110 resultados para FLUÍDO


Relevância:

20.00% 20.00%

Publicador:

Resumo:

Dissertação para obtenção do Grau de Mestre em Engenharia Civil – Perfil Estruturas

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Relatório de estágio de mestrado em Média Interativos

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Samples of whole fluid pasteurized, UHT and powdered milk were analyzed for the presence of organophosphorus pesticide residues (OPR) using the QuEChERS method with detection by GC-FPD and confirmation by UPLC-MS/MS. A total of 23% of fluid milk samples and 27% of powdered milk samples contained at least one organophosphorus residue. The OPR found in the samples showed these can reach the milk and remain even after pasteurization, sterilization and drying processes. Some domestic sanitary residues were also present in the powdered milk samples. These residues have no LMR in Brazilian food legislation and are therefore not taken into account in food intake evaluations. There was an unidentified chromatographic peak in 30% of all the liquid and powdered milk samples, indicating the presence of some other contaminant.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

OBJETIVO: Investigar se a adoção de um protocolo de restrição hídrica intravenosa em colecistectomia aberta diminui a permanência hospitalar. MÉTODO: Estudo prospectivo envolvendo pacientes submetidas a colecistectomia aberta após a adoção de um protocolo multimodal (projeto ACERTO). Pacientes com intercorrencias intra- ou pós-operatórias foram excluídas. Todas as pacientes receberam uma solução de carboidratos 2h antes da operação. Foram coletadas as seguintes variáveis: peso, altura, estado nutricional, volume total de fluidos intravenosos (VTFI) e volume prescrito em ml/kg de peso por dia. RESULTADOS: 64 pacientes (11 M e 53 F; idade mediana = 43 [18-65] anos) completaram o estudo. A re-alimentação pós-operatória ocorreu no mesmo dia da operação (62,5%) ou no dia seguinte (37,5%). Não foram registradas complicações infecciosas ou óbitos. O tempo mediano de internação pós-operatória foi de 1 (1-4) dia. Observou-se correlação entre o VTFI (r=0,44; p<0.001) e volume de fluídos / kg peso /dia (r=-0,29; p=0,03) e o tempo de internação pós-operatória. Alta no 1º PO foi possível em 73,3% dos casos quando a prescrição foi de até 20mL/Kg/dia e em 41,2% quando o volume prescrito foi maior (p<0.001; Odds Ratio=3,92; IC95% 1,36-11,32). CONCLUSÃO: A restrição de fluidos intravenosos em colecistectomia aberta determina alta mais precoce.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Este trabalho teve por objetivo estabelecer padrões de normalidade para as características do fluído ruminal de ovinos da raça Santa Inês criados sob regime extensivo de pastagem no município de Garanhuns, Agreste Meridional de Pernambuco. Foram coletadas amostras de 50 animais, por meio de sonda esofágica, nos períodos de inverno (estação chuvosa) e verão (estação seca). As cores do fluído predominantes foram a verde oliva, no período chuvoso, e a castanha, no período seco. O odor aromático foi observado em todas as amostras, estando mais pronunciado no inverno. A consistência levemente viscosa predominou em ambas as estações, com maior freqüência desta no inverno. O tempo de sedimentação e flotação foi de 6,73min (±1,63) na estação chuvosa e 3,15min (±0.72) na estação seca. Nas provas bioquímicas os valores médios encontrados para o inverno e verão, respectivamente, foram: pH, 6,76±0,21 e 6,59±0,14; redução do azul de metileno, 3,20 min (±0,76) e 7,76min (±3.00); teor de cloretos, 28,14±4,16mEq/L e 24,97±5,65mEq/L; acidez total titulável, 21,90±4,38UC e 13,68±2.97UC. Observou-se densidade abundante (+++) de protozoários no inverno e moderada (++) no verão. A motilidade dos protozoários foi bastante ativa (+++) e havia aproximadamente 90% deles vivos em ambos os períodos experimentais. A contagem de protozoários no inverno foi de 425.373±217.258/mL e 155.375± 83.113/mL no verão. As bactérias Gram-negativas predominaram em ambas as estações.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Apresenta a descrição de metodologia para obtenção da velocidade de escoamento e estimativa de vazão de fluído através do método de Pitot. Descreve os equipamentos necessários para medição experimental: tubo de Pitot com possibilidade de deslocamento radial em uma secção transversal da tubulação, tomada de pressão estática, manômetro e registro regulador de vazão. Para fins comparativos mede-se também a vazão pelo método de pesagem com o auxílio de balança e cronômetro. Todas as etapas do procedimento são reproduzidas detalhadamente. O perfil de velocidade em função do raio na seção estudada pode ser calculado através do deslocamento do tubo de Pitot no interior da tubulação. A partir do perfil de velocidade é possível estimar a vazão e comparar o resultado obtido com o método da pesagem.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The decontamination of the materials has been subject of some studies. One of the factors that it increases the pollution is the lack of responsibility in the discarding of toxic trash, as for example the presence of PCB (Polychlorinated Biphenyls) in the environment. In the Brazilian regulations, the material contaminated with PCB in concentrations higher than 50 ppm must be stored in special places or destroyed, usually by incineration in plasma furnace with dual steps. Due to high cost of the procedure, new methodologies of PCBs removal has been studied. The objective of this study was to develop an experimental methodology and analytical methodology for quantification of removal of PCBs through out the processes of extractions using supercritical fluid and Soxhlet method, also technical efficiency of the two processes of extraction, in the treatment of contaminated materials with PCBs. The materials studied were soils and wood, both were simulated contamination with concentration of 6.000, 33.000 and 60.000 mg of PCB/ kg of materials. Soxhlet extractions were performed using 100 ml of hexane, and temperature of 180 ºC. Extractions by fluid supercritical were performed at conditions of 200 bar, 70°C, and supercritical CO2 flow-rate of 3 g/min for 1-3 hours. The extracts obtained were quantified using Gas chromatography-mass spectrometry (GC/MS). The conventional extractions were made according to factorial experimental planning technique 22, with aim of study the influence of two variables of process extraction for the Soxhlet method: contaminant concentration and extraction time for obtain a maximum removal of PCB in the materials. The extractions for Soxhlet method were efficient for extraction of PCBs in soil and wood in both solvent studied (hexane and ethanol). In the experimental extraction in soils, the better efficient of removal of PCBs using ethanol as solvent was 81.3% than 95% for the extraction using hexane as solvent, for equal time of extraction. The results of the extraction with wood showed statistically it that there is not difference between the extractions in both solvent studied. The supercritical fluid extraction in the conditions studied showed better efficiency in the extraction of PCBs in the wood matrix than in soil, for two hours extractions the obtain percentual of 43.9 ± 0.5 % for the total of PCBs extracted in the soils against 95.1 ± 0,5% for the total of PCBs extracted in the wood. The results demonstrated that the extractions were satisfactory for both technical studied

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

In this work we have investigated some aspects of the two-dimensional flow of a viscous Newtonian fluid through a disordered porous medium modeled by a random fractal system similar to the Sierpinski carpet. This fractal is formed by obstacles of various sizes, whose distribution function follows a power law. They are randomly disposed in a rectangular channel. The velocity field and other details of fluid dynamics are obtained by solving numerically of the Navier-Stokes and continuity equations at the pore level, where occurs actually the flow of fluids in porous media. The results of numerical simulations allowed us to analyze the distribution of shear stresses developed in the solid-fluid interfaces, and find algebraic relations between the viscous forces or of friction with the geometric parameters of the model, including its fractal dimension. Based on the numerical results, we proposed scaling relations involving the relevant parameters of the phenomenon, allowing quantifying the fractions of these forces with respect to size classes of obstacles. Finally, it was also possible to make inferences about the fluctuations in the form of the distribution of viscous stresses developed on the surface of obstacles.