Pruebas diagnósticas e inmunoterapia sublingual en la alergia al látex

316 p. (Bibliogr. 301-316)

Perioperative latex hypersensitivity reactions: an integrative literature review

This article characterizes hypersensitivity reactions during anesthetic-surgical procedures. This integrative literature review was conducted in the LILACS, CINAHL, COCHRANE and MEDLINE databases including papers published from 1966 to September 2011. A total of 17 case reports, two prevalence studies and one cohort study were identified. Latex reactions were mainly type III and the primary source of intraoperative reaction was latex gloves. The average time for clinical manifestation was 59.8 minutes after anesthetic induction; 44.4% of patients reported a reaction to latex at the pre-anesthetic evaluation. It was determined that the history of allergic reactions to latex obtained in the pre-anesthetic evaluation does not ensure the safety of patients if the staff is inattentive to the severity of the issue. There is also a tendency to initially attribute the anaphylactic event to the anesthetic drugs.

Prevalencia de síntomas cutáneos asociados a dermatitis de contacto y su relación con factores sociodemográficos y ocupacionales en el personal asistencial de un laboratorio clínico de la ciudad de Bogotá en el año 2012

El objetivo fue determinar la prevalencia de síntomas cutáneos asociados a Dermatitis de Contacto y su relación con factores socios demográficos y ocupacionales, en el personal asistencial de un laboratorio clínico de la ciudad de Bogotá en el año 2012. Es un estudio descriptivo observacional de corte transversal (n= 100) se estimo la prevalencia de síntomas cutáneos de Dermatitis de Contacto y sus factores asociados socio demográficos y ocupacionales en el personal asistencial de un laboratorio clínico de la ciudad de Bogotá en Se usó como instrumento el cuestionario Nórdico para Enfermedades profesionales de la piel (NOQS) en su versión larga validada al español. La sensibilidad y especificidad del cuestionario aplicado en lo referente a las preguntas sobre eczema fue del 96 y 75% respectivamente. Los resultados encontrados fueron que la prevalencia de la sintomatología cutánea de Dermatitis de contacto en la población estudiada fue de 30% para manos y de 16 % para muñecas o antebrazos.

Reacciones de hipersensibilidad a los alimentos : normativa de aplicaci??n en el control oficial de los al??rgenos presentes en alimentos

T??t. tomado de la cub.

Correlacion clinica-patologica de corioamnionitis en pacientes que ingresan al servicio ginecologia en el año 2009 en el Hospital Universitario Clinica San Rafael

Este trabajo tuvo como utilidad básica determinar cuál es la correlación del diagnóstico clínico con los criterios de Gibss y con el Gold estándar que es la patología en las paciente con corioamnionitis para así poder establecer si el diagnostico se realizó en forma adecuada y cuáles son los criterios más relevantes para su diagnóstico. Dicha investigación se realizó de la siguiente manera: 1. Se Identificaron las pacientes que ingresaron al servicio de urgencias o al servicio de ginecología de la Clínica san Rafael con diagnóstico de Corioamnionitis (teniendo en cuenta los criterios de Gibbs), pacientes que desarrollaron la entidad durante el trabajo de parto o a las cuales se les hizo el diagnostico durante el mismo parto se establecieron los criterios de Gibss para cada una como parte del diagnóstico clínico de corioamnionitis 2. se revisaron los estudios anatomo-patologico realizado a las placentas culminado el proceso de trabajo de parto ya fuera por vía vaginal o cesárea y se realizó un estudio de asociación entre el resultado patológico de corioamnionitis y el diagnóstico clínico. Con esta investigación se estableció el diagnóstico clínico se correlaciono con la patología en el 54% de los casos 1. la asociación de los criterios de Gibbs con el diagnostico patológico, encontrando que individualmente los criterios que se asocian con el diagnóstico definitivo de corioamnionitis fueron: la taquicardia materna OR (8,53), taquicardia fetal OR (7,7), y leucocitosis OR (2,86), la descarga vaginal fétida y la hipersensibilidad uterina tuvieron menor significancia con OR de 1,24 y 1,1 respectivamente. e En la regresión logística se encontró que los criterios de Gibbs fueron estadísticamente significativos en donde para la taquicardia materna OR (7,29), taquicardia fetal OR (4,107), hipersensibilidad uterina OR (2,96), leucocitosis OR (4,93) y descarga vaginal OR (2,65)

Efecto del ácido oxálico bajo restauraciones cervicales en dientes con hipersensibilidad: ensayo clínico randomizado controlado doble ciego

To evaluate the effect of oxalic acid in cervical hypersensitivity, used under two different resin restorations one based on methacrylate and another based on silorane. Methods: 19 patients with “LCNC with hypersensitivity” were distributed into 4 groups according to treatment: G1 (n = 31): 0.5% oxalic acid (Desenssiv, SSWhite) + Z250 (3MESPE), G2 (n = 31): 0.5% oxalic acid + Filtek Silorane - P90 (3MESPE), G3 (n = 30): Distilled water + Z250; G4 (n = 30): Distilled water + Filtek Silorane - P90. Two clinical calibrated (kappa> 0.75) evaluated the sensitivity of the teeth: Before treatment, at 30, 60 and 90 days post-treatment (VAS). Results: The 4 groups at 30, 60 and 90 days reduced HS compared with the baseline (p <0.05). G1 and G2 showed less HS than G3 and G4 (p <0.05). Conclusion: The 4 restorative procedures significantly reduce the hypersensitivity, 30, 60 and 90 days compared to the baseline.

A new low temperature synthesis route of fraipontite (Zn,Al)3(Si,Al)2O5(OH)4

A low temperature synthesis method based on the decomposition of urea at 90°C in water has been developed to synthesise fraipontite. This material is characterised by a basal reflection 001 at 7.44 Å. The trioctahedral nature of the fraipontite is shown by the presence of a 06l band around 1.54 Å, while a minor band around 1.51 Å indicates some cation ordering between Zn and Al resulting in Al-rich areas with a more dioctahedral nature. TEM and IR indicate that no separate kaolinite phase is present. An increase in the Al content however, did result in the formation of some SiO2 in the form of quartz. Minor impurities of carbonate salts were observed during the synthesis caused by to the formation of CO32- during the decomposition of urea.

Synthesis and Raman spectroscopic study of Mg/Al,Fe hydrotalcites with variable cationic ratios

Hydrotalcites of formula Mg6 (Fe,Al)2(OH)16(CO3).4H2O formed by intercalation with the carbonate anion as a function of divalent/trivalent cationic ratio have been successfully synthesised. The XRD patterns show variation in the d-spacing attributed to the size of the cation. Raman and infrared bands in the OH stretching region are assigned to (a) brucite layer OH stretching vibrations (b) water stretching bands and (c) water strongly hydrogen bonded to the carbonate anion. Multiple (CO3)2- symmetric stretching bands suggest that different types of (CO3)2- exist in the hydrotalcite interlayer. Increasing the cation ratio (Mg/Al,Fe) resulted in an increase in the combined intensity of the 2 Raman bands at around 3600 cm-1, attributed to Mg-OH stretching modes, and a shift of the overall band profile to higher wavenumbers. These observations are believed to be a result of the increase in magnesium in the structure. Raman spectroscopy shows a reduction in the symmetry of the carbonate, leading to the conclusion that the anions are bonded to the brucite-like hydroxyl surface and to the water in the interlayer. Water bending modes are identified in the infrared spectra at positions greater than 1630 cm-1, indicating the water is strongly hydrogen bonded to both the interlayer anions and the brucite-like surface.

Indentation size effect and strain rate sensitivity of nanocrystalline Mg-Al alloys

Deformation Behaviour of microcrystalline (mc) and nanocrystalline (nc) Mg-5%Al alloys produced by hot extrusion of ball-milled powders were investigated using instrumented indentation tests. The hardness values of the mc and nc metals exhibited indentation size effect (ISE), with nc alloys showing weaker ISE. The highly localized dislocation activities resulted in a small activation volume, hence enhanced strain rate sensitivity. Relative higher strain rate sensitivity and the negative Hall-Petch Relationship suggested the increasingly important role of grain boundary mediated mechanisms when the grain size decreased to nanometer region.

Compressive behaviour of nanocrystallilne Mg-5%Al alloys

Magnesium alloys are attracting increasing research interests due to their low density, high specific strength and good mechineability and availability as compared to other structural materials. However, the deformation and failure mechanisms of nanocrystalline Mg alloys have not been well understood. In this work, the deformation behavior of nanocrystalline Mg-5% Al alloys was investigated using compression test, with a focus on the effects of grain size. The average grain size of the Mg-Al alloy was changed from 13 µm to 50 nm via mechanical milling. The results showed that grain size had a significant influence on the yield stress and ductility of the Mg alloys, and the materials exhibited increased strain rate sensitivity with decrease of grain size. The deformation mechanisms were also strongly dependent with the grain sizes.

A participant’s response : recreating the circle with We Al-Li: a program for sharing and regeneration

Personal reflections on the We Al-Li Program

Molecular structure of Mg-Al, Mn-Al and Zn-Al halotrichites : an infrared spectroscopic study

Near infrared (NIR), X-ray diffraction (XRD) and infrared (IR) spectroscopy have been applied to halotrichites of the formula MgAl2(SO4)4∙22H2O, MnAl2(SO4)4∙22H2O and ZnAl2(SO4)4∙22H2O. Comparison of the halotrichites in different spectral regions has shown that the incorporation of a divalent transition metal into the halotrichite structure causes a shift in OH stretching band positions to lower wavenumbers. Therefore, an increase in hydrogen bonded water is observed for divalent cations with a larger molecular mass. XRD has confirmed the formation of halotrichite for all three samples and characteristic peaks of halotrichite have been identified at 18.5 and 24.5° 2θ, along with a group of six peaks between 5 and 15° 2θ. It has been observed that Mg-Al and Mn-Al halotrichite are very similar in structure, while Zn-Al showed several differences particularly in the NIR spectra. This work has shown that halotrichite structures can be synthesised and characterised by infrared and NIR spectroscopy.