Combined (13)C NMR and DFT/GIAO studies of the polyketides Aurasperone A and Fonsecinone A

Structural characterization by NMR spectroscopy and DFT calculations was performed for two dimeric naptho-gamma-pyrones, the polyketides Aurasperone A and Fonsecinone A. Experimental data ((13)C NMR chemical shifts and interatomic geometries) were found to be in reasonable agreement with theoretical ones, obtained at B3LYP level for three different basis sets (6-31G/6-31G(d)/6-31G(d,p)). Additionally, the dipolar moments calculation allowed explaining the different solubility for these molecules. The (13)C NMR theoretical chemical shifts were calculated with the GIAO method and the solvent effects were taken into account by means of the PCM approximation. In this work, the DFT/GIAO methodology shows to be a reliable tool in the assignment of experimental NMR chemical shifts of similar molecules. (C) 2008 Wiley Periodicals, Inc. Int J Quantum Chem 108: 2408-2416, 2008.

Configuration of stilbene derivatives by (1)H NMR and theoretical calculation of chemical shifts

The direct E/Z configuration assignment of tri- and tetra-substituted stilbenes (and other analogous olefins) when only one of the isomers is available is a quite challenging task. Sometimes, a chemical transformation or some other tedious method is necessary for determination of the double bond substitution pattern. In this paper, we relied on theoretical calculation of chemical shifts as a complementary tool for (1)H NMR determination of the configuration of an alpha-phenylcinnamic acid prepared as a unique isomer by the Perkin reaction. (C) 2010 Elsevier B.V. All rights reserved.

Development of an injectable grout for concrete repair and strengthening

This paper deals with the coupled effect of temperature and silica fume addition on rheological, mechanical behaviour and porosity of grouts based on CEMI 42.5R, proportioned with a polycarboxylate-based high range water reducer. Preliminary tests were conducted to focus on the grout best able to fill a fibrous network since the goal of this study was to develop an optimized grout able to be injected in a mat of steel fibers for concrete strengthening. The grout composition was developed based on criteria for fresh state and hardened state properties. For a CEMI 42.5R based grout different high range water reducer dosages (0%, 0.2%, 0.4%, 0.5%, 0.7%) and silica fume (SF) dosages (0%, 2%, 4%) were tested (as replacement of cement by mass). Rheological measurements were used to investigate the effect of polycarboxylates (PCEs) and SF dosage on grout properties, particularly its workability loss, as the mix was to be injected in a matrix of steel fibers for concrete jacketing. The workability behaviour was characterized by the rheological parameters yield stress and plastic viscosity (for different grout temperatures and resting times), as well as the procedures of mini slump cone and funnel flow time. Then, further development focused only on the best grout compositions. The cement substitution by 2% of SF exhibited the best overall behaviour and was considered as the most promising compared to the others compositions tested. Concerning the fresh state analysis, a significant workability loss was detected if grout temperature increased above 35 degrees C. Below this temperature the grout presented a self-levelling behaviour and a life time equal to 45 min. In the hardened state, silica fumes increased not only the grout's porosity but also the grout's compressive strength at later ages, since the pozzolanic contribution to the compressive strength does not occur until 28 d and beyond. (C) 2012 Elsevier Ltd. All rights reserved.

Estrategias de tercerización en Colombia como centro de operaciones enfocado a los Call Centers en Barranquilla

El sector BPO&O es un sector con alto potencial en Colombia que aún se encuentra Incipiente. Dentro de este sector, los Call Centers juegan un papel importante para su desarrollo y Barranquilla posee grandes cualidades para permitir este crecimiento si se plantean las estrategias adecuadas.

Síntese e enriquecimento enantiomérico via catálise enzimática do sistema 5-bromo-12-oxa-pentaciclo[6.2.16,9.12,7.12,10]dodeca-4-eno-3-endo-ol e derivados. RMN de 1H e 13C: correlação de parâmetros teóricos e experimentais

Partindo de ciclopentadieno, ciclohexadieno, p-benzoquinona e 2,5-dibromo-pbenzoquinona, os adutos 1, 5, 30 e 31 foram sintetizados. Os adutos 1, 5 e 30 foram utilizados como produtos de partida para a síntese de 13 (treze) novos compostos, em sua maioria com potenciais características para apresentarem atividade biológica inibidora de glicosidases e reguladora da liberação de Insulina no sangue. O aduto 31 é inédito na literatura até o momento. Cinco novas propostas de mecanismos são apresentadas. Os álcoois racêmicos 6 e 29 foram submetidos a reações de transesterificação catalisadas por lipase de Pseudomonas cepacia em diferentes preparações e seus enantiômeros separados com enantiosseletividade (E) maior que 100 em todos os casos. Este processo resultou, também, na obtenção dos respectivos acetatos 43 e 44 enantiomericamente puros e com excelentes rendimentos químicos. Os compostos 6, 29 e 34 depois de terem suas estruturas moleculares resolvidas através dos métodos espectroscópicos de rotina, tiveram suas estruturas moleculares calculadas pelo método ab initio e por Funcionais de Densidade. As geometrias otimizadas foram submetidas ao método GIAO para o cálculo dos tensores de blindagem magnética isotrópica. Estes cálculos mostraram-se eficazes na descrição dos deslocamentos químicos da maioria dos átomos, incluindo os dos anéis ciclopropanos presentes nas estruturas moleculares de cada composto. Algumas dificuldades foram encontradas para a descrição do sistema vinílico halogenado dos álcoois 6 e 29. Foram utilizadas moléculas modelo para verificar a extensão de tais dificuldades.

Ovipositional behavior in predator and prey blowflies

In this study we analyzed the ovipositional behavior of C. albiceps, C. megacephala and L. eximia in response to previous presence of larvae of different species, both predator and prey. The preference for substrates that previously had had no larvae was predominant for all species. However, the experiments showed that C. megacephala and L. eximia avoid laying eggs principally in patches with previous presence of C. albiceps larvae. The implications of these results for the necrophagous Diptera community dynamics are discussed.

Survival of submerged blowfly species and their parasitoids: Implications for postmortem submersion interval

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of patient size on radiation dose for abdominal MDCT with automatic tube current modulation: phantom study

OBJECTIVE: The purpose of this study was to evaluate in a phantom study the effect of patient size on radiation dose for abdominal MDCT with automatic tube current modulation. MATERIALS AND METHODS: One or two 4-cm-thick circumferential layers of fat-equivalent material were added to the abdomen of an anthropomorphic phantom to simulate patients of three sizes: small (cross-sectional dimensions, 18 x 22 cm), average size (26 x 30 cm), and oversize (34 x 38 cm). Imaging was performed with a 64-MDCT scanner with combined z-axis and xy-axis tube current modulation according to two protocols: protocol A had a noise index of 12.5 H, and protocol B, 15.0 H. Radiation doses to three abdominal organs and the skin were assessed. Image noise also was measured. RESULTS: Despite increasing patient size, the image noise measured was similar for protocol A (range, 11.7-12.2 H) and protocol B (range, 13.9-14.8 H) (p > 0.05). With the two protocols, in comparison with the dose of the small patient, the abdominal organ doses of the average-sized patient and the oversized patient increased 161.5-190.6%and 426.9-528.1%, respectively (p < 0.001). The skin dose increased as much as 268.6% for the average-sized patient and 816.3% for the oversized patient compared with the small patient (p < 0.001). CONCLUSION: Oversized patients undergoing abdominal MDCT with tube current modulation receive significantly higher doses than do small patients. The noise index needs to be adjusted to the body habitus to ensure dose efficiency.

Abdominal multislice CT for obese patients: effect on image quality and radiation dose in a phantom study

RATIONALE AND OBJECTIVES: To evaluate the effect of a modified abdominal multislice computed tomography (CT) protocol for obese patients on image quality and radiation dose. MATERIALS AND METHODS: An adult female anthropomorphic phantom was used to simulate obese patients by adding one or two 4-cm circumferential layers of fat-equivalent material to the abdominal portion. The phantom was scanned with a subcutaneous fat thickness of 0, 4, and 8 cm using the following parameters (detector configuration/beam pitch/table feed per rotation/gantry rotation time/kV/mA): standard protocol A: 16 x 0.625 mm/1.75/17.5 mm/0.5 seconds/140/380, and modified protocol B: 16 x 1.25 mm/1.375/27.5 mm/1.0 seconds/140/380. Radiation doses to six abdominal organs and the skin, image noise values, and contrast-to-noise ratios (CNRs) were analyzed. Statistical analysis included analysis of variance, Wilcoxon rank sum, and Student's t-test (P < .05). RESULTS: Applying the modified protocol B with one or two fat rings, the image noise decreased significantly (P < .05), and simultaneously, the CNR increased significantly compared with protocol A (P < .05). Organ doses significantly increased, up to 54.7%, comparing modified protocol B with one fat ring to the routine protocol A with no fat rings (P < .05). However, no significant change in organ dose was seen for protocol B with two fat rings compared with protocol A without fat rings (range -2.1% to 8.1%) (P > .05). CONCLUSIONS: Using a modified abdominal multislice CT protocol for obese patients with 8 cm or more of subcutaneous fat, image quality can be substantially improved without a significant increase in radiation dose to the abdominal organs.

Effect of automatic tube current modulation on radiation dose and image quality for low tube voltage multidetector row CT angiography: phantom study

RATIONALE AND OBJECTIVES: To evaluate the effect of automatic tube current modulation on radiation dose and image quality for low tube voltage computed tomography (CT) angiography. MATERIALS AND METHODS: An anthropomorphic phantom was scanned with a 64-section CT scanner using following tube voltages: 140 kVp (Protocol A), 120 kVp (Protocol B), 100 kVp (Protocol C), and 80 kVp (Protocol D). To achieve similar noise, combined z-axis and xy-axes automatic tube current modulation was applied. Effective dose (ED) for the four tube voltages was assessed. Three plastic vials filled with different concentrations of iodinated solution were placed on the phantom's abdomen to obtain attenuation measurements. The signal-to-noise ratio (SNR) was calculated and a figure of merit (FOM) for each iodinated solution was computed as SNR(2)/ED. RESULTS: The ED was kept similar for the four different tube voltages: (A) 5.4 mSv +/- 0.3, (B) 4.1 mSv +/- 0.6, (C) 3.9 mSv +/- 0.5, and (D) 4.2 mSv +/- 0.3 (P > .05). As the tube voltage decreased from 140 to 80 kVp, image noise was maintained (range, 13.8-14.9 HU) (P > .05). SNR increased as the tube voltage decreased, with an overall gain of 119% for the 80-kVp compared to the 140-kVp protocol (P < .05). The FOM results indicated that with a reduction of the tube voltage from 140 to 120, 100, and 80 kVp, at constant SNR, ED was reduced by a factor of 2.1, 3.3, and 5.1, respectively, (P < .001). CONCLUSIONS: As tube voltage decreases, automatic tube current modulation for CT angiography yields either a significant increase in image quality at constant radiation dose or a significant decrease in radiation dose at a constant image quality.

Calculated 11B–13C NMR chemical shift relationship in hypercoordinate methonium and boronium ions

The boronium-carbonium continuum was extended to include hypercoordinated protonated methanes and their boron analogs. The 11B NMR chemical shifts of the hypercoordinated hydriodo boron compounds and the 13C NMR chemical shifts of the corresponding isoelectronic and isostructural carbocations were calculated by using the GIAO-MP2 method. The data show good linear correlation between 11B and 13C NMR chemical shifts, which indicates that the same factors that determine the chemical shifts of the boron nuclei also govern the chemical shifts of carbon nuclei of these hypercoordinated hydriodo compounds.

Iminopropadienones R-N=C=C=C=O and carbon suboxide, C3O2. Theoretical and experimental 13C NMR spectra

The C-13 NMR data of five iminopropadienones R-N=C=C=C=O as well as carbon suboxide, C3O2, have been examined theoretically and experimentally. The best theoretical results were obtained using the GIAO/B3LYP/6-31 +G**//MP2/6-31G* level of theory, which reproduces the chemical shifts of the iminopropadienone substituents extremely well while underestimating those of the cumulenic carbons by 5-10 ppm. The computationally faster GIAO/HF/6-31 + G**//B3LYP/6-31 G* level is also adequate. (C) 2004 Elsevier B.V. All rights reserved.

Połączenia krzyżowe pochodnych cysteiny z aldehydowymi adduktami nukleozydów adeninowych

Wydział Chemii