Improving the Fuel Economy of a Tuned 600cc FSAE Engine

To maintain its relevance, motorsport cannot be exempt from
the trend of increasing fuel economy. This bears obvious
competitive benefits as well, either in decreasing the
frequency of pit stops or the mass of fuel carried. Given the
increased points weighting of fuel economy for the Formula
Student (FS) competition, a complete analysis was performed
on the Queen's Formula Racing 600cc motorcycle engine in
preparation for the 2011 competition.
The criteria for such high performance fuel economy differ to
a degree from most mass transportation counterparts and were
divided into three distinct regimes; full load, part load and no
load conditions.
Full load positions naturally demand maximum torque for
performance but that does not imply that fuel savings cannot
be made whilst preserving this. The point at which maximum
torque is produced with minimum air -fuel ratio, Leanest
mixture for Best Torque (LBT), was therefore sought and
mapped for full load.
At part load, torque is less of a concern, and maintaining a
sustainable engine temperature and transient response become
more important. With decreasing AFR, engine temperatures
can rise dramatically so temperatures were measured close to
the exhaust port for a wide range of air-fuel ratios.
Competition track data was analysed to highlight key part load
operating regions and these were mapped according to
measured safe temperature limits. Torque response to a step
throttle change was also measured to ensure suitable engine
transient performance was maintained.
At no load conditions, with low engine speed only idle
conditions need to be satisfied. In the situation where the
engine is still at high speed without load, the engine is being
motored and no fuel is required. An overrun fuel cut was
employed to reflect this giving significant fuel savings. The
effect on torque and engine pickup was measured.
Modifications were also made to the fuel injector location to
improve fuel mixing and evaporation at this lower air flow
condition.
These mapping regimes were implemented and tested using
fully transient lap simulations using competition track data
and a four quadrant AC engine dynamometer. The experiment
indicated a reduction in fuel consumption for 22 laps of the FS
track from 5.08litres to 3.67litres, around 27% in total. The
actual fuel used at the 2011 competition was 3.6 litres while
placing 8th in the endurance event, further validating the
benefits of these mapping regimes.

Improving fuel economy application of the organic Rankine Cycle on a hybrid bus

Globally vehicle operators are experiencing rising fuel costs and increased
running expenses as governments around the world attempt to decrease carbon dioxide emissions and fossil fuel consumption, due to global warming and the drive to reduce dependency on fossil fuels. Recent advances in hybrid vehicle design have made great strides towards more efficient operation, with regenerative braking being widely used to capture otherwise lost energy. In this paper a hybrid series bus is developed a step further, by installing another method of energy capture on the vehicle. In this case, it is in the form of the Organic Rankine Cycle (ORC). The waste heat expelled to the exhaust and coolant streams is recovered and converted to electrical energy which is then stored in the hybrid vehicles batteries. The electrical energy can then be used for the auxiliary power circuit or to assist in vehicle propulsion, thus reducing the load on the engine, thereby improving the overall fuel economy of the vehicle and reducing carbon dioxide emissions.

Augmentation of research and analysis capabilities for timely support of automotive fuel economy activities. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

A computer program (VEHSIM) for vehicle fuel economy and performance simulation (automobiles and light trucks). Volume I: description and analysis. Final report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington, D.C.

A computer program (VEHSIM) for vehicle fuel economy and performance simulation (automobiles and light trucks). Volume II: users guide. Final report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington, D.C.

Consumers need more reliable automobile fuel economy data.

Mode of access: Internet.

A computer program (VEHSIM) for vehicle fuel economy and performance simulation (automobiles and light trucks). Volume IV: enhancements. Final report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington D.C.

Final regulatory analysis of the model year 1982 light truck fuel economy standards.

Mode of access: Internet.

Passenger car fuel economy, EPA and road : a report to the Congress in response to the National Energy Conservation Policy Act of 1978, public law 95-619, title IV, part 1, section 404 /

"September 1980"--Cover.

Requests by General Motors and Ford to reduce fuel economy standards for MY 1981-85 passenger automobiles. Report.

Mode of access: Internet.

A computer program (HEVSIM) for heavy duty vehicle fuel economy and performance simulation. Volume II: users' manual. Final report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington, D.C.

A computer program (HEVSIM) for heavy duty vehicle fuel economy and performance simulation. Volume III: appendices A through F. Final report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington, D.C.

Rulemaking support paper - light truck fuel economy standards - model year 1981.

Mode of access: Internet.

The effect of light truck design variables on top speed, performance, and fuel economy, 1981. Final report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington, D.C.

A computer program (HEVSIM) for heavy duty vehicle fuel economy and performance simulation. Volume I: description and analysis. Final report.

National Highway Traffic Safety Administration, Office of Research and Development, Washington, D.C.