906 resultados para Building materials -- Environmental aspects
Medidas de concentração de radônio proveniente de argamassas de cimento portland, gesso e fosfogesso
Resumo:
Portland cement being very common construction material has in its composition the natural gypsum. To decrease the costs of manufacturing, the cement industry is substituting the gypsum in its composition by small quantities of phosphogypsum, which is the residue generated by the production of fertilizers and consists essentially of calcium dihydrate and some impurities, such as fluoride, metals in general, and radionuclides. Currently, tons of phosphogypsum are stored in the open air near the fertilizer industries, causing contamination of the environment. The 226 Ra present in these materials, when undergoes radioactive decay, produces the 222Rn gas. This radioactive gas, when inhaled together with its decay products deposited in the lungs, produces the exposure to radiation and can be a potential cause of lung cancer. Thus, the objective of this study was to measure the concentration levels of 222Rn from cylindrical samples of Portland cement, gypsum and phosphogypsum mortar from the state of Paraná, as well as characterizer the material and estimate the radon concentration in an environment of hypothetical dwelling with walls covered by such materials. Experimental setup of 222Rn activity measurements was based on AlphaGUARD detector (Saphymo GmbH). The qualitative and quantitative analysis was performed by gamma spectrometry and EDXRF with Au and Ag targets tubes (AMPTEK), and Mo target (ARTAX) and mechanical testing with x- ray equipment (Gilardoni) and the mechanical press (EMIC). Obtained average values of radon activity from studied materials in the air of containers were of 854 ± 23 Bq/m3, 60,0 ± 7,2 Bq/m3 e 52,9 ± 5,4 Bq/m3 for Portland cement, gypsum and phosphogypsum mortar, respectively. These results extrapolated into the volume of hypothetical dwelling of 36 m3 with the walls covered by such materials were of 3366 ± 91 Bq/m3, 237 ± 28 Bq/m3 e 208 ± 21 Bq/m3for Portland cement, gypsum and phosphogypsum mortar, respectively. Considering the limit of 300 Bq/m3 established by the ICRP, it could be concluded that the use of Portland cement plaster in dwellings is not secure and requires some specific mitigation procedure. Using the results of gamma spectrometry there were calculated the values of radium equivalent activity concentrations (Raeq) for Portland cement, gypsum and phosphogypsum mortar, which were obtained equal to 78,2 ± 0,9 Bq/kg; 58,2 ± 0,9 Bq/kg e 68,2 ± 0,9 Bq/kg, respectively. All values of radium equivalent activity concentrations for studied samples are below the maximum level of 370 Bq/kg. The qualitative and quantitative analysis of EDXRF spectra obtained with studied mortar samples allowed to evaluate quantitate and the elements that constitute the material such as Ca, S, Fe, and others.
Resumo:
"June 1988."
Resumo:
Pt. 2 has subtitle: Hearings before the Committee on Energy and Natural Resources, United States Senate, One Hundredth Congress, first session, on the status of the Department of Energy's effects to address issues concerning the defense materials production reactors ... October 27 and 29, 1987.
Resumo:
The innovative Horizon 2020 program sponsored by the European Union (EU) aims to promote and develop processes of waste integration in construction materials. However, several potential health hazards caused by building materials have been identified and, there-fore, there is an ongoing need to develop new recycling methods for hazardous wastes and effi-cient barriers in order to prevent toxic releases from the new construction solutions with wastes. This paper presents an overview that focus on two main aspects: the identification of the health risks related to radioactivity and heavy metals present in building materials and identification of these toxic substances in new construction solutions that contain recycled wastes. Different waste materials were selected and distinct methodologies of toxicity evaluation are presented to analyse the potential hazardous, the feasibility of using those wastes and the achievement of op-timal construction solutions involving wastes.
Resumo:
Mode of access: Internet.
Resumo:
HERITAGE 2008 - World Heritage and Sustainable Development. Barcelos: Green Lines Institute for Sustainable Development, Vol. 2, p. 571-579
Resumo:
Evaporative cooling is a traditional strategy to improve summer comfort, which has gained renewed relevance in the context of the transition to a greener economy. Here, the potential for evaporative cooling of two common porous building materials, natural stone and ceramic brick, was evaluated. The work has relevance also to the protection of built heritage becauseevaporation underlies the problems of dampness and salt crystallization, which are so harmful and frequent in this heritage. It was observed that the drying rate of the materials is, in some cases, higher than the evaporation rate of a free water surface. Surface area measurements by a three-dimensional optical technique suggested, as probable cause of this behavior, that surface irregularity gives rise to a large effective surface of evaporation in the material. Surface temperature measurements by infrared were performed afterward during evaporation experiments outside during a hot summer day in Lisbon. Their results indicate that ordinary building materials can be very efficient evaporative media and, thus, may help in achieving higher energy efficiency while maintaining a simultaneous constructive or architectural function.
Resumo:
Introduction Visceral leishmaniasis (VL) stands out as a zoonosis observed on four continents and also in urban expansion zones in several regions of Brazil. Methods A cross-sectional epidemiological study of VL cases in children under 15 years of age in the period from 2007 to 2012. Clinical data were gathered from medical reports; meteorological data were obtained at the Meteorological Measurement Department of UFT. Environmental variables were divided into two periods, rainy and dry. Results The study revealed no difference by gender (p=0.67) among the 821 patients. However, the most affected age group was between one and five years of age (58.6%; p<0.01); the highest prevalence of the disease (99.03%; p<0.01) occurred in urban zones; and the most affected ethnic group (85.5%; p<0.01) was mixed race. The highest incidence coefficients in this population occurred in 2007 and 2008 (578.39/100,000 inhabitants; 18.5/100,000 inhabitants, respectively), whereas the highest lethality coefficients occurred in 2008 and 2011 (0.85/100 deaths). There was no significant correlation between average rainfall and the number of VL cases. The correlation between temperature and number of VL cases was negative (r = -0.4039; p<0.01). Conclusions In Araguaína, visceral leishmaniasis in children under 15 years is an urban-based endemic disease distributed across all districts of the city wherein temperature as an environmental factor, a higher prevalence in mixed race children between one and five years of age, and a high incidence coefficient all strongly contribute to child mortality.
Resumo:
Equity research report
Resumo:
Residual insecticide activity of BHC vapors from various building materials in controlled humidity chambers in the laboratory were significantly different. Laboratory-reared, first instar nymphs of Dipetalogaster maximus were exposed to vapors of BHC which were being released from the treated surfaces of building materials taken from Mambaí, Goiás.
Resumo:
Työn tavoite onharmonisoida yhtenäiset rakenteet UPM:n paperi- ja sellutehtaiden merkittävilleympäristönäkökohdille sekä niiden ympäristöriskienhallintajärjestelmille. Näin saavutetaan yhteneväiset tavoitteet ja analysointikeinot yrityksen yksiköille. Harmonisointiprosessi on osa koko yrityksen ympäristöhallintajärjestelmän kehittämistä. Ja konsernin EMS -prosessi puolestaan konvergoi konsernin integroidun johtamisjärjestelmän kehitystä. Lisäksi työn tapaustutkimuksessa selvitettiin riskienhallintajärjestelmien integroitumispotentiaalia. Sen avulla saavutettaisiin paremmin suuren yrityksen synergia-etuja ja vuorovaikutteisuutta toimijoiden kesken, sekä parannettaisiin riskienhallintajärjestelmän mukautuvuutta ja käytettävyyttä. Työssä käsitellään kolmea esimerkkiä, joiden pohjalta tehdään esitys harmonisoiduille merkittäville ympäristönäkökohdille sekä riskienhallintajärjestelmien parametreille. Tutkimusongelmaa lähestytään haastattelujen, kirjallisuuden, yrityksen PWC:llä teettämän selvityksen sekä omien päätelmien avulla. Lisäksi työssä esitetään ympäristöhallintajärjestelmän tehokkuuden todentaminen ympäristösuorituskyvyn muuttujiin suhteutettuna. Pohjana jatkuvan kehityksen päämäärälle on organisaatio-oppiminen, niin yksittäisen työntekijän, tiimien kuin eri yksiköiden kesken. Se antaa sysäyksen aineettoman omaisuuden, kuten ympäristö-osaamisen, hyödyntämiseen parhaalla mahdollisella tavalla. Tärkeimpinä lopputuloksina työssä ovat ehdotukset harmonisoiduille merkittäville ympäristönäkökohdille sekä ympäristöriskienhallintajärjestelmän määritetyille komponenteille. Niitä ovat määritelmät ja skaalat riskien todennäköisyydelle, seurauksille sekä riskiluokille. Työn viimeisenä osana luodaan pohja tapaustutkimuksen avulla Rauman tehtaan jätevedenpuhdistamon kahden erilaisen riskienhallintajärjestelmän integroitumiselle.
Resumo:
Various regulations and customer requirements have made it necessary for Vacon Oyj to pay more attention to the environmental aspects in its processes. The main purpose of this master’s thesis project is to define how environmental aspects could be integrated into Vacon’s product development process. The aim is to find out the most important environmental aspects for the company to address, to examine how these could be taken into account during the development process and to map the critical factors that need consideration in order to ensure the successful integration of environmental aspects into the design process. Based on the customer requirements and evolving regulations the most important aspects for Vacon include minimizing the amount of harmful substances, improving the recyclability and energy efficiency of the product and moreover providing meaningful information related to these aspects. To tackle these issues, a new DfE process was developed, tasks in each phase were described and responsibilities were indicated. To ensure the success of the DfE process, management commitment, support of other processes and significant improvements in ways the information is managed are required. The developers should be provided with training and support. Environmental expertise and knowledge in-house should be developed and establishing meaningful environmental indicators is suggested.
Resumo:
Receipt for building materials bought by Samuel Woodruff for E. Riddle, signed by Mr. Kiddee, Aug. 5, 1876.