Sulfur geochemistry at ODP Site 112-680 and 112-686

We have measured the concentrations of (1) pore-water sulfide and (2) solid-phase pyrite, iron monosulfide (=acid volatile sulfide), elemental sulfur, and extractable and nonextractable organic ("kerogen") sulfur in sediments from Ocean Drilling Program (ODP) Sites 680 and 686. Pore-water sulfide defines classic "bell-shaped" profiles. Maximum concentrations of 6 to 12 mM occur where sulfate is exhausted, or is most depleted, at depths between 15 and 50 mbsf. Sulfide resulting from bacterial sulfate reduction reacts in three ways: (1) some is reoxidized to elemental sulfur in surface sediments; (2) some reacts with detrital iron minerals to form iron monosulfide and pyrite, primarily in the top meter or two of the sediment; and (3) some reacts with, and is incorporated into, kerogen. Incorporation of reduced sulfur into kerogen occurs over the top 15 m of the sediment at both Sites 680 and 686, after the main phase of pyrite formation. Up to 45% of the total sedimentary sulfur is organically bound, and concentrations of 12 wt% sulfur are reached in the kerogen. These values are like those measured in lithologically similar, but more deeply buried, sediments from the Monterey Formation.

Chemistry of interstitial waters of ODP Leg 112 samples

Two distinct hydrogeochemical regimes currently dominate the Peruvian continental margin. One, in shallower water (150-450 m) shelf to upper-slope regions, is characterized by interstitial waters with strong positive chloride gradients with depth. The maximum measured value of 1043 mM chloride at Site 680 at ITS corresponds to a degree of seawater evaporation of ~2 times. Major ion chemistry and strontioum isotopic composition of the interstitial waters suggest that a subsurface brine that has a marine origin and is of pre-early Miocene "age," profoundly influences the chemistry and diagenesis of this shelf environment. Site 684 at ~9°S must be closest to the source of this brine, which becomes diluted with seawater and/or interstitial water as it flows southward toward Site 686 at ~13?S (and probably beyond) at a rate of approximately 3 to 4 cm/yr, since early Miocene time. The other regime, in deep water (3000-5000 m) middle to lower-slope regions, is characterized by interstitial waters with steep negative and nonsteady-state chloride gradients with depth. The minimum measured value of 454 mM chloride, at Site 683 at ITS, corresponds to ~20% dilution of seawater chloride The most probably sources of these low-chloride fluids are gas hydrate dissociation and mineral (particularly clay) dehydration reactions. Fluid advection is consistent with (1) the extent of dilution shown in the chloride profiles, (2) the striking nonsteady-state depth profiles of chlorides at Sites 683 and 688 and of 87Sr/86Sr ratios at Site 685, and (3) the temperatures resulting from an average geothermal gradient of 50°C/km and required for clay mineral dehydration reactions. Strontium isotope data reveal two separate fluid regimes in this slope region: a more northerly one at Sites 683 and 685 that is influenced by fluids with a radiogenic continental strontium signature, and a southerly one at Sites 682 and 688 that is influenced by fluids with a nonradiogenic oceanic signatures. Stratigraphically controlled fluid migration seems to prevail in this margin. Because of its special tectonic setting, Site 679 at ITS is geochemically distinct. The interstitial waters are characterized by seawater chloride concentrations to -200 mbsf and deeper by a significantly lower chloride concentration of about two-thirds of the value in seawater, suggesting mixing with a meteoric water source. Regardless of the hydrogeochemical regime, the chemistry and isotopic compositions of the interstitial waters at all sites are markedly modified by diagenesis, particularly by calcite and dolomite crystallization.

Carbon and Sulphur concentrations of sediments from Peru, Oman and Benguela upwelling environments

Abundances of organic carbon, sulfur, and reactive iron in sediments of three upwelling environments (Peru, Oman and Benguela) suggest that organic carbon/reduced sulfur ratios (C/S-ratios) in this category of marine sediments deviate considerably from previously established empirical ratios in normal marine sediments. To clarify the discrepancies, we investigated those components of the diagenetic system that limit the formation of pyrite: sulfate concentrations and reduction rates in pore waters, availability of reactive iron, and the quantity and quality of organic matter. All three limitations are evident in our sample pools. The results suggest that C/S-ratios in recent and fossil marine sediments rich in organic matter may be unsuitable as paleoenvironmental indicators.

Characterization of sorbed volatile hydrocarbons from the Peru margin

Bacterial and thermogenic hydrocarbons are present in the sorbed-gas fraction of Peru margin sediments. At Ocean Drilling Program (ODP) Sites 681, 682, 684, and 686, bacterial gases are restricted to the early diagenetic zones, where dissolved sulfate has been exhausted and methanogenesis occurs. Methane migrating into the sulfate zone at Sites 681, 684, 686, and possibly 682, has been consumed anaerobically by methanotrophs, maintaining the low concentrations and causing an isotope shift in d13C(CH4) to more positive values. Significant amounts of C2+ hydrocarbons occur at the shelf Sites 680/681, 684, and 686/687, where these hydrocarbons may be associated with hypersaline fluids. There is evidence at Site 679 that sorbed C2+ hydrocarbons may also have been transported by hypersaline fluids. This characteristic C2+ hydrocarbon signature in the sorbed-gas fractions of sediments at Site 679 is not reflected in data obtained using the conventional "free-," "canned-," or "headspace-gas" procedures. The molecular and isotope compositions of the sorbed-gas fraction indicate that this gas may have a thermogenic source and may have spilled over with the hypersaline fluids from the Salaverry Basin into the Lima Basin. These traces of thermogenic hydrocarbon gases are over-mature (about 1.5% Ro) and are discordant with the less-mature sediments in which they are found. This observation supports the migration of these hydrocarbons, possibly from continental sources. Sorbed-gas analyses may provide important geochemical information, in addition to that of the free-gases. Sorbed-gases are less sensitive to activities in the interstitial fluids, such as methanogenesis and methanotrophy, and may faithfully record the migration of hydrocarbons associated with hypersaline fluids.

Planktonic foraminifera in ODP Hole 112-688A (Table 1)

Species of Globorotalia are among the most dissolution-resistant planktonic foraminifers in sediments of the inner wall of the Middle America Trench; parts of their Phylogenetic history have been recognized in sediments of Leg 107 (Glacon and Bourgois, 1985). These species can be integrated into the biostratigraphic scheme on the basis of calcareous and siliceous nannoplankton and calibrated on the basis of paleomagnetism (Keller, 1980, 1981; Keller et al., 1982; Barron and Keller, 1982). Data compiled for this data report extend to the southern area of occurrence of Globorotalia species. About 250 sediment samples were collected on board JOIDES Resolution and examined as follows: 20-cm**3 samples were dried for 8 hr at 60°C, weighed, and then washed through sieves of 0.5, 0.2, 0.125, and 0.063 mm mesh size. The residues were dried and reweighed. The abundance of planktonic foraminifers counted is reported as numbers of specimens per weight of the original sample.

Contents, partition, and isotopic composition of sulphur in sediments from ODP Sites 680 and 686

We have determined (1) the abundance and isotopic composition of pyrite, monosulphide, elemental sulphur, organically bound sulphur, and dissolved sulphide; (2) the partition of ferric and ferrous iron; (3) the organic carbon contents of sediments recovered at two sites drilled on the Peru Margin during Leg 112 of the Ocean Drilling Program. Sediments at both sites are characterised by high levels of organically bound sulphur (OBS). OBS comprises up to 50% of total sedimentary sulphur and up to 1% of bulk sediment. The weight ratio of S to C in organic matter varies from 0.03 to 0.15 (mean = 0.10). Such ratios are like those measured in lithologically similar, but more deeply buried petroleum source rocks of the Monterey and Sisquoc formations in California. The sulphur content of organic matter is not limited by the availability of porewater sulphide. Isotopic data suggest that sulphur is incorporated into organic matter within a metre of the sediment surface, at least partly by reaction with polysulphides. Most inorganic Sulphur occurs as pyrite. Pyrite formation occurred within surface sediments and was limited by the availability of reactive iron. But despite highly reducing sulphidic conditions, only 35-65% of the total iron was converted to sulphide; 10-30% of the total iron still occurs as Fe(III). In surface sediments, the isotopic composition of pyrite is similar to that of both iron monosulphide and dissolved sulphide. Either pyrite, like monosulphide, formed by direct reaction between dissolved sulphide and detrital iron, and/or the sulphur species responsible for converting FeS to FeS2 is isotopically similar to dissolved sulphide. Likely stoichiometries for the reaction between ferric iron and excess sulphide imply a maximum resulting FeS2:FeS ratio of 1:1. Where pyrite dominates the pool of iron sulphides, at least some pyrite must have formed by reaction between monosulphide and elemental sulphur and/or polysulphide. Elemental sulphur (S°) is most abundant in surface sediments and probably formed by oxidation of sulphide diffusing across the sediment-water interface. In surface sediments, S° is isotopically heavier than dissolved sulphide, FeS and FeS2 and is unlikely to have been involved in the conversion of FeS to FeS2. Polysulphides are thus implicated as the link between FeS and FeS2.

Sapientia, 1974, Vol. XXIX, nº 112 (número completo)

Contenido: Le príncipe d’idetité chez Saint Thomas / R. Verneaux – Unidad de ser y analogía en Santo Tomás de Aquino / Cesáreo López Salgado – St. Thomas’ solution of the problema of faith and reason / A. G. M. Van Melsen – Necesidad de la directa confrontación de textos / Carlos A. Iturralde Colombres – Notas y comentarios -- Bibliografía