Pedestrian and bicyclist safety: a review of key program and countermeasure developments during the 1980's. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Traffic calming, auto-restricted zones and other traffic management techniques: their effects on bicycling and pedestrians. Case study #19.

Federal Highway Administration, Washington, D.C.

An evaluation of the adequacy of the State of Maryland Demonstration Bikeway Project. Final report.

Maryland State Highway Administration, Brooklandville

An evaluation of the adequacy of the State of Maryland Demonstration Bikeway Project. Summary report.

Maryland State Highway Administration, Brooklandville

Characteristics of the regular adult bicycle user. Final report.

Mode of access: Internet.

Ethanol intake of paediatric intensive care patients

Background - Limiting the amount of alcohol in children's medicines is advisable but as alcohol is the second most common solvent used in liquid preparations, paediatric patients with increased medication intake may be exposed to a considerable alcohol intake. Few medicines are specifically designed for children in Paediatric Intensive Care (PICU), and therefore adult formulations are frequently administered, with high medication use further exposing a PICU patient to undesired alcohol intake. Aims - This small pilot study aimed to examiine the intake of a sample of PICU patients, highlight common medicines used on PICU containing alcohol, provide alternatives where possible and where alternatives are not possible, provide the prescriber with a list of the higher alcohol containing medicines. Method - A retrospective medication chart review was undertaken as a two point snap shot. Data collected included age, weight, medications prescribed and the formulations used at time of the study. The patients' sedation score was recorded. The electronic medicine compendium (EMC) was consulted for any ethanol content for the commercially available products. The manufacturer was contacted for ethanol content of all ‘specials’ and any commercial products found to contain ethanol from the EMC. The PICU patient's daily intake of ethanol was calculated. The calculation was converted to an adult equivalent alcohol unit intake and although this method of conversion is crude and does not take physiological differences of adult and children into account, it was done in order to provide the clinician with commonly used terminology in deciding the risk to the patient. Results - Twenty-eight patients were prescribed a range of 69 different medications. Of the 69 medicines, 12 products were found to contain ethanol. Patient ages ranged from a 26 week premature infant to 15 years old, weights ranges from 0.7 kg to 45 kg. Only 2 out of the 28 patients did not receive ethanol containing medications, and most patients were prescribed at least two medicines containing ethanol. Daily ethanol intake uncorrected for weight ranged from 0.006 ml to 2.18 ml (median 0.26 ml). Converting this to adult units per week, alcohol intake ranged from 0.07 to 15.2 units (median 1.4 units). The two patients receiving above 15 units/week adult equivalent were prescribed an oral morphine weaning regimen, therefore the high alcohol exposure was short term. The most common drugs prescribed containing alcohol were found to be nystatin, ranitidine, furosemide and morphine. No commercially available alcohol-free oral liquid preparations were found for ranitidine, furosemide or morphine at the time of the study. Correlation of the sedation score against ethanol intake was difficult to analyse as most patients were actively sedated. Conclusions - Polypharmacy in PICU patients increases the exposure to alcohol. Some commercially available medicines provide excessive ethanol intake, providing the clinician with ethical, potentially economical dilemmas of prescribing an unlicensed medicine to minimise ethanol exposure. Further research is required to evaluate the scope of the problem, effects of exposure and provision of alcohol free formulations.

Peculiarities of the Electronic Educational and Methodological Complex under the Point-rating Technology

At present in the sphere of electronic learning in the light of solving tasks put by the Bologna Declaration an important place is being taken by electronic educational and methodological complexes (EMC).The authors have put forward new components of EMC necessary for the organization of educational process and for the determination of labour intensity according to modules and students’ activity type. They also suggested a technology of defining the rating of the grade in the credit-module system.

High frequency electric machine models for the evaluation of operational impacts in integrated drives

A high frequency physical phase variable electric machine model was developed using FE analysis. The model was implemented in a machine drive environment with hardware-in-the-loop. The novelty of the proposed model is that it is derived based on the actual geometrical and other physical information of the motor, considering each individual turn in the winding. This is the first attempt to develop such a model to obtain high frequency machine parameters without resorting to expensive experimental procedures currently in use. The model was used in a dynamic simulation environment to predict inverter-motor interaction. This includes motor terminal overvoltage, current spikes, as well as switching effects. In addition, a complete drive model was developed for electromagnetic interference (EMI) analysis and evaluation. This consists of the lumped parameter models of different system components, such as cable, inverter, and motor. The lumped parameter models enable faster simulations. The results obtained were verified by experimental measurements and excellent agreements were obtained. A change in the winding arrangement and its influence on the motor high frequency behavior has also been investigated. This was shown to have a little effect on the parameter values and in the motor high frequency behavior for equal number of turns. An accurate prediction of overvoltage and EMI in the design stages of the drive system would reduce the time required for the design modifications as well as for the evaluation of EMC compliance issues. The model can be utilized in the design optimization and insulation selection for motors. Use of this procedure could prove economical, as it would help designers develop and test new motor designs for the evaluation of operational impacts in various motor drive applications.

Physics-based modeling of power system components for the evaluation of low-frequency radiated electromagnetic fields

The low-frequency electromagnetic compatibility (EMC) is an increasingly important aspect in the design of practical systems to ensure the functional safety and reliability of complex products. The opportunities for using numerical techniques to predict and analyze system's EMC are therefore of considerable interest in many industries. As the first phase of study, a proper model, including all the details of the component, was required. Therefore, the advances in EMC modeling were studied with classifying analytical and numerical models. The selected model was finite element (FE) modeling, coupled with the distributed network method, to generate the model of the converter's components and obtain the frequency behavioral model of the converter. The method has the ability to reveal the behavior of parasitic elements and higher resonances, which have critical impacts in studying EMI problems. For the EMC and signature studies of the machine drives, the equivalent source modeling was studied. Considering the details of the multi-machine environment, including actual models, some innovation in equivalent source modeling was performed to decrease the simulation time dramatically. Several models were designed in this study and the voltage current cube model and wire model have the best result. The GA-based PSO method is used as the optimization process. Superposition and suppression of the fields in coupling the components were also studied and verified. The simulation time of the equivalent model is 80-100 times lower than the detailed model. All tests were verified experimentally. As the application of EMC and signature study, the fault diagnosis and condition monitoring of an induction motor drive was developed using radiated fields. In addition to experimental tests, the 3DFE analysis was coupled with circuit-based software to implement the incipient fault cases. The identification was implemented using ANN for seventy various faulty cases. The simulation results were verified experimentally. Finally, the identification of the types of power components were implemented. The results show that it is possible to identify the type of components, as well as the faulty components, by comparing the amplitudes of their stray field harmonics. The identification using the stray fields is nondestructive and can be used for the setups that cannot go offline and be dismantled

Cyclical DNA methyltransferase 3a expression is a seasonal and oestrus timer in reproductive tissues

Acknowledgments This work was funded by the University of Aberdeen CLSM grant to TJS. EWJL was funded by a Society for Reproduction and Fertility undergraduate scholarship. TJS conceived the project, designed experiments, analyzed data and wrote the manuscript. EWJL conducted experiments and analyzed the data. CC conducted the immunocytochemistry. ML conducted HEK293 cell culture assays. EMC and ASB provided technical assistance. The authors thank Gerald Lincoln for critical feedback on a previous version of this manuscript.

Cyclical DNA Methyltransferase 3a Expression Is a Seasonal and Estrus Timer in Reproductive Tissues

Acknowledgments This work was funded by the University of Aberdeen CLSM grant to TJS. EWJL was funded by a Society for Reproduction and Fertility undergraduate scholarship. TJS conceived the project, designed experiments, analyzed data and wrote the manuscript. EWJL conducted experiments and analyzed the data. CC conducted the immunocytochemistry. ML conducted HEK293 cell culture assays. EMC and ASB provided technical assistance. The authors thank Gerald Lincoln for critical feedback on a previous version of this manuscript.