Towards Active Course Marks for Autonomous Sailing Competitions

This paper describes the environmental monitoring / regatta beacon buoy under development at the Laboratory of Autonomous Systems (LSA) of the Polytechnic Institute of Porto. On the one hand, environmentalmonitoring of open water bodies in real or deferred time is essential to assess and make sensible decisions and, on the other hand, the broadcast in real time of position, water and wind related parameters allows autonomous boats to optimise their regatta performance. This proposal, rather than restraining the boats autonomy, fosters the development of intelligent behaviour by allowing the boats to focus on regatta strategy and tactics. The Nautical and Telemetric Application (NAUTA) buoy is a dual mode reconfigurable system that includes communications, control, data logging, sensing, storage and power subsystems. In environmental monitoring mode, the buoy gathers and stores data from several underwater and above water sensors and, in regatta mode, the buoy becomes an active course mark for the autonomous sailing boats in the vicinity. During a race, the buoy broadcasts its position, together with the wind and the water current local conditions, allowing autonomous boats to navigate towards and round the mark successfully. This project started with the specification of the requirements of the dual mode operation, followed by the design and building of the buoy structure. The research is currently focussed on the development of the modular, reconfigurable, open source-based control system. The NAUTA buoy is innovative, extensible and optimises the on board platform resources.

Multilingual ontology specification: a collaborative approach

19-22 June 2012 Madrid, Spain

On the requirements of interpolating polynomials for path motion constraints

In the framework of multibody dynamics, the path motion constraint enforces that a body follows a predefined curve being its rotations with respect to the curve moving frame also prescribed. The kinematic constraint formulation requires the evaluation of the fourth derivative of the curve with respect to its arc length. Regardless of the fact that higher order polynomials lead to unwanted curve oscillations, at least a fifth order polynomials is required to formulate this constraint. From the point of view of geometric control lower order polynomials are preferred. This work shows that for multibody dynamic formulations with dependent coordinates the use of cubic polynomials is possible, being the dynamic response similar to that obtained with higher order polynomials. The stabilization of the equations of motion, always required to control the constraint violations during long analysis periods due to the inherent numerical errors of the integration process, is enough to correct the error introduced by using a lower order polynomial interpolation and thus forfeiting the analytical requirement for higher order polynomials.

Hox genes control the specification of global vertebral domains

Dissertação apresentada para obtenção do grau de doutor em Biologia pelo Instituto de Tecnologia Química e Biológica da Universidade Nova de Lisboa

Integration of forest fire management with SDI: user requirements.

Dissertation submitted in partial fulfilment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Predictive Variables Affecting Transfusion Requirements in Orthotopic Liver Transplantation

INTRODUCTION AND AIMS: Adult orthotopic liver transplantation (OLT) is associated with considerable blood product requirements. The aim of this study was to assess the ability of preoperative information to predict intraoperative red blood cell (RBC) transfusion requirements among adult liver recipients. METHODS: Preoperative variables with previously demonstrated relationships to intraoperative RBC transfusion were identified from the literature: sex, age, pathology, prothrombin time (PT), factor V, hemoglobin (Hb), and platelet count (plt). These variables were then retrospectively collected from 758 consecutive adult patients undergoing OLT from 1997 to 2007. Relationships between these variables and intraoperative blood transfusion requirements were examined by both univariate analysis and multiple linear regression analysis. RESULTS: Univariate analysis confirmed significant associations between RBC transfusion and PT, factor V, Hb, Plt, pathology, and age (P values all < .001). However, stepwise backward multivariate analysis excluded variables Plt and factor V from the multiple regression linear model. The variables included in the final predictive model were PT, Hb, age, and pathology. Patients suffering from liver carcinoma required more blood products than those suffering from other pathologies. Yet, the overall predictive power of the final model was limited (R(2) = .308; adjusted R(2) = .30). CONCLUSION: Preoperative variables have limited predictive power for intraoperative RBC transfusion requirements even when significant statistical associations exist, identifying only a small portion of the observed total transfusion variability. Preoperative PT, Hb, age, and liver pathology seem to be the most significant predictive factors but other factors like severity of liver disease, surgical technique, medical experience in liver transplantation, and other noncontrollable human variables may play important roles to determine the final transfusion requirements.

Quality-of-service aware routing for static and mobile IPv6-based low-power and lossy sensor networks using RPL

The Internet of Things (IoT) has emerged as a paradigm over the last few years as a result of the tight integration of the computing and the physical world. The requirement of remote sensing makes low-power wireless sensor networks one of the key enabling technologies of IoT. These networks encompass several challenges, especially in communication and networking, due to their inherent constraints of low-power features, deployment in harsh and lossy environments, and limited computing and storage resources. The IPv6 Routing Protocol for Low Power and Lossy Networks (RPL) [1] was proposed by the IETF ROLL (Routing Over Low-power Lossy links) working group and is currently adopted as an IETF standard in the RFC 6550 since March 2012. Although RPL greatly satisfied the requirements of low-power and lossy sensor networks, several issues remain open for improvement and specification, in particular with respect to Quality of Service (QoS) guarantees and support for mobility. In this paper, we focus mainly on the RPL routing protocol. We propose some enhancements to the standard specification in order to provide QoS guarantees for static as well as mobile LLNs. For this purpose, we propose OF-FL (Objective Function based on Fuzzy Logic), a new objective function that overcomes the limitations of the standardized objective functions that were designed for RPL by considering important link and node metrics, namely end-to-end delay, number of hops, ETX (Expected transmission count) and LQL (Link Quality Level). In addition, we present the design of Co-RPL, an extension to RPL based on the corona mechanism that supports mobility in order to overcome the problem of slow reactivity to frequent topology changes and thus providing a better quality of service mainly in dynamic networks application. Performance evaluation results show that both OF-FL and Co-RPL allow a great improvement when compared to the standard specification, mainly in terms of packet loss ratio and average network latency. 2015 Elsevier B.V. Al

GVSOS: A New Client for OGC SOS Interface Standard

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Criação e atualização de aplicações para área de retalho por MDA

Nos últimos anos tem-se verificado a constante evolução dos mercados em plataformas na Internet como forma de melhoria não só dos serviços prestados, mas também para o aumento de vendas de produtos e respetiva internacionalização dos mesmos. Este aumento da procura por este tipo de softwares, assim como a constante evolução e atualização dos mesmos tem contribuído para que estas aplicações evoluam em termos de funcionalidades e complexidade. Isto contribui cada vez para a dificuldade de formar equipas capazes de manter e desenvolver estes sistemas sem que comprometa em grandes custos para as organizações. Neste sentido surgiram diversas ferramentas que permitem criar soluções pré desenvolvidas de aplicações na Internet denominadas de "E-commerce applications". Estas plataformas, apesar do utilizador não ter obrigatoriamente que deter conhecimentos de programação para proceder à sua instalação, são bastante restritas tanto aos serviços que podem ser usados, e na sua escalabilidade, visto que normalmente correm em servidores específicos e por vezes as configurações necessárias para instalação tornam-se bastante complexas de ser efetuadas. Pretende-se no âmbito desta dissertação de mestrado propor um modelo de uma arquitetura de um sistema baseado em mecanismos MDA para a área de retalho, particularmente em ambientes de e-commerce. Serão inicialmente sistematizados os principais tipos de ecommerce numa perspetiva de evolução histórica. Será igualmente enquadrado o MDA no desenvolvimento de um sistema de e-commerce. Neste sentido, serão equacionadas as diferenças entre o modelo típico de desenvolvimento de software e o desenvolvimento de software orientado pelas metodologias do MDA. No processo de especificação e desenvolvimento do modelo proposto será realizada uma análise de requisitos, assim como, a proposta do modelo da arquitetura de um sistema baseado em mecanismos MDA, tendo como orientação os requisitos e arquitetura definida na fase de análise. Finalmente no sentido de analisar o resultado esperado para um sistema orientado por metodologias definidas por MDA, serão realizado alguns testes no sistema desenvolvido de forma a analisar o seu desempenho e validar a sua adequabilidade no âmbito do processo de desenvolvimento de sistemas e-commerce

Translation encoding for OGC services

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Framework development for providing accessibility to qualitative spatial calculi

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Sistema aplicacional para o acompanhamento e monitorização de casos de perturbação psicótica

Pretende-se, na presente dissertação, descrever o trabalho desenvolvido e os conhecimentos adquiridos no decorrer do projeto “iCOPE”, realizado no âmbito do curso de Mestrado em Engenharia de Computação e Instrumentação Médica. O projeto consistiu no desenvolvimento de um sistema aplicacional para o auxílio à prestação de serviços e cuidados de saúde a pacientes com doenças psicóticas tanto através de ferramentas de autogestão, como por funcionalidades que permitirão a um terapeuta monitorizar as ocorrências comunicadas pelos respetivos pacientes atribuídos. As tarefas à responsabilidade do autor desta dissertação compreenderam o levantamento e especificação de requisitos funcionais, o desenvolvimento das funcionalidades e interfaces de gestão de utilizadores e administração do sistema, o desenvolvimento das funcionalidades e interfaces para utilização pelos terapeutas e a criação de ferramentas para a instalação do servidor aplicacional central, existindo ainda cooperação no desenvolvimento de funcionalidades e interfaces para utilização pelos pacientes, nomeadamente ao nível da modelização da base de dados e na realização de testes e deteção de erros. Os resultados da avaliação das interfaces desenvolvidas, obtidos por meio da análise de respostas dadas por um grupo de potenciais utilizadores a um inquérito de usabilidade anónimo, demonstraram que estes estão satisfeitos com a solução implementada, havendo, no entanto, margem para futuros melhoramentos e incremento de funcionalidades.

Design and implementation of 3D buildings integration for a Webgl-Based Virtual Globe: a case study of Valencian Cadastre and Fide Building Mode

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Derivation and consistency checking of models in early software product line engineering

Dissertação para obtenção do Grau de Doutor em Engenharia Informática

Capital requirements and loan market conditions insight into the Portuguese banking system (2004-2011)

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Finance from the NOVA – School of Business and Economics