POWER DEPENDENCE OF THE RECOMBINATION PROCESSES IN THE INXGA1-XAS/GAAS SINGLE-QUANTUM-WELL

We have measured the power dependence of the photoluminesence spectra from a set of strained InxGa1-xAs/GaAs single quantum wells. The result shows that the excitation power has important effect on the carrier recombination processes. When the power increases from 0.5 to 14 mW, the photoluminescence from the barrier becomes more intense than that from the well and the trapping efficiency decreases. At high excitation level, the ratio of the radiative recombination rate to the nonradiative recombination rate of the barrier increases ten times than that at lower excitation level, while it only doubles for the well.

OPTICAL CHARACTERISTICS OF GAAS/ALGAAS RIDGE-QUANTUM-WELL-WIRES GROWN BY MBE ON NONPLANAR SUBSTRATES

With conventional photolithography and wet chemical etching, we have realized GaAs/AlGaAs buried ridge-quantum-well-wires (RQWWs) with vertically stacked wires in lateral arrays promising for device application, which were grown in situ by a single-step molecular beam epitaxy growth and formed at the ridge tops of mesas on nonplanar substrates. Confocal photoluminescence (CPL) and polarization-dependent photoreflectance (PR) are applied to study optical characteristics of RQWWs. Lateral bandgap modulation due to lateral variation of QW layer thickness is demonstrated not only by CPL but also by PR. As one evidence for RQWWs, a large blue shift is observed at the energy level positions for electronic transitions corresponding to quantum wells (QWs) at the ridge tops of mesas compared with those corresponding to QWs on nonpatterned areas of the same sample. The blue shift is in contradiction with the fact that the GaAs QW layers at the tops of the mesas are thicker than those on nonpatterned areas. The other evidence for RQWWs, optical anisotropy is provided by the polarization-dependent PR, which results from lateral quantum size effect existing at the tops of the mesas.

OPTICAL BISTABILITY IN A GAAS/GAALAS MULTI-QUANTUM-WELL (MQW) SELF-ELECTROOPTIC EFFECT DEVICE (SEED)

Based on a GaAs/GaAlAs MQW pin structure grown by a home-made MBE system, we have successfully fabricated a SEED. The optical bistability and related properties of the device under symmetric operation (S-SEED) and asymmetric operation are reported.

GAAS/GAALAS GRADED INDEX SEPARATE CONFINEMENT SINGLE QUANTUM-WELL SINGLE-MODE WAVE-GUIDE ELECTROABSORPTION LIGHT-MODULATOR

A GaAs/GaAlAs graded-index separate confinement single quantum well heterostructure single-mode ridge waveguide electroabsorption modulator was fabricated and investigated. For the modulator with a quantum well width of 100 angstrom and device length of 700-mu-m, an on/off ratio of 29.7 dB and estimated absorption insertion loss of 3 dB were obtained for TE polarised light with wavelength 8650 angstrom, and for TM polarisation the on/off ratio was 28.5 dB. With a switching voltage of 1 V, an on/off ratio of 15 dB was achieved. Photocurrent spectra exhibited a red shift of 600 angstrom of the absorption edge when the voltage applied to the PIN diode was varied from 0.5 to -7 V. The corresponding shift of the room temperature exciton peak energy was 96 meV.

OPTICAL-PHONON MODES AND FROHLICH POTENTIAL IN ONE-DIMENSIONAL QUANTUM-WELL WIRES

By extending our microscopic model on optical-phonon modes in quantum wells to one-dimensional (1D) quantum-well wires (QWW), the optical displacements and associated electrostatic potentials of optical-phonon modes in 1D QWW are calculated. The modes can be clearly divided into confined LO bulklike, TO bulklike modes, and extended interfacelike modes provided the bulk phonon dispersion is ignored. The character of each type of mode is illustrated with special attention to the interfacelike modes, which are hybrids of longitudinal- and transverse-optical waves from the corresponding bulk materials. Based on the numerical results, approximate analytical formulas for bulklike modes are presented. As in 2D wells, both the optical displacements and Frohlich potentials for the bulklike modes vanish at the interfaces. The finite dispersion of bulk phonons has a more pronounced effect on the 1D phonon modes because interfacelike modes show mixed characteristics of 2D interface and bulklike modes.