Experimental study of the complex reflection coefficient of shear waves from the solid-liquid interface

The determination of the reflection coefficient of shear waves reflected from a solid-liquid interface is an important method in order to study the viscoelastic properties of liquids at high frequency. The reflection coefficient is a complex number. While the magnitude measurement is relatively easy and precise, the phase measurement is very difficult due to its strong temperature dependence. For that reason, most authors choose a simplified method in order to obtain the viscoelastic properties of liquids from the measured coefficient. In this simplified method, inconsistent viscosity results are obtained because pure viscous behavior is assumed and the phase is not measured. This work deals with an effort to improve the experimental technique required to measure both the magnitude and phase of the reflection coefficient and it intends to report realistic values for oils in a wide range of viscosity (0.092 - 6.7 Pa.s). Moreover, a device calibration process is investigated in order to monitor the dynamic viscosity of the liquid.

A simple and environmentally friendly reflectometric method for the rapid quantitative analysis of captopril in pharmaceutical formulations

This paper describes a simple, environmentally friendly and rapid quantitative spot test procedure for the determination of captopril (CPT) in bulk drug and in pharmaceutical formulations by using diffuse reflectance spectroscopy. The proposed method is based on the reflectance measurements of the orange compound (λ max 490 nm) produced by the spot test reaction between CPT and p-chloranil (CL). Under optimal conditions, calibration curves were obtained for CPT by plotting the optical density of the reflectance signal (A R) vs. the log of the mol L -1 concentration, from 6.91×10 -3 to 1.17×10 -1, with a good coefficient of determination (R 2 = 0.9992). The common excipients used as additives in pharmaceuticals do not interfere in the proposed method. The method was applied to determine CPT in commercial pharmaceutical formulations. The results obtained by the proposed method are compared favorably with those obtained by an official procedure at 95% confidence level. The method validation results showed that the sensitivity and selectivity of the methods were adequated for drug monitoring in industrial quality control laboratories. © 2011 Moment Publication.

Alignment of operations strategy: Exploring the marketing interface

Purpose - The purpose of this paper is to identify factors that can help managers to overcome barriers to alignment of operations strategy at the interface with marketing. Design/methodology/approach - This objective required the application of a procedure based on strategic consensus and a deeper analysis, such that the delimitation of the study in a single case was mandatory. The strategic processes of interfacing involve managerial attributes that are subject to the influence of human aspects and, therefore, the research method used a qualitative approach. The protocol design included the following data sources: interviews, document reviews and researcher observations. The categorisation was made based on the theoretical references, the frequency of observations, common responses and information from documents. Findings - The balance between intra-functional trade-offs, joint research on the competitive context, reflections on the understanding of customer needs and operational performance, and understanding of inter-functional trade-offs were the main factors verified. They effectively support decisions associated with interface processes and promotes the integration of these processes. They can generate inputs that enable managers to achieve an appropriate balance among alternatives in light of various trade-offs. Practical implications - These factors make possible new connections between strategic processes in the context of operations and marketing functions. The formations of these strategies are aligned through a better understanding of both threats and opportunities by means of a joint analysis of the competitive context. The presented findings can be used to develop a clear definition of strategic objectives of operations and a more appropriate treatment of market needs. Originality/value - The findings from the research can be considered as new elements for promoting alignment in the formation process of the operations strategy. Little research to date has examined the operations-marketing strategic interface of companies in the context of strategic consensus. © Emerald Group Publishing Limited.

Preparation and photoluminescence characteristics of In(OH) 3:xTb3+ obtained by Microwave-Assisted Hydrothermal method

Crystalline terbium-doped indium hydroxide structures were prepared by a rapid and efficient Microwave-Assisted Hydrothermal (MAH) method. Nanostructures were obtained at a low temperature. FE-SEM images confirm that these samples are composed of 3D nanostructures. XRD, optical diffuse reflectance and photoluminescence (PL) measurements were used to characterize the products. Emission spectra of terbium-doped indium hydroxide (In(OH)3:xTb 3+) samples under excitation (350.7 nm) presented broad band emission referent to the indium hydroxide matrix and 5D4 → 7F6, 5D4 → 7F 5, 5D4 → 7F4, and 5D4 → 7F3 terbium transitions at 495, 550, 590 and 627 nm, respectively. Relative intensities of the Tb 3+ emissions increased as the concentration of this ion increased from 0, 1, 2, 4 and 8 mol%, of Tb3+, but the luminescence is drastically quenched for the In(OH)3 matrix. © 2012 Elsevier B.V. All rights reserved.

Rapid determination of furosemide by combined spot test/diffuse reflectance spectroscopy to detect doping in sport

This paper describes the development and application of a simple, cheap, and clean method for the quantification of furosemide in urine samples from athletes, to detect doping, using a combined spot test/diffuse reflectance spectroscopy procedure. The method is based on the complexation reaction of furosemide (5-(aminosulfonyl)-4-chloro-2-((furanylmethyl)amino)benzoic acid, dissolved in ethanol, with FeCl3 and the surfactant dodecyltrimethylammonium bromide (DTAB) in aqueous solution, yielding a colored compound on the surface of a filter paper. The reagent concentrations were optimized using a chemometric experimental design. The reflectometric measurements of the complex formed were carried out at 477nm. The linear range obtained was 1.65-9.00×10-3molL-1 of furosemide (R=0.997), and the detection and quantification limits were 4.9×10-4 and 1.62×10-3molL-1, respectively. The proposed method was successfully applied in the analysis of furosemide in spiked urine, demonstrating that it is a reliable alternative method for the detection of furosemide doping in sport. © 2012 Elsevier B.V..

Expressando-se: uma interface do ensino de artes visuais com a musicalidade

Pós-graduação em Artes - IA

Estudo da interface titânio/porcelana, com três porcelanas de ultra baixa fusão, empregando-se microscopia eletrônica de varredura e dilatometria

Pós-graduação em Ciências Odontológicas - FOAR

Características da interface dos sites de notícias: um estudo do design e da usabilidade de jornais impressos e eletrônicos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Interface antropométrica digital: parâmetros antropométricos de populações extremas

Pós-graduação em Design - FAAC

A ordem SV/VS no português como L2 na fronteira Brasil/Paraguai: uma investigação sociofuncionalista na interface variação/aquisição

Pós-graduação em Estudos Linguísticos - IBILCE

Análise morfológica e de resistência à flexão da interface ponta ativa/haste metálica em fresas carbide após o uso de esterilização

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influência do tipo de fundição e uso de retificação na interface pilar/cilindro protético na adaptação marginal e tensão peri-implantar sobre conexão protética tipo Micro-Unit

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo comparativo da influência de três diferentes métodos de fundição na resistência da interface metal-cerâmica, por meio do teste de cisalhamento

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Avaliação de interface de reação e colisão para eliminar interferências poliatômicas na análise de etanol combustível por ICP-MS

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Desenvolvimento de Interface gráfica como suporte para soluções numéricas das equações de Maxwell em coordenadas gerais – 3D

Neste trabalho, é implementada uma interface gráfica de usuários (GUI) usando a ferramenta Qt da Nokia (versão 3.0). A interface visa simplificar a criação de cenários para a realização de simulações paralelas usando a técnica numérica Local Nonorthogonal Finite Difference Time-Domain (LN-FDTD), aplicada para solucionar as equações de Maxwell. O simulador foi desenvolvido usando a linguagem de programação C e paralelizado utilizando threads. Para isto, a biblioteca pthread foi empregada. A visualização 3D do cenário a ser simulado (e da malha) é realizada por um programa especialmente desenvolvido que utiliza a biblioteca OpenGL. Para melhorar o desenvolvimento e alcançar os objetivos do projeto computacional, foram utilizados conceitos da Engenharia de Software, tais como o modelo de processo de software por prototipagem. Ao privar o usuário de interagir diretamente com o código-fonte da simulação, a probabilidade de ocorrência de erros humanos durante o processo de construção de cenários é minimizada. Para demonstrar o funcionamento da ferramenta desenvolvida, foi realizado um estudo relativo ao efeito de flechas em linhas de baixa tensão nas tensões transitórias induzidas nas mesmas por descargas atmosféricas. As tensões induzidas nas tomadas da edificação também são estudadas.