Ultraviolet Photodissociation of the N-Methylpyridinium Ion: Action Spectroscopy and Product Characterization

The ultraviolet photodissociation of gas-phase N-methylpyridinium ions is studied at room temperature using laser photodissociation mass spectrometry and structurally diagnostic ion-molecule reaction kinetics. The C5H5N-CH3+ (m/z 94), C5H5N-CD3+ (m/z 97), and C5D5N-CH3+(m/z 99) isotopologues are investigated, and it is shown that the N-methylpyridinium ion photodissociates by the loss of methane in the 36 000 - 43 000 cm(-1) (280 - 230 nm) region. The dissociation likely occurs on the ground state surface following internal conversion from the SI state. For each isotopologue, by monitoring the photofragmentation yield as a function of photon wavenumber, a broad vibronically featured band is recorded with origin (0-0) transitions assigned at 38 130, 38 140 and 38 320 cm(-1) for C5H5N-CH3+ C5H5N-CD3+ and C5D5N-CH3+, respectively. With the aid of quantum chemical calculations (CASSCF(6,6)/aug-cc-pVDZ), most of the observed vibronic detail is assigned to two in-plane ring deformation modes. Finally, using ion-molecule reactions, the methane coproduct at m/z 78 is confirmed as a 2-pyridinylium ion.

Ozone-induced dissociation of conjugated lipids reveals significant reaction rate enhancements and characteristic odd-electron product ions

Ozone-induced dissociation (OzID) is an alternative ion activation method that relies on the gas phase ion-molecule reaction between a mass-selected target ion and ozone in an ion trap mass spectrometer. Herein, we evaluated the performance of OzID for both the structural elucidation and selective detection of conjugated carbon-carbon double bond motifs within lipids. The relative reactivity trends for \[M + X](+) ions (where X = Li, Na, K) formed via electrospray ionization (ESI) of conjugated versus nonconjugated fatty acid methyl esters (FAMEs) were examined using two different OzID-enabled linear ion-trap mass spectrometers. Compared with nonconjugated analogues, FAMEs derived from conjugated linoleic acids were found to react up to 200 times faster and to yield characteristic radical cations. The significantly enhanced reactivity of conjugated isomers means that OzID product ions can be observed without invoking a reaction delay in the experimental sequence (i.e., trapping of ions in the presence of ozone is not required). This possibility has been exploited to undertake neutral-loss scans on a triple quadrupole mass spectrometer targeting characteristic OzID transitions. Such analyses reveal the presence of conjugated double bonds in lipids extracted from selected foodstuffs. Finally, by benchmarking of the absolute ozone concentration inside the ion trap, second order rate constants for the gas phase reactions between unsaturated organic ions and ozone were obtained. These results demonstrate a significant influence of the adducting metal on reaction rate constants in the fashion Li > Na > K.

Product 45

Contribution to a curated book of Australian 45rpm single covers. This contribution is a discussion about the possibilities afforded by available technologies in the late 70s in the production of music-related artwork: record covers, posters, handbills etc.

An ontology-based service discovery approach for the provisioning of product-service bundles

More and more traditional manufacturing companies form or join inter-organizational networks to bundle their physical products with related services to offer superior value propositions to their customers. Some of these product-related services can be digitized completely and thus fully delivered electronically. Other services require the physical integration of external factors, but can still be coordinated electronically. In both cases companies and consumers face the problem of discovering appropriate product-related service offerings in the network or market. Based on ideas from the web service discovery discipline we propose a meet-in-the-middle approach between heavy-weight semantic technologies and simple boolean search to address this issue. Our approach is able to consider semantic relations in service descriptions and queries and thus delivers better results than syntax-based search. However – unlike most semantic approaches – it does not require the use of any formal language for semantic markup and thus requires less resources and skills for both service providers and consumers. To fully realize the potentials of the proposed approach a domain ontology is needed. In this research-in-progress paper we construct such an ontology for the domain of product-service bundles through analysis and synthesis of related work on service description. This will serve as an anchor for future research to iteratively improve and evaluate the ontology through collaborative design efforts and practical application.

Raising levels of awareness of rights and obligations in the provision of financial product advice to retail clients

In September-December 2012, 548 financial planning retail clients and 77 financial advisers responded to online surveys addressing consumer satisfaction with financial planning services and the provision of information concerning regulatory and rights issues. Retail clients commented on areas related to the best interests duty in s 961B of the Corporations Act 2001 (Cth), in particular the extent to which advisers considered their clients’ financial objectives and lifestyle situations, and the client-centredness of the financial advice they received. Retail clients also indicated their level of awareness of their substantive rights in relation to receiving advice, the legal obligations imposed on advisers, and whether they would access internal and external complaints processes if warranted. Advisers reported on the extent to which they provide clients with information relating to their substantive rights, and complaints processes available to them. Responses were analysed in relation to client demographics (e.g., age, gender, education), and experience of financial advice. This article reports on the findings of the surveys and their implications for financial planners.

A platform - independent product library for BIM

There is considerable interest internationally in developing product libraries to support the use of BIM. Product library initiatives are driven by national bodies, manufacturers and private companies who see their potential. A major issue with the production and distribution of product information for BIM is that separate library objects need to be produced for all of the different software systems that are going to use the library. This increases the cost of populating product libraries and also increases the difficulty in maintaining consistency between the representations for the different software over time. This paper describes a project which uses “software transformation” technology from the field of software engineering to support the definition of a single generic representation of a product which can then be automatically converted to the format required by receiving software. The paper covers the current state of implementation of the product library, the technology underlying the transformations for the currently supported software and the business model for creating a national library in Australia. This is placed within the context of other current product library systems to highlight the differences. The responsibilities of the various actors involved in supporting the product library are also discussed.

Label-free SERS for natural product provenance

Introduction Natural product provenance is important in the food, beverage and pharmaceutical industries, for consumer confidence and with health implications. Raman spectroscopy has powerful molecular fingerprint abilities. Surface Enhanced Raman Spectroscopy’s (SERS) sharp peaks allow distinction between minimally different molecules, so it should be suitable for this purpose. Methods Naturally caffeinated beverages with Guarana extract, coffee and Red Bull energy drink as a synthetic caffeinated beverage for comparison (20 µL ea.) were reacted 1:1 with Gold nanoparticles functionalised with anti-caffeine antibody (ab15221) (10 minutes), air dried and analysed in a micro-Raman instrument. The spectral data was processed using Principle Component Analysis (PCA). Results The PCA showed Guarana sourced caffeine varied significantly from synthetic caffeine (Red Bull) on component 1 (containing 76.4% of the variance in the data). See figure 1. The coffee containing beverages, and in particular Robert Timms (instant coffee) were very similar on component 1, but the barista espresso showed minor variance on component 1. Both coffee sourced caffeine samples varied with red Bull on component 2, (20% of variance). ************************************************************ Figure 1 PCA comparing a naturally caffeinated beverage containing Guarana with coffee. ************************************************************ Discussion PCA is an unsupervised multivariate statistical method that determines patterns within data. Figure 1 shows Caffeine in Guarana is notably different to synthetic caffeine. Other researchers have revealed that caffeine in Guarana plants is complexed with tannins. Naturally sourced/ lightly processed caffeine (Monster Energy, Espresso) are more inherently different than synthetic (Red Bull) /highly processed (Robert Timms) caffeine, in figure 1, which is consistent with this finding and demonstrates this technique’s applicability. Guarana provenance is important because it is still largely hand produced and its demand is escalating with recognition of its benefits. This could be a powerful technique for Guarana provenance, and may extend to other industries where provenance / authentication are required, e.g. the wine or natural pharmaceuticals industries.

The role of intellectual resources, product innovation capability, reputational resources and marketing capability combinations in SME growth

This article examines the extent to which combinations of intellectual resources and product innovation capability, and reputational resources and marketing capability, influence the ability of small and medium-sized enterprises (SME) to meet or exceed performance goals. Empirical results drawn from 171 SMEs suggest that when the combination of intellectual resources and product innovation capability in addition to the combination of reputational resources and marketing capability are high, SME growth is enhanced. However, a high level of intellectual resources combined with a low level of product innovation capability as well as a combination of a high level of reputational resources with a low level of marketing capability (and vice versa) are not significantly related to growth. These results imply that a high level of resources cannot compensate for a low level of capabilities (and vice versa).

Examining the role of within functional area resource–capability complementarity in achieving customer and product-based performance outcomes

Adopting both the resource-based view and dynamic capability theory this study advances the contention that firms must possess both resources and capabilities at a superior level to achieve superior customer and product performance. To examine this contention this study investigates the individual effect of the complementarity between marketing resources and capability and complementarity between innovation resources and capability on customer and product performance respectively. The results of a survey of 171 B2B manufacturing firms show a significant main effect for complementarity between marketing resources–capability and complementarity between innovation resources–capability on customer and product performance. The findings also show that complementarity marketing resources–capability has a stronger positive relationship with customer performance than with product performance, while complementarity between innovation resources–capability has a stronger positive relationship with product performance than with customer performance.

A review selection method using product feature taxonomy

As of today, online reviews have become more and more important in decision making process. In recent years, the problem of identifying useful reviews for users has attracted significant attentions. For instance, in order to select reviews that focus on a particular feature, researchers proposed a method which extracts all associated words of this feature as the relevant information to evaluate and find appropriate reviews. However, the extraction of associated words is not that accurate due to the noise in free review text, and this affects the overall performance negatively. In this paper, we propose a method to select reviews according to a given feature by using a review model generated based upon a domain ontology called product feature taxonomy. The proposed review model provides relevant information about the hierarchical relationships of the features in the review which captures the review characteristics accurately. Our experiment results based on real world review dataset show that our approach is able to improve the review selection performance according to the given criteria effectively.

Malaria rapid diagnostic test performance : results of WHO product testing of malaria RDTs : round 5 (2013)

WHO estimates that half the world’s population is at risk of malaria. In 2012, there were an estimated 207 million cases (with an uncertainty range of 135 million to 287 million) and an estimated 627 000 deaths (with an uncertainty range of 473 000 to 789 000). Approximately 90% of all malaria deaths occur in sub-Saharan Africa, and 77% occur in children under 5 years. Malaria remains endemic in 104 countries, and, while parasite-based diagnosis is increasing, most suspected cases of malaria are still not properly confirmed, resulting in over-use of antimalarial drugs and poor disease monitoring (1)...

A rating aggregation method for generating product reputations

Many websites offer the opportunity for customers to rate items and then use customers' ratings to generate items reputation, which can be used later by other users for decision making purposes. The aggregated value of the ratings per item represents the reputation of this item. The accuracy of the reputation scores is important as it is used to rank items. Most of the aggregation methods didn't consider the frequency of distinct ratings and they didn't test how accurate their reputation scores over different datasets with different sparsity. In this work we propose a new aggregation method which can be described as a weighted average, where weights are generated using the normal distribution. The evaluation result shows that the proposed method outperforms state-of-the-art methods over different sparsity datasets.

Privacy concerns and purchase of travel product online

The travel and tourism industry has come to rely heavily on information and communication technologies to facilitate relations with consumers. Compiling consumer data profiles has become easier and it is widely thought that consumers place great importance on how that data is handled by firms. Lack of trust may cause consumers to have privacy concerns and may, in turn, have an adverse impact on consumers’ willingness to purchase online. Three specific aspects of privacy that have received attention from researchers are unauthorized use of secondary data, invasion of privacy, and errors. A survey study was undertaken to examine the effects of these factors on both prior purchase of travel products via the Internet and future purchase probability. Surprisingly, no significant relationships were found to indicate that such privacy concerns affect online purchase behavior within the travel industry. Implications for managers are discussed.

A conceptual analysis of strategic capability development within product innovation projects

Strategic capability development refers to the renewal of the organisational capabilities which are sources of competitive advantage. The aim of this paper is to examine how strategic capability and competitive advantage build up over time. Recent literature points to the integration of dynamic capability and ambidexterity perspectives in explaining organisational capability development. Literature analysis reveals the role of knowledge integration and product innovation in integrating dynamic capability and ambidexterity. However, little attention has yet been paid to knowledge integration within innovation projects as a context for capability development. Accordingly, this paper aims to develop a conceptual framework for strategic capability development focusing on the role of knowledge integration within product innovation projects. This framework contributes to identifying and emphasising the role of micro processes in capability renewal which in turn enhances our understanding of strategic capability development.