to elevated temperatures were investigated. Based on the present study, major conclusions derived could be summarized as follows. There is a definite proportion for various ingredients to achieve maximum strength properties. Geopolymer concrete with total aggregate content of 70% by volume, ratio of fine aggregate to total aggregate of 0.35, NaOH molarity 10, Na2SiO3/NaOH ratio of 2.5 and alkali to fly ash ratio of 0.55 gave maximum compressive strength in the present study. An early strength development in geopolymer concrete could be achieved by the proper selection of curing temperature and the period of curing. With 24 hours of curing at 100 °C, 96.4% of the 28th day cube compressive strength could be achieved in 7 days in the present study. The interface shear strength of geopolymer concrete is lower to that of OPC concrete. Compared to OPC concrete, a reduction in the interface shear strength by 33% and 29% was observed for unreinforced and reinforced geopolymer specimens respectively. The interface shear strength of geopolymer concrete is lower than ordinary Portland cement concrete. The interface shear strength of geopolymer concrete can be approximately estimated as 50% of the value obtained based on the available equations for the calculation of interface shear strength of ordinary portland cement concrete (method used in Mattock and ACI). Fly ash based geopolymer concrete undergoes a high rate of strength loss (compressive strength, tensile strength and modulus of elasticity) during its early heating period (up to 200 °C) compared to OPC concrete. At a temperature exposure beyond 600 °C, the unreacted crystalline materials in geopolymer concrete get transformed into amorphous state and undergo polymerization. As a result, there is no further strength loss (compressive strength, tensile strength and modulus of elasticity) in geopolymer concrete, whereas, OPC concrete continues to lose its strength properties at a faster rate beyond a temperature exposure of 600 °C. At present no equation is available to predict the strength properties of geopolymer concrete after exposure to elevated temperatures. Based on the study carried out, new equations have been proposed to predict the residual strengths (cube compressive strength, split tensile strength and modulus of elasticity) of geopolymer concrete after exposure to elevated temperatures (upto 800 °C). These equations could be used for material modelling until better refined equations are available. Compared to OPC concrete, geopolymer concrete shows better resistance against surface cracking when exposed to elevated temperatures. In the present study, while OPC concrete started developing cracks at 400 °C, geopolymer concrete did not show any visible cracks up to 600 °C and developed only minor cracks at an exposure temperatureof 800 °C. Geopolymer concrete beams develop crack at an early load stages if they are exposed to elevated temperatures. Even though the material strength of the geopolymer concrete does not decrease beyond 600 °C, the flexural strength of corresponding beam reduces rapidly after 600 °C temperature exposure, primarily due to the rapid loss of the strength of steel. With increase in temperature, the curvature at yield point of geopolymer concrete beam increases and thereby the ductility reduces. In the present study, compared to the ductility at ambient temperature, the ductility of geopolymer concrete beams reduces by 63.8% at 800 °C temperature exposure. Appropriate equations have been proposed to predict the service load crack width of geopolymer concrete beam exposed to elevated temperatures. These equations could be used to limit the service load on geopolymer concrete beams exposed to elevated temperatures (up to 800 °C) for a predefined crack width (between 0.1mm and 0.3 mm) or vice versa. The moment-curvature relationship of geopolymer concrete beams at ambient temperature is similar to that of RCC beams and this could be predicted using strain compatibility approach Once exposed to an elevated temperature, the strain compatibility approach underestimates the curvature of geopolymer concrete beams between the first cracking and yielding point.

A Short History of Cultural Studies (Taiwanese edition)

This is the first volume to capture the essence of the burgeoning field of cultural studies in a concise and accessible manner. Other books have explored the British and North American traditions, but this is the first guide to the ideas, purposes and controversies that have shaped the subject. The author sheds new light on neglected pioneers and a clear route map through the terrain. He provides lively critical narratives on a dazzling array of key figures including, Arnold, Barrell, Bennett, Carey, Fiske, Foucault, Grossberg, Hall, Hawkes, hooks, Hoggart, Leadbeater, Lissistzky, Malevich, Marx, McLuhan, McRobbie, D Miller, T Miller, Morris, Quiller-Couch, Ross, Shaw, Urry, Williams, Wilson, Wolfe and Woolf. Hartley also examines a host of central themes in the subject including literary and political writing, publishing, civic humanism, political economy and Marxism, sociology, feminism, anthropology and the pedagogy of cultural studies.

Marketplace forces and the history of retailing : The cycle of control

This paper traces the history of store (retailer-controlled) and national (manufacture controlled)brands; identifies the key historical characteristics of the past 200 years of marketing history;describes the four main time periods of U.S. retail marketing (1800 - 2000); and comments on the most likely developments within the current phases of brand marketing. Will the future focus on technology and new forms of communications? The Internet exemplifies an unconventional retailing environment, with etailer numbers growing rapidly. The central proposition of this paper is that a "cycle of control" - a pattern of marketing developments within the history of retailing and national marketing communications - Can indicate the success of marketing strategies in the future.

The urban littoral frontier : land reclamation in the history of human settlements

The urban waterfront may be regarded as the littoral frontier of human settlement. Typically, over the years, it advances, sometimes retreats, where terrestrial and aquatic processes interact and frequently contest this margin of occupation. Because most towns and cities are sited beside water bodies, many of these urban centers on or close to the sea, their physical expansion is constrained by the existence of aquatic areas in one or more directions from the core. It is usually much easier for new urban development to occur along or inland from the waterfront. Where other physical constraints, such as rugged hills or mountains, make expansion difficult or expensive, building at greater densities or construction on steep slopes is a common response. This kind of development, though technically feasible, is usually more expensive than construction on level or gently sloping land, however. Moreover, there are many reasons for developing along the shore or riverfront in preference to using sites further inland. The high cost of developing existing dry land that presents serious construction difficulties is one reason for creating new land from adjacent areas that are permanently or periodically under water. Another reason is the relatively high value of artificially created land close to the urban centre when compared with the value of existing developable space at a greater distance inland. The creation of space for development is not the only motivation for urban expansion into aquatic areas. Commonly, urban places on the margins of the sea, estuaries, rivers or great lakes are, or were once, ports where shipping played an important role in the economy. The demand for deep waterfronts to allow ships to berth and for adjacent space to accommodate various port facilities has encouraged the advance of the urban land area across marginal shallows in ports around the world. The space and locational demands of port related industry and commerce, too, have contributed to this process. Often closely related to these developments is the generation of waste, including domestic refuse, unwanted industrial by-products, site formation and demolition debris and harbor dredgings. From ancient times, the foreshore has been used as a disposal area for waste from nearby settlements, a practice that continues on a huge scale today. Land formed in this way has long been used for urban development, despite problems that can arise from the nature of the dumped material and the way in which it is deposited. Disposal of waste material is a major factor in the creation of new urban land. Pollution of the foreshore and other water margin wetlands in this way encouraged the idea that the reclamation of these areas may be desirable on public health grounds. With reference to examples from various parts of the world, the historical development of the urban littoral frontier and its effects on the morphology and character of towns and cities are illustrated and discussed. The threat of rising sea levels and the heritage value of many waterfront areas are other considerations that are addressed.

The digital Dark Ages : a retro-speculative history of possible futures

The Dark Ages are generally held to be a time of technological and intellectual stagnation in western development. But that is not necessarily the case. Indeed, from a certain perspective, nothing could be further from the truth. In this paper we draw historical comparisons, focusing especially on the thirteenth and fourteenth centuries, between the technological and intellectual ruptures in Europe during the Dark Ages, and those of our current period. Our analysis is framed in part by Harold Innis’s2 notion of "knowledge monopolies". We give an overview of how these were affected by new media, new power struggles, and new intellectual debates that emerged in thirteenth and fourteenth century Europe. The historical salience of our focus may seem elusive. Our world has changed so much, and history seems to be an increasingly far-from-favoured method for understanding our own period and its future potentials. Yet our seemingly distant historical focus provides some surprising insights into the social dynamics that are at work today: the fracturing of established knowledge and power bases; the democratisation of certain "sacred" forms of communication and knowledge, and, conversely, the "sacrosanct" appropriation of certain vernacular forms; challenges and innovations in social and scientific method and thought; the emergence of social world-shattering media practices; struggles over control of vast networks of media and knowledge monopolies; and the enclosure of public discursive and social spaces for singular, manipulative purposes. The period between the eleventh and fourteenth centuries in Europe prefigured what we now call the Enlightenment, perhaps moreso than any other period before or after; it shaped what the Enlightenment was to become. We claim no knowledge of the future here. But in the "post-everything" society, where history is as much up for sale as it is for argument, we argue that our historical perspective provides a useful analogy for grasping the wider trends in the political economy of media, and for recognising clear and actual threats to the future of the public sphere in supposedly democratic societies.

The digital Dark Ages : a retro-speculative history of possible futures

The Dark Ages are generally held to be a time of technological and intellectual stagnation in western development. But that is not necessarily the case. Indeed, from a certain perspective, nothing could be further from the truth. In this paper we draw historical comparisons, focusing especially on the thirteenth and fourteenth centuries, between the technological and intellectual ruptures in Europe during the Dark Ages, and those of our current period. Our analysis is framed in part by Harold Innis’s2 notion of "knowledge monopolies". We give an overview of how these were affected by new media, new power struggles, and new intellectual debates that emerged in thirteenth and fourteenth century Europe. The historical salience of our focus may seem elusive. Our world has changed so much, and history seems to be an increasingly far-from-favoured method for understanding our own period and its future potentials. Yet our seemingly distant historical focus provides some surprising insights into the social dynamics that are at work today: the fracturing of established knowledge and power bases; the democratisation of certain "sacred" forms of communication and knowledge, and, conversely, the "sacrosanct" appropriation of certain vernacular forms; challenges and innovations in social and scientific method and thought; the emergence of social world-shattering media practices; struggles over control of vast networks of media and knowledge monopolies; and the enclosure of public discursive and social spaces for singular, manipulative purposes. The period between the eleventh and fourteenth centuries in Europe prefigured what we now call the Enlightenment, perhaps moreso than any other period before or after; it shaped what the Enlightenment was to become. We claim no knowledge of the future here. But in the "post-everything" society, where history is as much up for sale as it is for argument, we argue that our historical perspective provides a useful analogy for grasping the wider trends in the political economy of media, and for recognising clear and actual threats to the future of the public sphere in supposedly democratic societies.

Malcolm Shepherd Knowles : A History of His Thought

This book traces the evolution of thinking of the American adult educator, Malcolm Knowles, and maps the development of his conceptual framework over the period 1950 to 1995. It constructs an overall narrative history of Knowles’ thought, and shows how andragogy provided him with both a label and a unifying theme for his practical-theoretical framework aimed at producing self-directed lifelong learners. Knowles died in 1997 and left a large legacy of books and journal articles. The book examines the writings that constitute Knowles' principal works. It identifies the major elements of his thought, shows the interrelationships between ideas and indicates the major phases through which his thinking passed. Importantly, the book establishes that Knowles’ theorising was traceable and that he possessed a clear and coherent conceptual framework.